Screen doesn't respond

The screen doesn't respond. I can't slide the bar to unlock it. I can't slide to power off. I've rebooted but the problem persists.
Any suggestions?

I had somewhat of the same problem with my screen frezzing up on me where i was not allowed to do anything. all i did was leave the phone on until the battery drains out then reconnect the phone to ac outlet to recharge the battery. about 2 hours into the recharge i held both the sleep button and the home button at the same time for about 10 seconds and the phone reset it self and i did not lose any of my settings or data, hope this helps you.
IMAC G5 20" INTEL, IPHONE 8G, IMAC G4 17", IPOD 60G   Mac OS X (10.4.10)  

Similar Messages

  • TS2771 my ipod touch screen doesn't respond  but only if tap what i want and tap it twice again. it like tap and a double tap

    my ipod touch screen doesn't respond  but only if tap what i want and tap it twice again. it like tap and a double tap

    I think you have an Accessibility feature turned on. Triple click the Home button and then try to go to Settings>General>Accessibility and turn all Accessibility features off. To scroll you may have to use three fingers. If proem see:
    iPhone: Configuring accessibility features (including VoiceOver and Zoom)

  • Portion of screen doesn't respond to touch

    I got my iPod Touch a few months ago and just today I found that about the top inch (almost half) of the screen doesn't respond to touch.
    I can't access 'calendar, notes, etc...', nor can i scroll through my songs from the top half or hit the 'back' button.
    I tried restarting it, but that didn't work. I don't know if I want to try restoring it because I don't have a backup of all my songs on my computer, and I searched on the internet, and the only PC to iPod program compatible with the iPod Touch is $20.
    I purchased the iPod Touch from Amazon.com, so I'm not sure if I will be able to bring it to the Apple Store.
    I am not sure what I should do. :/
    Any help is very much appreciated!

    https://selfsolve.apple.com/GetWarranty.do
    Go to that website. that's where you can check if the ipod is covered under apple's limited year warrenty. Just type in the your Serial Number and the country where you live and it'll will tell you if it's still covered under the warrenty. And if it is, you can go to the apple store and complain about the problem. They might even give you a new one. hope that helped.

  • My Iphone 5 touch screen doesn't respond to touch

    Although I can hard reset, my iPhone 5 suddenly stopped responding to touch. Calls come in and texts, but I can't answer or open the phone since the screen doesn't respond to any touch. I am unable to get to AT&T or Apple right now. Any advice would be greatly appreciated! Thank you.

    Put it into recovery mode and set it up as new device:
    iOS: Unable to update or restore
    How to back up your data and set up as a new device

  • All of a sudden my screen doesn't respond anymore? i-pad 2.

    I turned on my i-pad 2 and now the screen doesn't respond anymore. I got the slider to unlock it, to move once, but that was it? Help?
    Thanx in advance
    Tim

    Did you drop the iPad?
    Yes, a wireless keyboard will work with the iPad, but you'll need the iPad to work so you can set it up.
    Try this  - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) No data/files will be erased.
    Frozen or unresponsive iPad
    Resolve these most common issues:
        •    Display remains black or blank
        •    Touch screen not responding
        •    Application unexpectedly closes or freezes
    http://www.apple.com/support/ipad/assistant/ipad/
    iPad Frozen, not responding, how to fix
    http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
    iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
    http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
    Black or Blank Screen on iPad or iPhone
    http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • IPhone 6 screen doesn't respond 80% of the time

    iPhone 6 screen doesn't respond 80% of the time.  And then it will get a mind of it's own and dial people on my favorites and open apps randomly.

    Try to reset the phone by holding the sleep and home button for about 10sec, until the Apple logo comes back again. You will not lose any data by resetting, but it can cure some glitches.
    If this does not help, setting it up as new device would be the next thing to try:
    How to erase your iOS device and then set it up as a new device or restore it from backups

  • 1/3 screen doesn't respond to touch.

    After a waiting 2 months to get the tablet fixed in the US (and 40£ spend on postage) the battery on my touchpad was fixed.
    Was very happy to see it rendering something again until I've noticed that 1/3 of the screen doesn't work when I touch it.
    And it's consistent. If I move it around to portrait and landscapte modes the same area doesn't work.
    The device fisically doesn't look damaged. And the image looks ok even on the area that doesn't respond to touch.
    I don't think this is a software issue but I don't want to send it back to the states and spend another 40£ and two months to get it fixed without trying other options.
    Can anyone help me to try out some other things?
    Thanks.
    Post relates to: HP TouchPad (WiFi)

    I am not very savy with technology. Can you please help me out? I would greatly appreciate the help. How do I check my screen cells? 
    cygnusX1_1 wrote:
    Try the touchsensor test.
    Open Launcher > Device Info > application menu > Tests > Interactive Tests
    Run the touch sensor test to test all the cells on the touchscreen.
    It it fails the test, it will need to be repaired.

  • IPod Touch Screen Doesn't Respond

    I've Had my ipod touch 3g for about 6 days now. Everything was going well but after i synced my ipod touch, my screen just stop respond. I've tried restoring it many times and its just fail. What should i do? Could i go to the Apple store and get a new one?
    Message was edited by: iKanji

    Hi iKanji,
    Is the screen stuck at a sync prompt? As I've had this happen with my iPhone many times in the past.... It's a strange predicament that you can get into and I don't now the cause...
    At times I try to connect and disconnect my device from the dock connector until the device's OS realizes that one of the jobs are stuck and it reboots that prompt. Then all is fine.
    Again this issue was with my iPhone and it was a lot worse before the 3.1.2 update. It happens very rarely now, and does come back to life once the OS of the device realizes that this is occuring. Until then, the screen and power buttons are totally useless..
    Very frustrating, but this is the only solution I've seen work for me.
    Good luck and let me know if this helps.

  • My gmail screen doesn't respond to tap

    My gmail will load, but then the screen does not respond to touch so I cannot open it

    do a reset hold down the home/power button together until you see the apple logo and then release. wait for phone to boot back up, see if that helps.

  • Touch Screen doesn't respond

    I'm using HP AIO PRO400 with Windows 10 TP up from Windows 8.1
    After all, the touch screen seem to be disabled. Someone help me.

    Time for an appointment at the Genius Bar of an Apple store. Appears to be a hardware problem.

  • HT201406 3G got wet and screen doesn't respond

    I dropped my iPhone 3G in water, but it was only submerged for about 45 seconds. I got it out, turned it off and took out the sim card. I quickly dried it with a towel in put it in uncooked rice for over 24 hrs. It turns on now and the screen is normal, but I cannot do anything with the touchscreen. It's like it's not working anymore, but I see no damage. Do I need to pop it open and clean the logic board and stuff, or do I need to replace the entire screen? It's a used phone, so I have no warranty anyways. Any help would be appreciated!

    So, my phone that does work is toast?? Sound works, nothing is cracked, still charges and turns on and off, screen display works, there is just a small watermark in the top right corner and the touchscreen acts as if there is no 'connection'. So, it's not toast. I just need to know if it'd be safe to buy a new screen or if I could just pop it open and clean it out.

  • My MBA screen doesn't respond well on wake,after it goes to sleep. Any ideas?

    Is it that there is just too much going on for the system, I have my HD encrypted.

    Boot from your recovery partition (command-R at startup.) Same artifacts?

  • After upgrade to Win 10 ENVY TouchSmart 15-j001tx Notebook PC display doesn't respond to touch

    I just upgraded to Windows 10 from 8.1 and after I did, my touch screen doesn't respond or work.  I basically have a non-touch display... ugh I've searched this forum and the hp support for possible drivers but don't see anything.  I've even tried the Win 10 Drivers Update process with no success. Any suggestions?

    Hi ,
    Thank you for visiting the HP Forums! A great place where you can find solutions for your issues with help from the community!
    I came across your post about the Notebook, and wanted to assist you! I have looked into your issue about your HP ENVY TouchSmart 15-j001tx Notebook and the Touch display doesn't respond to touch after a Windows 10 update. If your computer is having problems finding and installing operating system updates, try using the Windows Update Troubleshooting tool to fix the problem. Here is a document that shows how to update drivers that are not working correctly with Windows 10. Here is a link to your driver page. I would try the section on Driver -Chipsets. Intel Management Engine Interface Driver should help. Restart the Notebook after the install. I hope something here helps you. Thanks.

  • Screen ipad doesn't respond during video viewing home sharing with multiple iOS devices simultaneously

    A have a problem with the videos app and iTunes home sharing on multiple iOS devices.
    This is my setup. On my iMac 2006 with Snow Leopard I have:
    - 100+ dvd's ripped in my iTunes movie section
    - 600+ episodes ripped in iTunes TV-section in 35 TV-shows
    - 1 apple tv, 1 iPad 2, 1 iPad mini
    On an average evening my family is watching different tv-shows simultaneously on the apple tv, the ipad, an iphone, and an ipad mini.
    This is done through home sharing on the one iTunes library.
    All updated apps, software etc..
    What happens on the ipads, after viewing for more than 10 minutes, the user interface doesn't show up when tapping the screen. The touchscreen doesn't respond, only the home button works. Clicking the home button closes the app, but the sound of the video keeps on playing. Opening up the videos app again gives a black screen with sound still playing and still no button or UI.
    The only workaround which currently works is killing the videos app. Power off the ipad and power on again, reconnect to the shared library, wait until it has found all the content (1+ minutes) and startup the tv show again.
    All in all, a nasty way to pause your viewing or switching to another movie of tv episode, or even wanting to finish viewing.
    The problem has haunted me for a year now, patiently waiting and hoping software-updates would fix it. They didn't.
    A fix would obviously hugely improve my user experience, getting it on par with Apples usual quality of service.
    Anyone familiar with this problem? Apple: is it possible to fix it in an update?

    Same here for over a year now.
    You cant imagine how happy i am that im not the only one with this problem.
    many of frinds have the same setup as me (ipad 2, 27"imac, express, apple tv 2)
    No problem
    I had the problem on Snow Leopard, lion and now on mountain lion.
    I'am also starting to get a new problem - sometimes when waching a movie on iPad or ATV it just quits the movie and you have to start it again
    on the iPad most of the time it also shows the wrong cover art. I tried all the hints here, and i works for a day or two then its wrong again
    I store my itunes library on an external drive - you ???

  • My macbook pro was on sleep mode, and when i opened it again, it wouldn't come off the black screen. It is very hot and also doesn't respond to the power button...

    My macbook pro was "asleep". I opened it later, and the screen wouldn't change from black.. The bottom of the laptop is very hot and making a hissing/whirring sound. I tried hitting the power button to turn it off, but the conditions just stayed the same. It doesn't respond to the power button, and the screen just stays black. How do i fix this?!

    I will go to the Apple store.  I just thought I would throw it out there to see if anyone had a solution.  They repaired this macbook before twice.  The last time they replaced several things to fix the screen.  I just threw out the question to see if someone could save me the trip to the store. 
    I was curious if the new programs (like lego games) can cause the computer to run to a point to blank the screen.
    And curious if there are other things I can try to get the screen up and running.

Maybe you are looking for

  • Problem in using the install()'s byte array values?

    I tried to pass the values to the OwnerPIN object at the time of initialization. But when I try to install the applet I will get 6A80 error code . Can anybody tell me why I am getting this message. And if i use some different data values for pin.upda

  • MIGO printing material document when saving.

    Hi, how enabling automatically the printing of materials document in MIGO when saving ? Best regards

  • Full text search with XML input in Oracle

    Hi, I need to develope a web application which can do full text search for a library. We will use XML as the input data format and stored XML file in Oracle. How can I do full text search to the XML according todifferent tags or elements. e.g search

  • Can I mount another instance of standby database

    1. If I have a RAC physical standby database and instance 1 is mounted and is applying redo, can i mount second instance if I wish for example to perform a backup using rman? 2. If instance 1 is mounted and applying redo can I stop it and start insta

  • Error message on sign in?

    I can't sign into mail on icloud