Screen turned black and blue?

i dropped my phone today from not that high and the screen turned black with blue lines all over it and it won't work. i have no clue what to do or how to fix it? after 4 hours of this, siri started working but my screen is still black and blue.... any ideas of why it did this? and how to fix it?

Hi there sydneyntarrant,
You may find the troubleshooting steps in the article below helpful.
iPhone: Hardware troubleshooting
http://support.apple.com/kb/ts2802
-Griff W. 

Similar Messages

  • My ipod nano 4th generation only works when it is plugged into the computer; otherwise, the screen turns black and it is completely unresponsive to any efforts such as pushing buttons, reseting, etc. What should I do?

    My ipod nano 4th generation only works when it is plugged into the computer; otherwise, the screen turns black and it is completely unresponsive to any efforts such as pushing buttons, reseting, etc. What should I do?

    Sounds like the battery is shot and in need of a replacement.  You can have Apple replace the battery for a flat fee or you can send it into a third party repair center for a bit less.
    Not much else you can do for troubleshooting this one.
    B-rock

  • Screen turns black and shuts down unexpectedly- help!

    screen turns black and shuts down unexpectedly- help!

    Try:
    iPod touch: Hardware troubleshooting
    iOS: Not responding or does not turn on

  • Screen turned black and makes some sort of an alarm sound

    Does anyone knows a solutions for this: my intel iMac was on all afternoon till suddenly the screen turns black and it starts making some sort of an alarm sound "tuut tuuut". I tried restarting but nothing changes. I tried restarting from the installation Disc with C-key but no result. As a matter of fact i can't even get the disc out of my iMac anymore. Thanx

    That sounds like hardware problems, I suggest you call your local Apple Store to my an appointment for them to check it out for you.

  • My Ipod touch 2nd gen. was working fine but when I tried to charge from my PC the Ipod start getting too hot and the screen turn black and doesn't  work anymore.Maybe is burn?

    My Ipod touch 2nd generation was working fine until I tried to charge again from my PC,when I connected the Ipod was getting too hot and smelling like burn cable,the screen turn black and doesn't work anymore. any ideas about what happen?

    You can try here:
    iPod touch: Hardware troubleshooting
    However, from your discription, I suspect that something is broken.  Maybe a dead battery.  In that case. I would make an appointment at the Genius Bar of an Apple store and see what they say.

  • My ipad was in the process of updating (ios7) while at the same time syncing with my laptop.  suddenly the screen turned black and after few seconds the new itune icon  appeared on the screen.  the same icon appears even after i reset it.

    I was updating my ipad (ios7) while syncing with my laptop.  suddenly the screen turned black and seconds later a huge itunes icon appeared on the screen.  the same icon appears and not the usual interface even after resetting it several times. 
    please explain whta's happening.
    thank you

    See Unable to Update or Restore  >   http://support.apple.com/kb/ht4097
    You may need to try this More than Once...
    Be sure to Follow ALL the Steps...
    Once you have Recovered your Device...
    Re-Sync your Content or Restore from the most Recent Backup...
    Restore from Backup
    http://support.apple.com/kb/ht1766

  • I have some problems when turning on my iphone5.  The screen turns black and so white and when I start an app it suddenly turn itselves off.  This happens every time when I turn it on.  After I have turned it on several times it acts normal...Anyone??

    I have some problems when turning on my iphone 5.  The screen turns black and then white and the appli is red and when I finally get in and start an app it turnes itselves off.  This happens every time when I turn it on.  After I have turned it on several times it acts normal.... But something is wrong...Anyone???

    Try reset
    Reset: Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Note: You will not lose any data
    If no joy, restore backup using iTunes.
    Finally last attempt, rsetore as new and sync content back manually.

  • (Mountain Lion) suddenly the screen turns black, and I have to use the switch to turn it on. And, the screen turns to zoom, and the only way to turn to normal is to close the window and start all over again?

    (Mountain Lion) suddenly the screen turns black, and I have to use the on/off switch to turn it on. And, the screen turns to zoom, and the only way to return to normal is to close the window and start all over again?

    Does the screen go black while you are using the machine? ...or after it has sat idle for a bit?
    If it happens while you're using the machine, check to see if a hot corner has been set for sleep. You can do that here: System Preferences > Desktop & Screen Saver > Screen Saver and click the button labelled "Hot Corners..." in the lower right.
    If it happens after a bit of idle time, that's normal sleep behavior. The delay can be adjusyed here: System Preferences > Energy Saver.
    In either case, pressing any key on the keyboard should bring it out of sleep.
    Re zooming -
    If this happens while in Safari, and you are using an Apple Magic Mouse, a default setting applicable to it is that a soft double-tap on the mouse will zoom the Safari window. A second double-tap will bring it back.
    If it is the entire screen that is zooming, Control plus scroll gesture on the mouse will zoom the whole screen. Repeat with the opposite scroll gesture to bring it back.

  • I went to update my ipad 2 and the screen turned black and now it does not turn on what do i do

    I WENT TO UPDATE MY IPAD 2 AND THE SCREEN TURNED BLACK AND NOW IT DOES NOT TURN ON, PLEASE HELP!!

    THANK YOU FOR THE SIDE BAR SOLUTIONS, ITS WORKING AGAIN !!

  • The camera screen turning black and locking up.

    I see a lot of people having issues with the camera screen turning black and having to restart phone to fix it.  I have the 6 plus and the screen turns black and locks when taking a second picture on the txt screen.  I have replaced the phone and the new one does the same thing.  I went to the Verizon store and they just scratched their heads.  I have reset the old phone 3 times and restored from my back up which did not help.  I put my sim card in new phone and restored it and it had the same problem.  I thought my back up was the problem so I restored the new phone to new again without using my backup and it worked.  After a few hours of turning off and on every setting I use and many many many factory resets I found the problem.  Whenever the option for "speak screen" is turned on it causes the camera software to glitch and freeze after one picture is taken.  I have verified it on 3 different Iphone 6 Plus.

    Try:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up                                                                
    - Restore to factory settings/new iOS device.      
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar                       

  • My iPhone screen turned black with blue stripes then went to the logo screen and then turned black. (iPhone 5) help!

    My lock button has not been working for a few months. I dropped it a couple of days ago but it barely did it a while ago. I was texting when the screen developed blue/purple lines with a black background and then it went to the apple logo. So I thought it would just restart but then it turned black and won't respond to me trying to work it blindly (guessing where the icons are)... Should I just let it die and hope for the best? Any advice? Help.

    Most likely a damaged LCD display. Probably will not fall under warranty . Apple can do an out of warranty repair for 199 on a 4S. You could look into insurance options as well through your carrier.

  • HT4061 I did install the OS7 on my Ipad yesterday, and right now, while browsing internet with safari, the screen turned black, and no way to return to normal

    I am lost: I did install iOS7 a couple of days ago, and right now, while browsing internet with Safari, the screen turned black suddenly, and I can't reactivate it anyway (buttons death, screen death)

    Thank you very much!
    During the minutes needed  looking for help, I decided to put the magnetic cover on the screen again, and I connected the iPad to the charger. Whe I did uncover the iPad now for a try with your tip (hold sleep and home buttons for about 10 seconds), it came to life again.
    Thank you.
    Best regards,
    Lorenzo

  • Why does my screen turns black and I have to reset the phone to make it work?

    My phone is fully charged when suddenly the screen turns black it doesnt matter if I push the buttons the screen still is black, I have to reset the phone to make it work. When the screen is black and if you call you can hear is ringing but my phone does not sound.
    I had a bad experience with this phone, to tell you the truth I dont even want it anymore, I have other apple products and they are excellent and had worked fine but the iphone is a dissapointment to me.

    Go to an Apple store.

  • The screen turns black and the computer stays on

    hi,
    Once in a while when I am on my beige power macintosh and it runs smoothly, it all of a suddenly stops what it is doing and the screen turns black. when I am on iTunes some times, the screen turns black but the music still plays. I unplug and replug the monitor in but it is still black. Here are my computer stats. Ram 320mb, OS 10.2.8, 8 gig hard drive, 6mb vram, built in video, USB & Firewire PCI cards, and an AV Personality Card w/ 28k Modem, Running 333 mhz, and I have tried 3 other mother boards

    Welcome Jarrett,
    The article implies that using a certain version or "build" of the 10.2.8 updater fixes the problem. No true. Almost everyone who's experienced it on a Beige G3 has used the preferred updater specified in that article.
    Not every Beige gets it. I had 640MB when I moved to 10.2.8 and it never hiccuped. However, I run video off a PCI accelerator card and, as Frank mentioned, the video issue seems to happen when you are using the logic board video port.
    If you can't get your computer to boot and run long enough to use Terminal, pop it open and pull RAM until its under 192MB. Then the computer should be stable long enough to do the fix. Then you can add the pulled RAM back.
    The good new is that everyone seems to have permanently fixed the problem by applying the Terminal procedure described.
    Allan

  • I had an update from a program and now my screen turned black and i can't do anything i have an ipad mini. Any helps?

    Help My ipad mini's screen turned black afther doing an update from a program can anybody tell me what to do?

    Care to share your solution with the rest of the community?
    It might help someone else down the road.

Maybe you are looking for

  • How to connect multiple nanos and minis to one computer and share content

    I have 3 iPod nano's and 1 iPod mini in my house and would like to make a central repository of music on one computer that can be shared across nanos where users can select all or some of the available tunes. How can I do this? Dell   Windows XP Pro

  • My airplay button is not showing up on my iPad?

    And I am swiping up from the bottom of the pad. Help plz.

  • New iMac can't see Laserwriter Select connected to a PC on same LAN-- why?

    I've just returned to the Mac universe after a five year hiatus. When I discovered how well Macs play with PCs and Unix these days, I decided to come back. There's just one issue: I can't print to my Laserwriter Select 360, connected by parallel port

  • Can't open a group of layers in Elements 13

    I am trying to open a group of layers in Elements 13 but get the following error message:  "you are attempting to open a group which is not supported in photoshop elements"  Then it prompts to simplify all the layers into one layer.  This is useless!

  • Converting double to String

    I am looking for a way to convert double to String. I think that I have to use wrapper like Double class and use toString(double d), but I am not sure how to do it. Since toString() is static method, I do not have to have an instance of the Double cl