Screen turning to white

Suddenly screen turn to white until restarting device

Hi shadysham,
Oh no! That doesn't sound too good. Luckily you have taken the correct troubleshooting steps found in this article:
iPhone: Hardware troubleshooting
http://support.apple.com/kb/TS2802
Display shows a white screen
Try turning iPhone off and then on again.
If the iPhone will not turn off, try to reset it.
If that doesn't work, try restoring the device.
If the issue comes up again, I highly advise taking step three: restoring the device.
Thanks,
Matt M.

Similar Messages

  • My Blackberry Curve 8520 screen turns ALL WHITE!! :'(

    Hello everyone. I need help here.
    I found out that my Curve 8520 screen turns all white. When I pulled the battery out, and put it back, things went ok; screen shows uploading but NEVER FINISH and it turns ALL WHITE again. I dd this a few times but still not working. 
    What is wrong to my blackberry? HELP!

    Hello grasyapagsinta
    Welcome to BlackBerry Support Community Forums
    If you think your Battery it OK then try Updating or reloading your device software to rule out any software issue.Have a look at  on how to perform a clean reload of device software :
     KB11320 : How to perform a clean reload of the BlackBerry Device software using BlackBerry desktop software for windows.
    Additional Information :KB30280 : BlackBerry smartphone displays a blank white or black screen.
    Prince
    Click " Like " if you want to Thank someone.
    If Problem Resolves mark the post(s) as " Solution ", so that other can make use of it.
    Click " Like " if you want to Thank someone.
    If Problem Resolves mark the post(s) as " Solution ", so that other can make use of it.

  • If the screen turns to white is der anyway that this could be fix?

    If the screen turns to white is der anyway that this could be fix?

    Redundant posts will get you nowhere. Your question has been asked and answered twice now. Please stop reposting the same question. You need to take your Mac in to get it repaired.
    GB

  • My ipod nano (6th gen)'s screen don't turned on... when resetting it, the screen turns to white.. the most worst is, it doesn't work out...

    I really don't know to fix it... What happen was, when i played my ipod nano, it turns to white... i don't know if I accidentally clicked anything on the screen or the buttons at the side of the device... What i did was, I connected it in my laptap because I was thinking that maybe my ipod was in hang mode. When I was able to connect it, the itunes recognized it but I can't played the music and the screen in my ipod screen was still white... SO, I restored it in factory setting... the same thing happen... i don't know what happen, so I need your help...

    You can work through the remaining five 5 R's of troubleshooting.
    http://www.apple.com/support/ipod/five_rs/
    It might also be a good idea to let the iPod's battery fully drain. Then charge it back up and restore it once more in iTunes.
    Otherwise, it's likely a hardware issue with the iPod's LCD display, meaning you'll need to take or send your iPod in for service either via Apple or a third party repair service. Here is Apple's repair pricing.
    http://www.apple.com/support/ipod/service/prices/
    Note that they don't actually repair the device, but exchange it for one of the same generation, model, and capacity.  A third party service will actually replace the damage part for a little less.  Google "iPod screen repair" and you should get a number of results to work with.
    B-rock

  • Ipod touch's screen turn all white help?!

    ok at first it was white last month and so i recharged it and the next day it worked and 2 days ago it turned white again and did the same procedures but it still wont work,u cant do anything and u cant even turn it off
    info:
    5 months old
    has a pink hard case
    dropped it but w/ case so no effect
    didnt do the earphones alot
    has screen protecter
    after a lil wile it turns blackish and wen u press somethin it turns wite agen
    plz help plz

    Welcome to the discussions,
    Display shows white screen
    Turn iPod touch off and turn it on again.
    If the iPod will not turn off, try to reset it. Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until either the Apple logo or battery symbol appears. If the battery symbol appears, continue to charge iPod touch until it is fully charged.
    If that doesn't work, try restoring the iPod. See this article for assistance: http://support.apple.com/kb/HT1414
    copied from: http://support.apple.com/kb/TS2771#whitescreen
    If still no luck, you'll have get it serviced.

  • Why does my imac show vertical coloured lines on bootup? Then the screen turns solid white

    My iMac 3.4 i7 OS 10.6.8 is showing 5 Virtical Coloured lines when I turn it on. The imac does not boot. The screen goes clear white. Anbody aware of this problem if so what is the cause?

    Hi Leon Ellenport,
    It seems I have the same issue with my iMac, and I am thinking about my plan of action. Did you ever fixed this issue? If yes, how?
    Thank you very much in advance, and sorry for bothering.

  • I was on facebook and my screen turned completely white and it won't respond to anything. What do I do?

    I was on facebook on my iPod touch and the screen suddenly went white and will not respond to anything. What do I do?

    - Try am reset.
    Reset iPod touch:  Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Next connect to thecoputer and if iTunes ees the iPod restore via iTunes
    - If still white screen, let the battery fully drain. After charging fro an hour try the above again.
    For the future, saying yu tried everything provides no useful information.  We do not know what is your "evertything".

  • Screen turns bright white while display freezes? Any one know why?

    The screen freezes and gets brighter and brighter until it becomes all white. If I move the screen of the laptop the display returns to normal for a brief second then starts turning white all over again. Anyone know what the problem could be?
    I have already run that Hardware Test and nothing seems to be wrong...
    Thanks,
    Hijazirm

    yes your screen interconnection has a bad bias rail
    all lcd use a bias voltage supplied by the mainboard to keep it dark till its lit
    and control the back light
    if you have already reset the smc http://support.apple.com/kb/ht3964
    then you should think its a physical connection problem
    and perhaps is just a small flat cable needs plugged back in
    the flat flashed ribbon type cables can become disjointed from there socket
    or there small pads oxidise...
    its a job for an apple dealer to fix the interconnections ribbon
    by replacement or cleaning with a 'gold cloth' as you should use to clean the contacts on sims simms etc
    and ribbon cables used in display interconnect mostly !!!
    dont use any harsh methods a 'gold cloth ' is a special cloth that rough on one side smooth on the other
    and has a chemical embeded to it for use on gold plate etc to clean it of crap...
    and reseating the ends back to there sockets
    its defo a job for an apple store etc...

  • MacBook Pro screen turns blank white when try to turn on!

    My MacBook Pro is turning on to startup screen with apple icon and loading signal, but then after a few minutes the screen just turns white. What is wrong?

    Reset the PRAM >    Resetting the PRAM
    If that doesn't help, if your Mac is running v10.7 Lion, v10.8  Mountain Lion, or v10.9 Mavericks, startup your Mac while holding down the Command + R keys. From there you should be able to repair the startup disk if necessary and restore OS X using OS X Recovery
    For OS X prior to v10.7, insert your install disc then startup your Mac while holding down the C key. From there you can use Disk Utility to repair the disk.

  • Screen turning to white and freezing

    Hi, I was hoping someone could help me. I have had my Macbook for a year and a half. It has suddenly started acting up. The screen will sort of freeze in a start and stop sort of way, then fade to white in a pixelated way. I have seen some archived discussions about this but haven't seen a definitive answer. Anyone out there have any advice? Being out of my warranty I am obviously a bit stressed out to have to pay for this repair myself after only a year and a half. Seems too short for a laptop that is quite expensive! Thanks

    Hi Chappy. Try resetting the PRAM and SMC. If these doesn't help, boot from the install disk and see if the same thing happens. If it does, it could be a hardware issue. You can also try creating a test account (full access) and see if the same thing occurs. If it does, then try visiting an Apple store. Could be a loose connection with your screen flex and the logic board. Good luck.
    http://support.apple.com/kb/ht3964
    http://support.apple.com/kb/ht1379

  • Ipod 4g recently updated, screen turned to white, cannot reset. help please

    help i cant reset my ipod touch4g, i just updated it to ios5 and all of a sudden it turned white and i cant do anything. help please

    i tried all of that too. itunes cant detect it. i tried uninstalling and installing itunes again but still it didnt work.

  • My i pod screen turned white what do i do

    i was on my app and my i pod screen turned complity white and i tryed turing it off and it dont work at all:(

    - Trhere:
    iOS: Not responding or does not turn on
    If not successful and yuo if you can't turn it off, let the battery fully drain. After charging for at least an hour try the article again.
    If not successful time for an appointment at the Genius Bar of an Apple store.

  • Mac Pro and Lucite 23" cinema display turns all white when starting up the

    I have a friend that has a 2.6 MacPro and a ADC 23" cinema display with adapter. When ever he starts the computer the screen turns all white and locks ups ? Any ideas what's causing it ?

    Try Resetting the PRAM (Press and hold the Command-Option-P-R on start-up), some of the basic monitor parameters are stored there, maybe it'll be enough, and its an easy and harmless procedure.
    About Resetting PRAM and NVRAM:
    <http://docs.info.apple.com/article.html?artnum=2238>
    Good Luck,
    Baryo.

  • My ipod screen is solid white

    I dropped my ipod and the screen turned completely white... Everything still works on it, but I don't get to choose what song I'm listening to!!

    Some people solved that by letting the battery run down and connecting in recovery mode, explained in this article:
    iOS: Recovery mode

  • My MacBook Pro just turned itself off while installing Windows 7. It has now got a black screen with a white flashing bar in the top left corner...what can I do?

    I was just installing windows 7 onto my MacBook Pro. I selected to have 200GB for Windows and the rest leave for Mac.
    I clicked install and the bar filled up as it should do. However, once the install had completed, my MacBook turned itself off. I assumed this was normal. Now, my MacBook has a black screen with a white flashing underscore in the top left corner.
    What is wrong and what should I do?

    Hold down the Option key when starting up then on the sceen that comes up select Mac OS X to boot from.
    The Win 7 install didn't go well and is hung in some way. You should use boot camp assistant to remove the win partition and start over.
    Make sure you are using a Retail version of Win 7. A Branded OEM version, like ones from Dell and HP, will NOT work to install Windows 7 on your Mac.

Maybe you are looking for

  • Problem with refresh button in tool bar in ALV

    hello experts,                           I am displaying a report using OOPS ALV. Here i am deleting one row. After deleting the row, if i clicked on REFRESH button in the tool bar, it should display the table newly with all updations which i made. w

  • Adding new field in Objects(Equipment) either using AET or EEWB.

    I have to add a new field in the screen for Objects (under Processing data). To do the same first i tried using AET but i get the "Show Enhancements" and "Create New Fields" buttons grayed out in AET so i assume that AET is not available for Objects(

  • IPhoto 6.0x conflict with Blackmagic Decklink 5.4.2

    If you find that iPhoto is crashing when editing photos and you are running a Blackmagic Decklink you must turn OFF the Video Desktop option in the Blackmagic Control panel.

  • When I click on my iTunes icon, it highlights but does not open.

    I can't open iTunes and haven't been able to for a couple days now. I can't find any solutions anywhere. Does anyone know a way to fix this?

  • Error at XML Creation time

    Hi ALl, Unexpected Error in method: public abstract com.elitecore.billing.utils.ResultObject com.elitecore.billing.ejb.bill.interfaces.IBillSearchSessionBeanLocal.getXsltContent(java.lang.String) java.lang.NoSuchFieldError: conversion at oracle.xdb.X