Screen turns black and when I touch it, it comes back to normal

It happens all the time. My macbook's screen starts pixeling until it turns black. It comes back to normal when I touch the screen. Sometimes it happens so often that I have to touch the screen all the time. How can I solve this problem ???

By bringing it to an Apple store or an AASP.

Similar Messages

  • My Ipod touch 2nd gen. was working fine but when I tried to charge from my PC the Ipod start getting too hot and the screen turn black and doesn't  work anymore.Maybe is burn?

    My Ipod touch 2nd generation was working fine until I tried to charge again from my PC,when I connected the Ipod was getting too hot and smelling like burn cable,the screen turn black and doesn't work anymore. any ideas about what happen?

    You can try here:
    iPod touch: Hardware troubleshooting
    However, from your discription, I suspect that something is broken.  Maybe a dead battery.  In that case. I would make an appointment at the Genius Bar of an Apple store and see what they say.

  • HT1420 i tried updating the software on my i pod touch, and it looked like it was working cause it said "verifying update". but suddenly the screen went black and when i tried to turn it back on, it only had a picture of a usb chord pointing to the itunes

    i need help. i tried updating the software on my ipod touch, and it looked like it was working fine, because it said "verifying update", but suddenly the screen went black and when i tried to turn it back on, it only had a picture of a usb chord pointing to the itunes icon. what do i do?

    Your iPod has dropped into Recovery mode. You'll need to restore it via iTunes on your computer.
    http://support.apple.com/kb/ht1808
    Regards.

  • My ipod nano 4th generation only works when it is plugged into the computer; otherwise, the screen turns black and it is completely unresponsive to any efforts such as pushing buttons, reseting, etc. What should I do?

    My ipod nano 4th generation only works when it is plugged into the computer; otherwise, the screen turns black and it is completely unresponsive to any efforts such as pushing buttons, reseting, etc. What should I do?

    Sounds like the battery is shot and in need of a replacement.  You can have Apple replace the battery for a flat fee or you can send it into a third party repair center for a bit less.
    Not much else you can do for troubleshooting this one.
    B-rock

  • I have some problems when turning on my iphone5.  The screen turns black and so white and when I start an app it suddenly turn itselves off.  This happens every time when I turn it on.  After I have turned it on several times it acts normal...Anyone??

    I have some problems when turning on my iphone 5.  The screen turns black and then white and the appli is red and when I finally get in and start an app it turnes itselves off.  This happens every time when I turn it on.  After I have turned it on several times it acts normal.... But something is wrong...Anyone???

    Try reset
    Reset: Hold down the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Note: You will not lose any data
    If no joy, restore backup using iTunes.
    Finally last attempt, rsetore as new and sync content back manually.

  • Screen turns black and shuts down unexpectedly- help!

    screen turns black and shuts down unexpectedly- help!

    Try:
    iPod touch: Hardware troubleshooting
    iOS: Not responding or does not turn on

  • My iphone doesn't ring when it's unlocked .. i have calls but the screen still black and when i slide to unlock the screen i found i had missed calls

    My iphone doesn't ring when it's unlocked .. i have calls but the screen still black and when i slide to unlock the screen i found i had missed calls
    i have tried manythings but it doesn't work
    i put it in silent mode and i found my calls comes normaly and it works good but when i turn on ring mode it's back as it how can i fix that ?!

    Basic troubleshooting steps outlined in the user guide are restart, reset, restore from backup, restore as new device.  Try each of these steps until your problem is solved. If these steps fail to solve your issue, then you'll need to bring your phone into Apple (or an authorized service provider in your area) for evaluation.

  • The camera screen turning black and locking up.

    I see a lot of people having issues with the camera screen turning black and having to restart phone to fix it.  I have the 6 plus and the screen turns black and locks when taking a second picture on the txt screen.  I have replaced the phone and the new one does the same thing.  I went to the Verizon store and they just scratched their heads.  I have reset the old phone 3 times and restored from my back up which did not help.  I put my sim card in new phone and restored it and it had the same problem.  I thought my back up was the problem so I restored the new phone to new again without using my backup and it worked.  After a few hours of turning off and on every setting I use and many many many factory resets I found the problem.  Whenever the option for "speak screen" is turned on it causes the camera software to glitch and freeze after one picture is taken.  I have verified it on 3 different Iphone 6 Plus.

    Try:
    - Reset the iOS device. Nothing will be lost
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings      
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                 
    iOS: How to back up                                                                
    - Restore to factory settings/new iOS device.      
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
    Apple Retail Store - Genius Bar                       

  • I dropped my ipod 5 and screen is black and i cant touch anything but siri still works

    i dropped my ipod 5 and screen is black and i cant touch anything but siri still works

    Try:
    - Reset the iOS device. Nothing will be lost       
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Restore from backup. See:                                                
    iOS: How to back up                                                                                     
    - Restore to factory settings/new iOS device.             
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
      Apple Retail Store - Genius Bar

  • Screen turned black and makes some sort of an alarm sound

    Does anyone knows a solutions for this: my intel iMac was on all afternoon till suddenly the screen turns black and it starts making some sort of an alarm sound "tuut tuuut". I tried restarting but nothing changes. I tried restarting from the installation Disc with C-key but no result. As a matter of fact i can't even get the disc out of my iMac anymore. Thanx

    That sounds like hardware problems, I suggest you call your local Apple Store to my an appointment for them to check it out for you.

  • My ipad was in the process of updating (ios7) while at the same time syncing with my laptop.  suddenly the screen turned black and after few seconds the new itune icon  appeared on the screen.  the same icon appears even after i reset it.

    I was updating my ipad (ios7) while syncing with my laptop.  suddenly the screen turned black and seconds later a huge itunes icon appeared on the screen.  the same icon appears and not the usual interface even after resetting it several times. 
    please explain whta's happening.
    thank you

    See Unable to Update or Restore  >   http://support.apple.com/kb/ht4097
    You may need to try this More than Once...
    Be sure to Follow ALL the Steps...
    Once you have Recovered your Device...
    Re-Sync your Content or Restore from the most Recent Backup...
    Restore from Backup
    http://support.apple.com/kb/ht1766

  • (Mountain Lion) suddenly the screen turns black, and I have to use the switch to turn it on. And, the screen turns to zoom, and the only way to turn to normal is to close the window and start all over again?

    (Mountain Lion) suddenly the screen turns black, and I have to use the on/off switch to turn it on. And, the screen turns to zoom, and the only way to return to normal is to close the window and start all over again?

    Does the screen go black while you are using the machine? ...or after it has sat idle for a bit?
    If it happens while you're using the machine, check to see if a hot corner has been set for sleep. You can do that here: System Preferences > Desktop & Screen Saver > Screen Saver and click the button labelled "Hot Corners..." in the lower right.
    If it happens after a bit of idle time, that's normal sleep behavior. The delay can be adjusyed here: System Preferences > Energy Saver.
    In either case, pressing any key on the keyboard should bring it out of sleep.
    Re zooming -
    If this happens while in Safari, and you are using an Apple Magic Mouse, a default setting applicable to it is that a soft double-tap on the mouse will zoom the Safari window. A second double-tap will bring it back.
    If it is the entire screen that is zooming, Control plus scroll gesture on the mouse will zoom the whole screen. Repeat with the opposite scroll gesture to bring it back.

  • I went to update my ipad 2 and the screen turned black and now it does not turn on what do i do

    I WENT TO UPDATE MY IPAD 2 AND THE SCREEN TURNED BLACK AND NOW IT DOES NOT TURN ON, PLEASE HELP!!

    THANK YOU FOR THE SIDE BAR SOLUTIONS, ITS WORKING AGAIN !!

  • My iPod Touch 4th Gen Camera's screen turns black and nothing is visible, but on FaceTime, camera does work.Help?

    When I open up the camera app on iPod Touch 4th Gen, the screen stays black and you are not able to take a picture/video. On the other hand when i'm FaceTiming someone, the front and back camera works fine. I went to the genius bar at the apple store and they restored my iPod and the camera was still not working but FaceTime still is working fine. Does anyone have any suggestions on why this might be happening or how I could get my iPod working like normal?

    Try:
    - Reset the iOS device. Nothing will be lost      
    Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Reset all settings                            
    Go to Settings > General > Reset and tap Reset All Settings.
    All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
    - Restore from backup. See:                                               
    iOS: Back up and restore your iOS device with iCloud or iTunes      
    - Restore to factory settings/new iOS device.                       
    If still problem, make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
      Apple Retail Store - Genius Bar                                              

  • Why does my screen turns black and I have to reset the phone to make it work?

    My phone is fully charged when suddenly the screen turns black it doesnt matter if I push the buttons the screen still is black, I have to reset the phone to make it work. When the screen is black and if you call you can hear is ringing but my phone does not sound.
    I had a bad experience with this phone, to tell you the truth I dont even want it anymore, I have other apple products and they are excellent and had worked fine but the iphone is a dissapointment to me.

    Go to an Apple store.

Maybe you are looking for

  • Error while opening Shared Services console

    Hi, I have installed and configured HSS 931 (32bit) on win 2003 64bit successfully. App server is WebLogic92 MP3. IE version 6.0 When i try to launch Shared services console, login page opens with error : "Object doesn't support this method or proper

  • HP Laserjet P1005 print in Text Edit but nor in Word or Adobe Reader

    I just bought a HP LaserJet P1005 printer, it does print in all the aplications that camed with the operating system Mac OS X 10.4.10 ( Text Edit, Ical, Iweb, Sherlock, etc) but It does not print in any other aplication ( Open Office, Microsoft Offic

  • Dynamic PL/SQL block vs dynamic SQL SELECT

    Hi there, I have a question regarding the optimal way to code a dynamic SELECT INTO statement. Below are the 2 posiibilities I know of: _1. Dynamically executing the SELECT statement and making use of the INTO clause of the EXECUTE IMMEDIATE statemen

  • Default Month and Year in Date Paramater

    Hi, I have a question and not able to understand how to show a default current month year i.e 112010 as a deualt value in the prompt. Thanks in Advance, Poojak

  • Duplicate record found short dump, if routed through PSA

    Hi Experts, I am getting these errors extracting the master data for 0ACTIVITY 1 duplicate record found. 1991 recordings used in table /BI0/XACTIVITY 1 duplicate record found. 1991 recordings used in table /BI0/PACTIVITY 2 duplicate record found. 210