Separate vlan for Voice and Video

I'm implementing a Polycom HDX9002 video conf codec into my network (point to point). What is the prefered method, do I segregate the traffic with another VLAN or use the existing Voice VLAN at both sites.
Thanks
Paul

Voice vlan is fine. What really matters, is QoS in the WAN.

Similar Messages

Eight-Class Model QoS for voice and video

One of the QoS recomendation in the SRND "Enterprise QoS" is to create a Eight-Class QoS Model utilizing a seperate priority queue for voice and video.
It says that even though you have only one physical priority queue, that LLQ has an implicit policer that allows for time-division multiplexing of the single priority queue. This implicit policer abstract the fact that there is essentially a single LLQ within the algorithm and, thus, allows for the "provisioning" of multiple LLQs.
My question is if anyone has tried this and if there are any limitations on the platforms that can support this "dual-LLQ design."

Design guide which is basically the QoSDesign recommendation bible.
http://www.cisco.com/univercd/cc/td/doc/solution/esm/qossrnd.pdf
It has a large section for WAN recommendations...while you may not
need to follow one of these Based on my understanding what what you
have for a link (DS3) and what you are trying to accomplish, I
believe the following section would be a good place to start.
- WAN Aggregator QoS Design
- WAN Edge Classification and Provisioning Models
- High Link Speed QoS Class Model
- Eight-Class Model

Vlan for voice and vlan for data with diferent ISP best choice of config??

Hello everyone,
Im, Oscar
At our company we have a redundant ISP connection to two separate ISP's.
We are also using VoIP on the network.
Currently one ISP connection is used primarily and the second on is just used as a backup.
I was wondering if it is possible to use the first connection primarily for data traffic and the second connection for VoIP traffic?
We use different VLAN's for voice and data.
Any help would be appreciated.

Disclaimer
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
Liability Disclaimer
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Posting
Yes, for egress. Ingress is "it depends".
You could also consider using both links for both kinds of traffic.

Port with multi-vlan for voice and data??

Hi guys,
I've a situation where my VOIP and DATA on a different segments. Voice is 10.x.x.x riding on VLAN 701. And my data is 192.x.x.x riding on VLAN 100.
The problem occur when our receptionist PC have a software installed for call forwarding for our general line. This software need to be on the same vlan with the IP Phone vlan which is 701. If I put her PC on those vlan, she can't access
to our LAN which is vlan 100. So she can't check her email etc.
Can I know what is the options I have? Can I configured multi-vlan for her PC on the switch? We are using Cisco PoE 3560 switch. Thanks.

Hi,
on the L3 switch, you should have an IP address for both VLAN 701 and 100. So, the L3 switch is doing inter-VLAN routing.
This means, unless you have ACL blocking traffic, any device will be able to reach any other device, even on a different VLAN.
And, no matter where you put voice and applications, everything will work anyway.

Separate vlan for wireless voice

Hi all, I'm about to embark on reconfiguring my home lab, at present I have just 2 vlans which are for VoIP and data, I'm going to split my network so I have the following:
Data VLAN for our home PC's
Voice VLAN for phones
1 wireless VLAN for home laptops
1 wireless VLAN for games consoles
1 wireless guest access so I don't have to give out my own ssid credentials
1 Management VLAN
My question is do I have a separate VLAN for wireless VOIP or do I just use the same Voice VLAN?
Regards
Martyn
Sent from Cisco Technical Support iPad App

Martyn:
Both solutions are valid. You can use the current voice VLAN or create a new VLAN.
If you create a new VLAN you need to apply needed QoS to wired side as well.
If your current Voice VLAN is already configured for QoS then using it for wirelss voice is easier.
So the preffered option is to use your current voice VLAN for wireless voice as well.
HTH
Amjad

Trouble installing plugin for Google Voice and Video

Just upgraded to Yosemite. After doing so, my Google Voice and Video stopped working. I have re-installed the plugin multiple times with each attempt reaching the "Install Successful" message. I've restarted Safari and my computer, but the Google Voice and Video for Hangouts is still not working. Any suggestions??? Thanks.

Hello again,
Seems to be fixed in the Firefox new version (4.0.1).
Best Regards.

Welcome to the Voice and Video over WLAN Discussion

Welcome to the Cisco Networking Professionals Connection Wireless Forum. This conversation will provide you the opportunity to discuss issues surrounding Voice and Video over WLAN. We encourage everyone to share their knowledge and start conversations on issues such as bandwidth intensive wireless applications, and any other topic concerning Voice and Video over WLAN.
Remember, just like in the workplace, be courteous to your fellow forum participants. Please refrain from using disparaging or obscene language or posting advertisements.
We encourage you to tell your fellow networking professionals about the site!
If you would like us to send them a personal invitation simply send their names and e-mail addresses along with your name to us at [email protected]

This is easily done with dial peer statements . The dial peer in your originating router must route the calls to the terminating router first. That would look like :
dial-peer voice xxxxx voip ( the xxxxx is just a tag)
destination-pattern 45... (that would route any 5-digit calls beginning with 45)
session-target ipv4:xxx.xxx.xxx.xxx (ip address of the terminating router)
If digitones are to be dialed after the connection is established, use the statement:
dtmf-relay-h.245-alphanumeric
You could also use a statement to specify the codec to be used:
codec g711ulaw
You would need multiple voip dial peers if the calls were going to different routers based on the dialed digits. If all calls are sent to the same terminating router, use all wild cards in the dest-pattern statement.
At the terminating router configure pots dial peers:
dial-peer voice xxxxx pots
dest-pattern 45...
port x/x (whichever port the call is to be terminated on)
prefix 45 (this re-inserts matched digits which are stripped off by the pots dp)
Repeat for other ports which will receive calls.
Paul

How to set up VLAN for DATA and VOIP on SRW248G4P switch?

Hi guys,
I am totally new and was given this task to complete. I really really need help.
We are using one network 192.168.1.0
Shared with data and voip.
CISCO C870, 5 switches LINKSYS SRW248G4P .
The email wrote:-
On the Linksys switch;
- create two different VLANs one for voice and one for data.
- put a firewall between the two VLANs (between voice and data) and only enable certain ports to flow to voice network (inbound tcp 8443 and ssh )
What should i do guys? I really need a dumb guide now.
I know its simple for you guys but i am not a smart IT fella. Whats the step by step?

If the switch is new or you have support on this, then you might try calling the support center. Here is a link:
https://www.myciscocommunity.com/community/smallbizsupport
On the right hand side you can find links to the support center.
Here is a link to the guide:
http://www.cisco.com/en/US/products/ps9967/prod_maintenance_guides_list.html
@ the bottom of this link you can find your switch model, you want the larger of the two. In this guide it shows you how to create a second vlan.
Will your router be the firewall between the two?
Kindest regards,
Andrew Lissitz

Has anyone tried installing the Google Voice and Video plugin?

Hi,
I wanted to check out the Hangouts feature at Google+, but I need the Google Voice and Video plugin for that. I tried unpacking the deb package supplied by Google and installing it manually, but the plugin does not work and Firefox just keeps crashing. Could anyone actually get it to work with Arch yet?

Sorry for not using the search, I see it's available in AUR... http://aur.archlinux.org/packages.php?ID=36308
Now trying to install from there!

ISight conflict when installing Google Voice and Video driver

After installing Google Voice and Video driver, the iSight stops working on Flash based applications or websites.
Two camera drivers are installed: Google camera 0 and Google camera 1.
Even if I go to Settings and choose the correct driver (iSight Integrated), it does't works.
The only way I found to solve this issue is removing those Google's drivers (Library/Application Support/Google/GoogleVoiceAndVideoUnistaller).
However, this is not a solution since I can't use GTalk anymore.
Does Flash Player 10.2 fixes this conflict?
Regards,
Flávio Mikami

Sorry for not using the search, I see it's available in AUR... http://aur.archlinux.org/packages.php?ID=36308
Now trying to install from there!

BBM Voice and Video calls not working

Hi!
I'm using BB Z3 OS: 10.3.1 and my friend using BB Z3 OS: 10.2.1, we both are using BBM over wifi and our BBM is upto-date but when i'm dailing call, "Connecting to BBM video service, please wait and try again" error apears, why we unable to make voice or video calls? any one tell me?

The last I read, BBM voice and video is not available in Pakistan.
I believe it is in UAE.
1. If any post helps you please click the below the post(s) that helped you.
2. Please resolve your thread by marking the post "Solution?" which solved it for you!
3. Install free BlackBerry Protect today for backups of contacts and data.
4. Guide to Unlocking your BlackBerry & Unlock Codes
Join our BBM Channels (Beta)
BlackBerry Support Forums Channel
PIN: C0001B7B4 Display/Scan Bar Code
Knowledge Base Updates
PIN: C0005A9AA Display/Scan Bar Code

Problem with BBM voice and video on Z10

i have problem connecting on my Z10 with BBM voice and video. before it works fine but i think after an update of BBM is not working anymore. the chat sesion works fine.
i have a second Z10 but that one works fine.
any solution ?
THX
Bryan

On your BlackBerry10 device:
Reboot: On the side edge volume keys, press and hold down both of the Up and Down volume keys for about 20 seconds, ignoring the initial screenshot message... the screen will go black and reboot.
Now, try again.
Likewise, ask a BBM contact of yours to tell you if your BBM contact has the green icon for BBM voice/video.
1. If any post helps you please click the below the post(s) that helped you.
2. Please resolve your thread by marking the post "Solution?" which solved it for you!
3. Install free BlackBerry Protect today for backups of contacts and data.
4. Guide to Unlocking your BlackBerry & Unlock Codes
Join our BBM Channels (Beta)
BlackBerry Support Forums Channel
PIN: C0001B7B4 Display/Scan Bar Code
Knowledge Base Updates
PIN: C0005A9AA Display/Scan Bar Code

Software record voice and video

Dear All,
Do you know software record voice and video after record we can copy to Laptop...... Does everyone know this program??
Best Regards,
Rechard

griffin's italk records voice. and after you record, you can transfer it wirelessly to a computer on the same network. you need to download a small program from griffin tho. it works really well, i'm very pleased with it. and best of all, its free. look for it in the app store.

Can I use two Time Capsules? one as an extension of my laptop (for music and video storage) and the other one to back up everything from the laptop and Time Capsule (for music and videos)

Can I use two Time Capsules? one as an extension of my laptop (for music and video storage) and the other one to back up everything from the laptop and Time Capsule (for music and videos)

Not via Time Machine. It cannot back up from a network location.
The 3rd-party apps CarbonCopyCloner and ChronoSync may be workable alternatives.
EDIT: And, if you're going to do that, you could back up from the Time Capsule to a USB drive connected to the TC's USB port. Second TC not required.
Message was edited by: Pondini

I have Adobe Photoshop Elements 10 and Adobe Premier 10 loaded on a Dell PC. Do I need to uninstall from the Dell before I install on a recently purchased Apple Mac Pro? There are separate disks for Mac and PC in the package.

I have Adobe Photoshop Elements 10 and Adobe Premier 10 loaded on a Dell PC. Do I need to uninstall from the Dell before I install on a recently purchased Apple Mac Pro? There are separate disks for Mac and PC in the package.

Generally, it's ok to install on two machines as long as they are both yours and you only use one version at a time.
BTW, this is the forum for Adobe Contribute.

Separate vlan for Voice and Video

Similar Messages

Maybe you are looking for