SF300 LAG port doesn't work, LACP will not enable.

Question

I'm trying to configure something that seems pretty trivial.
I need 2-3 ports to participate in a LAG port.  First off, I  get the "Port X belongs to a vlan" if the participating port is  something other than access vlan 1.  This is totally useless.  I need these ports to be dot1Q tunnels.  This happens even If i set the default vlan to 300, (300 is my native or PVID).  Another piece that doesn't seem to work is that LACP will not enable, even if I throw in the towel and make my ports access vlan 1.  What gives?  I've tried this on the only firmware available which has no patches avail yet.  I've tried this on 2x 24ports, and on 2x 48 ports..  all the same issue.

Answer 1

Hi I just gave it a try  you can see my screen captures below.
If you are having trouble, have a word to the good folk at the SBSC if the switch is still under phone support coverage.
http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html
Maybe play it safe and delete your settings and start again... Here are some screen shots from my attempt.
I have to admit I enabled LAG and LACP before I created vlan 100.
you can see i have the same software as you.
add the ports and enable LACP at the same time.
ports 47 and 48 are still excluded from my Tagged Vlan
Now I selected port drop down for VLAN100 and selected LAG.
I then  received and then modified the following screen capture.
Note I manually added LAG interface 1 as a tagged member of VLAN 100.
Why Lag interface 1, because I created LAG 1 previously, as seen in a previous screen shot above.
regards Dave