Sim geblokkeerd na update 6.01 iPhone 4
Hallo,
Nadat ik mijn iphone 4 van een update had voorzien (IOS6 naar IOS 6.01) werd na enige uren perfect werken mijn SIM geblokkeerd. Ik probeerd een herstel waarna mijn volledige telefoon blokkeerde. Kan er mij iemand verder helpen om mijn telefoon aan de praat te krijgen. Of kan het ook aan mijn SIM kaart liggen?
Alvast dank ...
You may have to do this a few times http://support.apple.com/kb/HT1808
Similar Messages
-
after updating to iOS 6.0.1 my iphone 3s won't recognize my SIM card. i updated my phone through iTunes, what happened to my phone?
If it now says "invalid" or "unsupported" SIM, your iPhone was almost certainly hacked to unlock it from the original cell carrier and updating has now removed that hack and the iPhone has relocked back to that original carrier. You will have to contact that carrier and ask if it would be possible to get your iPhone officially unlocked.
Regards. -
Hello everyone,
I just updated my 3GS from iOS 5.0.0 to 5.0.1
Since the update, Itunes says that no SIM card is detected, and the iPhone says that it cannot be activated. It also obviously does not detect any network.
I tried restarting the phone several times, removing the SIM card several times, but it did not change anything, the SIM is still not detected.You do not need to keep posting the same thing over and over again.
Look to the right side of this page at "more Like this" or do a forum search. -
I updated my iPhone 3G today and after the update it said on iTunes that my sim was not compatible and my iPhone screen went on to slide for emergency/connect to itunes. Ive tried restoring it but it hasnt worked. Please help!
Unless the iPhone was purchased as unlocked very recently directly from an Apple Store (the only place in the US where unlocked iPhones are sold, and then only since June), which from the symptoms I doubt is the case, then it was locked to AT&T and jailbroken to make it work with an Irish cell carrier. Updating the operating system has now relocked the iPhone back to AT&T.
Only the cell carrier can institute an official unlock, one which will hold across updates of the operating system, and AT&T will not do so for any reason. All we can advise here is that you return the iPhone to your uncle and purchase an iPhone there in Ireland.
Regards. -
before i do updates for my iphone (to 5.0.1) i close my SIM card, i can not complete the update proccess becouse SIM is closed also i can not activate iPhone becouse the SIM must be opened. when i try to open it , the networks does not appear (no service).
Its a serious problem and many people are facing the same issue on both locked and factory unlocked phones.
I wonder when Apple will address to this issue. After all it is losing all its reputation!
See this thread, many users are encountering the same issue:
https://discussions.apple.com/thread/3425746?start=75&tstart=0
I believe its a software issue and could be solved asap Apple fixes it! -
HT4972 Why won't my iPhone 4 recognize my sim card after update?
Why won't my iPhone 4 recognize my sim card after update?
I updated my iPhone 4 over wifi and it went through the process fine, until it switched back on and now refusese to recognize my sim card!
Any ideas?Usually this means the phone was previously jailbroken or hacked to unlock it from the carrier it was locked to, and the update re-locked it to that carrier.
-
my iphone wont accept my sim after the update , and so it don,t complet turning on .
It hasnt been jailbroken has it?
-
I recently updated a friends iPhone 3 to I cloud , however some contacts have disappeared. These seem to be the ones that were added onto her phone and not her sim. As I have done a sim import. This is the first time she has ever done a back up and sync.
This information will explain it:
http://support.apple.com/kb/HT1495
Hope this helps -
TS4148 what do you do if you have no sim and you updated your iphone 4
what do you do if you have no sim and you update your iphone 4
Why do you need to do anything?
Are you having a problem of some sort?
What is that problem?
Do you not own a SIM card?
Not sure I understand your question. You can use the iphone without a SIM -
I updated my ipad2 to ios7 after that , iam facing problems with my sim, it showing no sim card after inserting sim. there is no prbolem with my sim.
arun kumar chenna123 wrote:
i have updated my iphone to ios4.1. after installation, it is showing as"The SIM card inserted in this iPhone does not appear to be supported. only compatible sim cards from a supported carrier may be used to activate iphone. Please insert the sim card that came with your iphone...."
how to solve this problem. I don't have any sim cards that came with iphone.
Please help out to solve this problem.
It sounds like the phone was hacked or jailbroken, and updating it locked it to the original carrier. As it is not possible to update to any version other than the current one (5.1) the fact that you updated to 4.1 pretty much confirms the phone was hacked. There is no solution that you can get in an Apple forum. -
The SIM card inserted in this iPhone does
not appear to be supported.
Only compatible SIM cards from a supported Carrier may be used
to activate iPhone. Please insert the SIM card that came with your
iPhone or visit a supported Carrier's store to receive a
replacement SIM card.It appears that you have an iPhone that is locked to a carrier other than the one you were using. Now that you have tried to update the iOS, it has relocked. That is what happens if you are using a phone that has been hacked to unlock. You have also forfeited support from Apple and from this forum.
-
2.1 Update Killed my iPhone
Installed iTunes 8.0 first. Plugged the iPhone in and selected the option to download and install the 2.1 update.
Now the phone is bricked. Get this message in iTunes:
"The iPhone ... cannot be used with itunes because the information required for activation could not be obtained from the iphone. Check that the SIM card is inserted in your iPhone and that it is not PIN-locked."
Please help. Any suggestions appreciated.
ThanksClever solution! I didn't know how to solve this upgrade problem and I was about to take my phone to the O2 shop. I bet they would have said they need to send it away to be repaired for 2 weeks. Saved me lots of trouble!
Thanks -
After the last update of the iPhone 5.1 sound became low tones specifically entered into the settings and made the maximum sound d, but to no avail there is no update for this problem Haddl Is it possible to delete the Japanese language and take advantage of memory storage space
Osmhto tried to solve the problem of low sound we have become we do not hear a tone sounds clearly like the first phonehello...
I am having the same issue here... just upgraded my 5s to 7.1.1 (never jailbroken - factory unlocked) and then boom... NO Service!!! Searching ... that's it. currently using Smart Telecom Sim... at first it was working for me... after 6-7 hours, it started the No Service issue. I cannot send a text or make a call...
I did the steps you have taken but it is still not working... any updates on your end? -
Please somebody help me !!!! I just got back from Paris and Israel and this update got my iphone 5 in recovery mode. I can't loose all my pics and videos from my vacations ??????????????????????????????????
NOO it's not broken it is a software error. What you need to do is put your phone into what is called DFU mode or Device Firmware Upgrade Mode. What you have to do is connect your phone to itunes but do not start the sync process. Ignore any popups from itunes initially. When you are connected to itunes take your phone and hold down the home button and power button at the same time. Hold them down for about 30 seconds or so and you should see your device screen rollover to the black screen and disconnect from itunes once this happens it will reboot and automatically connect to iTunes, after this happens start the restore process through itunes and it should continue past the error message.
* Also before you do this try ejecting your sim card if you have the at&t model if you are on Verizon ignore this. There is a small oval port on the right side of the phone with a small pinhole. Use a paperclip and insert it into the hole, the door will pop open. Take the door out, remove the sim card and wait 5 minutes then return the sim card back into the phone and begin the above process.
If none of this works you may just want to bring it the genius bar and have them look at it. Good Luck and I hope this helps! -
I updated my 3GS iphone to 5.0.1 cannot receive calls or messages.
I updated my 3GS iphone to 5.0.1 yesterday. I can make calls and send messages, but cannot recieve calls or messages. I called telstra as I instantly thought network problems. My friends and family who are also on telstra have not had network issues. I thought it was strange that this has only occurred after updating my software?? I have restored my phone, reset network settings and still nothing!! Is anyone else experiencing anything similar?
Thanks,i have since inserted my sim card into an old phone and then put it back in my 3gs and just received 40+ messages.. not sure why its working now, but it is so I'm happy
Maybe you are looking for
-
Hi i take cold backup of my 9i database .... in case my database is up ..... how will i recover my database if i lose a single database file and i want to recover it from cold backup...... Thanks in advance Gagan
-
Lion OS Folder Icons and Settings Change
My new 8 core Mac Pro with Lion arrived August 29 to replace an older Mac Pro with Snow Leopard. FYI - Just before the new Mac Pro arrived, I checked and repaired any permissions issues via the Disk Utility. Once the new Mac arrived, it took four day
-
How can we handle multiple applications in session method
how can we handle multiple applications in .. session method. can any body reply me. thanks
-
Spry Accordion Panel Default State All Closed?
Is it possible to set a group of Spry accordion panels so that all are closed by default?
-
Dispatcher Running Server Not started
Hi, I have installed abap+java stack ECC 6.0 I have problem with J2ee engine not started . the trace file error log is: #1.5#001B789F31FE00240000000B00001F340004467CFFEBCD37#1203402590380#/System/Server##com.sap.engine.core.service630.container.Servi