Siri dosen't work !!

'I'm really sorry about that but i can't take any requests right now' .. it is always siri answer for any question !!!
I haven't use Siri ever form that I have had buy my new IPhone, it's really annoying and I want an advise or help please :(

That is sometimes Siri's response to questions. Are you sure it has always been that way? Wait a while and try again. Usually it snaps out of it. I have noticed that message comes up sometimes when there is spotty cell reception and Siri gets cut off from contacting the Internet due to poor signal.

Similar Messages

Siri dosen't work correctly

I was talking with siri a couple of days ago and after a short conversation suddenly there were a black page, but luckly it wasn't endless and there wasn't an apple on the middle of page, here are some examples what happened:
I hope you help me

That is sometimes Siri's response to questions. Are you sure it has always been that way? Wait a while and try again. Usually it snaps out of it. I have noticed that message comes up sometimes when there is spotty cell reception and Siri gets cut off from contacting the Internet due to poor signal.

My Straight Talk Official Iphone's data dosen't work, how do you fix?

My Straight Talk Official Iphone's data dosen't work, how do you fix?

This is my exact issue too,
I can temporarily restore this function by going to
Settings
General
Siri, and turning Siri off then on again.
But after some hours, or by the next day it happens again. Hope this helps.

Gif imagen dosen't work at o.s 6.0

The gif imagen in profile bbmsn contactas dosen't work in my torch 9800 os 6.0 all my friends that have got the os 6.0 have goy the same proble, i wanna know if there are or when is coming a update to solution this problem

Hi,
the problem whit NI 9223 module and the example that you talk about is know. Indeed, there is a CAR - Corrective Action Request - #30724 that deals with the erroneous implementation of the example.
To improve the code, the owner of CAR, suggest:
Added pipelining loops and removed from FPGA VI to Increase maximum acquisition rate and modified host VI to implement proper DMA FIFO programming practices.
I try to implement and improve the code. Bye
Mario

Siri is not working in iPhone 5 even if i say properly

Siri is not working in iPhone 5 even if i say properly

Hi Mitkml!
Here is an article for you that will help you troubleshoot this issue:
iOS: Troubleshooting Siri
http://support.apple.com/kb/ts4079
Take care, and thanks for visiting the Apple Support Communities.
-Braden

My 4s has a blank homescreen, that is, no icons, and Siri won't work. How can I fix it?

I have a 4s and recently updated to the newest ios. Also, today I changed my homescreen photo and lock photo, and gave a game access to my photos. Tongith when I was playing a game, my phone became very sluggish and knocked me out of the game. It wouldn't let me back in, so I powered off the phone. When I turned it back on, the homescreen had no icons. It only showed my background photo, AT&T signal, Wifi signal, time and battery power. It lets me pull up the notification list and control center, but that is all. Siri doesn't work, either. I can answer calls but when I hang up, it doesn't dim the end button or go back to the homescreen, it just gets stuck with the caller's identity and the end button. I have turned it off and on several times, plugged it in even though it has over 50% of battery remaining, I have reset it by tapping the power button 5 times, and I have reset it by holding the power button with the home button. It hasn't fixed the problem. What else can I do? And, what could have caused this? I was just playing a game.

This is my exact issue too,
I can temporarily restore this function by going to
Settings
General
Siri, and turning Siri off then on again.
But after some hours, or by the next day it happens again. Hope this helps.

Siri is not working like it should i ask it to play songs and it just says sorry i cant do that any ideas y

siri is not working like it should i asked it to play songs and it just says sorry i cant do it any ideas y

Debbie:
deborahfromwindsor wrote:
he advises restarting by inserting the OSX disc and pressing down the C button to reboot from there then selecting disk utility, hard disk and repair.... Does he mean me to hold down the C key on the alpha keyboard or the ctrl key?
Should I just ask for my money back??? If it is a simple repair do I just literally push the disc in, push the power button and hold down the C button?
That's where I would begin, too, with
Repair Disk
Insert Installer disk and Restart, holding down the "C" key until grey Apple appears.
Go to Installer menu (Panther and earlier) or Utilities menu (Tiger) and launch Disk Utility.
Select your HDD (manufacturer ID) in the left panel.
Select First Aid in the Main panel.
(Check S.M.A.R.TStatus of HDD at the bottom of right panel, and report if it saysanything but Verified)
Click Repair Disk on the bottom right.
If DU reports disk does not need repairs quit DU and restart.
If DU reports errors Repair again and again until DU reports disk is repaired.
If DU reports errors it cannot repair you will need touse autility like TechTool Pro,Drive Geniusor DiskWarrior
First we need to determine if the issue you are experiencing with the computer is software or hardware based. Once we have gotten things sorted out there should be time enough to make you decision about keeping or returning it.
cornelius

Siri no longer works, since I lost my sound IPAD

Siri no longer works on my iPad. I don't use it often, so I am not worried, but I lost it when I reset my iPad after reading in these forums how to get the sound back. The sound worked just fine, then it didn't. I have tried all the usual fixes,Anne I guess I will have to take into a apple store just thought I'd try one last time in case someone has foundation new solution.
HELP ME PLEASE

Did you make sure it is still turned on? Settings>General>Siri>On>Voice Feedback>Always. Do you still have sounds in apps and notifications? In the Music app?

Siri is not working on my new iPad Air

Siri isn't working on my week old iPad Air. I've turned it off and on and sync'd it several times but no joy. Any help will be appreciated.

In SE OK and connected to wi-fi. Siri working on my iphone and old iPad so it has to b the new Air. It says it can't answer questions "at this time" and does not do dictation in messages. I've turned Siri off n on and rebooted the iPad as well as using sinc. Seems I read something about this issue when the Air first came out but I can't remember if there was a fix or not.

Siri is not working properly

I have just updated my new ipad to ios6 yesterday, siri is not working properly how can i fix this problem?

Irishkatrina_09 wrote:
... siri is not working properly...
This is very vague...
Try this...
Close All Open Apps... Perform a Reset... Try again...
Reset ( No Data will be Lost )
Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
http://support.apple.com/kb/ht1430
There is also this...Troubleshooting Siri
http://support.apple.com/kb/TS4079

UBLR dosen´t work in an interfaces trunk?

I´m configuring Aggregate policer in a Sup720-3B, I need to configure Aggregate Policer in a Trunk interfaces, It´s required to limit the bandwidth for vlan to L2 through an interface trunk, between two catalyst. But it´s dosen´t work. The configuration that I am using is:
S6509#run int giga 3/2
Building configuration...
Current configuration : 167 bytes
interface GigabitEthernet3/2
switchport
switchport trunk encapsulation dot1q
switchport mode trunk
no ip address
service-policy input LIMIT
end
S6509#
S6509#show ip access-lists TRAFFIC
Extended IP access list TRAFFIC
10 permit ip any any
S6509#
S6509#show class-map Daniel
Class Map match-all Daniel (id 1)
Match access-group name TRAFFIC
S6509#
S6509#
S6509#show policy
S6509#show policy-map
Policy Map LIMIT
Class Daniel
police flow mask src-only 2000000 200000 conform-action transmit exceed-action drop
S6509#
S6509#
hostname S6509
boot system flash disk1:s72033-advipservicesk9_wan-mz.122-18.SXF14.bin
logging buffered 32768 debugging
logging rate-limit all 1000
enable secret 5 $1$Oewp$4FbojEBx0Nn.sXO1ZzhIj/
class-map match-all Daniel
match access-group name TRAFFIC
policy-map LIMIT
class Daniel
police flow mask src-only 2000000 200000 conform-action transmit exceed-action drop
S6509#show mls qos
QoS is enabled globally
Policy marking depends on port_trust
QoS ip packet dscp rewrite enabled globally
Input mode for GRE Tunnel is Pipe mode
Input mode for MPLS is Pipe mode
QoS Trust state is DSCP on the following interface
Gi3/4
Vlan or Portchannel(Multi-Earl) policies supported: Yes
Egress policies supported: Yes
----- Module [5] -----
QoS global counters:
Total packets: 233
IP shortcut packets: 0
Packets dropped by policing: 0
IP packets with TOS changed by policing: 0
IP packets with COS changed by policing: 0
Non-IP packets with COS changed by policing: 0
MPLS packets with EXP changed by policing: 0
S6509#
S6509#
S6509#show policy-map interface gigabitEthernet 3/2
GigabitEthernet3/2
Service-policy input: LIMIT
Class-map: Daniel (match-all)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: access-group name TRAFFIC
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
S6509#

Contact the wireless carrier to which the iPhone is locked and
ask that carrier if they provide unlocking and if you qualify.
What is the exact wording of any error message you receive?

LoadingSecondFile - Dosen't work

loadMovie() loads SWFs into _root.mc1.mc2, and I use the below method to be able to identify the selected movieclip. It works when I load the first SWF but when the second SWF is been loaded it dosen't work. What may be the cause for this.
I tried unloadMovie() and removeMovieClip() to clear the movieclip before loading the new file, but no success.
function traceName():Void {
     trace(this._name);
for (i=0; i<5; i++) {
    _root.mc1.mc2["color"+i].onRelease = traceName;

Thanks Ned. But I've got an array named mc
var mc:Array = [mc1, mc2, mc3];
I'm loading the below code as an external swf as well. Could that be causing this issue?
function traceName():Void {
     trace(this._name);
for (i=0; i<5; i++) {
    _root.mc1.mc2["color"+i].onRelease = traceName;

In I tunes I cant down load a CD. I get the message "The file couldn't be convereted. You don't have write access for you ITunes media folder or a folder with in it. To change permissions, ... When I do this it still dosen't work

In I tunes I can't down load a CD. I get the message "The file couldn't be convereted. You don't have write access for you ITunes media folder or a folder with in it. To change permissions, ... When I do this it still dosen't work.

Thanks C F McBlob but I recursively changed the permissions of my Music directory meaning every file and directory beneath it, as well as the directory itself, had the write permissions added.
I used "chmod -R u+w ./Music" and chmod -R g+w ./Music" to do it.
Alas, no cigar. :-(

Siri does not work after ios6 upgrade

I upgraded my iPhone 4S to IOS6 and ever since Siri almost never works. No matter what I ask I either get something to the effect that she cannot handle my request or she wants to do a web search. She has become all but useless. Too bad I cannot revert back to IOS5.

Same issue on my iphone s4....I tried everything except a factory reset...

When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.

When try to connect my iPod touch 4th gen to my house Wifi it won't connect, it used to work fine but now it dosen't work, but it does say that the internet is available, but when I tap on it it just loads. all other devices work fine.

Does the iOS device connect to other networks? If yes that tend to indicate a problem with your network.
Does the iOS device see the network?
Any error messages?
Do other devices now connect?
Did the iOS device connect before?
Try the following to rule out a software problem:
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Power off and then back on your router
.- Reset network settings: Settings>General>Reset>Reset Network Settings
- iOS: Troubleshooting Wi-Fi networks and connections
- Wi-Fi: Unable to connect to an 802.11n Wi-Fi network
- iOS: Recommended settings for Wi-Fi routers and access points
- Restore from backup. See:
iOS: How to back up
- Restore to factory settings/new iOS device.
If still problem and it does not connect to any networks make an appointment at the Genius Bar of an Apple store since it appears you have a hardware problem.
Apple Retail Store - Genius Bar

Siri dosen't work !!

Similar Messages

Maybe you are looking for