Skype 7.9 shuts down after choosing the person to talk

Hello everybody! Few days ago I got a problem. Skype on my macbook suddenly started to shut down after I choose a person from the contact list. Even if I turn it on, someone calls me, I pick the call up and the program shuts down. When choosing a person from the list of contacts - it shows a dialog window without any dialog history and also shuts down. After it I get the alarm messege from the system that skype suddenly stopped working and so on and so on... Can anyone help me to fix it?   Thank you!

In the middle of the fault descrition I've found this: Logical CPU: 0
Error Code: 0x02000148
Trap Number: 133 Maybe it will help!

Similar Messages

  • Computer shuts down after unplugging the power cord

    My computer is showing a Plugged in, not charging message, but it is at 88%.  When I unplug the charger from the computer to work somewhere else, the computer totally shuts down and will not power up unless the power charger is plugged in.  I tried taking the battery out and leaving the cord connected and the computer started fine.  How do I get the computer to stop shutting down after unplugging?  Any help is greatly appreciated.

    Sounds like battery #2 has a short. When the system detects a critically low battery, it is likely to devote all power to battery charge until the batery reaches 5% or so. Try each battery seperately. If no power at any time, remove the battery, disconnect the AC adapter. Press the power switch for about ten seconds. Then connect the AC adapter, let it boot, then install the battery and check the charging status. This resets the power manager. I think one battery id bad, but you will need to test them one at a time. Good luck.

  • C7 breaks down after choosing the resolution for a new project

    Hello Community,
    finally I succeeded in installing C7 on my MacBook Pro with Mavericks 10.9. But it breaks down every time after I choose the resolution for my project. The beachball appears for one second and then C7 breaks down.
    On the same MacBook I can open C7 on another account. But I want to use C7 on my account.
    Has anybody expereienced the same problems?
    Has anybody a solution for my problem?
    Cheers,
    Tom

    Hi there,
    can you please try deleting preferences by using the "CleanPreferencesMac" present in the Captivate installation location/Ultils folder, relaunch Captivate and see it resolves the issue or not.
    Thanks,
    Nimmy Sukumaran.

  • I recieved a new 4s today in replacement for my other one shutting down after installing the new update. Made a phone call, person on the other end cant hear me though i can hear them! im about to loose my block...what is going on? Help PLEASE :-(

    So, i recieve a new TODAY due to my other ones software stuffing up due to a stuff up in the new software update. Alls well and good, i leave the store drive home which is a hours drive mind you, make a phone call we talk for a while, it cuts out. I didnt think anything of it. Next phone call the person im speaking with cant hear me, 5 phone calls later i turn on speaker phone horray they can hear me. WHAT IS GOING ON??? I have had that many problems with my iphones but this is behond a joke...brand new phone thats already not working!!!!! I've tried to restore it and do everything i can but its not fixing anything. Im hoping someone out there can help because im done with Apple after this because this ludacris. Thanks in advanced :-)

    If you've had it for less than a year, then it's still under warranty.  Take it to an Apple store or an authorized service facility.  See http://support.apple.com/kb/HT1434

  • Macbook keeps shutting down after replacing the screen!

    Hi,
    The screen of my four year old Macbook cracked the other day and, after being quoted around £500 from Apple to replace it, I decided it was pointless seeing as though the machine cost £700 nearly four years ago.
    A friend of mine ordered a screen and replaced it for me. I've just turned it on for the first time an hour ago and the screen and everything else works, but for whatever reason the machine just turns itself every now and then. Does anyone have any idea why?
    I assume it must have something to do with how much of the processor is being used because I have done a little testing and have found that, when the machine is hard at work, it switches off after about ten minutes, while after 45 minutes of being idle, the thing has stayed on when I haven't touched it (typing this from a different machine).
    So I'm just wondering if anyone can help me diagnose the problem, and better still, help me resolve the issue. I know taking the Mac to the Apple store would have been the safest solution but surely you can understand my unwillingness to do so considering the machine is worth less than the price to fix it.
    Many, many thanks in advance for any help.
    Additional info:
    The Apple logo at the back of the screen is very dim compared to normal.

    Have you tried a different charger?
    Hardware fault, very likely logic board. 
    Make a service call to Apple for diagnostic / repair at your local Apple store.

  • Hi my desktop starts and then shuts down after the apple logo and an oblong box appear.thanks

    hi my mac
    desktop starts then shuts down after displaying the apple logo and an oblong box.
    thanks

    Sounds like something is badly wrong with your system.  First step would be to start up from your Mac OS X install disk, by inserting the disk and holding down 'c' at startup.  Select your language, then choose Disk Utility from the Utilities menu.  In Disk Utility, choose your hard drive and click the Repair Disk button.
    If problems are repaired, try restarting and see if the problems are gone.
    If problems couldn't be repaired, you can try DiskWarrior, which can sometimes repair problems that Disk Utility cannot.  However, if nothing works, you probably are going to have to erase the hard drive and reinstall the system from scratch.  Hopefully you have backups!
    If there were no errors, or they were repaired successfully but that didn't fix the problem, then you should try booting into safe mode by holding down the shift key at startup.  If that works, you may have some bad third-party software.  What that might be is hard to say, though.
    If nothing works, try rebooting from the Mac OS X install disk again and install Snow Leopard right on top of your current system.  That shouldn't disturb your apps or data, but of course, if you don't have backups, you're in trouble if something goes wrong.

  • S10e shutting down when moving the unit

    It seems that the system is shutting down after moving the unit from its base. Crashes often.
    Power problem? Require a motherboard change?

    Hi jharinstein,
    The issue could be related to system board as you may get it check with the service center.
    Best Regards,
    Tanuj
    Did someone help you today? Press the star on the left to thank them with a Kudo!
    If you find a post helpful and it answers your question, please mark it as an "Accepted Solution".! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
    Follow @LenovoForums on Twitter!

  • My computer shuts down after being unplugged

    My powerbook G4 sometimes shuts down when I unplug it, even though the battery is fully charged. This seems to happen more often when I unplug it and then pick it up (or put it down). After I restart it, the clock and date have been reset to 1970.
    Any ideas of what may be wrong?

    Hi c,
    Welcome to Apple Discussions.
    How long does your PB run on the batt when it does not shut down after removing the power adapter? If a very short time, you may have a nearly dead batt, and the backup batt, even if it is still operational, only lasts a few minutes; once that is dead too, then date and time are reset.
    I should have said this first, but just noticed that you said movement seems to cause the issue. That strongly suggests a loose battery. The "fix" can be as simple as wedging a thin piece of rubbery material between the battery compartment and the battery itself, on the side opposite the contacts, to make the contacts remain in contact at all times (earlier models had this issue, but it was supposedly fixed on later models, yet we still hear about it periodically).

  • Mac shuts down after boot. Is it the logic board?

    mac shuts down after boot. Doesn't go beyond gray screen with apple.  Is it the logic board?
    I do not have the start up disks to safe boot or check the hardware.
    Any ideas what the problem is or is it junk?  It is 8 years old.

      Shutdown your machine.  Hold down the shift key.  Poweron.  Wait awhile Wait awhile while you harddrive
    is being checked.
        http://support.apple.com/kb/ht1455
    I'd let the machine sit for awhile in open firmware & see if it stays alive.  Do a few prints.
    Sometimes if volumes don't appear in Startup Manager (what you get when you hold down the Option key at startup), you need to reset the Mac's PRAM, NVRAM, and Open Firmware. Shut down the Mac, then power it up, and before the screen lights up, quickly hold down the Command, Option, P, and R keys, until the Mac has chimed twice more after the powerup chime. Then, before the screen lights up, hold down Command-Option-O-F until the Open Firmware screen appears. Then enter these lines, pressing Return after each one:
    reset-nvram
    set-defaults
    reset-all
    "The reset-all command should restart your Mac. If so, you have successfully reset the Open Firmware settings."
    http://support.apple.com/kb/TS1812?viewlocale=en_US
    How to eject a cd from the internal cd drive:
    eject cd
    List of devices:
    devalias
    Restore Tiger 10.4 & Leopard 10.5  DVDs are available from Apple by calling 800-767-2775 as of January 20, 2013.
    https://discussions.apple.com/thread/4720126?tstart=0

  • Is there a way to prevent ibooks author from shutting down after just one or two uses of the alpha tool?

    Is there a way to prevent ibooks author from shutting down after just one or two uses of the alpha tool?

    Hello One Job at a time,
    Deleting the application will not delete your projects.
    Normally I keep all my work files on a separate drive.
    If you command click on the title name of your project you will get a drop down path to show you the location of your book project.
    or you can click on the drop down triangle beside its name to duplicate.
    Just remember where you saved the file too.
    In your applications folder on your computer select the iBA icon and press delete and also erase / empty the trash can.
    You can then go back to the APP STORE and install iBA from new again.
    I hope this helps.
    Regards,
    Nigel

  • Pse trial v12 installed but when opening the editor it shuts down after 2 seconds, what can be the problem? I have windows 8.1 64 bit with the latest video drivers installed. Thanks

    PSE trial 12 installed just fine but when i start the editor it opens and shuts down after about 2 seconds without an error, the only thing that appears is a message with 'continue trial'.
    I have windows 8.1 64 bit and i already installed the latest video drivers, intel hd 4000 and nvidia geforce 710M.
    I also installed premiere elements version 12 with the same problem.
    What can be the problem here, please help?
    Thanks.
    Wim.

    Hi roberto-
    Yes, its a shame. I have also contacted lenovo support hoping that they can sort out this problem. However, first response from them was 'contact your internet service provider since internet connectivity goes down'! :-/ I am hoping I have been able to get through to them now at least about where the problem lies. I wonder if anyone has tried using the laptop with the same broadcom wireless adapter with some other version of OS (linux, windows 7 etc.) and whether they still face the same problem. I haven't tried that yet. If this is just an OS / driver issue I hope someone somewhere is working on a fix! If not, I guess the only other solution would be to get an external USB wifi adapter but that is not something one would want to do when you buy a brand new Lenovo laptop. This was a big let down for me.
    -sag

  • After having shut down after installing updates, when I restarted and tried to open a word file, it started opening ALL the word docs and the only way I could stop it was by"force quit"  arted  and tried to open

    After having shut down after installing updates, when I restarted and tried to open a word doc, it started opening ALL the word docs and the only way I could stop it was by"force quit"  . This is REALLY annoying!!

    May be it is the Resume feature.
    System Preference > General > Number of recent items
    Uncheck the box next to      "Restore windows when quitting and re-opening apps".
    Best.

  • Bridge: when I want to export from .psd to .jpeg the export window opens but the target (Ziel) window is empty, thus no target can be selected. This happens since a brigde shut down after "out of memory"

    Bridge: when I want to export from .psd to .jpeg the export window opens but the target (Ziel) window is empty, thus no target can be selected. This happens since a brigde shut down after "out of memory"
    Felix

    Not quite following your terminology.
    Möchten Sie es vielleicht mal auf Deutsch versuchen?

  • HT1338 Mac mini display connection will not come back after sleep, I have to shut down and restart the monitor.

    Mac mini display connection will not come back after sleep, I have to shut down and restart the monitor.

    Finder icon on dock, macintosh hd, library, launch agent - delete all files & restart sleep to test
    also
    Finder icon on dock, macintosh hd,
    Library/Preferences/SystemConfiguration/com.apple.PowerManagement.plist
    delete file & restart sleep to test.

  • TS2972 WHY IS MY HOME SHARING SHUT DOWN AFTER 5 MIN WHEN WATCHING A MOVIE. I DOWNLOADED LATEST VERSION FROM THE APPLE SITE. STILL DOES NOT WORK.

    home sharing shuts down after 5 min when watching a movie. any solutions. already downloaded itunes from apple. did not work.

    Make sure your computer is not set to fall asleep. Also check www.istumbler.net (netstumbler for windows) for interference on the network

Maybe you are looking for