Solid black line on HP tablet screen

I just got this HP stream 7 5709. So far so good except there is a horizontal black line just across the screen. I first thought it is the screen protector, but now I begin to think it is in the display itself. Is this known?Attached the image here. Thanks
This question was solved.
View Solution.

invalid image link.
any kind of lines on the screen that persist all the time are defective LCDs and will need a replacement. 

Similar Messages

  • 5800 express solid black line across bottom of dis...

    hi everyone
    please can someone help me
    i have a nokia 5800 which up until now has been great.
    however i noticed recently that at the bottom of my screen there is a thin solid black line which goes from end to end
    so much so it even crosses out the word 'options' and 'exit' - since its solid and black
    i dont know why its doing this as it has never happened before
    i am using the latest firmware V20.0.012
    why is this black line there? why wont it go away?
    i have tried everything from removing the battery to resetting to settings to default to changing my themes and wallpapers
    nothing seems to remove it
    its always there
    even on the nokia shut down and start up screens it is clearly visible
    please help. any suggestions would be most appreciated
    Message Edited by coolj0800 on 22-Jun-2009 01:58 PM

    guys
    would you believe that when i remove my memory card the solid line dissapears and the display is perfect!
    but now when i put the memory card back in and switch on the phone, there is no boot up ie i have my white screen with NOKIA and then it just switches off- no matter how many times i try the same thing happens
    but when i take the memory card outand switch the phone on again, the phone boots up perfectly
    what is going on? is the memory card corrupt? i have only used 500mb out of 8 gigs and the phone is only a few months old. what must i do? should i try formatting the card? or put in a warranty claim for a new memory card as this BS?
    thanks again for your advice
    regards
    coolj

  • Officejet 6310 prints solid black line instead of text.

    Good day. My officejet 6310 has started printing a 3/8" solid black line instead of text. I've replaced both color and black cartridges. I've also run align and clean cartridges. Does anyone have helpful suggestions?

    This type of result is often due to errors in the HP printer drivers. Several things can be tried. Sometimes, using a tested driver for an older, but compatible printer will do the job. A lot of folks used the use the HPLJ2 driver even with HPLJ3 and 4 systems. Another option is to try to print as a graphic. At this point, I can only suggest playing around with things. A lot of folks like the graphic driver aspect instead.
    You might also consider printing to the printer in a PS mode rather than PCL if that option is available.
    I am only suggesting things I have seen tried by various folks. I don't have a good explanation.

  • Solid Black Lines/Blocks Over Personal Data

    Some printouts have solid black lines and/or solid black boxes in sections of the printed page.  They generally appear over areas containing personal data (name, address, account #, etc.).  Typically happens when printing statements from third-party websites.  Occurs when printing black and white only and when printing color.  Printer is calibrated and not experiencing other issues. Any thoughts oh what is causing this and how to correct?  Thank you.

    Welcome to the HP Forums , I saw your post about some of your printouts having the personal data blacked out when they print out. I have personally heard of some third party websites printing forms like this for security reasons. However, you can try printing them from another web browser, which has worked for some. If you are using Internet Explorer, try Google Chrome, or Firefox. Free Download - FirefoxFree Download - Google Chrome  Let me know what happens!If you wish to thank me for my response lending a helping hand, click the  below!

  • HT1725 I purchased several books from itunes and on my iphone it shows the book cover, but I cannot open them.  There is a solid black line on each cover.  Any suggestions?

    I purchased several books but on itunes but cannot open them on my iphone 4S.  I purchased one without problem.  However, the next several appear in my library but have a solid black line on the cover as though they haven't downloaded.  When I check my itunes account for possible downloads, it shows everything has been done.  Any suggestions?

    Could you take a screenshot of this line?
    Press home and sleep button at the same time I believe.

  • Vertical black line running down imac screen

    This morning i noticed for the first time (wasn't there yesterday) a thin black vertical line running down my 21' imac screen.
    Any suggestions?

    Take a screen shot & view that in Preview, move the Preview window around, if you see 2 black lines it a Video card/VRAM problem, if the line does not move moving the pic around then it's the LCD or cable.

  • Thin black line running down the screen

    Just did latest update and noticed on the reboot a thin black line running down the left hand side of the screen 8cm in apex.
    Any one else got an issue or fixed the issue?

    Sounds like a problem with the display. Contact your local Apple Store or AASP and make an appointment to have the display looked at. > Apple - Support - iMac - Service FAQ

  • Black line Down Center of Screen

    Alright guys see if you can figure this one out.
    I have a MBP I have a black line directly down the center the the screen just under a quarter inch wide. It has been there for a while now but I was trying to fix it today. At times the line can get a bit smaller or larger and rarely it will go away...... I opened it up and unplugged the LVDS cable from the logic board and the entire lcd turned white but once i plugged it back in the lines retured. Not sure if this is an LCD problem or LVDS cable problem. I will add more detail if necessary but this is the start.

    Do you see the line while the startup of the computer? Do you see the line when starting from CD/DVD?

  • Hi, my Macbook Pro just shut down for no reason. Before, there were black lines all over the screen. Then it shut down and it started to make beeps (3). What can I do?!

    I was using my computer just as usual, I was on Microsoft Words and doing lectures on the Internet. Then, out of nowhere, the screen froze and black lines appeared all over the screen and the computer shut down. The screen was all black, but I think it was still open because my laptop was doing sounds, three beeps. When it beeps, the little light that shows you when your laptop is open is bright, so the beeps and the light are synchronized. AND I DON'T KNOW WHAT TO DO, help me!!!

    There is a hardware problem. Possibly bad RAM. Please make a Genius Appointment and take it in for service.

  • Solution for black line in Ipod classic screen?

    Hello
    Last week my ipod fell on the floor and since then I have a black line in the middle of the screen. The ipod is phisically intact, no scratch, not broken. Only when I turn it on, I have a big black line in the middle. At the beginning it was small dots and now it s a big line
    Is there any solution? Change the screen? Or do I have to live with it?
    Thanks a lot in advance
    Vivile

    When you drop it, the impact knock off some connection in the Display circuitry, those SMT balls, so the missing connection cause the unwanted  lines.
    However if you are lucky, just try
    this iPod Hard Reset ( it wont delete anything on your iPod)
    Toggle the Hold switch ( make sure you dont see the red mark)
    Press Menu and center buttons simultaneously for about 10 secs till the Apple Logo comes ON then release the buttons.
    Select you language preferrence.
    See this Apple support article on the 5Rs
    http://www.apple.com/support/ipod/five_rs/classic/
    Good Luck!
    You can change your screen, if it is under warranty. (they replaced it with a refurbish iPod)
    OR if it is not under warranty, to can also get it replaced for a  fee at Apple shop
    or bring it to a 3rd Party iPod service vendor.

  • My ipod has two thin black lines running across the screen. What causes this, and is there a fix?

    Suddenly, my Classic ipod got two narrow, black lines runnings horizontally across the screen.  Will thes eventually go away or is the screen damaged?
    Thanks!

    You can work through the remaining five 5 R's of troubleshooting.
    http://www.apple.com/support/ipod/five_rs/
    It might also be a good idea to let the iPod's battery fully drain. Then charge it back up and restore it once more in iTunes.
    Otherwise, it's likely a hardware issue with the iPod's LCD display, meaning you'll need to take or send your iPod in for service either via Apple or a third party repair service. Here is Apple's repair pricing.
    http://www.apple.com/support/ipod/service/prices/
    Note that they don't actually repair the device, but exchange it for one of the same generation, model, and capacity.  A third party service will actually replace the damage part for a little less.  Google "iPod screen repair" and you should get a number of results to work with.
    B-rock

  • HP2055 prints solid black lines how do I clear this?

    When printing to HP2055 any html web page results in output looking like redaction (thick black lines running entire width of page - some have texture but mostly solid black). Does not happen with any other printer. Replaced drivers. Deleted and reinstalled Firefox. Wiped profiles folder under /local. problem persists. Can print other apps fine such as WORD. only happens with Firefox to 2055.

    Check print margins.
    #In order to check the margins, we need to go to ''File'' > ''Page Setup''.
    #Once this is done, switch to the ''Margins & Header/Footer'' tab.
    #Check what's set there under ''Margins''.
    The following are the default values for ''Margins'':
    '''Right''': 12.7
    '''Top''': 12.7
    '''Left''': 12.7
    '''Bottom''': 12.7
    Check these values accordingly and change them if necessary.

  • Random black lines in different application screens

    My MacBook Pro is displaying random black lines across the screen on various applications. They stay on the screen even if I scroll up and down, but don't go onto background applications or the desktop. Has anyone else had this issue?
    I'd be happy to email a screenshot.

    Uninstalled iTunes completely and found a older firmware for the iPod. Installed it. Then installed the iTunes 7 but did not have the iTunes update the iPod. Worked like a charm! No more black lines.

  • Macbook Pro screen shows white/black lines all over the screen

    I recently run into this problem where my macbook shows white/black lines on the screen. I have to reboot to overcome the problem.
    I have attached pictures for reference.
    Did any body else expereince this problem?
    Thanks, M
    http://i45.tinypic.com/15s92yf.jpg
    http://i46.tinypic.com/e2bfc.jpg

    Look as if you're having a GPU glitch. If I were you, I'd take the computer into your local Apple Store and run extensive diagnostics on it. You can do a basic hardware check yourself, using the Apple Hardware Test.
    Good luck,
    Clinton

  • HP Laserjet Pro MFP M12fn, printing a solid black line on every paper

    I'm running windows 7 professional. I haven't received any error messages and nothing out of the oridarny has happened. My printer/scanner/fax/copy (My HP Laserjet Pro MFP M12fn, product # CZ181A) is printing with a black line down the entire paper, but its only doing it thru the feeder and not on the glass. HELP, How can I fix this? 

    Welcome to the HP Forums angelinaOO7,
    I read your post, which indicates that you are getting a black line down the page when using the feeder. You can print fine from the glass. I can help you with this.
    I would do a hard reset to see if that will resolve the issue.
    Leave the printer on and unplug the power cable from the printer and wall outlet for 60 seconds.
    Then reconnect the power cable to the printer and wall outlet rather than a surge protector.
    This ensures the printer is receiving full power and may help this situation.
    Clean the scanning glass and platen.
    Turn the printer off.
    Disconnect the power cord from the product and the wall outlet.
    Open the scanner lid.
    Clean the following scanner areas with a soft cloth or sponge that has been moistened with nonabrasive glass cleaner.
    Main scanner glass.
    Small scanner glass to the left of the main scanner glass.
    White plastic backing.
    Dry the glass and white plastic backing with a chamois or a cellulose sponge to prevent spotting.
    Plug the power cord into the product and the wall outlet.
    Turn the printer on.
    Try to make another copy.
    If you are still having issues, then update the printer's firmware.
    HP LaserJet Pro MFP M127fn Drivers.
    Select your operating system, click next, click the link for firmware.
    If you need further assistance, let me know.
    Have a wonderful day!
    Thank You.
    Please click “Accept as Solution ” if you feel my post solved your issue, it will help others find the solution.
    Click the “Kudos Thumbs Up" on the right to say “Thanks” for helping!
    Gemini02
    I work on behalf of HP

Maybe you are looking for

  • Designer v 8.2.1 will not do a Preview.

    Designer v 8.2.1 will not do a Preview. It used to when my adobe reader was v7.5 then I installed adobe reader v9 and no I get this message. "The Adobe Acrobat/Reader that is running can not be used to view PDF files in a web browser. Adobe Acrobat /

  • Open Catalog Interface (OCI) - Is CRM/ISA ready to be an External Catalog?

    I have found much information here and on help.sap.com talking about how to set up an external catalog to be part of our catalog(s). But, there is a severe lack of information to educate myself as to whether our catalog(s) are ready to be added as an

  • Urgent....Form Server Problem.

    I have installed the oracle forms server 6i. Also create a .fmx file using oracle forms 6i. When i run it on web from forms 6i designer, it works file i.e. applet is running, application is working fine. But when I start the application from the MS I

  • Enhancement section does not visible at runtime

    I created enhancement section in SAP standard program, activated it but it does not visible at runtime. How do I make it available? Thanks!

  • SmartView performance issue

    We have deployed SmartView as Excel add in for end users to drill down the budget data kept in Essbase. We found that sometimes the SmartView performance is very slow mainly due to the filtering criteria set by end users are very large so that almost