Sometimes can't hear outgoing calls, but speakerphone works

Has anyone else experienced a similar problem? Is this something that I need to get serviced?

Thanks for the help! I had the same issue earlier today, but I was told by Apple the only way to fix it was to send it in for repair!! This way was much easier!!

Similar Messages

  • Just recently, I have encountered a problem with my iPhone. When someone calls, I can clearly hear the caller, but the caler canno hear me speak. Sometimes the problem goe off and works properly, b most of the times, I am facing this problem.

    Just recently, I have encountered a problem with my iPhone. When someone calls, I can clearly hear the caller, but the caller cannot hear me speak. Sometimes the problem is nt there and works properly, but most of the times, I am facing this problem. I have tried plugging in the earphone and speak, but its the same.... can anyone advse what may be the problem?

    iphone 4g have this problem
    first solution :change the flex micro
    second solution : ic audio must reballed
    also watch video
    http://www.youtube.com/watch?v=C-n1LJEK3PM
    http://www.youtube.com/watch?v=prSZ9yJnofY
    http://www.youtube.com/watch?v=tkEiR6OPhhc

  • Can't hear outgoing call 'ringing' on iphone 5

    I cannot hear outgoing calls "ringing"on my iphone 5.  Sometimes I can if I put the iphone to speaker. 
    Anyone else experiencing this?
    Thank you!

    Have the same problem... have to switch to 'speaker' to hear outgoing call.

  • Can't make outgoing calls but receives fine (I believe it's the ISP)

    Hi.A small company were maintaining that uses a uc500 on a dedicated voip line suddenly can't make outgoing calls.This has occured on another two occasions when they were using a different ISP and It was due to them not paying their bill on time.This time we've called the ISP and they Insist everything Is fine on their end and that the company hasn't been disconnected.I can't find anything wrong with the UC.I can ping the ISP gateway.I can ping their SIP server and everything looks fine.I've added two debug files and would appreciate any assistance as my debugging knowledge Is not that great !

    Turns out the ISP was receiving calls In G729 and they use G711 Alaw.We didn't change any configuration on our side so I'm not sure what happened.I've set the sip trunk to use g711 alaw via CCA but calls are still going through as g729.I'm not sure what to configure via the cli.I assume It has something to do with transcoding but my telephony cli knowledge Is limited.
           Should I change the configuration for Individual dial-peers or Is there some global config. I can enter ?
      I added g711alaw to a dial peer and now I can't make any inbound calls either.I removed the g711alaw from the dial peer but It hasn't changed anything.
    Running debug ccsip message I receive "error 304 media type(s) unavailable. q.850 cause=65"
    I didn't expect such a small change to cause so much havoc.

  • I was using my iPhone 5 and the screen randomly went black. I can still hear incoming calls but the screen stays black and unresponsive and stays black. My lock button stopped working last week so I can't restart the phone. What can I do to solve this?

    I had an appointment this morning with Apple to try and solve the problem with my lock button ranomly not working anymore and a few hours before my appointment with the Apple store i was using my phone and my screen randomly went black and stopped working. And the p.roblem now i cant use it. I tried restarting the phone but I can't restart it due to my lock button not working so i need help with a solution on what i can do. I missed my appointment today because i could no longer use my phone and i'm now stuck using my laptop. I did also try connecting it to my MacBook but the screen was still unresponsive and black. I rescheduled my appointment to Monday to see what is wrong with my button and screen but in the meanwhile i would like to know if there is anything i can do or if i would just have to wait until monday and take it in to Apple. Any help would be really appreciated as i am phonelss for now until i take it in to Apple in a few days. Thanks.

    You wrote...
    ' What can I do to solve this'
    What have you tried...?
    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...

  • I can hear the caller, but they can't hear me??  This is my second iphone and it's happened on both?

    Does anyone have any suggestions??? I can hear the caller, but they can't hear me!

    Here's the problem I faced.  I have a iPhone 4 with AT&T.  I have the latest iOS 5.0.1.  When on a voice call the other party was unable to hear my voice.  The other party couldn't hear me even if I used the white ear buds that came with the phone or even on speaker phone.  All other features of the phone worked.  I could even Facetime, record voice memos and use Voice Control.  So I knew it wasn't a hardware problem.  AT&T installed a new SIM card.  Apple had me reset everthing and even do a restore.  I even went to an Apple store and an Apple Genius couldn't figure out why only phone calls didn't work.  He ran a diagnostics on the phone and everything checked out.  His only option was to offer to sell me a replacement phone for $149, since mine was out of warranty.  So today I continued my search for an answer and came to this page (https://discussions.apple.com/message/16912532#16912532)  and noticed the little green checkmark under the "More like This" section for "Re: iOS 5 Bluetooth Bug".  So I thought to myself, if theres a connection on this page, maybe it is my problem.  It was worth a shot at least.  So I turned Bluetooth off on my phone and now the other party can again hear my voice again on phone calls.  All this and I resolved my own problem and didn't have to spend $149.  CRAZY!

  • I can hear the caller, but they cannot hear me when I use the speaker function on my iPhone4.  Are there any fixes?

    I can hear the caller, but they cannot hear me when I use the speaker function on my iPhone4.  Are there any fixes?

    Basic troubleshooting steps outlined in the user guide are restart, reset, restore from backup, restore as new device.  Try each of these steps until your problem is solved. If these steps fail to solve your issue, then you'll need to bring your phone into Apple (or an authorized service provider in your area) for evaluation.

  • TS3718 Facetime:  I can hear the caller but not see them.  They can hear and see me.  What could be the problem.  I am using an I-Pad 2 updated with OS7.

    When receiving a Facetime call, I can hear the caller but can not see them.  They can hear and see me. 

    Unfortunately, the drive is pretty much restricted without hacking it. That is, you can't stream its content via standardized protocols like UPnP, SMB, FTP and the like. This makes you won't be able to access its content from any third-party apps otherwise capable of playing back AVI files from UPnP / SMB / FTP / WebDAV etc. sources.
    While this is certainly not a recommendation (I can in no way be held responsible if anything goes wrong): you may want to consider extending the capabilities of the drive by installing the hack: http://www.hackseagatesatellite.com/wordpress/welcome/
    It'll "open" the drive for third-party, AVI-capable multimedia apps like GoodPlayer, It's Playing etc. to directly play the files over the network.

  • No sound for incoming calls but it works using speaker and earpiece. I can't hear anything but the other party can hear me clearly. I was told it's hardware problem. Would anyone please help? Thanks

    No sound for incoming calls but it works using speaker and earpiece. I can't hear anything but the other party can hear me clearly. I was told it's hardware problem. Would anyone please help me? Thanks

    This is an annoying problem for many people. Most likely your dock connector (on the bottom where you plug in your phone) is dirty or screwed up and is probably just coincidence that it happened after you updated. Some people have had success cleaning the port with a dry clean tooth brush. There is a long discussion going on at the thread I linked below. Good luck...
    https://discussions.apple.com/thread/2475631

  • Can u plz tell me I hav problem with I phone 4 which I can hear their call but they can't hear my voice

    Can u plz tell me I hav problem with I phone 4 which I can hear their call but they can't hear my voice

    Get help with hardware features on your iPhone, iPad, and iPod touch - Apple Support

  • Sometimes on my iphone 5 i can't hear during calling how can i fix that thanks

    sometimes on my iphone i can't hear during call !!!!!!!!!!!!!!!
    i get my new iphone 5 about 1month ago
    need solution

    Try a reset: Simultaneously hold down the Home and On buttons until the device shuts down. Ignore the off slider if it appears. Once shut down is complete, if it doesn't restart on it own, turn the device back on using the On button. In some cases it also helps to double click the Home button and close all apps from the tray BEFORE doing the reset.

  • My iphone 4 can make and receive calls but I cannot hear the person on the other end...they can hear me.  I have tried plugging headphones in and resetting...any other ideas?

    My iphone 4 can make and receive calls but I cannot hear the person on the other end...they can hear me.  I have tried plugging headphones in and resetting...any other ideas?

    If you need to use the phone now, try using speaker phone until you can take it to an Apple store and have them further look into the problem.

  • Can't hear my caller after I remove my iphone headphones

    Has anyone else had this problem?
    you are listening to your music using th iphone headphones, then you remove your headphones from the iphone, when you get a call you can't hear the caller and they can't hear you. I discovered that the only way to fix this problem is to re-insert the headphone and click the mute button on the headphone! It seems that when you use the headphones and click mute and then remove your headphones it remains stuck on mute, not allowing you to be heard on an outgoing or incoming call!!!!!
    What's up with that this? is my second iphone and it has happened to both my phones. It's a good thing I had my headphones with me, otherwise my phone would be useless or worse yet if it was an emergency I would not be able to call 911!

    That is the solution so far other than a restore.
    FWIW It worked with a Belkin audio cord as well. I tried it a few times in and out with no luck.
    Here's what worked for me:
    1. Start ipod and pause on a song.
    2. Insert cord or headset.
    3. Hit play.
    4. Hit Pause.
    5. Remove cord or headset.
    6. Hit play....
    After (6) it didn't do much but then I noticed the volume slider grab a life of its own. When it settled down... all was working again.
    What a pain in the rear.
    Apple if you reading this fix it. I happened to get stuck at work after listening to music the night before... when I tried to make a call, guess what. All day without audio.
    Brutal!

  • I can't make outgoing calls from my Iphone 3GS. I am using Vodafone as my Carrier

    I can't make outgoing calls from my Iphone 3GS. I am using Vodafone as my Carrier

    I would but I work on a remote mine site, closest apple store 2 hour flight away. Hence the reason I'm asking here

  • My iPad screen has gone black.  I have tried resetting it with the sleep and home buttons and it only flashes the apple on the screen for a nano second and then it goes black again.  I can even hear notifications arriving, but I cannot see anything...

    My iPad screen has gone black.  I have tried resetting it with the sleep and home buttons and it only flashes the apple on the screen for a nano second and then it goes black again.  I can even hear notifications arriving, but I cannot see anything...I'd rather not reset it to the factory settings as I have a lot of things I worry about using.  Either way seems to me that the system itself is working since I can hear it working, but its the screen that isn't.  It has not been dropped and has been in a case for years!  Please help!

    When the power is on and I press the home button, I can slide my finger where the slider bar "would be" and it makes the noise as if its "opening" flashes a blue screen then returns black...

Maybe you are looking for

  • How to extend the size of c3k database in Sybase(Adaptive Server Enterprice 15.5)?

    Hi All, I am trying to extend the size of c3k database in my system. I tried like the above screen short but it could not work because the increament button is disable. how can i increase the size? can any one help at this?

  • Old Exchange Rate in PO

    Hi, Old Foreign Exchange rate is being taken while creating the PO.  Exchange rate 0.4321 is taken (maintained upto 23 Jan 08) instead of 0.7561 (current). But if I change the qty or price the new rate is taken. Could you pleae throw some light on th

  • CS4 Bridge opens 16bit, is resizing without input from me

    Photoshop expert changed settings on me, Bridge now opens all photos in 16bit, I don't know how to change back to 8bit automatic opening like it used to be.  Now there is a new after three years of no such problem: I convert a 8x10 to 8 bit, change r

  • How the heck do i display an image in jeditorpane???

    Ive search the site and i still cant find any info on how to enter an image into jeditorpane, i know its possible cause i can display web pages in it without a hitch cheers-

  • RFC 1939 delete problem

    sorry if this is the wrong post my problem is : i am writing mail server in POP (RFC1939) i found that every message after reading has to be deleted is that right? is it necessary to delete the message after reading the mail message ? hope for help t