Sound quality/speaker problem Pearl 9105

My Blackberry Pearl 9105 seems to have a problem with the speaker. I can hear people OK but the sound quality has gone really strange - kind of buzzy/robotic and when I ring out, the dialling tone also sounds buzzy and strange. Will I need to take it to be repaired or can I sort it out myself?
Thanks

Hi megan_c,
Welcome to BlackBerry Support Community Forums.
Have you tried reinserting the battery and testing again? If that doesnt resolve it, try backing up and performing a clean reload of your device software. http://bbry.lv/bpv7DT Make sure to test for the speaker issue before restoring any data from your backup file.
-FS
Come follow your BlackBerry Technical Team on Twitter! @BlackBerryHelp
Be sure to click Kudos! for those who have helped you.
Click Solution? for posts that have solved your issue(s)!

Similar Messages

  • Sound surround speaker problem

    I have a new sound surround system.   Everything was working fine until a couple of weeks after my husband ran the wires in the basement.  Now one speaker does not work when connected to its current wire.  It does work fine on the other speaker wire.   Do we just need a new wire?   If so,   can I get it at Best Buy and will they know which one I need if they know info from the sound surround system?    Thanks for your help in advance!

    Have you checked to make sure that the wire is connected to the receiver?  Are there any breaks in the speaker wired that goes from the receiver to the speaker?  One thing you can do to check is take a double A battery and connect it to the speaker wire by the receiver, you should here the speaker clicking.  If you do the speaker wire is fine and you did not have it connected properly into the receiver.  If you don't there is a break or cut in the wire at some point and I would rerun that wire or a different one.

  • The sound quality of my speaker suddenly got really poor when playing music or videos.  Sounds like an old AM radio or Sputnik.  Pretty sure it's hardware related but maybe not.  Thoughts on what the problem might be and if it can be repaired?

    The sound quality of my speaker suddenly got really poor when playing music or videos.  Sounds like an old AM radio or Sputnik.  Pretty sure it's hardware related but maybe not.  Thoughts on what the problem might be and if it can be repaired?

    The batterys the ipods come with are very sensetive somtimes they dont react right to the first couple of charges. Try fully charging it and then leaving it on until its completely drained a few times. If that doesnt work it might be a lemon.

  • 5300 external speaker sound quality problem....som...

    I recently got a nokia 5300 phone.Everything is fine except for the sound quality of the external speaker at full volume.The mp3s as well as the ring tones including the default nokia tone sound scratchy.Please help me has any one else experienced this problem or is it specific to my handset?What can I do about it?

    Well if it looks like it's faulty you could take it to your nearest Nokia Service Centre and they will repair it free of charge under it's 2 year warranty.
    Nokia N95
    V 20.0.015
    0546553

  • Poor X-FI Xtreme Music sound quality due to speake

    I purchased a X-FI Xtreme music the other day, poped her in, and she sounded beautiful. That is until a couple days ago, when some songs I play having static sound (games run alot better now, because I was running a SB Li've! 24 BIt, it used alot of CPU). The main reason I love this card so much is because of the lightened load on my CPU, and because games sound so much better now. Problem is some of my music sounds like it has static fuzz in it, where other songs sound perfectly normal. Im wondering if it is my sound card, my speakers (I have TomMade 2. speakers, have had em for about 8 months, so they are getting old, cost me about 80 bucks Canadian when I got them) or the song file itself (because some songs sound normal, or perhaps the instruments are just so loud I cant hear the static). I dont know if it might be my speakers because they are old. And as for wonderng if its the sound file itself, the one song I hear it big time on is a quiet song at the start, but with some instrumental, and I hear static big time. Other songs are louder, and I dont know if i can hear the static or not. Coming from my SB LIve! 24 Bit, games sound better on my X-Fi, but I have to say that songs probably sound better on my SB Li've!. I didnt really notice alot of static on my old card, but maybe I just wasnt paying attention. Is there anyway I can be sure of what the problem is?
    Another question but off topic, with my old card's software, I could change my output to 96 Hz. With the new software I can change digital output to 96, but Im not running digital speakers, I have analog (im guessing thats the SPDIF input settings under audio console) but if I go there, the SPDIF box is greyed out saying default. Perhaps the sound quality is lessened because the card thinks Im running digital?

    96khz output is in thx console on the tab speaker selection and the heading "digital output sampling frequency" if you don't have then somethings gone wrong somewhere.
    I can assure you though having 96 khz output will not make any difference to your sound its more likely that you have the other problem or static sound as you put it, that has not been fixed yet, this is what is likely to be degrading your sound not the digital output bit-rate. In fact in some cases setting it higher results in more static.
    The static you get sounds like you have the the classic pops and crackles with the creative range of sound cards this has been going on for years, try reading the link I posted in my other post there are litterly thousands in the same boat as yourself.

  • Itune 6 sound quality problem

    I just downloaded itune 6 and the sound quality is horrible - distorted and fuzzy sound.
    I thought it was my speaker so I listened through quicktime and the quicktime played alright.
    Any idea? did I do something wrong?
    my computer's G4 powerbook / panther.
    please help me if you have any solution.

    Hi, i think i've got the same problem as you, the music played in iTunes 6 has a hiss whenever there's something being played; whether it's mp3 or CD. if i play the same file in Windows Media Player, it's perfectly fine there.
    I was using iTunes 4.9 before upgrading to 6, and everything was fine then. I really hope this gets fixed soon, i'm using iTunes everyday at work.
    If Apple's reading this, please solve this quick! <=(

  • Pearl 9105 Keyboard Fault or Software Problem?

    Hi,
    I have had my BB Pearl 9105 for about 3 months now, it my first BB and I am overly impressed with it as it does everything I need and more.  However I have noticed over time that when I am writing text (either email, or SMS or anything that uses text input), I find that when I push a key once, the equivalent letter or number will output multiple times.
    For instance if I set numlock on and press the number "2" once, it will write "222".  This sometimes happens on other letters on the keyboard also, but the worst is mainly when using key 2.
    I have done a reset by removing the battery when the device is on, and that temporarily fixes the problem, however after a couple of hours it goes back to outputting multiple letters or numbers.
    Has anybody else seen this?  I would have thought this problem was actually something physically wrong with the keyboard, but it moves around randomly and can happen to any of the keys or multiple keys at once, which suggests a software problem to me?
    Any help would be much appreciate. My details are below.  Thanks and regards,
    Jamie
    BB Pearl 3G 9105
    V5.0.0.689 (Platform 6.2.0.54)

    It sounds like what I have seen multiple times on a device with moisture damage.
    Even sitting on a bathroom counter during a hot steamy shower or bath can cause keyboard and trackball problems UNTIL properly dried out.
    It really is more common than you think.
    1. Remove the battery immediately!! Do not attempt to turn on your BlackBerry.
    2. Let the device dry in a warm, dry place for 3 to 5 days* (see below)
    3. DO NOT "check it each day" by placing the battery in. Leave it be to dry completely. This takes time. Replacing the battery to check it can only damage it more (moisture + electrical current = disaster).
    3. If the device is warm after the drying period, allow it to cool to room temperature before placing the battery back in.
    *Suggestions on drying your BlackBerry in a warm place (open, with the battery out):
    Place the BB in a container of dry UNcooked rice, and then you might also place it in any of the locations mentioned below.
    On top of any dry heat emitting electronic component: TV cabinet or CRT, LCD, cable TV/Satellite converter box or plasma monitor
    On the dashboard of your car on a sunny day
    1. If any post helps you please click the below the post(s) that helped you.
    2. Please resolve your thread by marking the post "Solution?" which solved it for you!
    3. Install free BlackBerry Protect today for backups of contacts and data.
    4. Guide to Unlocking your BlackBerry & Unlock Codes
    Join our BBM Channels (Beta)
    BlackBerry Support Forums Channel
    PIN: C0001B7B4   Display/Scan Bar Code
    Knowledge Base Updates
    PIN: C0005A9AA   Display/Scan Bar Code

  • Ipod second Generation sound quality problem.

    Hello there,
    i´ve been using my nano for 1 year without any problems, with the first version (i think 1.1.3) that came with the equipment.
    The sound quality was great until i update it to the last FW. The sound quality is terrible. Very very bad.
    Please, how can i reinstall the old version of the FW?
    many thanks to anyone
    Nuno

    I'm having the same problem. If you find a solution please let me know. Ever since I installed the last update my nano sound quality is awful when I try to play it in my car via my iPod connector or use headphones.

  • PROBLEM with a PEARL 9105 please help me

    Hi ,I've got  a PEARL 9105 (with 14 characters) and I had a problem with it so I made an upgrade of it but when I upgraded it the phone is regognize by the Os as a 9100 with 20 characters. So I can't write correctly an sms or mail or anything . I tried to upgrade again but without success. Please HELP ME.

    Hey dumpeal2,
    Welcome to the forums.
    Try following the instructions here to backup and do a clean reload of your device software. http://bbry.lv/cKy9A0 if you get the same result then I would suggest contacting your service provider and have them escalate your issue to RIM. 
    -SR
    Come follow your BlackBerry Technical Team on twitter! @BlackBerryHelp
    Be sure to click Kudos! for those who have helped you.Click Solution? for posts that have solved your issue(s)!

  • Poor sound quality with 7g Nano through docking speaker.

    Very poor sound quality with 7g Nano through docking speaker.  Sound through ear bud is fine.  A different 7g Nano sounds fine through the same speakers.  There does not seem to be debris in the lightning port.  Any suggestions?

    Hey Failagain,
    Thanks for the question. The following article may help you to isolate this issue further. Based on the information you provided, the next best step may be to restore the iPod nano:
    Troubleshooting iPhone, iPad, and iPod touch accessories
    http://support.apple.com/kb/TS2634
    Thanks,
    Matt M.

  • Sound Quality Problem when importing

    I am importing my CD collection to my IPOD Classic but a small number of CDs are importing with poor sound quality that sounds like interference.  Anybody know what then problem is and how to fix it?
    The CDs are from the late 80s to early 2000s but age of the CD does not appear to be the problem.
    Thanks

    How does the quality sound lower?
    What is your sample frequency? (of the recorded files)
    Have you set the recording bitdepth to 24?
    Logic Pro>Preferences>Audio
    File>Project Settings>Audio

  • For best sound quality should volume be controlled from iPad or BlueTooth speaker?

    For best sound quality when listening to music, should the volume be controlled from iPad or from a connected Bluetooth speaker?

    Pajaro wrote:
    For good sound quality, flat response is the most important thing. Take a look at qloud, http://aur.archlinux.org/packages.php?ID=34412, and find yourself a very good microphone.
    Then you will probably want to set a global equalizer for your machine. You can try with alsa, http://krustev.net/w/articles/Global_eq … _for_ALSA/.
    If ALSA isn't finegrained enough, jack has a lot more flexibility, except for the fact that it doesn't allow you to set default output device, so you will need a helper application to redirect all output connections to your equalizer.
    Well, i would say this is quite subjective. Untouched signal is superior to any equalized sound in my opinion, but i know this debate is never satisfying

  • I recently buy an apple iphone 4s.the problem is that when i started music player on my iphone the speaker is not outputting the sound.and when i lock the phone at the same time the sound starts.thos problem is from last 3 days.and i am really confused???

    i recently buy an apple iphone 4s.the problem is that when i started music player on my iphone the speaker is not outputting the sound.and when i lock the phone at the same time the sound starts.thos problem is from last 3 days.and i am really confused???

    Basic troubleshooting from the User's Guide is reset, restart, restore (first from backup then as new).  Try each of these in order until the issue is resolved.
    If the issue continues, take the device to Apple for evaluation and possible replacement.

  • Having problems with sound quality in my iphone 5 since update

    Since update done my iphone 5 sound has really deterioated

    Hello Tanper
    Check out the articles below, it will provide multiple options for troubleshooting issues with the sound from your iPhone.
    iPhone: No sound or distorted sound from speaker
    http://support.apple.com/kb/ts5180
    iPhone: Receiver and call audio quality issues
    http://support.apple.com/kb/ts5196
    Regards,
    -Norm G.

  • Archlinux + wine + spotify sound quality problems

    Hi,
    have installed Spotify on my Archlinux box using Wine. But I am not able to get the same sound quality as in Windows XP. Have tried all kinds of settings in winecfg. Anybody have the same problem or know how to fix this?
    Br,
    Burra.

    burra wrote:
    Hi,
    yes I tried the settings they suggested. But with emulated the music plays good for some seconds and then it starts jumping for some seconds. It does this all the time.
    When I try to run Full it works fine no jumping but instead it has some kind of distorted sound, as being in a metal jar.
    I have the possibility to chose ALSA and OSS in winecfg. The sound quality seems to be a bit better if I use OSS. But not as good as in windows.
    Any more ideas?
    Burra
    Try to change your default sound API to OSSv4, it has better sound... way better, because you're not actually using OSS, but instead ALSA's OSS emulation...

Maybe you are looking for