Started update today when i had a look at ipod later it had connect to itunes pic on screen did this then itunes said it has detected an ipod in recovery mode and to restore it done this it fails because of error 3194 and is currently not responding help!
started update today when i went back to ipod it had on screen pic of connect to itunes did this itunes detected an ipod in recovery and needed restored did this and error 3194 coming up ipod is currently stuck in recovery mode help!
3194-How do I reset the hosts file back to the default?
iPhone Error 3194 - How to Fix iTunes Error 3194?
Fix Error 3194 from iTunes during iPhone restore
iTunes: Specific update-and-restore error messages and advanced troubleshooting
Similar Messages
-
I was updating my Ipads software when it just shut off. I turned on the i pad and it gave me this picture of the wire plugging in to itunes. i plugged it into i tunes and i got this message on itunes saying itunes has detected an ipad in recovery mode. you must restore this i pad before it can be used with i tunes. pleasssse help
iOS Recovery Mode -
iOS: Unable to update or restore
http://support.apple.com/kb/ht1808 -
I have tried to update my Iphone 4S today to IOS 7.0.6 and now my iphone wont connect to itunes as it says that it is detected that it is in recovery mode and needs restoring. How do I restore it? I cannot get my phone on at all?
Click restore in itunes.
-
I reboot the computer, deleted and restart itunes, change computer, change cable, check ping, check connection. need help
Step by step
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. iPad Recovery Mode on computer screen
8. Select "Restore iPad"...
9. Select "Restore and Update"
10. Extracting Software.
11. Preparing iPad for restore.
12. Waiting for iPad.
13. Verifying iPad restore...
14.Restoring iPad software.
15. Verifying iPad software.
16. Verifying iPad Restore...
17. Restoring iPad firmware...
18. Your iPad is restored to factory settings; keep iPad connected to computer
19. Activate iPad
20. Enter Apple ID and Password
21. Continue
22. Welcome to Your New iPad -
when I wanted to downloaded the new software the phone went of and in my computer saying iTunes has detected an iPhone in recovery mode. you must restore this iPhone before it can be used with iTunes,
my hone is off pls help i need to make calls as i use my phone for work ,
Many Thanks
kerrySo do what it says and restore the phone. Nothing else you can do.
-
When performing the new iPhone(IOS6) update I received an error message - iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes. Will I lose everything if it goes back to factory settings. Right now my phone wont do anything. It is just showing a cable, an arrow and the iTunes logo.
If you restore from backup.
You should have made sure that everything was on your computer bef ore updating anyway. Did you fail to do that?
All pics taken with iphone should be imported to your computer regularly as you would with any digital camera, most especially before any update/restore/etc. Did you fail to do that? -
I try to update IOS 6 to my ipad 2/ wf/3g and after about half of the procedure stopped ... then I try to reconnected to the itunes and say "iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes". Can everyone help please. In the screen of iPad appears the itunes Logo and the cable of connectios. Can't do nothing!!!
Click restore in itunes.
-
I was restoring my iPhone 4 when it showed to connect to itunes. i did, and got the message,"itunes has detected a device in recovery mode, please restore your device before it can be used with itunes" after i clicked the restore button. the message kept showing up, and i only had the option of updating and restoring. i waited three hours for it to restore, but there was no response with the iphone. HELPHELPHELP!!!!!!!!
Hello the_problematic_iphone
Check out the article below if you are not able to restore your iPhone.
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
Thanks for using Apple Support Communities.
Regards,
-Norm G. -
Never once has my phone updated without deleting everything. It says "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes. I can't call for help because my phone is frozen on the screen with iTunes. On line live chat won't chat until I give them my serial number which I can't get to because its frozen and can't call for the same reason!! Omg! Someone please help me!?
Morning AppleHlumamkhululi,
Thanks for using Apple Support Communities.
In most cases, the connected iPod needs to be restored.
For more information on this, take a look at this article:
iTunes has detected an iPod in recovery mode - Use iTunes to restore
http://support.apple.com/kb/ts1456
Best of luck,
Mario -
in attempting to reset my ipad2 thru itunes it states .iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes. when i hit restore it does not reset
Step by step
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. iPad Recovery Mode on computer screen
8. Select "Restore iPad"...
9. Select "Restore and Update"
10. Extracting Software.
11. Preparing iPad for restore.
12. Waiting for iPad.
13. Verifying iPad restore...
14.Restoring iPad software.
15. Verifying iPad software.
16. Verifying iPad Restore...
17. Restoring iPad firmware...
18. Your iPad is restored to factory settings; keep iPad connected to computer
19. Activate iPad
20. Enter Apple ID and Password
21. Continue
22. Welcome to Your New iPad -
When I havent got my ipad connected to a power supply I get an image on my ipad of the usb cable with an arrow pointing to a itunes icon and no matter what you try and do iyt stays on that for a few seconds and then switches off the ipad, connecting it through usb into itunes on my PC (XP) this image says on the screen but I get a message on itunes saying itunes has detected an ipad in recovery mode and mneeds to be restored - when I fire off the restore through itunes after a few minutes it comes back and says it cannot restore and give an error message 1603. I have also repeated the process through my wife's laptop (Vista) and get the same situation -it is an 32GB Ipad 3 purchased last November - any ideas ?
Try and turn off iPad/iPod and proceed to step 3 of Recovery Mode.
Recovery Mode
1. Disconnect the USB cable from the device, but leave the other end of the cable connected to your computer's USB port.
2. Turn off the device: Press and hold the Sleep/Wake button for a few seconds until the red slider appears, then slide the slider. Wait for the device to turn off.
3.While pressing and holding the Home button, reconnect the USB cable to the device. The device should turn on.
4. Continue holding the Home button until you see the "Connect to iTunes" screen. When this screen appears, release the Home button. iTunes should alert you that it has detected a device in recovery mode. Click OK, and then click Restore to restore the device.
Note: Data will be lost. You may have to repeat the above many times. -
The message"itunes has detected a iphone in recovery mode. You must restore the iphone before it caan be used on itunes." yet when i do i still get the same message!!!
You have to restore the iPod, no ifs, ands, or buts...
After iOS is installed you will be asked if you what to set it up as a new iPod or if you want to restore from a backup.
If you have a good backup you can restore that and you're good to go.
If you don't have a good backup, then you end up with a "clean" iPod.... -
After I downloaded iOS7 and my iPhone turned off I keep getting this message "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes." I dont wanna lose some stuff from my iPhone.
During a normal install of iOS 7.0.6 this does not happen but something clearly went wrong in your installation.
To fix this, connect to iTunes and restore to Factory. Hopefully your iPad will be working again and you can restore your iCloud backup during Setup. -
I downloaded the update because why not. I then turned my iPad on and get the iTunes logo and a lightning cable picture. I plugged the ipad into my computer and opened iTunes.
The I got:
"iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes"
When I click restore it then says:
"Are you sure you want to restore the iPad "iPad" to its factory settings? All your media and other data will be erased, and the newest version of the iPad software will be installed.
iTunes will verify the resotre with Apple. After this process is complete, you will have the option to restore your contacts, calendars, messages and other settings."
I don't want to lose my media. I was never told to make a back up, I was never told the update would be this difficult.
Can I just revert back to how it was before?I downloaded the update because why not. I then turned my iPad on and get the iTunes logo and a lightning cable picture. I plugged the ipad into my computer and opened iTunes.
Then I got:
"iTunes has detected an iPad in recovery mode. You must restore this iPad before it can be used with iTunes"
When I click restore it then says:
"Are you sure you want to restore the iPad "iPad" to its factory settings? All your media and other data will be erased, and the newest version of the iPad software will be installed.
iTunes will verify the resore with Apple. After this process is complete, you will have the option to restore your contacts, calendars, messages and other settings."
I thought okay, I'll just erase everything then. I get error 3004 when I try to restore.
I've tried disabling my security software, updating iTunes, replacing my hosts file and using a third party software recovery tool. Nothing works. I never thought Apple would break my iPad with an update but they managed to.
Any solutions?
Thank you. -
Would a backup occur if I was downloading pictures to Picassa 3 ??? Did a real backup take place w/I-Tunes, at that same time ??? I don't remember if I saw that on the screen. Three days later while trying to sync my iPHone, I had a msg "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes."
Concern: Will I lose all my media and other data ? Just hate to push the RESTORE & UPDATE button, only to find out I have LOST all that stuff. My son says it should be backed up when I did the 4.3.2 of iPhone. Concerned a ton over this problem.
Thanks to anyone out there who might be able to help. Would appreciate any ideas.
PLS HELP
--tinker62Syncing photos does NOT sync the phone; the camera is considered a separate device from the rest of the iPhone. You sync with iTunes, and should do it often enough so you don't cry if you lose all data on the phone.
At this point you have no choice; there is no way to NOT restore it. If the last backup is not corrupt it should restore the phone as of the time of the last backup.
Maybe you are looking for
-
I would like to create a website in iWeb '09 which will require multiple users to contribute/publish content, but the other site collaborators do not have Macs, just Windows-based PCs. Question: If multiple people are needed to publish content to the
-
New compoter has no music on it, my ipod has all my songs, if I sync the two will the computer erase all my ipod tunes and leave me with no tunes?
-
Keynote Transitions in Powerpoint
Is it really true that all of the transitions in Keynote will go without problem into Powerpoint? If so, it must mean that you can already do those things in Powerpoint, but I've never seen any of the "exclusively Keynote" ones. Is Apple lying or som
-
Distiller 8.1 NOT respecting eps BoundingBox
Distiller 8.1 (OSX 10.4.11) When creating a pdf from an eps file using Distiller with setting e.g. "High Quality Print.joboptions" the "BoundingBox" of the eps-file is not reflected in the generated pdf. Of course the last DSC item is always checked
-
When I send or receive an email the date, to, from and subject line are fine but after that there is all of this encrypted information that is listed. I do not know what this information is called, how this information started showing up, I do not wa