Stuck in loud speaker mode
I have an ipod nano 4th generation that is just over a year old. I have had no problems up to now. A few weeks ago i went to turn my ipod on and play my music through my headphones and it was almost like the ipod would not register that there were headphones plugged into my ipod and it was playing on loudspeaker mode. I dont ever use my ipod in loud speaker mode and had not used it for a couple of days when i turned it on and experienced this problem. Any suggestions?
First, if you have a speaker then you have a 5th Generation Nano, not a 4th generation.
Get a flashlight and inspect the headphone jack and make sure there is not an obstruction, lint, dirt, etc., blocking the connection. Clean it out if necessary.
If there is no obstruction, try a different set of headphones. If the problem persists you have a damaged headphone jack and will need to get it serviced.
Similar Messages
-
when i take a call or dial a call in the high density traffic area or noicy area i can't hear properly so at that time i put my phone in the loud speaker mode.
I have had this happen to me on 3GS, 4 and 4s. Usually the solution is one of the following:
1- If your volume indicator says headphones even though they are not plugged in, then:
Stick your headphones into the headphone jack and then remove quickly.
2. If that does not work Power your phone off. Then when restarting Reset the phone by pressing the home button and the power button at the same time until the apple logo appears.
3. Make sure you have not chosen to send audio to an Airplay device such as Apple Tv.
Hope one of these works for you -
E71 Gets stuck after loud speaker is used in a pho...
Hi all,
My first post...
I only got my phone this week and have used the nokia updater to get the latest firmware (dont know what it is exactly).
I've noticed that after I use the loud speaker/ hands free setting in a phone call the phone gets stuck on the "front page". It wont go into the menu page by any means, or any other page at that.
[edit] I have to turn the phone off and on again to get it unstuck. [edit]
Has any one else experienced this?
Cheers,
Roddersf.
Message Edited by roddersf on 04-Nov-2008 06:22 AMI haven't been able to correlate this with loudspeaker use, but I have experienced the same symptom.
After some usage (it may, or may not involve loudspeaker being activated), menu gets "stuck" behind the home screen. That is, upon pressing the menu button once, I can see a bit of menu screen appearing in top right corner of the screen, but I can't navigate it; it's almost like there is some bug in z-buffer ordering of the screens being rendered, and/or it also prevents the screen getting focus. I can still switch between the apps already running via the menu button press-and-hold though.
Didn't find a way to cure this except by switching the phone off/on.
Quite annoying.
This is on 100.07.76 RM-357 phone, will report if this continues after I upgrade to the latest firmware soonish.
P.S. At least one of my friends is experiencing exactly the same behaviour on his E71.
Message Edited by mbravo on 08-Dec-2008 08:57 AM -
My iphone working only in loud speaker mode?? help required
Hi,
I'm facing this wierd problem where I can't hear what the other person is speaking unless I turn it into speaker mode. Can someone help me solve this problem..Hi,
Have you taken the plastic screen cover off the iPhone, if it's new, as it covers the ear speaker?
If you've noticed this happening whenever you use you earphones, then try unplugging them several to many times to resolve the problem. Though if you say that your speaker is working, it's more likely to be the first problem, i.e. the screen cover blocking the earpiece.
Message was edited by: jia10 -
My ear bud aux piece is stuck in my headphone port. Is there a way I can turn all my volume on speaker mode?
As long as there is material stuck in the port, the external volume will be disabled. I suggest you take it to an apple retail store or call 1-800-APL-CARE for service
-
5310 loud speaker is not silent in "silent mode"
Hi,
I just got a 5310 (FW 5.91) and love it. One annoying querk I would like to get resolved.
When I have the phone in silent mode (and have set all sounds to "off" in the silent profile), the loud speaker still plays music when the "play" button for the music player accidentally gets pressed. I can lower the volume to the lowest level, but I cannot silence the loud speaker.
When in silent mode, it seems that you should be able to silence the loud speaker.
Thanks for any help.
EricSilent profile is designed only to silence call functions, it dates back to the days when phones were only phones.
Perhaps it is something to be reviewed now that so many models have multimedia buttons on the phone itself. I'm not familiar with that model, does the keypad lock perhaps deactivate the music buttons too? -
E50 Goes to Loud speaker (IHF) mode automatically ...
Hi,
I have a problem with my E50 which is some thing like this,
During call waiting (While I am receiving a second call, when I am already on a call) the incoming audio is switching to loud speaker automatically with out any commands. Then I can not change it into normal speaker even if I tried to do so. The only way to get rid of this is to remove the battery and restart the unit again. Do anybody having the same issues,
regards,
Sanjuvikashvjain wrote:
If you have fring installed then uninstall it and try . . It should work fine . . I had the same problem with fring installed now working fine after uninstalling it .
Seems as if fring causes alot of compatibilty issues (first the RSS feeds) and now this, problem is i need fring, any work around?
If you found this post or any other psot helpful please press the green kudus star -
i have had my ipod for a few years now and when i turned it on this morning, it would not go off of speaker mode when i put the headphones in. when i put the headphones in, the ipod plays through both the headphones and the speaker. what should i do?
First make sure the headphones are all the way in, meaning the white plastic part is flush with the Nano and no silver from the plug can still be seen.
If that doesn't help, try a hard reset. To do this, press and hold both the Select (Center) and Menu buttons together long enough for the Apple logo to appear.
B-rock -
Curve 9220 problem with loud speaker
I am having problem with loud speaker since purchase. Volume level fluctuate every time, sometimes not audible also.
Complaint given to service centre in Jaipur-India but they are not cooperative.Hi and Welcome to the Community!
I recommend that you attempt to boot into Safe Mode:
KB17877 How to start a BlackBerry smartphone in Safe Mode
It may take you multiple attempts to get the ESC key sequence (press/release/hold) correct, so be patient. When successfully into Safe Mode, see what happens.
If the behavior ceases, then think carefully...what happened just before this behavior started? A new app? An update? A Theme? Something else? Think carefully as the smallest change could be causal...and attempt to undo whatever that was.
But if the behavior continues in Safe Mode, then you may need to consider more drastic actions -- WIPE, OS Reload, BBSAK Wipe/Reload, and the "Bare Bones" OS Reload Process. To prepare, you should be sure that you have a full backup to your PC...please review the Backup link in my auto-sig on this post for instructions.
amitasmrj wrote:
Complaint given to service centre in Jaipur-India but they are not cooperative.
Unfortunately, if your issue is a hardware problem, then no one here in this forum can help...refer:
http://supportforums.blackberry.com/t5/Social-Lounge/How-This-Site-and-Formal-Support-Work/td-p/2540...
Good luck and let us know!
Occam's Razor nearly always applies when troubleshooting technology issues!
If anyone has been helpful to you, please show your appreciation by clicking the button inside of their post. Please click here and read, along with the threads to which it links, for helpful information to guide you as you proceed. I always recommend that you treat your BlackBerry like any other computing device, including using a regular backup schedule...click here for an article with instructions.
Join our BBM Channels
BSCF General Channel
PIN: C0001B7B4 Display/Scan Bar Code
Knowledge Base Updates
PIN: C0005A9AA Display/Scan Bar Code -
N8 switching to loud speaker automatically
Hi there
recently on my N8 sometimes while talking on the phone it switches to loud speaker automatically (on the screen options it still shows the option to open loudspeaker) and the only way to switch to handset mode is to activate loudspeaker then deactivate... anyone else have this same problem
*looking for a solution other than soft reset cause i'm kinda liking my ovi store
If you found this post or any other psot helpful please press the green kudus starvikashvjain wrote:
If you have fring installed then uninstall it and try . . It should work fine . . I had the same problem with fring installed now working fine after uninstalling it .
Seems as if fring causes alot of compatibilty issues (first the RSS feeds) and now this, problem is i need fring, any work around?
If you found this post or any other psot helpful please press the green kudus star -
Phone is stuck in voice recognition mode
Phone is stuck in voice recognition mode. she speaks what I do but nothing is really happeing. how do I turn it off?
Settings > General > Accessibility > Voiceover > Off
-
Loud Speaker Turns on during call . Any solution ?
Loudspeaker turns on during call with an option showing me that its in handset mode and offcourse it still gives me an option to switch the loudspeaker on . Is there any solution for this tried updating the software and all ...
If any other solutions pls let me know ....
I had this problem with my N8 which i got on October 11 2010 since then i have been to Nokia Care more than 30 times for service and other problem . Atlast they gave me a replacement handset (swap is what they call) a week back but even with the New handset i am facing the same problem .. Is there any solution
Regards
VikashNo Bro it doesnt works ...
Tried it with a different Sim card as well but facing the same problem Loud Speaker turns on by itself ... ... Dont know if there is ever gonna be a solution for this . . Even Nokia care has no solution for this problem .. I guess the Nokia Technician are incapable or inefficient of sorting the issue ..
Do tell me if u have anything else which i could try ...
Thanks
Vikash -
I bought my iphone 4s from canada about less than a month ago. It worked perfectly fine, until i recently discovered that the mic on speaker mode stopped working. That means, when i speak to someone on speaker during a call, they are unable to hear me.However Siri and voice memos are working fine. I could initially face-time but now i cant. I have also tried restoring my iphone a few times.
As i am based out of india, I contacted apple in India, they refused to touch the phone as it was purchased in Canada and the warranty is apparently applicable only in the country of purchase. I can in no way go back to canada to get the phone replaced. Does anyone have any ideas as to how I can resolve this? Shouldnt apple be able to get this sorted since its a brand new phone under warranty?Hello jaymc04_463,
The following article details a number of troubleshootings steps that may help restore normal audio to your iPhone.
iPhone: Can't hear through the receiver or speakers
http://support.apple.com/kb/TS1630
Cheers,
Allen -
My iPhone 6 ear speaker is not working properly I couldn't able to hear any thing from ear speaker to listen I had to put on loud speaker or to use hands free please help me out with this problem if some body have answer?
Hi Venkata from NZ,
If you are having an issue with the speaker on your iPhone, I would suggest that you troubleshoot using the steps in this article -
If you hear no sound or distorted sound from your iPhone, iPad, or iPod touch speaker - Apple Support
Thanks for using Apple Support Communities.
Best,
Brett L -
My Iphone 5 voice speaker is not working.I'm not able to hear the voice of the person calling.But when I put my iphone 5 on speaker mode, things seem ok.Please provide me some suggestions.
Hello rizvijunaid,
Thank you for providing the details of the issue you are experiencing with calls on your iPhone. I recommend following the steps in the article below for the issue you described:
iPhone: Receiver and call audio quality issues
http://support.apple.com/kb/ts5196
Thank you for using Apple Support Communities.
Best,
Sheila M.
Maybe you are looking for
-
I have been unable to find out any details about this specific error message, other than for Google Chrome, which is strange because although I have Chrome installed I don't use it, I use either Internet Explorer or - most often - Firefox. This error
-
Best Method For Keyword Search (Full Text Search)
I have some cataloged columns I am searching for Keywords. This table is getting huge over 6.7 million records and it is becoming slow. What is the best method to optimize the DB for this Search. Do I need to create a column that will have a keyword
-
Hi guys, I'm new here and just have browsed some of the related topics here regarding my problem but could not seem to find anything to help me fix this problem so I decided to post this. I currently have a saved waveform from an oscilloscope that i
-
Win 7, 64 bit USB connection problems
I'm having real problems getting my Touch to reliably connect with my new Win 7, 64 bit Dell laptop. Dell tech support says the drivers and hardware are fine. Following the troubleshooting via Apple support hasn't solved the problem. The Touch times
-
Customer create notification - sd
dear wf experts, sd std workflow - customer create notification is activated in OOCU, but we find in our system ecc 5, that there is no activate event linking for std workflow WS20000084 - customer create notification also all sd std workflows are do