Stuck on moving bar and black screen?

Hi, I have a Toshiba Satellite A300 Series. Windows Vista. My laptop was working perfectly fine last night and when I woke up this morning, I turned it on and it was stuck on the Windows Corporation where the green bar is moving from left to right. I tried doing pressing F8 for safe mode and it went pass through the moving bar but then the screen turned black and all I can move is the cursor. I left it there for good hours just to see if it'll work but it stayed like that. I also tried start up repair and it said if the start up repair fixed the problem, windows should start normally. Then I clicked finish, but it still did the same, still stuck on the moving bar. It showed me a code 0x0 after the start up repair if that will help?
Any suggestions? Greatly appreciated! Thank you!

Try the solutions in this article.
What can I do if my Windows 7 or Windows Vista laptop won't start?
- Peter

Similar Messages

My lumia 720 suddenly stuck and black screen with ...

Hi
My lumia 720 suddenly stuck and black screen with Nokia Symbol is displaying I have tried for soft reset but it doesnt work will someone help me its very urgent
varun

You can try to perform the soft reset again. If this would fail, below hardware key reset combination is what I can suggest. This deletes all the personal content of the phone.
Option 2: Hardware key combination
Use this option if the phone fails to fully switch on when pressing the power on key.
Note: No warning about data loss!
Nokia Lumia with Windows Phone 8
Step 1
Make sure the charger is disconnected.
1. Switch the power Off.
2. Press and hold the Volume down and connect the charger, if succeed an exclamation mark (!) is shown on the screen.
Step 2
Then input the keys in the following order:
1. Volume up
2. Volume down
3. Power
4. Volume down
Step 3
The phone will reset and boot up automatically. Please note that this may take several minutes.

Repeatedly getting stuck on spinning wheel and grey screen, even after multiple re-installs of the OS

Ok, so running Lion on a MacBook, (2010 i think) and the OS got corrupted(stuck on spinning wheel and grey screen on boot)
Tried to repair the disk via disk utility using an install CD, no go, couldn't repair, so, did a clean install.
New install went fine, computer worked for about 3 days and then stuck on the spinning wheel again.
suspecting physical damage to the harddrive, I installed the OS to an external, and booted from there. Worked for a couple days and then stuck on the spinning wheel.
I have repeated the process 5 times now, each time it works for a little and then craps out again.
What's going on?
as a note, when I say it gets stuck on the spinning wheel, I have left it for 12 hours trying to boot to no avail.

The Apple Hardware Test doesn't always detect all errors.
Next time you get the gray screen/spinning wheel, try booting into the Safe Mode to see if it will boot.
Shut down the computer and then power it back up. Immediately after hearing the startup chime, hold down the shift key and continue to hold it until the gray Apple icon and a progress bar appear. The boot up is significantly slower than normal. This will reset some caches, forces a directory check, and disables all startup and login items, among other things. If the system operates normally, there may be 3rd party applications which are causing a problem. Try deleting/disabling the third party applications after a restart. For each disable/delete, you will need to restart if you don't do them all at once.
Safe Mode
Safe Mode - About
Startup Gray Screen
Startup Issues - Resolve
Startup Issues - Resolve (2)
Startup Issues - Resolve (3)

Ipod 4 is displaying blue frozen screen and black screen with apple logo. I try to turn power off but as soon as it goes out it automatically reboots. Plugged it into the usb port on my mac and it doesnt do anything. It doesnt appear in Itunes. Help?

ipod 4 is displaying blue frozen screen and black screen with apple logo. I try to turn power off but as soon as it goes out it automatically reboots. Plugged it into the usb port on my mac and it doesnt do anything. It doesnt appear in Itunes. Help?

Let the battery fully darain. After charging for an least an hour try a reset and restore. Use Recovery mode if necessary.
If not successful, then time for an appointment at the Genius Bar of an Apple store.

Panic message restart grey and black screen

WOONT RE BOOT OR START
Computer froze and after manual power down and restart, grey and black screen appeared with a message to hold powwer button down to power off and then hold power button again to restart. I did and got same screen and message. "PANIC" and "Debugger called: <panic>" message in background.

Hi Fred,
Is this happening for all Flash content or just your website? Can you give us a link so we can take a look? Can you also please post back with your system's configuration report?
Windows Instructions
Mac Instructions
Please check to see if you are using the NPAPI version of the Flash Player plugin in Chrome. Let me know if you need instructions on how to do this. If you are, please try switching back to the PPAPI version to see if that corrects the problem.
I'm moving this post over to the Flash Player beta forum.
Thanks,
Chris

Macbook 101 stucks on apple logo and changing screen colour to grey and whitej

CAnt power it on stucks on apple logo and changing screen colour to grey and white

Startup - Gray, Blue or White screen at boot, w/spinner/progress bar
Startup - Gray Screen
Startup Issues - Resolve
Startup Issues - Resolve (2)
Startup Issues - Resolve (3)

Lenovo G560 - Issue with won't boot and black screen after HDD upgrade

Lenovo G560 - Issue with won't boot and black screen after HDD upgrade.
What happen: My laptop was working fine, no blue screen issue, no funny business at all. I bought a new SSD Intel 120 GB and thought it would be a good idea to replace the HDD. I shutdown and disconnected the power adapter, waited a couple of minutes and removed the battery. I opened up the back case and replaced the HDD. And put all the screws back and put the battery back in.
Problem: The very first time I turned the power on, nothing happens besides a black screen. I pressed the dvd drive it works and opens up and closes. I waited for about 30 mins and still has blac screen. When I mean black screen, no bios menu, no logo, just a black screen with the fan sound on.
I have tried these:
1. Unplugged everything - battery, adapter, and pressed the power on button for about 60 seconds, nothing, the laptop turns on with the LED display on for both on and battery LED's. But nothing but black screen, no sound of windows loading just the fan and black screen.
2. I tried putting back my old 2.5" and nothing but black screen.
Thoughts and suggestions?
Solved!
Go to Solution.

Hi Autoexit173,
Welcome to Lenovo Community!
As per the query we understood that you are facing issue with system not booting in your Lenovo G560 laptop.
As you have mentioned that the system not booting, please try to remove the RAM and turn on the system and check if you can hear any beep sound. Also try to clean the RAM slots and check for the issue.
Click here for the steps to remove the RAM and refer page number 40.
Hope this helps. Do post back if issue persists!
Best regards,
Ashwin.S
Did someone help you today? Press the star on the left to thank them with a Kudo!
If you find a post helpful and it answers your question, please mark it as an "Accepted Solution"! This will help the rest of the Community with similar issues identify the verified solution and benefit from it.
Follow @LenovoForums on Twitter!

My iphone 5 died so I plugged it back in to charge and it will not turn on. It will turn to the screen with the apple logo and black screen then turn off again. Any suggestions?

My iphone 5 died so I plugged it back in to charge and it will not turn on. It will turn to the screen with the apple logo and black screen then turn off again. Any suggestions?

I leave it charging until it gets back to full, usually it turns on after a little bit of time after plugging it in, but all its doing is going to the apple logo screen and going blank again.

Phone doesn't appear in iTunes and black screen!!

Phone doesn't appear in iTunes and black screen i cant do nothing please help me!!

I read this article.
I can't restore iPod because iPod Updater can't recognize it, when one connect to the computer.
How to solve the problem: as i wrote, iTunes diagnostic informs that can't find the controller IEEE 1394 (WiFi), but I HAVEN'T WiFi card on computer, I use USB 2.0.

Blinking light and black screen

My 3rd gen apple tv light was blinking and giving a black screen. I reset it using my laptop nas instructed. It is still doing the same thing. (Light flashing and black screen) Where do i go from here?

May be an issue with it but try holding menu and up key on teh remote TOGETHER for 6 secs in case it's selecting an incorrect video mode - that option will cycle video modes. Check HDMI connection to display is not loose at either end.

Have a 27 imac desktop with mac osx 10.5.8, finally got out of grey and black screens etc. is there anything I can do to prevent all this from happening again when I shut down?

Have a 27 imac desktop with mac osx 10.5.8, finally got out of grey and black screens etc. is there anything I can do to prevent all this from happening again when I shut down? Or before I shutdown? TIA.

Basic Backup
For some people Time Machine will be more than adequate. Time Machine is part of OS X. There are two components:
1. A Time Machine preferences panel as part of System Preferences;
2. A Time Machine application located in the Applications folder. It is
     used to manage backups and to restore backups. Time Machine
     requires a backup drive that is at least twice the capacity of the
     drive being backed up.
Alternatively, get an external drive at least equal in size to the internal hard drive and make (and maintain) a bootable clone/backup. You can make a bootable clone using the Restore option of Disk Utility. You can also make and maintain clones with good backup software. My personal recommendations are (order is not significant):
1. Carbon Copy Cloner
2. Get Backup
3. Deja Vu
4. SuperDuper!
5. Synk Pro
6. Tri-Backup
Visit The XLab FAQs and read the FAQ on backup and restore. Also read How to Back Up and Restore Your Files. For help with using Time Machine visit Pondini's Time Machine FAQ for help with all things Time Machine.
Although you can buy a complete external drive system, you can also put one together if you are so inclined. It's relatively easy and only requires a Phillips head screwdriver (typically.) You can purchase hard drives separately. This gives you an opportunity to shop for the best prices on a hard drive of your choice. Reliable brands include Seagate, Hitachi, Western Digital, Toshiba, and Fujitsu. You can find reviews and benchmarks on many drives at Storage Review.
Enclosures for FireWire and USB are readily available. You can find only FireWire enclosures, only USB enclosures, and enclosures that feature multiple ports. I would stress getting enclosures that use the Oxford chipsets especially for Firewire drives (911, 921, 922, for example.) You can find enclosures at places such as;
1. Cool Drives
2. OWC
3. WiebeTech
4. Firewire Direct
5. California Drives
6. NewEgg
All you need do is remove a case cover, mount the hard drive in the enclosure and connect the cables, then re-attach the case cover. Usually the only tool required is a small or medium Phillips screwdriver.

What to do when the apple logo and black screen persist (apple tv)

What to do when the apple logo and black screen persist, when connecting apple tv.

Have you unplugged from the power for 30 secs and retried?
If it constantly still does that it may have become corrupted and you'd need to restore via iTunes:
Restoring your Apple TV - Apple Support

Print to Tape color bars and black order

Hello. i'm about to print a videoclip for a tape. my question is the following, in the print to video setup theres is the option for color bars and black.. but the color bars come first and then the black. i would like to have the black first for 2 minutes and then color bars for 30 seconds..how can i do that?

I want full control over how things happen. As an added benefit, by keeping everything in the sequence timeline, I have the ability to use a custom countdown clock.
x

HT4623 MY iPad screen is stuck on the "terms and conditions screen. I tap the agree button and the send email button, but nothing happens. Please help.

While trying to update my Ipad to the new operating systemm my screen is stuck on the "Terms and Conditions" screen. I tried touching the "agree" button and the "send my email" button, but nothing happens. I can't get out of the screen without missing my full update. Please help.

completely switch off your ipad with pressing the top power button really long and then swipe the red swiper at the top. Then turn your ipad back on, skip the icloud login screen and you should be good! That's what i did so should work for you too

20" imac won't start up-flashes between blank grey screen and black screen

20" imac
2GHz Intel Core 2 Duo
Was running system 10.5.8 just fine. Worked great.
But then I wanted to give the imac to a relative. And so, I tried to boot from the original grey mac install dvd to wipe the hardrive and set the imac back to factory specs.
But it wouldn't boot off the dvd. All It would do at restart was to flash slowly back and forth between blank grey screen and black screen. So, I tried the Leopard update dvd. Same results. So I zapped the pram and tried again. Same results.
If I just pushed the start button tho.. the imac would start right up and run fine. However, I didn't want to give it to someone else with all our information on it.
I finally restarted it and held the "T" key to turn it into a giant firewire drive, hooked it up to our other 20" imac, and used the disk utility from the second imac to erase the drive of the first imac. Then I inserted the grey install dvd into the second imac and selected the drive of the first imac and ran the install process.
Now, the first imac won't start up at all. Just a continual grey screen for a bit, than a couple of buzz sounds in the machine and then the black screen... than back again.
It ran great before I erased the drive and re-installed OS 10.5
What's wrong? How do I get the machine to either boot off the install cd?

So, I've figured out a little more on the first machine. It's a 20" 2.6 GHz Intel Core 2 Duo running 10.5.8.
It ran great. But, I wanted to erase the hard drive and reinstall the OS system before giving it to a relative.
I found that although the optical drive would read and write to normal cds and dvds, the machine would NOT boot from the grey start-up disks I had on hand. ( I have two imacs, and I tried both sets of dvds without success.)
I zapped the PRAM, and used disk utilities via firewire connection from my other 20" imac to check the hardrive and make repairs. Disk Utilities couldn't find any problems. So, using disk utilities from the other imac, I erased the first imac's harddrive and then used the install dvds on the second imac to install the original OS to the hard drive of the first imac.
(looking on the hard drive of the first imac, I can see all the contents)
However, the first machine will not start up. It just switches from grey....to black..... then grey..... and then black again.... over and over
Why won't it boot from the newly installed OS on it's own hard drive?
And Why won't it boot from the original install dvds?
How can I get it to start up again?

Stuck on moving bar and black screen?

Similar Messages

Maybe you are looking for