Sync data acquisition for Arduino and cDAQ

Question

Hello,
I am using the Labview cDAQ, thermocouple (NI 9214) and digital input (NI 9411) modules, as well as an arduino uno
to read a few signals and do some data processing.  I would like a 0.2-0.5 Hz sampling frequency such that all the data collected is synched to the same timestamp.  I have about 30 thermocouples (2 NI9214 units), 2 TTL signal (approx 1Hz frequency), and the arduino
is acquiring an analog voltage signal.
Any examples or guidance would be appreciated.
Kind Regards,
Anna

Answer 1

Hello Anna,
Just to make sure I understand correctly, you wish you acquire all data (analog, digital, thermocouple) at 0.2-0.5 Hz and have each data point taken along with a timestamp at the same point in time?  In other words, at 0.5 Hz, you will read 30 TC measuremnts, 1 point of each TTL signal, and one point of the analog signal ever 2 seconds, and the associated timestamp for that acquisition?
Since the timing is relatively slow, you would likely be able to do this fairly well in software alone.  The following Community Example...
https://decibel.ni.com/content/docs/DOC-9543
...uses the producer/consumer architecture to collect Analog Waveform data in one loop (you would acquire analog and digital), and then break it out in the consumer loop to write a timestamp (from the waveform) to the first column of a 2D array, and the corresponding data points to the subsequent columns, which you could then write to a file, display in a table, etc.
Regards,
National Instruments