T61 Bluetooth won't pair w/ Wiimote (Wii Remote) with 5.5.0.5800

I'm trying to use a wiimote for a elecronic whitebaord implementation. (wiimoteproject.com). The wiimote doesn't use a passkey to pair. If one is given, it won't pair. I just downloaded the latest BT stack and am now version 5.5.0.5800. However, when you add a device in My Bluetooth Places, it requires a passkey. The previous version of the BT stack ( I believe the version I had before was 5.1.xxx ) didn't require the passkey to pair.
Help.
Solved!
Go to Solution.

Hi.
I could't find the drivers version metioned above.
My case was the same, I always was asked for a key pass for the wii mote.
And when I went to Start->Settings->Control Panel-> Blue Tooth Devices. In the Hardware tab there was nothing.
Using add and remove programs I remove Thinkpad Bluetooth with Enhanced Data Rate Software (It took much time with the progress bar stoped) and after restarting, windows installed automatically its drivers ¿instead of the lenovo ones?.
The fact is that now I can use Start->Settings->Control Panel-> Blue Tooth Devices. In the hardware tab now there is information and using the Devices tab I can add the wii mote, this time it asks you if a pass key is needed.
I hope this was your case too.

Similar Messages

  • How to pair my white apple remote with my macpro?

    this is the kind of mac I have G87151S7UQ2 (I think?)
    its a tower pro, and I'd like to pair my white apple remote with it
    Thank you!

    The Mac Pro does not have a built-in IR receiver. You can however buy a USB IR receiver and use that in conjunction with your Apple Remote.
    See http://twistedmelon.com/mira/hardware.html

  • Im havingtrouble pairing a new apple remote with apple.tv. Any suggestions? Have followed directions so far.

    Im havingtrouble pairing a new apple remote with apple.tv. Any suggestions? Have followed directions so far.

    A classic chicken/egg problem. I see this in the Apple TV manual:
    You can also hold down Menu and Right for 6 seconds to pair Apple TV and the Apple Remote.
    When you successfully pair your Apple Remote, Apple TV displays a chainlink symbol (          ) above a picture of a remote. Apple TV now works only with the paired remote.
    You might have to change your screen name (kidding).

  • HT204387 iphone5 bluetooth won't pair with non apple devices.

    iphone 5 won't pair with non apple devices.

    Not sure what your trying to connect to via bluetooth, but here are the supported files http://support.apple.com/kb/ht3647

  • Bluetooth won't pair (Motorola h700  cell phone headset )

    I have been trying to pair the Motorola H700 headset I use with my cell phone with my new iPod touch.
    It will not pair. Is the headset I use with my cell phone different, or should it be able to pair for use with apps like Skype on my iPod Touch????

    Could you please clarify? I understand your point that bluetooth headsets that are only designed for phone calls won't work with the touch, but don't most bluetooth headsets that play music also handle phone calls. For instance, the samsung bluetooth headset that I use with my Windows mobile Omnia will play music and phone calls and skype and voip calls. And it is my understanding that the touch supports skype and voip.

  • HT204368 bluetooth won't pair with speakers.tried turning phone and and off etc.

    Phone won't recognize speakers, no problem with another phone.tried turning everything on and off. problem developed suddenly

    did that already twice. no pairings listed until I turn on bluetooth device then it just say not paired and pairing not successful. Jambox says it's paired but Iphone says not paired. Plus the ringer problem. When I choose a ring tone or sound it plays but when the I get an incoming call or text it just vibrates. And sometimes Itunes and youtube has no sound. What's going on?

  • Bluetooth won't pair both audio and phone. Car multi-media in range and turned on?

    I have iOS 8.1.3.  Can no longer use both phone and audio- it disconnects one to pair the other and doesn't allow both. Error message says make sure car multi-media is turned on, in range, and ready to use.

    Thanks Peter! I had done  that before multiple times with no success- even turning off bluetooth and the phone in hopes for a reset; I called Apple and my rad service person Shaquita requested I turn off my wireless, reset my network, and try again. That worked and both the audio and the phone paired. Have a great day! Hopefully this helps others with the same issue; but I understand that the bluetooth may kick out again and I may have to repeat this process. Kind regards, Angela

  • IPhone 4 bluetooth won't pairing with my MacBook Pro and Blackberry

    I just bought an iPhone 4 few days ago, but seems I'm having an issue in pairing my iPhone with my Blackberry Bold 9700, and the worst part is I can't even pairing it with my MacBook Pro 13" 2.66GHz Intel Core 2 Duo. All devices has been in "discovery" mode, but my iPhone can't recognize any of those devices. On the other side my MBP and Blackberry recognizing my iPhone, but can not be pairing.
    Anyone could help me on this? I've been trying to search for the answer in the forum but can't find it. I found some subjects regarding iPhone bluetooth issue but can't find the answer of my problem.
    Thanks,

    Just sync, I'm not sure what else it is suppose to be able to do as I am yet to achieve a connection.
    I am assuming it should be able to sync my library, playlists, etc.

  • After IOS7 bluetooth won't pair

    After I updated to IOS7 my iPhone4 will not pair or even find my Plantronics Discovery 975. I tried hard power reset, reset Network settings, turning Bluetooth on and off on device and phone and nothing.
    Tho device worked perfectly before the update!

    Problem pairing headset after upgrade to IOS 7 ?
    I have a Plantronics Voyager Pro and was having similar issues after upgrading to IOS7.
    This is what I did... See if it helps you...
    1. I went to Settings in iPhone and turned "off" bluetooth option
    2. Then I turned off my bluetooth headset
    3. I went to Settings again in iPhone and turn "on" the bluetooth option so that it goes to searching mode
    4. Turned on my headset.
    5. Viola! It showed my Voyager Pro, but when I clicked on it to connect, it failed.
    6. I tapped on the '(i)' next to my bluetooth device within the bluetooth setting on iPhone and did a 'Forget this Device'. I also turned off my Voyager at this point.
    7. Then I turned on the headset until I saw the blue light; and continued to hold down the on/off (power) switch until the blue/red light started flashing. (hard reset)
    8. My iPhone again discovered my Voyager and I tapped on it to connect.
    9. Yippe! all set...
    Basically, holding down the power button on the headset did a hard reset, and starts a search for a new device or new software, in this case it was iOS7. Otherwise the poor headset was searching for its old buddy (iPhone with IOS6).
    Cheers!

  • TS2225 Bluetooth won't pair iPhone with WiTscale

    When trying to pair my WiTscale with my iPhone bluetooth, the bluetooth keeps scanning for device but never finds it. I have tried everything - relaunching the app, turning the phone off and on, repowering the scale - nothing works!

    When trying to pair my WiTscale with my iPhone bluetooth, the bluetooth keeps scanning for device but never finds it. I have tried everything - relaunching the app, turning the phone off and on, repowering the scale - nothing works!

  • Bluetooth won't pair

    hi just got my X yesterday & i've been tring to pair it with my bluetooth its a plantronics explorer 390 it worked fine for my previous phone but its just not connecting to my droid. i figured out how to pair but its not getting detected any ideas.

    Anyone have difficulty pairing their phone with a printer at a photo kiosk? Mine goes into discovery mode, but when I try to pair it asks for a password? Which password? Don't recall setting a password, so this is confusing. Although many kiosks say they are not compatible with some bluetooth enabled devices.

  • Pairing apple remote with MacBook Air

    I want to know how to pair the Apple TV remote with the MacBook Air Late 2010 Model. 

    this is not possible as that model MBA has no IR receiver.

  • I just downloaded the newest IOS software and now my iPhone5 won't pair with the Bluetooth in my car (the car system says it's paired when I try to re-pair it but then when n try to make a call it tells me it doesn't recognize the phone.

    I just downloaded the IOS upgrade, 7.0.2, and now my iPhone 5 won't pair with my Bluetooth in my car, despite repeated attempts to re-pair the two and despite the fact it's been paired fine previously.  The car system tells me it's paired but then when I try to make a call I get another message that says there is no paired phone.

    You can't override it no matter what you do. The device has to connect to the server to complete the iOS update. You could try rebooting the iPad and see if that lets you connect to the server after it starts up.
    Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.
    If that will not work, you can try connecting to iTunes on your computer and see if the activation will complete. Sometimes when thes activation issues arise, you end up having to restore the device again, but first things first. Reboot and see what happens.

  • My ipod touch 4th gen won't pair with bluetooth audio receiver?

    My ipod touch 4th gen won't pair with my aluratech istream universal bluetooth audio receiver.  It automatically paired the first time I used it, but now will not pair.  I removed the bluetooth receiver from the ipod because it kept saying make sure the receiver device is on and within range.  Now it doesn't even detect the bluetooth receiver.  Any ideas?

    Thank you!  We got the bluetooth receiver to use with our car stereo and our motorcycle stereo and were very frustrated when it quit working.  Thank you for helping me solve the problem!

  • IPhone6 won't pair with BlueTooth on MBPro

    IPhone6, iOS 8.1.1 won't pair with BlueTooth on MBPro nor can I use it as Blue Tooth "hands free" device in my car. Blue Tooth is enabled on the phone and on the MBPro.  I try to "connect to network" on the iPhone, using BT preferences on the MBPro, but get the message "can't connect" . On the MBPro, have gone to Sys. Pref., Network, can see the phone but again get the same message when I try to connect.
    On the phone under the green button (which enables) the BlueTooth, I see the word "other devices" and a spinning beach ball as the phone tries to find additional devices but no joy.
    Have Googled the problem, am reading similar issues - people seem to think it was the new iOS 8.0 and 8.1.1 was supposed to be a fix but it isn't.  Any thoughts out there would be much appreciated.

    Great - finally got our iPhones6 "discoverable" on our car. Whew!!!  Thank you so much.
    But, still can't pair our iPHone with my MBPro.  Follwed directions on your link but no joy....<sigh>
    The MBPro does NOT find the iPhone device. Don't know why......
    However, the biggest problem is solved, hopefully.....that being the car/phone connection.
    Appreciate the assistance.
    thx

Maybe you are looking for

  • Genius needs to help! problems with my video card and system

    Hey guys! I'm going to post my specs first so that you get a good idea of what I'm running on: MSI Neo2 LS 865PE.....MAT=Slow Pentium4 2.4C.....FSB=233=2.8C hyperthreading enabled ~>1.55V Corsair TwinX 1gig PC3700.....memory on "AUTO" in BIOS with ti

  • How to un-group columns on my the report and how to add an export to PDF

    Hello OBIEE developers... So, I have this report with about 7 columns, I just submitted to my boss he came back saying "Don't group the columns, the users typically want to see data on each row".... I am not quite sure what in the world he is talkign

  • Third Party Sales order related Purchase requisition Kicking twice one line

    Hi, Purchase requisiotn related with Third Party Scenario kicking Twice one line item, The same line item is appearing one time in Sales Order but when we check Purchase requisition it is showing twice. Example S.O Item 10            QTY             

  • Adobe Reader LE Updates

    Are standard OEM equipped device users entitled to product updates? I'm using Adobe Reader LE 2.5.0.0. but there is no facility in the product to check for updates. Have there been any updates?

  • Standard keyboard is acting weird!

    Just recently my keyboards been acting weird. Most annoying of the problems is when I am pressing delete and it gets to the end of the word and then inserts another word instead of deleting! At first I thought I was knocking letters around the delete