TA21610 Trying to fit screen size when using 42" tv for Mac mini

Trying to fit screen for Samsung tv. The current view is too large. Tried the system preference display options. It remain to large 42" screen with 1080p 60Hz

Do you see a Scaled option next to Resolution: ...?
If so, select Scaled and try choosing the highest Resolution in the list.

Similar Messages

Best LED TV to be used as monitor for Mac Mini (Late 2012 model)

Hi All,
I am having a mac mini (late 2012 model). Now, I am planning to buy a HD LED Tv from my home. So I would like to know which one will be best suited to be used as a monitor for mac mini so that I can buy a TV which will be used as both TV and Monitor
--jR

You'll want something that's 1080p. Best to have one with HDMI input, too. Other than that, let price and warranty be your guide.

No Sound when using Digital out with Mac Mini

The Digital out on my mac mini has become seriously unreliable. The sound slider is all the way up but locked, no movement is possible. The Toslink cable shows light, and when plugged into another device the amplifier receives sound.
This is an intermittent problem, for awhile rebooting would make the sound come back, however this has stopped working.
unplug the toslink and the built in speaker plays fine. Sound slider becomes movable.
If you sent the sound slider to 50% then plug the toslink back in it jumps to 100% and all controls ar grayed out and 0 sound.
any troubleshooting tips would be most appreciated as this is my primary audio video device.

Not likely. Think about this: The output is simply a digital stream of bits. Volume does not apply to digital bits... The first place where you can adjust volume will be in an outboard DAC, a preamp or an integrated receiver.
For a great DAC, check out ps audio "digital link III", retails currently for around $695, B stock may be avail for around 550. There is a cheaper quality DAC available from Cambridge Audio "Digital Magic", but it is not in the same league as the PS Audio or other higher cost DACs (such as Benchmark Media's DAC1).
For a fantastic audio system that takes digital audio from a Mac Mini, I have a PS Audio DL III taking Toslink from the Mini and feeding RCA analog into a Zpre from Parasound with a couple of Zamp (zone amps) from Parasound going into very nice bookshelf speakers and in ceiling speakers.
The volume is controlled by the Zpre amp ...As it must be

Very low signal strength when using DLINK 2640t with mac mini

i have a mac mini and i have been using it fine with a 2wire wireless modem. However i have just switched to a Dlink 2640t (54Mbps (802.11g) Wireless ADSL 2/2+ Router with Built-in Modem, 4-port 10/100Mbps Switch) and have been getting very low signal strengths on my mac mini, resulting in me not being able to surf the internet. The modem+ router is located in the next room. Does anyone know whether its the problem with the modem router or mac mini's airport wireless problems with the router itself. It worked perfectly fine with my previous 2wire wireless modem
please help!

Did you reset the router after you updated router's firmware? Its always recommended to perform a reset after firmware upgrade on the router.
Please refer to the link http://www6.nohold.net/Cisco2/ukp.aspx?vw=1&docid=eaa3127db5f4402584c959a7251e754c_4008.xml&pid=80&r...
For wireless range and signal issues, try changing the channel on the router to either 1,6,9 or 11.
Please refer to this link on changing wireless channel and SSID (network name)
http://www6.nohold.net/Cisco2/ukp.aspx?vw=1&docid=a0fb6c64337e47eb9e3e1027f364e70c_154.xml&pid=80&re...

IPhoto 6 Unable to Zoom in Full Screen Mode when using projector

When in full screen mode in iPhoto 6 I am able to zoom quite nicely but when I attach a projector I lose the slide for zooming. How do I zoom in full screen mode when using a projector?
Mac Book Mac OS X (10.4.9)

ParkerT
Given that the zoom works normally, this is not an iPhoto issue. The problem lies in the interaction between your MacBook and the Projector. You might have more luck posting on the MacBook forum
Regards
TD

Will pages automatically reformat to correct size when using Folio Builder or do I have to make pages iPad format, for example, in InDesign document set up from the start?

Will pages automatically reformat to correct size when using Folio Builder or do I have to make pages iPad format, for example, in InDesign document set up from the start?

Moved to DPS forum.
You need to set up the pages appropriately for the target device. For iPad that's 1024x768.

How do I get the contact photo to full screen size when receiving a call after iOs 7.1 update..?

how do Iget the contact photo to full screen size when receiving a call after iOs 7.1 update..?

I went to the link. I selected iPHONE. There was a big iPhone icon above the comment box -- so I was absolutely, positively on the right page. I spent five minutes or so crafting a constructive comment as to why I wanted the full photo feature back on incoming calls on iOS7. Then...i noticed the box below the comment area asked 'What operating system are you on?'. And the drop down selection list included every operating system since Job's garage days -- but not one single iOS entry. No iOS entries on an iphone page. Unless I'm missing something, I think anyone writing a feedback comment is wasting his/her time.

How do Iget the contact photo to full screen size when recieving a call

How do i get the contact photo to full screen size when recieving a call on my Iphone 4

Meg St._Clair wrote:
To the best of my knowledge, that's not a feature of the iPhone.
Actually, its always been a feature.

Not being able to hear application audio on quicktime screen recording when using headset

Can someone tell me how to still hear the computer audio (like the application sound) on while using quicktime screen recording when using headset?
Someone help me please or tell me another application to do this with.

hi paula
your problem could be hardware/software. lets hope its software issue first and i'd like you to do these:
if you have personal files on volume c, copy/backup them. shut down your computer, press one key recover button to perform clean windows installation. then check if the issue still persists.
if you don,t want to use okr, you can use windows restore to restore your computer to previous restore points but if it's windows/virus issue, it may not help.

HOW TO KEEP SCREEN ON WHEN USING GPS OR SHOOTING THE VIDEO

I was wondering if there any setting I could leave the screen on when using GPS or shooting the video, I'm currently set backlight timeout is 2 mins. After 2 mins device will automatically out and I have to reenter the password for continue my video, This is very inconvenience when using GPS or shooting the video.
Is there any one out there can assist? thanks in advance.

Did you get an answer?

Our ipad 1 goes to a black screen periodically when using the internet.

Our iPad 1 goes to a black screen periodically when using the internet. We have to hit the home button and hope we end up back at the site we were previously at. We have updated the iPad, but it still happens. Any suggestions on a solution?

Try This...
Close All Open Apps... Sign Out of your Account... Perform a Reset... Try again...
Reset ( No Data will be Lost )
Press and Hold the Sleep/Wake Button and the Home Button at the Same Time...
Wait for the Apple logo to Appear...
Usually takes about 15 - 20 Seconds... ( But can take Longer...)
Release the Buttons...

[svn:fx-trunk] 10891: Fix for ASDoc throws error when using getter methods for pseudo-inheritance of static constants

Revision: 10891
Author:   [email protected]
Date:     2009-10-06 09:46:47 -0700 (Tue, 06 Oct 2009)
Log Message:
Fix for ASDoc throws error when using getter methods for pseudo-inheritance of static constants
QE notes: None.
Doc notes: None
Bugs: SDK-22676
Tests run: checkintests
Is noteworthy for integration: No
Ticket Links:
    http://bugs.adobe.com/jira/browse/SDK-22676
Modified Paths:
    flex/sdk/trunk/modules/compiler/src/java/flex2/compiler/asdoc/AsDocUtil.java

Have you tried using com.adobe.air.crypto.EncryptionKeyGenerator instead?

I only see the phone numbers of my contacts when using iMessage on my MAC, whereas I see the names on my iPhone. Why, and how can I make it so I see the names (and pics) on my MAC?

I only see the phone numbers of my contacts when using iMessage on my MAC, whereas I see the names on my iPhone. Why, and how can I make it so I see the names (and pics) on my MAC?

Thanks Eric, but that was already turned on. I just now tried turning it off and on again, no change. Actually, I"m more interested in seeing the names than the pictures. I now only see the phone numbers and generic avatars where pics would be.

When using Back to my Mac can I use a local printer to print from the remote Mac?

When using Back to my Mac to access an iMac from a MacBookPro all with the latest OS updates may I use a local printer connected to the MacBook to print a document located on the iMac? If so, how? It looks like if I try to print it will all happen on the iMac. Thanks.

PeterFazio wrote:
The problem is that when in screen sharing mode the print command is executed on the remote computer.
I appreciate that, but it will still list the printer in your local location if things are set up properly and if it is you can print, if it isn't you can't, but you should be able to print it as a pdf, transfer the file to your local computer and print it from their.

Our iMac (intel, 11.2) freezes up when using Time Machine for Back Ups. We have 16GB of RAM and the BU drive is 1 TB on firewire.

Our iMac (intel, 11.2) freezes up when using Time Machine for Back Ups. We have 16GB of RAM and the BU drive is 1 TB on firewire.

See Pondini's TM FAQs for starters.

TA21610 Trying to fit screen size when using 42" tv for Mac mini

Similar Messages

Maybe you are looking for