The sys light blinks red and the GPS light is solid red even though the antenna is at a window. Wan light is blue.

My extender work fine for the last 8 months but now the system light just blinks red and the GPS is solid red even though the antenna is next to a window?

See the Network Extenders User Guide:
http://www.verizonwireless.com/support/pdf/network_extender_user_manual.pdf
There is a page dedicated to the light codes this device will display along with instructions on how to handle each situation.

Similar Messages

Messages only alert when received 1/4 of the time and do not appear in lock screen even though the ability to see them is turned on

I'm not notified at all 3/4 of the time that I have received a text message. How do I fix this?

Hey M0904,
I found the following information regarding troubleshooting notifications, I'd run through them and see if they resolve the issue:
iOS: Understanding Notifications
http://support.apple.com/kb/ht3576
Troubleshooting notifications
Push notifications require an active Wi-Fi or cellular connection. If you are not receiving notifications for a specific app, try these steps:
Verify that the app supports notifications.
After installing an app or restoring a backup to a different iOS device, open the app at least once to begin receiving notifications.
If the app requires entering or logging in to an account, you will need to do this before receiving notifications.
Check Settings > Notifications to ensure that the app is configured for notifications.
If notifications do not appear only in the Notification Center, verify that the Notification Center setting for the app is enabled.
If you are still unable to receive notifications and you are using a Wi-Fi connection, verify that the network or firewall is not blocking access to port 5223.
Have a good one,
David

HT3500 I am trying to hook up my new Canon MG5320 printer wirelessly to my MacBookPro with OSX.8.2. The Airport Extreme Base Station does not have a WPS button and so I seem to be stymied even though the printer detects the Airport Extreme. Suggestions?

I am trying to set up my new Canon MG5320 printer to my wireless network. However, there is no button on the Airport Extreme to push when I get to that step in the set-up directions. I am using OSX.8.2. Suggestions please!

If the display shows the "Press and hold the WPS button..." message on the MG display, press the red Stop button on the MG and then select Standard Setup. The MG will search for networks and should display your Airport Extreme's network name. Select this and then enter the password to connect to this network.

My Windows 8 laptop keeps downloading and installing iTunes 10.2.1.1 even though the latest version is 11.0.3

Hi everyone, I'm having a really annoying problem in installing iTunes 11.0.3. I use a Dell laptop with windows 8 installed. I tried to download iTunes 11.0.3 for Windows 64 bit on apple.com. The size is actually 85Mb, but my downloads keep downloading the 77.5Mb version. So when I installed it turns out to be iTunes 10.2.1.1, the problem is iTunes 10.2.1.1 can't even recognize my iPad and I can't sync anything to it right now. Please help me because this problem is really getting on my nerves. Thank you

I tried the back-up and restore option tonight and it worked a charm.
Not sure why I had the problem in the first place but that was a relatively quick and easy fix :-)
Just do the Factory restore...
Works like magic!

The menues are not appearing for me to work on a photo, even though the program has downloaded?

The meues are not visable on the photoshop window to work on a photo. I downloaded a bunch of photos to work on but all I can do is archive or rename. How do I get to edit them? Where are the menues? I downloaded the program and it is open.

Most menus will be greyed out until you have an image open, but you can do that via the file menu, or using Ctrl o (Cmd o). Does that work?

My phone is not notifying me of a call or text even though the sound is on - help - I am missing so many calls and texts

Help my i phone has stopped ringing and my texts do not alert me, even though the alert sounds are on and everything is on!!!!!

Make sure you do not have "Do Not Disturb" enabled. If you see a cresent moon icon up near the battery meter, then you have turned DND on, just turn it back off.

Multiple PR's being created even though the Lot Sizing procedure is WB.

The issue is system is creating more than one PR every week even though the lot sizing procedure is WB. The MRP type of the material is P3 and planning time fence is 21 days. The PR's created have the date of every week's Monday. There's also a quota arrangement for the material having two vendors, so two PR's both having different vendors are ok but system is creating multiple PR's for same vendor on same date.
Do let me know if anything else you want to know to understand this issue.
We want system to create only one PR per week for a vendor.
Thanks,
Rakesh.

Hi,
First thing theres a lot size WB
What is the qty of the PR have u maintianined any min lot sice or max lot size.
Coming to quota arrangement how did u maintained it
For eg
You might have maintained for a vendor 1 maximum qty as 100 and u have raised a request for 200 so it is raising two prs
Check u r quota arrangement once
Reagrds
sravanthi

Just received a license renewal even though the product is free?

We have just received the following email and I wonder why? The Adobe help desk can't help but as it states the license is about to run out I'm a little concerned even though the products are free. Any help on this will be much appreciated.
Dear IT
We are contacting you because you applied for and received a license to redistribute the following Adobe Software on Apr **, 2014.
Adobe AIR
Adobe Flash
Adobe Reader
Adobe Shockwave
Your current license will expire on Apr **, 2015. To continue to distribute Adobe Software, you must reapply for a new license before the expiration date.
To reapply for a new license, please fill out the form located here:
https://www.adobe.com/cfusion/mmform/index.cfm?name=distribution_form&pv=fp
Please select all products in the form that you wish to renew.
Thank you

Hi simon604596,
Please see this page: Volume distribution | Adobe Reader XI.
The distribution license isn't necessary if you're using those products for personal use. But, it is if you're distributing them for use beyond a personal installation (for example, if you're distributing via the intranet at your company).
Please let us know if you have additional questions.
Best,
Sara

My ipod shuffle 1st generation won't restore. There is an error that reads "The ipod cannot be restored. An unknown error has ocurred (1442)". The lights blink orange and green simultaneously...and it just won't restore. help?

So it's the little thin ipod with no screen...that has the usb thing and the landyard. Whenever I try restoring it it tries to restore and then a message pops up. There is an error that reads "The ipod cannot be restored. An unknown error has ocurred (1442)". The lights blink orange and green simultaneously...and it just won't restore. help?. I have literally tried restoring it like 10 times and nothing happens. When i connect headphones it does not hear and that little light think happens....which i had never seen happen before. I need to fix it. ....please help....if i take it to an apple store....will it cost alot to fix that?

reset utility should help...for mac
http://www.apple.com/support/downloads/ipodresetutility103formac.html
for windows
http://www.apple.com/support/downloads/ipodresetutility104forwindows.html

Even though the battery in my Macbook late 2008 shows 995 charged the power adapter light continues to glow red. What do I need to do? s/w fully uptodate, plenty of ram and hd space.

Even though the battery inb my Macbook late 2008 shows 99% chrged the indicator glows red(amber?) What do I need to do? s/w is up to date. Plenty of RAM and HD. s/n W8*******1AX
TIA
<Edited by Host>

Might be the adapter > Apple Portables: Troubleshooting MagSafe adapters

I just bought a new Motorola modem. Do I need to reconfigure my Airport Express? For some reason we have WiFi even though the amber light is blinking.

I just bought a new Motorola modem. Do I need to reconfigure my Airport Express? For some reason we have WiFi even though the amber light is blinking.

Typically, when changing out networking hardware, it is always a good idea to perform a complete power reset of all of your networking equipment.
I would recommend that you do the following as a minimum:
Power-down the modem, AirPort base station, and computer(s).
Power-up the modem; wait at least 10-15 minutes to allow it adequate time to initialize.
Power-up the AirPort base station; wait at least 5-10 minutes. Note: The AirPort's status light may continue to flash amber after it has intialized. That is because, there may be some additional configuration items necessary, like setting up wireless security, before the overall setup is completed to get a green status.
Power-up your computer(s).
If the above steps do not solve the problem, start over with step 1 above, but then perform the next steps between steps 1 & 2. above.
Disconnect the AirPort base station from the Internet broadband modem.
While all of the devices are powered-down, perform a "factory default" reset on the base station. This will get it back to its "out-of-the-box" configuration and make setting it up much easier, especially if you use the "Assist me" process within the AirPort Utility. (ref: Resetting an AirPort Base Station or Time Capsule)
After the base station resets, go ahead and power it back down.
Reconnect the AirPort base station to the Internet broadband modem. For the Extreme and Time Capsule, be sure to connect the cable to the base station's WAN (circle-of-dots) port.
Continue with step 2 in the first set of steps.
In this basic configuration, the AirPort base station will broadcast an unsecured wireless network with a Network Name (SSID) of Apple Network NNNNNN. Network clients, connected to the base station either by wire or wireless, should now be able to access the Internet through the ISP's modem. Once Internet connectivity has been verified, you can use the AirPort Utility to configure the base station for wireless security and any other desired options. Please post back your results.

When I have headphones plugged into my iphone it says warning'' high volume'' and becomes first a red and then plop a number of red pops but it will not be so for someone else I know. My sound will be much lower than anyone else in the music, and when I t

When I have headphones plugged into my iphone it says warning'' high volume'' and becomes first a red and then plop a number of red pops but it will not be so for someone else I know. My sound will be much lower than anyone else in the music, and when I talk by phone headset

Hi! I have the same problem when I use my headphones .
iPhone 4s England, iOS 6.1.2

Hi, this is amit from india. just started using iphone 4s. i am observing that when an incoming call comes, the phone smtimes shows two virtual buttons of red and green color so as to attend or reject the call. but smtimes it just shows green button. why?

Hi, this is amit from india. just started using iphone 4s. i am observing that when an incoming call comes, the phone smtimes shows two virtual buttons of red and green color so as to attend or reject the call. but smtimes it just shows green button with a slider to attend the call and there is no red button to reject the call. is it a bug or some setting?

Because it behaves differently depending on whether the phone is locked (in standby) or unlocked (in use) when the call comes in.

How do I tell Apple to fix their software like apps that play sound even though the sound is turned off and not being able to disable features you hate like game center

Apple is suppose to be the pinnacle of usability and, yet, I want to throw my new IPhone 4s as far as I can and watch is smash into a million pieces on concrete. Seriously, I've already got three things that irritate the **** out of me. First, there are Apple apps that insist on playing sound even though the sound is turned off. If I flick a switch to turn the sound off, I want the sound off!!!! Second, if I do not want a totally unnecessary feature like Game Center, I should be able to disable it. I completed most of the Angry Bird levels with 2 or 3 stars and now I have to start over from square one. Maybe, this happened when I upgraded to the 4s but it sure seemed to happen when I joined Game Center. Tomorrow, I am going to reset my 4s to factory defaults to try to get rid of my Game Center account. I don't want Game Center! I do need Game Center! I hate Game Center! Finally, I had an alarm go off to wake me up and there was a Snooze button but no button to turn the alarm off. I flicked the slider to access the main screen expecting to see something to turn the alarm off but there was nothing. The alarm just kept alarming. I had to warm boot my IPhone to shut the alarm off! Really, Apple!!!!

The sound is turned off. Only, some Apple apps like YouTube and Siri make sound when the sound is turned off. It is very embarrassing when this happens at work. My question was how do I tell Apple to fix this?
Turning off game center does not work. The games just prompt me to sign in when they are started.I have tried everything I can find online to stop this behavior. It is annoying and should not happen. My question was how do I tell Apple to fix this?
The alarm went off. There was a green thing that looked like a button but pressing it did nothing. There was a red button that said snooze. I did not want to snooze. I wanted to turn the alarm off. I slid the bar to unlock the phone and there were no running apps with a button to press. The alarm just keep running. I have not had this problem since it first occurred. The alarm now shuts off when I just unlock the phone. It may have happened because I had another alarm app running. The two may have interfered with each other. I would like to tell Apple about it.
It also annoys me that the button that closes apps leaves the phone app running. If I press on a number at 6:00 AM to get information about who called me, the phone automatically dials the person back and my natural reaction is to press on the button to close the phone app but the phone keeps dialing this person at 6:00 AM. It is a bad design. I would like to tell Apple about it.
Finally, I looked all over Apple's site to try to find someplace I could send them a polite message to let them know that I was not happy with these "features" but could not find anything. It is extremely frustrating to have issues with a product and not being able to tell the manufacturer about it. So, you grow up!.
When trying to fix the Game Center issue, I saw a link someone posted to report issues with the IPad to Apple. The answer I am looking for is where is the link to report issues with the IPhone.

I'm having trouble downloading an update to my MacBook Pro. It comes up with my husband's name even though the MacBook is registered under my name and I have my own ITunes acct. how do I get his name off the ITunes update on my Mac

I'm trying to download an automatic update from ITunes but when I click on "Update" it comes up with the message, "You have updates available for other accounts" an tells me to sign in to my husband's account, even though the MacBook is registered in my name and I have my own ITunes account. My husband has his own MacBook and ITunes acct. How do I fix?

Anything Downloaded with a Particular Apple ID is tied to that Apple ID and Cannot be Merged or Transferred to a Different Apple ID.
Apple ID FAQs
http://support.apple.com/kb/HE37

The sys light blinks red and the GPS light is solid red even though the antenna is at a window. Wan light is blue.

Similar Messages

Maybe you are looking for