The volume of the iphone4 receiver is very low outside.

When I need to talk with someone, i need to find very very quite place without any noise. two or three person's voise are enough to stop the communication between I and other end of the phone. So, usually, I am not pick the phone outside. I don't know why, but I want to clerify,my hearing are very sensitive,and young. I think what wrong with my phone.

Honestly, I cannot remember how loud the lock sound was before I updated to iOS 6 since I updated weeks ago. But the volume on my lock sound seems to be the same as it was before I updated.
Have you tried rebooting your iPad? You could also try resetting all of your settings and see if that makes a difference.
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons.
You can try resetting all settings. Settings>General>Reset>Reset All Settings. You will have to enter all of your device settings again.... All of the settings in the settings app will have to be re-entered.

Similar Messages

I have a mid-2009 MBP and I've been using my BOSE Companion 20 with it for about half a year now. It was fine until recently, when i want to adjust the volume using the pod on the BOSE Companion 20, it will cause like a surge in volume, spiking it up

I have a mid-2009 MBP and I've been using my BOSE Companion 20 with it for about half a year now. It was fine until recently, when i want to adjust the volume using the pod on the BOSE Companion 20, it will cause like a surge in volume, spiking it up and down. It will not stablise itself! It's very fustrating. Anybody with the same issue?

I have the BOSE Companion 5 speakers and have had the same problem. I've searched everywhere and gotten nowhere. My speakers are way past their warranty, so calling Bose would probably get me no where either. Only thing I can think of is that the speakers overheat which causes the spikes in the volume. I've tried unplugging them for a few minutes and then plug them back on. The problem does go away, but after about 5 minutes, same problem.

How do you lower the volume on the dictation beep sound?

Hi there,
I like using the new iPad's built in dictation feature. But when I use it, I find that the alert beep it makes when you start and stop is quite loud, and I don't know how to turn the volume down. All of the other sounds on the my iPad are turned down.
Thanks!

I've tried this, but it doesn't work. Does anyone not notice the disparity in the volume of the dictation beep and all other alert sounds on your iPad? It's a loud beep. I have my alert sounds turned right down (still audible, but very low.)
(But thanks Diavonex!)

How do you control the volume to the earphones?

How do you control the volume to the earphones?

Apple Support Communities updatesActually I knew that part of it, but I had to go to Settings to correct something. They are working now that I fixed something that I have no recollection that I altered in the first place, nor do I now know what in heaven’s name I fixed this time. All I know is that I must have gone to setting a million and one times and the last time was the one I did something right.
Thank you for your help however.
Nan
From: Apple Support Communities Updates
Sent: Monday, July 07, 2014 10:43 PM
To: nandave
Subject: - How do you control the volume to the earphones?
                                                                                You received a reply
                                petermac87 has replied to your question. You can view the full discussion in Apple Support Communities.
How do you control the volume to the earphones?
                                With the volume up and down keys unless you purchase a set with a volume control connected to the chord.
                                Pete
                                                                                Correct Answer Helpful Answer
                              Use the buttons above to tell petermac87 and the rest of the community if this reply solved your question or helped you get closer to finding a solution.
                              To reply to petermac87, go to the discussion in Apple Support Communities.
                              You are receiving this email from Apple Support Communities. You can change your email preferences in your Apple Support Communities Profile.
                              TM and copyright © 2014 Apple Inc. 1 Infinite Loop, MS 96-DM. Cupertino, CA 95014.
                              All Rights Reserved | Privacy Policy | Terms of Use | Apple Support

I have iphone 4s 32GB ,the volume of the ringer and alerts can't be adjusted using the volume buttons and lock sounds and keyboard clicks available, but all not appear ??!!!!!!!

I have iphone 4s 32GB ,the volume of the ringer and alerts can't be adjusted using the volume buttons and lock sounds and keyboard clicks available, but all not appear ??!!!!!!!

Hi nitramred,
To start troubleshooting this issue where you are unable to adjust the volume after receiving a call, please go ahead and first force close all of the apps currently running on the device, and then reset it by following the steps in the articles below.
iOS: Force an app to close
Turn your iOS device off and on (restart) and reset
Take care,
Alex H.

One of the volumes on the media is still in use.

I cannot burn from DSP4. I can burn the very same content with Toast just fine so it's not the build thats an issue. I see this question in the archives but so far no answers. Anyone?
G5 for the moment Dual core 2.66 soon Mac OS X (10.4.9)

Hi:
Check in this Search if you find something:
http://discussions.apple.com/search.jspa?objID=f952&search=Go&q=Oneof+the+volumes+on+the+media+is+still+inuse
Hope that helps !
Alberto

Is it safe to turn the Volume all the way up?

hi, is it safe to turn the volume all the way up on Itunes, and have my IMAC volume all the way up as well?
The thing is, I never noticed any distortion coming from the speakers on my computer until I recently imported a smashing pumpkins song. And well, for some reason i can hear a slight "rumble" Distortion on the bass end of things.
I thought maybe its just the way it was recorded, you know with distortion, lol.
But , ive also noticed it on a Sigur ros song as well.
On any of these songs if you turn the volume very , very low and listen carefully you can still hear the distortion.
So I might have answered my own question regerding the distortion, but then again
what about turning the volume completetly up on an imac.
Is it under warrnaty , if im just playing mp3s thru itunes oon my internal speakers?

If you only hear the odd sound on a couple of songs, I doubt your speakers are damaged.
Songs are recorded in different ways. Some have distortion purposely. By playing these types of recordings too loudly, I would imagine it would be bad on your speakers.
Common sense dictates if turning it up sounds bad or seems to be stressing the speakers, it shouldn't be played that loud. The range of the volume control is there to compensate for different recording levels, not only to show you how far you can turn the knob.

My ipod has a white screen and i cant do nothing i click on the home the volume and the lock botton but nothing work what do i do

my ipod has a white screen and i cant do nothing i click on the home the volume and the lock botton but nothing work what do i do

Let the battery fully drain. After charging for an hour try:
- A reset.
Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Connect to computer and try to retore.
- If the screen remains white and you can't trun it off then it is time for an appointment at the Genius Bar of an Apple store. You very likely have a hardware problem.

My ipod 5th gen won't change volume when headphones are plugged in, but when they are not I can change the volume on the speaker. How do I fix this?

My ipod 5th gen won't let me adjust volume when headphones are plugged in, but when they are not I can adjust the volume on the speaker. How do I fix this?

Try a hard reset of the Nano. To do this, press and hold both the Select (Center) and Menu buttons together long enough for the Apple logo to appear.
I assume you have double checked to make sure you are plugging the headset all the way in meaning the white part of the headset is flush with the body of the Nano?
B-rock

We are recording 2 voices over an instrumental track. Every time there is a rest in the vocal part the volume of the instrumental track noticeable increases. Is this fixable? We are using Alesis multi mix 8 with 2 microphones.

We are recording 2 voices over an instrumental track. Every time there is a rest in the vocal part the volume of the instrumental track noticeable increases. Is this fixable? We are using Alesis multi mix 8 with 2 microphones.

Badger33rk wrote:
Every time there is a rest in the vocal part the volume of the instrumental track noticeable increases.
turn the Ducking menuItem off

How to find out the volume of the data updated in the custom table

Hi,
I need to find out the the volume of the data inserted or updated in the the custom table(Y tables).I have tried by the sm37.the job running in to update the table but i didnot get thde amount of the data.and if get the volume of the data which being updated in the custom table is there any option to control that amount to being updated?
Thanks in advance .....waiting for the respone.

Hi Sreenivas.
How did you find the solution to this? Trying to do the same thing!
Cheers,
Tom

I recently upgraded my MacBook from 10.5.8 to 10.6.8 Snow Leopard. Now when I create a song in Garage Band 2008, I cannot save the volume adjustment when I share back to iTunes and ultimately upload to YouTube. The volume reverts back to a default? low l

I recently upgraded my MacBook from 10.5.8 to 10.6.8 Snow Leopard. Now when I create a song in Garage Band 2008, I cannot save the volume adjustment when I share back to iTunes, which is now version 11.1.1, and ultimately upload to YouTube. The volume reverts back to a default? low level. How can I retain the volume I assign in Garage Band, so that when the song moves to iTunes it doesn't revert?

I recently upgraded my MacBook from 10.5.8 to 10.6.8 Snow Leopard. Now when I create a song in Garage Band 2008, I cannot save the volume adjustment when I share back to iTunes, which is now version 11.1.1, and ultimately upload to YouTube. The volume reverts back to a default? low level. How can I retain the volume I assign in Garage Band, so that when the song moves to iTunes it doesn't revert?

The volume on the second half of my Quicktime slideshow fades out--and I don't want it to do that!

I used FotoMagico 4.0 to make a slideshow. There are options for exporting, and I chose the one called Custom, which makes a Quicktime movie. For some reason the volume in the second half of the show starts to fade out, and by the end I can barely hear anything. If I export to their Standalone Player, which allows the slideshow to play on a Mac computer, everything works just fine. I'm at my wits end trying to figure out how to fix this. I want to be able to export the slideshow to Vimeo so that people on Macs and Pc's can both watch it, but I can't do it with the volume the way it is.

Go to System Preferences. Then under the General tab, there is a tick box saying "Restore windows when quitting and re-opening apps." Un tick that box. Once you start and quit Safari again, it will go back to your home page.

My Ipod, keeps on saying very low battery then restarting. then turning bright with the apple logo and going back to very low battery again.

My Ipod, keeps on saying very low battery then restarting.Then turning bright with the apple logo and going back to very low battery again. HELP PLEASE.. I have plugged it in for 2 hours now.

If you are trying to charge from your computer, try a different USB port, or try charging from a wall outlet.
And try here. Troubleshooting iPhone hardware
Powering Apple and third party peripherals through USB

Why is the volume on my MacBook Pro suddenly so low?

The volume on my macbook pro is really low. It used to be much better, now I can hardly hear people when on skype or listening to music... everything is set on high volume... help!?!

Try:
Reboot into Safe Mode then reboot normally. Safe mode takes longer to boot than booting regularly. That is normal.
Intel-based Macs: Resetting the System Management Controller (SMC)
Resetting your Mac's PRAM and NVRAM
Open Activity Monitor in the Utilities folder. Select All Processes from the Processes dropdown menu. Click twice on the CPU% column header to display in descending order. If you find a process using a large amount of CPU time (>=70,) then select the process and click on the Quit icon in the toolbar. Click on the Force Quit button to kill the process. See if that helps. Be sure to note the name of the runaway process so you can track down the cause of the problem.

The volume of the iphone4 receiver is very low outside.

Similar Messages

Maybe you are looking for