Third-Party earphones.

I have a great pair of third-party earphones for my ipod--the Shure E2G. Unfortunately, they don't work with my new iphone. Any suggestions for good-quality in-ear earphones that have the right plug for the iphone?

Just get a Shure Music Phone Adaptor... I did and works great!
http://store.apple.com/1-800-MY-APPLE/WebObjects/AppleStore.woa/wa/RSLID?mco=CDC 2673B&fnode=home/shopiphone/iphoneaccessories&nplm=TN544LL/A
Message was edited by: Mk Gonda

Similar Messages

FM Radio and Third Party Earphones

I was going to get third party earphones, but before I did that, I wanted to know if they would work with the FM radio as the earphones are used as the antenna?

Shouldn't be a problem, I don't think the Apple earphones are specially designed for this. I use Bose earbuds with my Nano and the radio works fine.

Can't use third-party earphones

Does anyone have problems using a third-party earphone? I tried using my Bose earphones and Sony earphones which are supposed to work with the I-Phone, but no luck. The earphones that came with the I-Phone works.

you most likely need the adapter.
here is a link: http://store.apple.com/1-800-MY-APPLE/WebObjects/AppleStore.woa/wa/RSLID?mco=3DB 4EB78&fnode=home/shopiphone/iphone_accessories/cablesdocks&nplm=TN546LL/A
there is apples to but there's is $20: http://store.apple.com/1-800-MY-APPLE/WebObjects/AppleStore.woa/wa/RSLID?mco=B19 14140&fnode=home/shopiphone/iphone_accessories/cablesdocks&nplm=MA854LL/A
Message was edited by: edden amber

A problem with volume control on a third party earphones

I have an old iPhone 4 that I use mosly for music and I recently bought a new pair of headphones (Bidenuo G380) and there is a problem with the buttons on it.
Whenever I press any of the buttons while music is playing on my iphone, the volume goes up by about two steps for a few seconds and goes back down again.
However that's not it. There is also a microphone on there and any loud noise or just touching it triggers the volume going up. It is especially annoying when I'm in a loud environment.
I tested these earphones om my mother's iPhone 5 ant they seem to be working perfectly, which means it's a problem with my iPhone 4. I have read a few other topics and although I didn't find anyone with the same problem, I found that cleaning the 3.5mm port on my iphone could fix it.
If it would, I'd be much appreciated if you could tell me exacly how to clean it. I was thinking if it's ok to use a little bit of alkohol and would it damage anything?
If there's another solution to this, please share it with me. Thank you for all your answers in advance.

Here is an article on how to clean a headphone jack:
http://www.instructables.com/id/How-to-Clean-a-18-3.5mm-Headphone-Jack/
Use at your own risk!

Third party earphones from Apple Retail Store - Warranty?

Hi guys,
I purchased some RHA 450i earphones on the 30th of December last year and have been very pleased with the sound and comfort. Unfortunately the first pair were DOA - Apple retail exchanged them as soon as I could get back there. The next pair have been working well, but the fabric sheath on the cable has fallen apart, as has the strain-relief at the jack. I thought I'd check out warranty before I went to work with some thick heat-shrink. Apple Retail said 'Yep, should be covered, but you do it through RHA's Australian Distributor' and showed me the warranty form on the distributors website. Interdyn (the distrib.) got back to me pretty quickly, but say that they don't deal with products sold through Apple - I must go to Apple.
What do you think?
1. Apple
2. RHA/Interdyn
3. Chunky heatshrink
Thanks

review your Country's Consumer laws , someone is responsible ,they all cannot play "pass the parcel "

IOS 6.0.2 update and third party earbuds

My Tour earphones from beats by dre won't work with the Music app on iPhone 5 after I updated to iOS 6.0.2.
They work fine during phone calls. The originals that came with the iPhone works fine with Music and phone calls.
Has anyone experienced this? Are there any fix?
Regards
Greenfee

Unless Apple replaced your battery, and it appears they didn't, you're pretty much on your own now. Have you tried going back to whoever replaced your battery? That's gonna be your only choice now, because if a third-party replaced your battery, Apple won't touch your phone now.

Do third party replacement tips fit on the apple in ear headphones? I prefer foam tips as they block out much more sound, but I'm not sure if Apple use the standard fitting for headphone tips!?!?!?!

Do third party replacement tips fit on the apple in ear headphones? I prefer foam tips as they block out much more sound, but I'm not sure if Apple use the standard fitting for headphone tips!?!?!?!

Answer found. Please find below an amazon review explicitly mentioning adding third party foam tips. Sounds like they fit and work like a dream:
"As a audio engineer, I own about a dozen different sets of earphones and in-ear 'phones. My favorite, by far, are my sure SE530s. I have some Sennheiser cx400s which are good workhorses, but lack the finesse, clarity and stunning accuracy of the Shures. For convenience, I bought the Apple's, as I wanted something I could use with the phone for calls.
I found the sound to be quite clear and beautifully clean, but like many, no matter how I tried, the stock Apple tips never made a good seal. The seal is absolutely essential to getting bass out of a balanced armature design. For you non-engineers, just trust me that if you don't have a proper seal, you will have no bass.
In my case, I think the trouble had to do with the largest size being a tiny bit too small, and the silicon being too rigid, yet slick, so they left small airgaps and were easy to remove. I tried using some foam tips from a third party, but their large was more of a medium, and never came close to a snug fit.
As an experiment, I dug around in my ear-tips from my Shure's and tried their rubber tips which are about the same size as Apple's large tips, but made of a more pliant and slightly sticky rubber.
OMG, what a transformation. Suddenly the sound blossomed, the bass became rich and well balanced, and the "top-heavy" sound was totally mellowed into a rich, well balanced and incredibly detailed presentation.
Make no mistake, these are the best 'phones under $200 I have ever heard. The bass is deep and warm, very detailed, and totally lacking fuzz or buzz that I can hear in the Sennheiser set. Look at getting tips from a better headphone. The trick is it has to have a soft rubber base that can expand over Apple's slightly larger stub. Some tips, like the Shure foam tips, have a rigid plastic sleave in the tip to keep it's position correct, and these won't expand over the larger Apple posts."

My wireless earbuds work just fine, but some third-party apps play audio only through the iPod speaker even though the buds are properly connected.

My wireless earbuds work just fine, but some third-party apps play audio only through the iPod and iPhone speaker even though the buds are properly connected. Does anyone know why and is there a solution?

Assuming you are using Bluetooth headphones, do the apps have the option to use Bluetooth?
The app should have an option to select the speaker (or wired earphones) or the Bluetooth headphones.
You can also try:
iOS: Troubleshooting applications purchased from the App Store
Contact the developer/go to their support site if only one app.
Restore from backup. See:
iOS: How to back up
Restore to factory settings/new iPod

Logical GR in Third Party Process

Hi Friends
There is logical GR involved in third party process. What if we do not want to trigger it?

very useful thraed for your Qn-
[stock not updating after doing MIGO (gr) for third party sales |stock not updating after doing MIGO (gr) for third party sales;
BR
Raj

Free Goods in Third Party

Hi..
Please send me configuration steps of Free Goods in Third Party..
Thanks in Advance
Shriniwas

Free goods cannot be used in make-to-order production, third-party order processing and scheduling agreements.
This is the Limitation of setting up free goods
Cheers

Automatic po creation third party order

Hello Gurus,
In case of automatic po creation from third party order we have attach purchase organization and vendor to sales organization. This restrict only one vendor against sales organization.
Is any BADI available which we can use which to change vedor dynamically ?
Best Regards,
Vasant

Dear Vasant,
For automatic PO at the time of GR following are the prerequisites:
1) In Customizing
a) Auto PO generation must be activated in Mov. Type 101 & 161
b) the plant for which GR is entered must be assigned to standard Pur. Org.
c) Default Document type for PO must be specified in GR ( MB 01)
2) Application - Front end side
a) material must be valuated material
b) Purchasing Info record must exist for vendor , material & standard Pur Org.
c) Conditions in Info Records must be valid.
d) Applicable for stock items & not consumable items
e) you cannot enter any movement in GR block stock
f) Material Master & vendor master records must.
If you ensure all above settings then it is possible to have auto PO during GR.
Please try,
Vivek

Stock is increased and FI entry is posted in statistical GR for third party

Hello
I was trying to activate the functionalty for statistical GR in third party but STUCK due to following issues. For enabling this functionaltity I have checked "Goods Reciept" and "GR Non-Valuated" check in "Delivery tab" of PO.
1. After creating Statistical GR through MIGO (101), stock has been posted in plant. I was expecting no movement in Stock .
2. I was hoping there should not be in FI posting but FI entry is posted through statistical GR .
We are using third party process from many years but without statistical GR. Requirement from client is to post statistical GR without FI entry and no stock should be updated. Please advise if anyone has idea on this.
FYI--We have item category TAS and schedule line category CS in customisation. Also advise if above two settings in PO are enought to turn ON the statistical GR functionality.
Thanks for your help.
Regards
Arvind

Thanks AKPT for reply
As advised , pleae find enclosed screens for OMS2, PO and FI entry. FI entry might be wrong as while posting MIGO ..I was getting error "WE etnry is missing in table YFTFI_SUBST236 and I maintained some dummy GL accounts.
Regards
Arvind

Goods return from customer in third party business process

hi all sd gurus
here I ve adoubt regarding returns in third party business process query is how a customer send his foulty goods n how he gets his credit note plz explain eleborately plz help me out
thankx in advance
santosh

It has not been addressed in standard SAP. For further detais, go through Note 751609 - Returns for third-party process (cancellation)
thanks
G. Lakshmipathi

Cannot do MIGO in Third Party Sales Process with shipping notification

In the Third party sales process with Shipping notification,the item category for the material is TAS (Billing relevance=R),item category group is BANS.
Intially sales order is created,then using me21n with reference to purchase requisation purchase order is created,then in MIGO stage i used the PO No there but i get the message no item found in PO.
what adjustment have to be done in order to do MIGO

Refer following SDN thread, by that you will be able to get overview on best practices about Third Party Sales & necessary configuration you need to follow for statistical GR:
- Third party direct shipment (II)
Further maintain Billing Relevance for Item Category as G - Order-related billing of the delivery quantity.
Regards
JP

Accounting Entries hit in Third party Sales Process

Hi,
Can anybody tell which accounting entries are hit when we create the following entries in third party sales process
1.When Sales Order is created.
2.When PR is Created
3.When ME21N is done
4.MIGO
5.MIRO
please provide your valuable suggestion..
Thanks...

Hi,
1. When Sales Order is created.
No FI Entry
2. When PR is Created
No FI Entry
3. When ME21N is done
No FI Entry
4. MIGO
(GBB-VAY) COGS - 3rd Party A/c - Dr
(WRX) GR/IR Clearing A/c - Cr
5. MIRO
Vendor Account - Cr
GR/IR Clearing A/c - Dr
6. VF01
Customer Account - Dr
Sales Revenue A/c - Cr

Third-Party earphones.

Similar Messages

Maybe you are looking for