Toshiba 56HM195 picture and sound shut off; blue light still on

The sound and picture will randomly shut off together but the blue light on the front under the screen stays on.  The tv will not respond to the remote or the buttons on the side.  I have to unplug then plug it back in and it will work fine for several hours before doing it again.  I have tried replacing the lamp but that did not change anything.
Any thoughts would be greatly appreciated!
Thanks

Try leaving the TV unplugged from power over night. If the problem persists, it may require servicing.
- Peter

Similar Messages

  • Equium A110 - DVD picture and sound appear to choppy & scratchy

    Hey guys, for the last couple of days when i insert a dvd/cd into my laptop and try to play it, the picture and sound both appear to choppy and scratchy. also when i try to copy and burn a dvd, it takes an eternity(2-3 hrs) whereas before it barely took 15 minutes.
    Is there any way to correct such a problem?
    And another question, I may want to try and restore the laptop to its "factory settings".
    Anyone know how to do it?
    Regards m1lz

    > I may want to try and restore the laptop to its "factory settings". Anyone knows how to do it?
    If you want to set the notebook to factory settings you have to recover the OS from the delivered Toshiba Recovery CD!!!! But be careful, the recovery procedure erases the whole HDD. Create a backup before start the installation from the recovery CD
    Now something about the sound and video issue:
    Maybe the ODD malfunctions, this is not impossible but improbably.
    You notebook supports acoustic silencer application try to remove it.
    But after recovery installation everything should run correctly... hopefully ;)

  • All sound shuts off

    Ihave a problem where all sound shuts off and restarting does not necessarily fix it. Applicatins work, but can't talk on phone. Anyone else have this problem? Is it a heating issue or something else?

    apparently you are restarting the phone incorrectly.
    to reset the phone press and hold the sleep button and home button at the same time until you see a silver apple. DO NOT slide to turn off at the screen prompt, just keep holding those buttons until you see the apple.
    Message was edited by: Dynamite DJs

  • Sound shuts off sporadically

    on my 5g the sound just stops ( or doesn't play). there is no sound output from either jack. This has happened in the middle of a podcast. then later has come on and then stopped again. Everything else seems to work ok. resetting and then the new 1.2 update did not help. any suggestions before I bring it back? Thanks...
    imac 20"   Mac OS X (10.4.3)  

    hi Kimmi!
    The third one... the sound shuts off about 10 seconds into playing the video.
    first head into your "about" screen on your ipod and check to see what software version you have installed on the ipod:
    Where's the iPod About screen, and what's in it?
    if you've got a 1.1, try upgrading to 1.1.1. see:
    Video created with third-party software plays incorrectly on iPod
    love, b

  • My ipad2 won't charge, it's been on 1% all day now. It's plugged in and keeps shutting off. The cord works fine, it's charging my husbands iPad. Any suggestions?

    My ipad2 won't charge, it's been on 1% all day now. It's plugged in and keeps shutting off. The cord works fine, it's charging my husbands iPad. Any suggestions?

    Is this with the power adaptor that was included with your iPad 2 purchase?
    The same power adaptor and USB dock connector cable charges your husband's iPad?
    If so, sounds like a hardware problem with the battery or something else. Have you tried powering the iPad off and on and/or a reset which is similar to a computer restart?
    If so with no change, make an appointment at an Apple store if there is one nearby.

  • My  BEATS speakers are connected to my Mac but I have no audio and do not understand how to turn off the speaker. I press the power button and not shut off. And the white light behind me indicating that this synchronized, does not turn off ever.

    My  BEATS speakers are connected to my Mac but I have no audio and do not understand how to turn off the speaker. I press the power button and not shut off. And the white light behind me indicating that this synchronized, does not turn off ever.

    Hello Sabroso007
    Check out the article below to troubleshoot the sound output to your Bluetooth speaker. Check in System Preferences > Sound to see what the output is set to.
    OS X Mavericks: Set up Bluetooth audio devices
    http://support.apple.com/kb/PH14217
    Regards,
    -Norm G.

  • Sound shuts off during video

    Hi,
    I put three music videos in mp4 format on my ipod. Two of them play great (video and audio). The third one... the sound shuts off about 10 seconds into playing the video. How can I fix this? I used xilisoft dvd to ipod converter software.
    Kimmi

    hi Kimmi!
    The third one... the sound shuts off about 10 seconds into playing the video.
    first head into your "about" screen on your ipod and check to see what software version you have installed on the ipod:
    Where's the iPod About screen, and what's in it?
    if you've got a 1.1, try upgrading to 1.1.1. see:
    Video created with third-party software plays incorrectly on iPod
    love, b

  • Macbook Pro starts up, has a small loading bar, and then shuts off.

    Macbook Pro starts up, has a small loading bar, and then shuts off after a few seconds, but the Windows bootcamp partition works fine.
    The repair disc option (using install disc) failed, and the computer cannot locate the original Mac side partition. Only Bootcamp appears under options to "restore from backup" or reinstall. The repair disc options says it should be repaired but doesn't seem to know how.
    Macbook Pro.
    Snow leaopard
    Bootcamped with Windows.
    Any ideas?

    Hold c or option key and boot off the 10.6 installer disk, run DU Repair from there.
    run through this list of fixes 1-8
    Step by Step to fix your Mac
    If it doens't work, you can recover files if you don't have any current OS X file backups, then grab what you can out of Bootcamp
    Use Data Rescue installed on the extenral boot drive ($100) to read the bits of the internal (non-filevaulted) drive to retrieve OS X data files if you can't get them off manually via drag and drop methods.
    Create a data recovery, undelete boot drive
    If you want to clone Windows, use WinClone and another drive. However it's likely compromised, unless it something you did in Windows, like trying to create a new parttition perhaps?
    Then perform a Zero Erase and install of 10.6 as shown here (on the entire drive, not only the parittions), this will give a new GUID partition table, EFI and map off bad sectors, totally fresh everything.
    How to erase and install Snow Leopard 10.6
    You cna use Carbon Copy Cloner to clone the new extenral setup to the new scrubbed internal drive. Recreate Bootcamp and WinClone back or fresh install Windows into Bootcamp like before. OR opt to use virtual machine software which is safer.
    Windows in BootCamp or Virtual Machine?
    Windows 7 can write to the boot drives GUID partition map (unlike XP), this is likely why it's borked now.

  • My iPad 2 is only 7 months old and is draining battery life quickly some days and others shutting off at 40% - 50% and when I turn the iPad back on it keeps turning it self off continuously. I have a feeling the battery could be faulty, what do I do?

    My iPad 2 is only 7 months old and is draining battery life quickly some days and others shutting off at 40% - 50% and when I turn the iPad back on it keeps turning it self off continuously. I have a feeling the battery could be faulty, what do I do?

    The Basic Troubleshooting Steps are:
    Restart... Reset... Restore from Backup...  Restore as New...
    Restart / Reset
    http://support.apple.com/kb/ht1430
    Backing up, Updating and Restoring
    http://support.apple.com/kb/HT1414
    If you try all these Steps and you still have issues... Then a Visit to an Apple Store or AASP (Authorized Apple Service Provider) is the Next Step...
    Be sure to make an appointment first...

  • Insert picture and sound without external sources

    how can we insert pictures and sound without using external sources??
    i mean , i want to make the picture somehow embeded inside the program, not from external source,
    can any1 help?/

    I sense that what you need to do is create a Jar (java archive) file for your code and images and any other resources. Do a search on the forum for the terms -- jar pictures getresource -- and you'll get a ton of helpful threads. Also check Google. Some useful links:
    http://java.sun.com/docs/books/tutorial/deployment/jar/
    http://forum.java.sun.com/thread.jspa?forumID=54&threadID=5183949
    http://www.cs.princeton.edu/introcs/85application/jar/jar.html

  • I have a Symphonic 32' HDTV (Dolby Digital Plus). can someone help me figure out how to configure it optimally with my Mac Mini? the display and sound is off. Do I need drivers/software? I'm new to macs.

    I have a Symphonic 32' HDTV (Dolby Digital Plus). can someone help me figure out how to configure it optimally with my Mac Mini? the display and sound is off. Do I need drivers/software? I'm new to macs.

    Hello, since nobdy else has replied...
    Long shot, but...
    Open Audio Midi Setup in Applications>Utilities, see the input & output options & KHz setting there.

  • I can start my iPod but it will only stay on the Apple icon screen for 5 minutes and then shuts off, what do I do to fix this problem?

    I can start my iPod but it will only stay on the Apple icon screen for 5 minutes and then shuts off, what do I do to fix this problem?

    Try:
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - If still not successful that indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar

  • Why do the sounds shut off without changing settings on my 4s?

    why do the sounds shut off without changing settings on my 4s? They come back when they want.

    Thanks.  That worked.  Weird that their's nothing in settings....
    Have a good one.

  • Why does my iMac display keep shutting off?  Computer still running in the background.  I've tried unplugging and restarting, to no avail.

    Why does my iMac display keep shutting off?  Computer still running in the background.  I've tried unplugging and restarting, to no avail.    The computer is well out of warranty - about 7-8 years old, running 10.6.8

    Checked.... the settings had not been inadvertently changed, but I did move the scroll and reset them back to the original.   Hasn't shut off again.... yet.   Will re-post with follow-up one way or the other.   Thanks.

  • TRIED TO DOWNLOAD SOFTWARE ios7.1.2 TO MY IPAD. iPAD FROZE ON THE APPLE PICTURE AND WONT TURN OFF OR RESPOND AT ALL.

    TRIED TO DOWNLOAD SOFTWARE ios7.1.2 TO MY IPAD. iPAD FROZE ON THE APPLE PICTURE AND WONT TURN OFF OR RESPOND AT ALL. IPAD MAY NEED MORE FREE MEMORY FOR THE NEW SOFTWARE BUT HOW DO I FREE UP MEMORY IF THE IPAD IS FROZEN. CAN THIS BE DONE ON iTUNES OR THE APPLE SITE?

    Took my iPad to the Apple store today and they were able to unfreeze it with a simple forced reset. This is done by pressing the Off button at the same time as you press the button on the front and hold for about 20 seconds. The new software had successfully installed and the iPad had frozen when it was starting up again after install. Not sure why this simple process can't be part of a FAQ page on the Apple site.

Maybe you are looking for

  • How to retrieve the Foreign key information in Oracle

    I want to know how to retrieve the Foreign Key information in Oracle while using SQL Statement? I have use three SQL statement to retrieve such information, but the performance is very bad. The three SQL Statements are: Select constraint_name, r_cons

  • Generic Data Source and InfoPackage Data Selection

    Hello,  I'm trying to extract data from a generic data source (composed of a view joining 4 tables) using the Data Selection Criteria in an infopackage.  Sometimes the selection criteria is ignored and more data is pulled than expected.  The number o

  • Search third word of all lines in a file

    I need to search the third word of all lines in a text file. Also,if the word is found, the total number of times the word appears should be counted. Is that possible?

  • OVS 2.2.1 install on HP ProLiant BL465c G7 Blade

    I'm installing OVS on a HP ProLiant DL465c G7 Blade. The installation bombs at the beginning because it doesn't recognize the storage adapter. It prompts me for a driver disk but I need advise on how to do this. The server uses a HP SmartArray P410i

  • How do I import my mbox file for Apple Mail?

    I just did a clean install of my mac os on an iMac. Prior to the install, I exported my mail account to an external drive. I got an INBOX.mbox file/folder that's 4.32GBs. When I click the file, there is an "mbox" file and a "table_of_contents" file.