Toshiba Satellite won't go past Toshiba welcome screen.

Hi. I have a Toshiba Satellite laptop that was shut while running and sat overnight without power so it was basically sleeping.
In the morning, I turned it on and it froze on the Toshiba welcome screen which is the first thing you see when you start up the laptop.
The keyboard and mouse wouldn't work which didn't let me go into safe mode.
Also, the little cylinder light that indicates when the computer loads was completely on and stayed on.
It runs on Windows XP.
And now it does this everytime I turn it on and won't go any further.
Please help! Thanks!

The computer is not finding a boot device or files. Go into the Bios and check the Boot Priority. On most Toshiba Satellites, you either hit the Escape key or the F2 key to get into the Bios. Make sure that the first boot device is the hard drive. Often you will see this abreviated at HDD. Also make sure that the hard drive is being seen in the Bios. If the hard drive is not being seen in the Bios you are not going to boot into Windows. Guaranteed. If the hard drive is being seen in the Bios and is the first boot device in the Boot Priority and it is still not going beyond the Toshiba splash screen, then you have a major software problem. In that case the only option is run the Recovery CDs and see if you can reimage the hard drive. If the hard drive is not being seen in the Bios, this could indicate that the hard drive is not properly connected to the computer or has gone bad. In that case, you will be talking to your friendly Toshiba authorized repair center for diagnostics and repairs.

Similar Messages

  • Windows 7 won't load past the welcome screen

    I'm trying to boot up my laptop but it keeps hanging on the welcome screen. I go through the password page and then it just sticks on the welcome screen with the little spinning circle. It does the same in safe mode but the circle is completely frozen
    on the welcome screen and then it gets no further. I don't have a windows recovery CD. Any suggestions?

    Hi,
    I suggest boot into Recovery Console to perform System Restore to test the issue.
    1. Remove all floppy disks, CDs, and DVDs from your computer, and then restart your computer using the computer's power button.
    2. Do one of the following:
    If your computer has a single operating system installed, press and hold the F8 key as your computer restarts. You need to press F8 before the Windowslogo appears. If the Windows logo appears, you need to try again by waiting until the Windows logon
    prompt appears, and then shutting down and restarting your computer.
    If your computer has more than one operating system, use the arrow keys to highlight the operating system you want to repair, and then press and hold F8.
    3. On the Advanced Boot Options screen, use the arrow keys to highlight Repair your computer, and then press Enter. (If Repair your computer isn't listed as an option, then your computer
    doesn't include preinstalled recovery options, or your network administrator has turned them off.)
    4. Select a keyboard layout, and then click Next.
    5. On the System Recovery Options menu, click
    System Restore.
    Kim Zhou
    TechNet Community Support

  • Satellite L500 will not load past the 'welcome' screen

    Hi,
    My Toshiba Satellite L500 laptop will not load past the 'welcome' screen. The cursor thing just keeps going around and around but won't go to my desktop.
    Last night it went into some temporary profile and it had a message saying 'your other profile cannot load at this time please try again later'
    Any help would be greatly appreciated.
    Thanks,
    Kara

    The error message is not known to me and also searching in google didnt get any hints.
    Possibly your Windows OS is muddled up.
    Did you try to boot Win 7 in safe mode?
    Try this. Restart your notebook, tap the F8 key.
    In advanced boot options choose the option called Safe Mode.
    If the notebook does not allow booting in Safe Mode, try the option Last Good Known Configuration.
    If this didnt help, try Repair my Computer. Here you can choose between different settings.
    The one which could solve this is HDD recovery which helps you to set the notebook to factory settings. But this means also that your HDD would be formatted!
    So be aware of this!

  • Hi guys. I've had my MacBook Pro for 2 years now. Last night it suddenly kept glitching to a dark grey screen every now and then, then it would flash yellow / blue spots, and now it won't go past the grey screen even when I reboot it.  I don't think I can

    Hi guys.
    I've had my MacBook Pro for 2 years now. Last night it suddenly kept glitching to a dark grey screen every now and then, then it would flash yellow / blue spots, and now it won't go past the grey screen even when I reboot it.
    I don't think I can access my disk anymore as I've moved across countries since I've first gotten my laptop.  it was working perfectly fine before  it kept going to the dark grey screen with a little blue on the bottom.
    If it helps, my camera light is still on, and it seems that my computer is working properly itself, but won't go past this grey screen.
    I'm a college student and am really panicking about this - can anyone please tell me what to do?
    Thank you & sorry for the long post.

    What operating system are you running on it? (iOS 5.1 is for iPhone, iPad...not a Mac).

  • I updated my first generation iPad to version 5.1.1 and won't go past the setup screen that asks if I want to use the iPad locator. I can go back but can't get any further.

    I updated my first generation iPad to version 5.1.1 and won't go past the setup screen that asks if I want to use the iPad locator. I can go back but can't get any further

    I just updated my original iPad 32 GB WiFi to iOS 5.1 about fifteen minutes ago.  But I did it with the system restore feature in iTunes.  So it wiped out everything on my iPad.  But it did work.  Then I restored an earlier backup and all went fine.  Maybe you could try backing up your iPad and then using Restore to get it back to factory settings to see what happens. 

  • My MacBook won't boot past the grey screen.. help!

    Today I was having a problem with Safari. For some reason, it kept restarting. This annoyed me, so I restarted my MacBook. Unfortunately, it won't boot past the grey screen, with the thing spinning in the middle. I've been into disk utility and it says my HDD is fine. I restarted from this, and yet it still won't boot. Can anyone suggest what's wrong/what to do?
    Thanks in advance

    Retrieving data using Target Disk Mode:
    1) Shut down both computers
    2) Connect the two computers using a Firewire cable
    3) Start up the working computer.
    4) Once the working computer is ready, startup your MacBook with the T key held down.
    5) Your MacBook's hard drive should appear as an external hard drive on the working Mac. Drag & drop any files you want to save.
    ~Lyssa

  • Computer won't get past the blue screen...

    During class today I decide to install new updates to my computer, but class ended before everything had downloaded so I just closed the screen thinking nothing of it. Now my computer won't get past the blue screen and it just keeps reloading and reloading. Help?

    You must have damaged your OS installation by putting the machine to sleep at the wrong moment. To fix that, you need to reinstall, but first you need to back up your data, if you haven't already done so. Have you?

  • MBP won't reboot past the white screen with the grey apple. Why? How do I fix it?

    MBP won't reboot past the white screen with the grey apple. Why? How can I fix it?

    Which OS are you on.
    try doing an SMC reset http://support.apple.com/kb/HT3964
    How long do you wait until giving up??

  • HT1349 I can't get past the welcome screen for my new macbook pro. Help!!

    Seriously. My new macbook pro will not let me progress past the welcome screen. It will not let me select australia (or any other) country as its host country!!!!

    I just had the exact same problem. You must physically push down on the trackpad and get an audible "click" to activate the continue button on the language screen. The one-touch click function is not yet enabled on your Macbook because you haven't set it up yet. This should work for you. It did for me!

  • Pavilion p6-2117 won't get past the splash screen with a parallel card installed.

    Pavilion p6-2117c won't get past the splash screen with a pci express parallel card installed.  I take the card out and the machine works just fine.  The screen says press "esc" for startup menu but nothing happens.
    This question was solved.
    View Solution.

    Take a careful look at the slot and see if any of the pins are broken or smashed to the bottom of the slot.  Do you have another pci slot to try or just the one?
    Reminder: Please select the "Accept as Solution" button on the post that best answers your question. Also, you may click on the white star in the "Kudos" button for any helpful post to give that person a quick thanks. These feedback tools help keep our community active, so you receive better answers faster.

  • IMac makes a loud beep on start up, won't load past the blue screen and the black ticking dial appears every few seconds in centre of screen.

    Urgent help!
    Out of the blue my mac lost the mouse cursor even though it had connection so I rebooted only for the mac to make a loud beep on start up then get stuck at the blue loading screen. It won't load past the blue screen. I've tried to reboot holding down the shift key but no change. I've also shut down, unplugged the main for 15 seconds, re plug and wait 5 seconds before starting up again but no change. Does anyone have any suggestions?
    PS: I'm not too sure which systems I am running without being able to check in about this mac. I bought my imac in January or February 2011 if that helps.

    The power on self-test resides in the ROM of the computer. This test runs whenever the computer is turned on after being fully shut down (the power-on self-test does not run if the computer is only restarted).
    If a fault is detected during the test, you will not hear a normal startup chime. Instead, the system will beep as explained below. If you experience one of these beeps, you may call your Apple Authorized Service Provider for additional troubleshooting assistance.
    1 beep = no RAM installed
    2 beeps = incompatible RAM types
    3 beeps = no good banks
    4 beeps = no good boot images in the boot ROM (and/or bad sys config block)
    5 beeps = processor is not usable
    http://support.apple.com/kb/HT1547

  • My iPhone 4s (bought today) won't get past the activation screen. It says 'it may take a few minutes to activate your iPhone' and then skips to another screen saying 'activation failed - try again'. Any solutions?

    my iPhone 4s (bought today) won't get past the activation screen. It says 'it may take a few minutes to activate your iPhone' and then skips to another screen saying 'activation failed - try again'. Any solutions?

    Apple's activation server is down.
    I called Apple and the support team had the same issue.
    All you can do is be patient.

  • When I start up my Mac it won't go past the grey screen. Any suggestions?

    When I start up my MAC it won't go past the grey screen. Any suggestion?

     
    Mac OS X: Gray screen appears during startup 

  • My iMac starts, but won't get past the loading screen?

    My iMac starts up, but won't even get past the white screen with the Apple logo.
    It kept giving me black screens, and would not start in safety mode. After command + option + p + r, the black screens stopped coming, but it still won't get past the loading screen, if I let it load long enough the Apple logo is replaced by a "denied" symbol but that is the only thing that happens. By hitting command + d, I was told nothing is wrong. When pressing command + r and going to disk utility, it found an issue while verifying and repairing. At first it stated "invalid journal" but now it only says to reinstall everything and that the problem couldn't be solved. I cannot mount the harddrive, and Time Machine just searches for copies without getting anywhere. When I try installing OS X (Mavericks) again, the harddrive doesn't even show up. What do I do?

    The HD sounds like it has crashed, take it into your local Apple Store or Apple Authorized Service Provider (AASP), if you bought AppleCare this will be covered. If you don't have an Apple Store in your area and don't know of any AASPs then please click https://locate.apple.com/country to begin finding one.

  • Reset PMU and Powerbook won't boot past the blue screen with "Mac OSX" box

    Hi-
    Problem: I tried to reset my PMU, and now when my computer restarts it won't go past the blue screen with the "Mac OSX" logo in the box (and progress bar, that never fills up). I then also tried to reset PRAM, but it still won't boot properly.
    Backstory--
    I've had my 12-inch Powerbook G4 for about 3.5 years already, so things are starting to get a bit out of whack. I replaced my battery about 3 months ago, which has been great, but recently my power-cord has been wonky (having to unplug it and replug it in to make sure it actually charges the computer, the light flickers on and off, etc). Today it actually started producing SPARKS at the place where the thin white wire meets the white plastic power brick, so I decided it was time to get a new one. Brought it home, plugged it in, and since it seemed like the battery indication icon on the menu bar was all out of sync with the powercord colored-light, I tried restarting it a few times, but still the same. Then, I decided to reset the PMU, which may have been a huge mistake. And now it won't boot past the blue screen... Any advice? I'm going to try restarting it in "safe" mode, but I'd be so grateful for any recommendations. Hope I haven't done something irreversibly stupid with the PMU reset.
    Thanks,
    Samantha

    Hello all,
    Thanks for all of your great suggestions and info-- here are a few responses.
    1) The disk I just borrowed from my friend appears to be the full retail version-- it looks just like the links that Ali B sent, and is in a large box saying "Mac OSX Tiger, version 10.4"... will this be the proper disk to do an Erase and Install? The only other disks I have came with my Powerbook when it was originally purchased, when it came Panther (I think, 10.3?). Would I use both sets of these disks to do erase and install? Or only the Tiger OSX disks?
    2) I get the sense that Disk Warrior or Tech Tool might be necessary, but does it make sense to TRY to do erase-install before buying them? Also, are there any downloadable (for pay) versions of this, or would I need to track down the actual physical disks in Hong Kong or wait for them to be shipped?
    3) I haven't yet tried the S.M.A.R.T. test, should I do that first? What is the procedure? Are there any results or ways to know if the drive is too far gone (so that I might instead replace the internal hard-drive) instead of pay 100 USD first to do the disk repair?
    4) Cornelius said: "An alternative would be to completely reformat and erase the entire HDD, then re-install and restore your data from backup. If your backup is in the form of a bootable clone of the entire HDD, you can just clone it back." I use Super-Duper to back-up and the most recent one copied the whole thing-- what would be the later procedure of "cloning it back"?
    5) As I'm able to use my computer pretty normally right now, but does it still mean that it might crash/die at any moment? Is there any way to tell?
    Thanks so much!

Maybe you are looking for