Trunks between 2950s stop working and wont come back

I've seen this happen on 2 different 'pairs' of 2950s, so it's time to investigate. The scenareo:
simple trunk (no vlan definitions) between 2 2950s. 1 switch looses power, when power is restored, the switch that didn't lose power doesn't pass any traffic. The interface is up (link and administrativly up) the logs don't show anything other than the interface went down and came back up. here's a sample port:
interface FastEthernet0/23
description new Feed from phone room switch
switchport mode trunk
no ip address
I'm not using spanning-tree, there aren't any redunant paths. Its worked fine for months (until a ups failure), I set up a new port on the switch and swing the cable and it comes up. Any ideas?
thanks!

Hello,
I know this is an old post... but I am posting here in case this is viewed by anyone with a possible solution.
Our organization has multiple locations configured the same way:
(x2) cross connected 2950 switches in trunk mode, configured the follwing way per each interface (fa0/19):
interface FastEthernet0/19
no ip address
duplex full
speed 100
no cdp enable
spanning-tree portfast
Our problem is similar to the one explained in this initial post. The switches are auto-trunked via port #19.
Let's call one switch "A" and one switch "B"
Whenever power is removed from one of the switches (Switch A), and it has completed a restart, the opposite switch (Switch B ..the one which was not powered off) will not return to a "Trunked" state. When you run the "show int status" command, it shows that the port is "connected". Even though the switch which was initially restarted returns to "Trunked" mode.
We have seen this with a few of our 2950's across the infrastructure.
The bottom line is that restarting one of the switches causes the other to lose the trunked state. The only was to correct the issue is to restart the opposite switch as well.
The IOS version is 12.1 (9) EA1d .. I know it's old, however we cannot upgrade it at this time due to policies within the organization.
Could anybody shed some light on this?
Thanks in advance..

Similar Messages

  • TS3694 my iphone keeps turning its self of and wont come back on

    my iphone keeps turning its self of and wont come back on

    Plug it into a wall outlet, let it charge for half an hour and then reboot by holding both the power and home buttons until the apple logo appears, ignore the red slider if that appears.

  • HT4623 my iphone just shut down and wont come back on

    my iphone just shut down and wont come back on what could be the problem

    Connect iPhone to Wall Charger for 10 minutes, it my turn ON itself. If still OFF, then keep on charger and Reset, hold both home and power buttons until the iPhone begins to start, this can take about 20 seconds time holding both buttons while on charger.

  • My ipod has just turned off and wont come back on

    my ipod has just turned off and wont come back on but i know it had a good amount of battery left and if i plug it into my computer or docking station nothing happens please help...

    Try:                                               
    - iOS: Not responding or does not turn on           
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable                     
    - Try on another computer                                                       
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
    Apple Retail Store - Genius Bar                                     

  • Ipod stopped working and wont turn on

    i was using my ipod and it stopped working and the screen turned off and now it wont turn on. the computer wont even reconize it when i plug it in.

    Hello, makaylla. 
    Thank you for visiting Apple Support Communities. 
    I am not sure what generation iPod nano you have so I will include a couple troubleshooting articles that may help with this issue. 
    iPod won't turn on
    http://support.apple.com/kb/ts1383
    iPod nano (6th generation): Hardware troubleshooting
    http://support.apple.com/kb/ts3474
    Cheers,
    Jason H. 

  • My phone went to a black screen and wont come back on, how do i fix it?

    At first, out of know where, it went to a white screen with a blach apple. Then Iplugged my phone into my computer and reset my phone and my home button or lock button wont work. Now its just on a black screen and wont turn back on. How do i fix this probkem with my phone?

    mckenzie8 wrote:
    my home button or lock button wont work.
    Won't work or are Broken ?

  • IPhone 4S switched itself off and wont come back on. Please help?

    Hi,
    My iPhone 4S has started switching itself off randomly over the last week but would then switch itself back on several minutes later by itself. However, last night it switched itself off and no matter what ive tried it wont come back on. Ive tried the home+power button, connected to itunes and not, connected to itunes with the home button pressed. I rang the Geek Squad as I have insurance and they could suggest anything more. Im loathed to take it back to the shop as all the sales assistant will do is send it off, give me a rubbish temporary phone/brick and it will take ages to come back. I would be grateful if anyone can help please?

    Hi, my phone eventually came back to life of its own accord the next day but with virtually no battery life even though I'd given it a full charge. After it came back on I plugged it in to be recharged but the back became very warm whilst the power drained quicker than usual after I unplugged it.
    I took it to the Apple store later that day and thankfully the phone switched itself off again right in front of one of the Genius assistants. He couldn't diagnose the problem and so gave me a brand new handset straight away. Credit to Apple there and I'm so glad I didn't take it back to the car phone warehouse where I bought it from. They would have sent it away for tests for weeks.
    I've had no problems with my new handset to date.

  • My iphone 4s has just gone off and wont come back on can it be reset ?

    my iphone 4s is 1 day old i was playing draw something on it, it had 96% battery on it but it just went off now it wont come back on. even my computer is not detecting it when i plug it in to that. any ideas why and can it be reset like my ipod can?

    Thank you i did do this but didn't hold it long enough, then i just paniced and thought it was broken. thank you very much.

  • Itunes stops working and wont play purchased tv shows, i tried the quicktime unchecking box fix and that didn't work. help

    im new here trying to get help.  my itunes stops working when trying to play tv shows and movies.  i tried the quick time fix, unchecking a tab in the advanced section that didn't work for me.  i have now uninstalled itunes that didn't work either.  help

    Try this. It worked for a few users after a drop.
    Turn the iPad over and give it a very HARD slap on the back. May take several slaps.
     Cheers, Tom

  • My ipod has just stop working and wont switch on after a full nights charge?

     

    Did you already try to reset it by holding the sleep and home button until the Apple logo comes back again?
    If this does not work, try to connect in recovery mode, shown here: http://support.apple.com/kb/HT1808

  • Firefox stops working and message comes up saying a plugin has stopped working. How do I fix this?

    Going thru a slide show. picture freezes and then screen get a milk white overlay. The popup stays a Firefox plug in has stopped working. then is satys looking for fix and then shuts down.

    Did the message say what had crashed?
    See if you have any crash reports.
    We're sorry to hear that Firefox is crashing. In order to assist you better, please follow the steps below to provide us crash IDs to help us learn more about your crash.
    #Enter ''about:crashes'' in the Firefox address bar and press Enter. A Submitted Crash Reports list will appear, similar to the one shown below.
    #Copy the '''5''' most recent Report IDs that start with '''bp-''' and then go back to your forum question and paste that into the "Post a Reply" box. (Please don't take a screenshot of your crashes, just copy and paste the ID's. The below image is just an example of what your Firefox screen should look like)
    [[Image:aboutcrashesFx29|width=520]]
    <br><br>
    Thank you for your help!
    More information and further troubleshooting steps can be found in the [[Firefox crashes - Troubleshoot, prevent and get help fixing crashes]] article.

  • I dropped my iphone 5c in a fire a few weeks ago and today it just stopped working and wont turn on what do i do?

    i dropped my iphone in a fire a few weeks back!! but it worked right after but now it just stopped working what do i do?

    Make an appointment at the genius bar. An out of warranty replacement will cost you $269. If Apple refuses because the damage is too extensive, buy a new phone.

  • My nano just quit and wont come back on. No evidence of it charging. Nothing. ????

    My ipod nano just stopped working. No evidence of it charging and computer is not recognizing it at all.

    Please press on the sleep/wake button while simultaenously holding down on the home button. (sleep wake button is the little rectangler button on the top of the device.
    If this does not resolve the issue read this article:
    http://support.apple.com/kb/HT1766
    good luck!

  • My ipad just went blank and wont come back on, any help??

    My IPad went blank and will not come back on.  Is there a reset button or procedure??

    Try resetting your iPad by pressing the home and sleep buttons until you see the Apple logo, ignoring the slider. Takes about 5-15 secs of button holding and you won't lose any data or settings.

  • HT1688 my iphone just completey shut off, and wont come back on, even when connected to the charger

    my iphone completely turned off and will not come back on, even when connected to the charger. how can i turn it back on?

    Hello ozzy9294,
    Thanks for using Apple Support Communities.
    For more information on this, take a look at:
    iPhone: Hardware troubleshooting
    http://support.apple.com/kb/TS2802
    Display has no backlight or dark screen
    Toggle the ringer switch to see if the unit vibrates. If it does, it could be that iPhone is getting power, but is not displaying any image.
    Try turning iPhone off and then on again.
    While connected to the iPhone charger, try to reset the iPhone.
    If the low-battery screen appears, charge the iPhone.
    Best of luck,
    Mario

Maybe you are looking for

  • Problem print all pages on my HP Laserjet 1320 from my Mac

    I am having a strange printing problem. Happens in almost any program (Mail / Excel /Preview/Word/TextEdit/etc.).   I can ask it to print a one page document.  It spools, the printer flashes.  The computer said it is done but nothing printed.   On th

  • Wishlist to Nokia Music

    I've been using Nokia Music in my Lumia for a while now and it's really good service. However, I would like a feature where you could mark tracks to your wishlist during playing the mix radio, so you could buy them later on. Do you have any plans on

  • Publish Crystal Reports to SAP NetWeaver Portal

    We are trying to publish Crystal Reports to SAP NetWeaver Portal.  So far we found that we always have to save to BusinessObjects Enterprise first, and then we found the ID from Crystal Reports in the InfoView.  After that, we put that ID in our iVie

  • UDF Importing Parameters

    Hi all, I have a user defined function which contains 32 importing parameters to pass to RFC for RFC lookup. But in UDF editor its allowing only 20 importing parameters to enter. Can any one help me out in this? please suggest me a best way to procee

  • I give up!!!  iDVD will not burn a disk

    I will try to give as much information as I can.  I have been struggling with iDVD for a couple weeks.  It will not burn a disk that has a complete menu.  Let me explain.  I've been  testing it to see if it would burn a disk at various stages of deve