Trying to create Manual IP Configuration, however, I get a error
Hello,
I am trying to create a manual IP address configuration on my MacBook. My router's IP is 10.1.1.1 and I need to make my Mac's static IP address 10.1.1.10. It was working for a while, however, I am now receiving the following error message when trying to connect to the internet:
10.1.1.10 is in use by 00:23:df:d9:cf:64
I looked up the MAC address, 00:23:df:d9:cf:64 and it is apparently manufactured by Apple, Inc. I have taken a look at the IP configurations of everything that is made by Apple in my house including: Macs, iPhones, iPods, etc and none of them have anything to do with 10.1.1.10. Please help me solve this issue and hopefully get the IP address up and running again.
Thanks a lot!
shmootz's router may not allow port forwarding at all if it (the router) is configured to hand out DHCP addresses to clients, hence his decision to go with static addresses rather than DHCP with manual address. I used to have a router that behaved like that.
shmootz, did you check both the airport panel and the ethernet panel on each computer? You know that the two interfaces will have different MAC addresses, right?
If you did not check both interfaces on each computer, I think you will need to look in your system preferences network advanced airport and ethernet panels on all of your computers and see if one of the interfaces has that 00:23:df:d9:cf:64 MAC address and manually pair it up with that 10.1.1.10 IP address.
It would be a lot nicer if you could just flush some table to clear the mapping of MAC addresses to IP addresses but I don't know where that info would be stored.
Similar Messages
-
I created a form in Adobe Forms Central to collect payment thru my PayPal account, however in the registration process after granting permissions to link the accounts, I get an error from Adobe that my email address is not confirmed in PayPal, when indeed it has been confirmed. I double checked the email setting in PayPal an the address is confirmed.
Error Message: [ref: formFailedRegPaypalEmailNotConfirmed]Your best bet would be to try resetting the password to the account that you would like to use via iForgot
Once you log in to that account change the email address to anything, it can even be fake its just a placeholder
After you do that you will be free to change your old email address on your appleID to the new one that is now free to be used as it is no longer attached to the other account. -
I am tryint to restore my locked ipad 2, however, in itunes I get 2 popup messages. The first pop up says "itunes can not connect to ipad because it is locked and requires a password" So I attempted to restore the ipad and an error message "itunes can not connect to this iPhone because of an unknown error occurrred"... Does anyone know what I do next?
m12pru wrote:
for some reason that link is taking me to 4oD
How bizarre, try this again http://support.apple.com/kb/TS3694#error1015 -
i am trying to install oracle 11g xe on ubuntu aws instance when i execute sudo /etc/init.d/oracle-xe configure command iam getting this error: sudo: /etc/init.d/oracle-xe : command not found.
"command not found" means ... there is no such thing.
Has the .rpm been installed?
http://docs.oracle.com/cd/E17781_01/install.112/e18802/toc.htm#XEINL122 -
i just created an apple ID and then tried to log in to facetime but, keep getting : an error occurred during activation, try again" can anyone assist?
i just created an apple ID and then tried to log in to facetime but, keep getting : an error occurred during activation, try again" can anyone assist?
-
While creating a device category i'm getting an error "enter a valid division via eg01,how can the error be overcome?
Neha,
you can do in two ways.
1. Enter a valid Division which you configured in the system.
2. Remove the Division as required field. However I suggest it should have a valid division. Why can not you check with your Functional owner?
Linganna Katigiri -
i am trying to install itunes 10.5 but I get an error message that says "click ok to try again or enter an alternate path to a folder containing the installation package iTunes.msi..." I try to point iTunes to the .msi file on my c drive but then it gives me a message says "the file location is not a valid installation packaage for the product iTuness. Try to find the installation package 'itunes.msi' in a folder from which you can install iTunes". Any help, insight, guidance would be greatly appreciated!!
"The feature you are trying to use in on a network resource that is unavailable. Enter alternate path to a folder containing the installation package itunes64.msi".
Download the Windows Installer CleanUp utility from the following page (use one of the links under the "DOWNLOAD LOCATIONS" thingy on the Major Geeks page):
http://majorgeeks.com/download.php?det=4459
To install the utility, doubleclick the msicuu2.exe file you downloaded.
Now run the utility ("Start > All Programs > Windows Install Clean Up"). In the list of programs that appears in CleanUp, select any iTunes entries and click "Remove", as per the following screenshot:
Quit out of CleanUp, restart the PC and try another iTunes install. Does it go through properly this time? -
I am trying to download itunes 10.6 and keep getting the error message "The feature you are trying to use in on a network resource that is unavailable. Enter alternate path to a folder containing the installation package itunes67.msi". Where do I find this or how do I get it?
"The feature you are trying to use in on a network resource that is unavailable. Enter alternate path to a folder containing the installation package itunes64.msi".
Download the Windows Installer CleanUp utility from the following page (use one of the links under the "DOWNLOAD LOCATIONS" thingy on the Major Geeks page):
http://majorgeeks.com/download.php?det=4459
To install the utility, doubleclick the msicuu2.exe file you downloaded.
Now run the utility ("Start > All Programs > Windows Install Clean Up"). In the list of programs that appears in CleanUp, select any iTunes entries and click "Remove", as per the following screenshot:
Quit out of CleanUp, restart the PC and try another iTunes install. Does it go through properly this time? -
When trying to purchase anything on itunes I am getting an error message. (There was an error in the itunes store. Please try later - 42408) Why is this?
poppypower wrote:
When trying to purchase anything on itunes I am getting an error message. ...
Contact iTunes Customer Service and request assistance
Use this Link > Apple Support iTunes Store Contact -
I am running InDesign CS5.5 and trying to open an In Design File but getting an error message. " Cannot open the file "PDavidLCover.indd". Adobe InDesign may not support the file format, a plug-in that supports the file format may be missing, or the file me be open in another application."Please help I really need to get this file open.
Since you've shown us the folder contents it's a good bet it isn't in use (no lock file). And it doesn't look like the file is mis-named as there doesn't seem to be anything else there that would be the .indd file (but just in case, open it in TextEdit and paste the first few lines here so we can see what the file header says), so the most likely case is the file is damaged. Is that on a removable device of some sort?
You can try the tool at Repair corrupt InDesign Adobe files on Mac OS X or send me a link to the file by private message and I'll try the recovery tool I have for Windows. -
I am using itunes 10 and trying to consolidate my files. I keep getting the error "Copying files failed. The file name was invalid or too long". How can I indentify what file is causing this problem or resolve this issue?
BUMP
Yes, I just get that message. I don't see how I could investigate this problem.
I didn't mention that this happened when I was consolidating my library, not copying files to another computer.
In other words, I'm using a "normal" itunes procedure, itunes won't complete it, and won't tell me exactly why or how to figure out how to fix it...
Is there at least some easy way to tell which files were successfully copied to my itunes music folder so I can work on moving the uncopied files?
Can anybody help me? -
I tried to update my iPAD & I just keep getting an error message
I connected my iPAD to my laptop to back up as i hadn't done it for about 3 weeks. I connected to iTunes & began to sync the iPAD then the iPAD screen went blank.
When I try & turn the iPAD on it just comes up with the cable sumbole & a message 'connect to iTunes.
When I connect to iTunes it tries to do a recovery/restore it tries & the timer bar fills up, then I get an error message 3014, unable to restore your iPAD.
It was working fine up until I tried to sync it :-(
I have tried;
turning off & on using the home button & power button reset
amending my security on the PC
Updating iTunes
all to no avail. I went into the iSolutions shop today who were less than helpful!
Is my iPAD completely dead or can it be salvaged??? My iPAD is 4 days over 2 years old
I hope aomeone can help me please
Thanks
ToriiPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Update and restore alert messages on iPhone, iPad, and iPod touch
http://www.buybuyla.com/tech/view/012953a0d412000e.shtml
iOS: Resolving update and restore alert messages
http://support.apple.com/kb/TS1275
iPad: Unable to update or restore
http://support.apple.com/kb/ht4097
iTunes: Specific update-and-restore error messages and advanced troubleshooting
http://support.apple.com/kb/TS3694
If you can’t update or restore your iOS device
http://support.apple.com/kb/ht1808
Cheers, Tom -
Working in Windows 8.1, trying to open Lightroom 3.6 64 bit, get the error message: Windows cannot access the specified device, path or file. You may no have th appropriate permissions to access the item. I have changed the permissions to everyone and it doesn't work
Any suggestions please?
-
When I am trying to upgrade my iOS version I am getting an error message saying " the iPad software update server could not be contacted", I also get an error message prior to that which says the certification of the server is invalid?
Temporarily disable any security software on the computer and try again.
-
I am trying to finalize a movie project and I get an "error in user parameter list" message. What does that mean, and how can I fix it?
what movie editing software are you using?
Maybe you are looking for
-
Ipod will not update songs from library
I recently purchased a 60GB Ipod video. Before that, I had a 3rd generation Ipod with Itunes 4.1. Once I purchased the new Ipod, I updated my Itunes and installed the new Ipod on my PC. When I sync the Ipod, everything appears normal at first. Then,
-
I am pretty new in APEX and need your help. I have a manual form for ex: say on Employee form with only one editable field say 'Salary'. If a user edits the salary and hits save, the record goes into the history table but doesn't update the original
-
HI to all, I try to enter bank data for Moldavia also entering the IBAN. But the system tells me all the time that the IBAN is not correct although I validated it. I belive it has to do with the country specific check rules. Do you know what are the
-
How can I transform a 3D world coordinate to a 2D device coordinate?
I have been working with Java 3D for a few months and I can create a scene graph and display it. Now, I want to transform a 3D world coordinate to a 2D device coordinate. I don't want to draw the 3D point in the scene, I just want to know what the 2D
-
CTXSYS.CREATE_THESAURUS and Apex
Hello, i am doing some tests using Oracle Text indexes and i creted a thesaurus from the SQL Workshop console. I noticed that the thesaurus is not created in my schema but under FLOWS_020200. Is this correct?!? Bye, Flavio