Trying to Port Forward Airport Extreme 802.11ac using Airpot Utility 6.3.2

Question

Hello kind experts. I am finally getting around to replacing my old BEFSR81 Cisco Router with an old Time Capsule attached with the Airport Extreme 802.11ac.  The BEFSR81 also had 8 ports, so I have 8 hardwired locations throughout the house.  I have a couple of IP cameras for which it was easy to port forward on the Cisco (just click on the port range forwarding tab, type the start/end ranges (which are identical) and the assigned IP address).  Everything has been working well for years.  Here's what I wish to do with the new setup: Cable Modem -> Airport Extreme -> Dumb gigaport switch with the hardwires connected to it.
When I go to Airport Utility (6.3.2) -> Network Tab -> Port Settings -> "+", the following comes up:
Firewall Entry Type (Defaulted to IPv4 Port Mapping)
Description (5 pull down choices)
Public UDP Ports : _________
Public TCP Ports: __________
Private IP Address (I take it that is where I enter the IP address for each camera, e.g. 192.168.1.xxx)?
Private UDP Ports: __________
Private TCP Ports: __________
I am obviously not a technophile, especially when it comes to networking, but was able to create my old setup.
Any advice on whether or not my configuration is appropriate and what exactly I need to put in the port fields would be greatly appreciated!
Thanks in advance!

Answer 1

To successfully access an IP camera on the local network from the Internet, the following basics need to be taken care of:
Install the camera(s) and verify that you can access them from the local network.
Configure port mapping/forwarding on your router. Typically, IP cameras require at least two ports: 1) A web port for administering the camera; Usually TCP port 80, and 2) A streaming port to broadcast the camera video feed; Usually UDP port 9000. Note: You should check with your camera's documentation for the exact ports required.
If the camera is attached to a computer, you will need to configure the computer's firewall to open the same ports as in step 2 above.
Verify that your modem is in bridge mode, i.e., if the modem provides NAT & DHCP services, turn them off.
Test your network. Use CheckIP to determine your router's current WAN-side (public) IP address. Then, from a remote location (not from a computer on the local network), use the DynDNS Open Port Tool to verify that the required ports are open. Success is an "Open" response from the Tool.
Check out the following AirPort User tip for configuring port mapping on an AirPort base station.