TS1367 Pressing iMac Power Button and nothing happens.
I followed the steps to reset the SMC on my late 2013 iMac, and once I plugged back in the iMac chimed and immediately quit a couple times. When I pushed the button, it chimed, started to spin up, and shut back down. So it was progress, previously there had been nothing. Any ideas?
Now the iMac is just chiming half a chime every few minutes and cutting back out. Weirdest thing is last night it did start and ran fine for hours.
Similar Messages
-
My ipod touch 5th gen. 16gb ios 8.1.2 wont turn on, i press the power button and nothing happens, and my home button doesnt work, PLEASE HELP ME OUT!!!
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try another cable
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I have a MacBook. It went to sleep and I could not wake it up. I shut it off by holding the power button so it shut off. Now I can't get it to start at all.
Julie...
It went to sleep and I could not wake it up
Try Resetting the System Management Controller (SMC) -
My new macbook pro doesnt turn on. i press the power button and i can hear it runing but it wont turn on. i tried charging it but nothing works. help me please.
ilmare55555 wrote:
i cant go because if my parents find out my new mac broke they will kill me. i tried to restart it but it wont work i can only hear the fans working and then completely stop after 10 seconds.
It's new and under warranty. That's the reason to go to the Apple Store.
Did something happen to it? -
My new macbook pro doesnt turn on. i press the power button and i van hear it runing but it wont turn on. i tried charging it but nothing works. help me please.
ilmare55555 wrote:
i cant go because if my parents find out my new mac broke they will kill me. i tried to restart it but it wont work i can only hear the fans working and then completely stop after 10 seconds.
It's new and under warranty. That's the reason to go to the Apple Store.
Did something happen to it? -
I just received a iPod Touch 5th generation for xmas and it acts like it is locked, when you slide the slider it says unlock button and nothing happens. Can't slide the power off either. It tells you the time, unlock button, power off button but nothing happens. Voice just tells you the unlock button, time, poweroff button.
Please help also itunes says I need to enter on iPod the passcode to reset to factory. I can't get it open to enter passcode, slider doesn't work. It is one day old and this happen xmas afternoon. PLEASE Help someoneTry:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
I have tried a hundred times pressing or holding the d key at power up and nothing happens ! What is the secret ?
At the top of this page is a link to the startup key combinations.
Learn about Startup key combinations for Intel-based Macs -
So just like last time I tried to update my iPhone software...MY PHONE IS FROZEN. Displaying iTunes icon and a USB cable I pressed the Power button and the menu botton together until the apple icon appeared held them down for 10 secs & NOTHING Now what? Do I just wait for the battery to run out?
Hi Careesa,
Your iPhone is in recovery mode-- you need to connect it to your computer and, most likely, iTunes will ask you to restore it. If you recently backed up this shouldn't be too much of a problem. -
My macbook air does not start! I press the on key and nothing happens.
my macbook air does not start! I press the on key and nothing happens.
this morning when I took my macAir it would nt start and when I pluged it, there was no light indicating a charge.
I checked the charger on my wife's mcAir and it worked.
I plugged it back to mine and the orange light came.
since a few hours, the plug is on with the orange light on, and still I cannot start the computer. Nothing happens!
help!Try a SMC reset
Shut down the computer.
Plug in the MagSafe power adapter to a power source, connecting it to the Mac if its not already connected.
On the built-in keyboard, press the (left side) Shift-Control-Option keys and the power button at the same time.
Release all the keys and the power button at the same time.
Press the power button to turn on the computer.
Note: The LED on the MagSafe power adapter may change states or temporarily turn off when you reset the SMC.
This process helps correct these power issues.
Power
The computer doesn't respond to the power button when pressed.
A portable Mac doesn't appear to respond properly when you close or open the lid.
The computer sleeps or shuts down unexpectedly.
The battery does not appear to be charging properly.
The MagSafe power adaptor LED doesn't appear to indicate the correct activity. -
My phone wont turn on ive tried holding the sleep and home button and nothing happened help?
i turned my phone off and it wont turn on ive tried holding the sleep and home button and nothing happened...i plugged it in to my computer and i didnt connect to itunes help
The two first choices are to reboot by holding both the power and home buttons until the apple logo appears, that can take up to half a minute. If that does not work, then more drastic is to restore using the recovery mode to connect to a computer running iTunes, described in http://support.apple.com/kb/HT1808 and summarized as:
-
I just bought an Ipad 3G and can't get past the first page of the setup. I choose a language (english) and hit the home button and nothing happens!!!!!!!!!! What am I doing wrong?
I'm pretty sure it say Next button or continue button, not Home. The home button would move you out of an application. When setting up you need to press the blue button with the white arrow at the top right corner to move on.
-
How do I restore the icloud backup for my Ipad if I never set up the "back up" in the first place? My Ipad is in a frozen state. I press the OK button but nothing happens. The message on the iPad is "iCloud Backup This iPad hasn't been backed up in 2 weeks. Backups happen when this iPad is plugged in, locked, and connected to Wi-Fi."
Perform a Reset...
Reset ( No Data will be Lost )
Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
http://support.apple.com/kb/ht1430 -
when i press the power button and the "home" button it lights up the screen. however.... the screen is magnatized like 300% percent. and i cant open it or anything becasue it wont let me move the screen!!! what to do??
Yup! I've been there! You just have to double-tap the screen with three fingers and the zoom should go back. You have to turn off the feature in Settings>Accessibility>Zoom>and turn the switch off so this won't happen again when you double-triple tap.
-
i was doing a software update downloading ios 6.1 and the phone froze half way through the download i tried to restart the phone by pressing the power button and the home button but its just a apple on the screen. what can i do to fix this??
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
Be sure to Follow ALL the Steps..
But... if the Device has been Modified... this will Not necessarily work. -
My macbook froze and i pressed the power button and the OSX utilities appeared
My macbook froze and i pressed the power button and the OSX utilities appeared .. i don't know if my things got erased or what does it mean and what should i do ? it doesn't let me click out of it or anything. the options are to restore fro time machine, reinstall OSX get help online and disk utility ,, how can i do to not erase anything i do not have an external memory or anything. PLEASE HELP
Hi there. If you have 10.9 Maverick you can get in recovery mode By using /command r Option R or Option. Then you came click on the link to go to disk utilities and repair your disk or do a reinstall of you operating system. I think the screen you are seeing is the recovery screen. Here is a hot of what it looks like. You will have to scroll down a little to see it.http://osxdaily.com/2013/11/05/downgrade-from-os-x-mavericks/ http://support.apple.com/en-us/HT4718 This link tells you what you can do.
Maybe you are looking for
-
Can some photos from ipad be transferred to mac or external hard disk
can some photos from ipad be transferred to mac or external hard disk
-
Location of the attachments in Guided Procedures
Hi, does anybody know the location where the attachments from the Guided Procedure Runtime are stored? Are they stored somewhere in the KM or in the database/filesystem directly? In the Guided Procedure Monitoring i can see the attached documents, bu
-
I have been trying to access my java preferences, but does not seem to be able to open up; I included clip from my screenshot, not sure how much it will help but here you go. Operating on version 10.6.8 What do I do? Anything I try to open that requi
-
ITunes 9.2.1 will not open automatically when iphone connected
i have all the relevant boxes ticked, and have tried all the 'fixes' i.e unchecking autosync boxes and then re ticking them but with no success. i have even unistalled iTunes, and reinstalled it. I have to say when i reinstalled iTunes, when i connec
-
Publish Provider Hosted (SP Online)
Hi guys, I have created a default Provider-Hosted App in Visual Studio 2013 without modify any code. I tried to publish this app to my Windows Server and i can't get it to work. If i publish in Windows Azure Web Sites it works great. (i can't use Azu