TS1368 HELP!!! After upgrading to IOS 6.13 my IPAD Stucks in a plug-in screen and the Itunes. When i Try to connect to iTUNES pop-up message apear "iTunes has detected an iPad in recovery mode.. You must restore this iPad before it can be used with iTunes
I have windows 8 enterprise OS and iTunes ver. 10.5.0.142. I was upgrading my iPad to IOS 6.1.3. After finishing the upgrade my iPad Reboot and currently stucked-up in a plug-in screen and iTunes Logo. When I try to connect it to the iTunes pop-up message appear saying " iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes." In short, I push the restore button then another pop-up message appear saying " The iPad software update server could not be contacted. Make sure your network settings are correct and your network connection is active, or try again later." I tried many ways but still no luck. I repeatedly reboot the iPad and open the iTunes still the same problem. I try also to uninstall the iTunes and installed the lower version but still the same problem, I even check the firewall if the ITunes was block or My privileges is administrator to run the iTunes or even reset my winsock but the problem still remain. PLEASE HELP! Thank you in advance!!!
Turn off your firewall and antivirus software.
Similar Messages
-
when i pluged my ipod classic 5g to PC then it shows “iTunes has detected an iPod in recovery mode. you must restore this iPod before it can be used with iTunes”?then after restoring the PIOD when IPod restarted then Itunes again detect the same ERROR.
If you are using XP, and you went through the procedure at the bottom of the previously linked document to change the iPod's assigned drive letter, and you also tried putting it into Disk Mode...
If you have not already, try shutting down your computer and disconnecting all USB devices, including hub. Start up with only standard keyboard and mouse connected. Just to be safe, put the iPod into Disk Mode again
http://support.apple.com/kb/HT1363
Run iTunes. Connect iPod to a direct USB port on computer. iTunes may prompt you about "recovery" and ask you to do a Restore. Try to do a Restore again. -
when I wanted to downloaded the new software the phone went of and in my computer saying iTunes has detected an iPhone in recovery mode. you must restore this iPhone before it can be used with iTunes,
my hone is off pls help i need to make calls as i use my phone for work ,
Many Thanks
kerrySo do what it says and restore the phone. Nothing else you can do.
-
Ipod nano 2nd generation: I cant restore, says, itunes has detected an ipod in recovery mode, you must restore this ipod before it can be used with itunes
What do you mean you can't restore? It's asking you to restore...
B-rock -
I have tried to update my Iphone 4S today to IOS 7.0.6 and now my iphone wont connect to itunes as it says that it is detected that it is in recovery mode and needs restoring. How do I restore it? I cannot get my phone on at all?
Click restore in itunes.
-
ok, so i finally found my ipod. I pick it up and it asks me if i would like to download the latest ios6 software so i did. Then moments later it died, ran out of battery. So i pluged it into my computer via apple usb cord. Then this is what itunes says "iTunes has detected an iPod in recovery mode.You must restore this iPod before it can be used with iTunes". All i want is to get my notes from the utilites section there so important to
If i restore it will my notes still be there, i dont want to restore original settings or something like that .
please help me what do i do?You have to restore the iPod, no ifs, ands, or buts...
After iOS is installed you will be asked if you what to set it up as a new iPod or if you want to restore from a backup.
If you have a good backup you can restore that and you're good to go.
If you don't have a good backup, then you end up with a "clean" iPod.... -
I'm having the same loop message appear when trying to sync my new Ipod Shuffle "Itunes has detected a device in recovery mode. You must restore this device before it can be used w/ Itunes".
I've restored several times but it keeps looping back to the same message. Turns out this message appeared with my last shuffle and I thought possibly the shuffle battery was depleted and it was time to get a new one.
any suggestions?If you restore from backup.
You should have made sure that everything was on your computer bef ore updating anyway. Did you fail to do that?
All pics taken with iphone should be imported to your computer regularly as you would with any digital camera, most especially before any update/restore/etc. Did you fail to do that? -
I reboot the computer, deleted and restart itunes, change computer, change cable, check ping, check connection. need help
Step by step
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. iPad Recovery Mode on computer screen
8. Select "Restore iPad"...
9. Select "Restore and Update"
10. Extracting Software.
11. Preparing iPad for restore.
12. Waiting for iPad.
13. Verifying iPad restore...
14.Restoring iPad software.
15. Verifying iPad software.
16. Verifying iPad Restore...
17. Restoring iPad firmware...
18. Your iPad is restored to factory settings; keep iPad connected to computer
19. Activate iPad
20. Enter Apple ID and Password
21. Continue
22. Welcome to Your New iPad -
Never once has my phone updated without deleting everything. It says "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes. I can't call for help because my phone is frozen on the screen with iTunes. On line live chat won't chat until I give them my serial number which I can't get to because its frozen and can't call for the same reason!! Omg! Someone please help me!?
Morning AppleHlumamkhululi,
Thanks for using Apple Support Communities.
In most cases, the connected iPod needs to be restored.
For more information on this, take a look at this article:
iTunes has detected an iPod in recovery mode - Use iTunes to restore
http://support.apple.com/kb/ts1456
Best of luck,
Mario -
After I downloaded iOS7 and my iPhone turned off I keep getting this message "iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes." I dont wanna lose some stuff from my iPhone.
During a normal install of iOS 7.0.6 this does not happen but something clearly went wrong in your installation.
To fix this, connect to iTunes and restore to Factory. Hopefully your iPad will be working again and you can restore your iCloud backup during Setup. -
During recovery on iPhone 4 I got : The iPhone could not be restored. Un unknown error occurred ( 3004 ). Then - iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes.Then I get error 3004 again. Latest iTunes and OS updates. I cant use the phone now. I did restart the destop,unplug the usb,...etc. Same iTune logo ,arrow and USB on the screen.THANK YOU SO MUCH,...!
Perhaps the information in this Apple support article will help:
http://support.apple.com/kb/TS3694#error3004
Regards. -
when I power on it shows go itune logo starts. Then I tried to download restore and update it shows Tunes has detected an iphone in recovery mode. You must restore this iPhone before it can be used with iTunes. iphone could not be restored. Then an unknown error occuired(1604) shows.an unknown error occuired(1604). Please help me and how can I restore the phone OS. Regards
It also happened to me. What I did was to put my USB connector at the back of my PC (the main USB port) then I open my iTunes again and Viola, it solves my problem.
-
i was downloading the latest software upgrade when the message "Itunes has detected an Iphone in recovery mode. You must restore this phone before it can be used with Itunes" came up. My option of I phone recovery mode says that it will restore the Iphone to factory mode losing all information.
is there anything I can do to prevent this?If the iPhone is in recovery mode, all data is already lost.
Restore it. -
I had some new albums I bogut from Itunes and wanted to put them on my Ipod Touch. Went to do that, ITunes said there was an update. I downloaded the update and then I couldn't see anything in my Ipod nor listen to anything. The screen of my Ipod shows a USB cable pointing to Itunes and when I plug it into ITunes again I get the message "iTunes has detected an iPod in recovery mode. You must restore this iPod before it can be used with iTunes." And the ONLY option it gives me is to restore my IPod to factory settings. I looked online for answers but all I see are people having problems with this because they bricked their phone, which I haven't ever done or even know how to do. Would appreciate some help, planned on spending my day off listening to my new albums.
If you are in the USA you can redown
If the music is not in your iTunes library (it is not in the backup that iTunes makes), you can redownload it if you are in the USA.
Downloading past purchases from the App Store, iBookstore, and iTunes Store
Are you in the USA?
What do you not understand? -
iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes.
so restore it
Peace, Clyde -
When performing the new iPhone(IOS6) update I received an error message - iTunes has detected an iPhone in recovery mode. You must restore this iPhone before it can be used with iTunes. Will I lose everything if it goes back to factory settings. Right now my phone wont do anything. It is just showing a cable, an arrow and the iTunes logo.
If you restore from backup.
You should have made sure that everything was on your computer bef ore updating anyway. Did you fail to do that?
All pics taken with iphone should be imported to your computer regularly as you would with any digital camera, most especially before any update/restore/etc. Did you fail to do that?
Maybe you are looking for
-
I am from the states and am in Greece on vacation. I have a good wifi connection yet keep getting a connection timed out error when I try to access the itunes store. It is funny because pending downloads show up in the cue, and they download no pro
-
I am moving files from one external hard drive to another, using the 'relocate originals' file command. This is very slow & tedious. Is there away to shortcut this? I was hoping to just set up a new library that would access the same files & folders
-
Transporting a Structure: Sending & Receiving Systems Don't Match?
I copied a Z1 structure to a Z5 structure in system A(sending system). Because System B(receiving system) already had a similar structure Z1 I did not want to overwrite. The only difference between both Z1s in system A and system B were some include
-
Buffer Misses On an hourly basis
Can anyone advise on guidelines I should pay attention to when determining if there is to much broadcase traffic in my network? For instance if I am looking at my switch should I see any buffer misses within a one hour time period? Are buffer misses
-
Hi, i have problem with my labview programing which in associate with cRio-9025 which also doing the data acquisition of temperature. below is my programing, pls help me to check on it, see error did i made. Apprecite it, thanks Attachments: asas.pn