TS1398 I tried all solution but still i am unable to connect to my wifi. It started yesterday when my ipad cant connect to wifi.
I tried all solution but still i am unable to connect to my wifi. It started yesterday when my ipad cant connect to wifi.
It's hard to provide help when your question starts out with, "I tried all solutions" however here is some troubleshooting advice.
If you are having WiFi problems it is necessary to isolate whether the problem is with your network or your iPad. Note: Do NOT consider your network to be blameless if some other devices can connect to it.
First, test your iPad on some other WiFi networks: a friends, Starbucks, Barnes & Noble, etc.
If it works well there then the problem is probably with your network. Try restarting your WiFi router by removing power for 30 seconds. If that does not help check for a firmware update for your router. If none exists which corrects the problem consider replacing the router.
If your iPad does not function well on other networks it possibly has a hardware problem. You could try Settings > General > Reset > Reset Network Settings to see if that corrects the problem. If not, contact Apple Support or visit an Apple store for evaluation. They can provide a replacement if your iPad is bad.
If you need more help please give the make, model, and version of your WiFi router and how you have it configured.
Similar Messages
-
iPhone2 can not scan for my wireless network; i tried all troubleshoots but still same problem. Can anyone help?
Anyone have any ideas or information to help with this? Any help and consideration is MUCH appreciated.
-
I have apple iPhone 4S upgraded to iOS 6.0.1 and everything was working fine suddenly my Wifi was not connecting and found the wifi on/off button is greyed out and to enable it I tried all resets but still my problem have not solved, still wifi is off
Same here.... No fix. Replacing is the option apparently and if you're out of warranty, you're SOL. That was as per the "Genius" at Apple.
-
TS1389 I tried all suggestions but still get code 42408.
I still get the error code 42408 and I cannot purchase anything from the iTunes store.
Delete and redownload them if doing so is free in your country.
(83692) -
My version of Lightroom 6 is still showing trial version after Serial Number has been Installed.
I have tried re-installation but still have the same problem.
Could you please forward a solution to this problem.Close your iTunes,
Go to command Prompt -
(Win 7/Vista) - START/ALL PROGRAMS/ACCESSORIES, right mouse click "Command Prompt", choose "Run as Administrator".
(Win XP SP2 & above) - START/ALL PROGRAMS/ACCESSORIES/Command Prompt
In the "Command Prompt" screen, type in
netsh winsock reset
Hit "ENTER" key
Restart your computer.
If you do get a prompt after restart windows to remap LSP, just click NO.
Now launch your iTunes and see if it is working now.
If you are still having these type of problems after trying the winsock reset, refer to this article to identify which software in your system is inserting LSP:
iTunes 10.5 for Windows: May see performance issues and blank iTunes Store
http://support.apple.com/kb/TS4123?viewlocale=en_US -
I am trying to restore software on my iPad which is connected to my PC with iTunes when i'm in recovery mode a warning comes up
"The iPad could not be restored an unknown error occurred (1604) This i have discovered probably a USB timing problem ?
I have followed all suggestions but still my iPad screen is locked with a iTunes logo and a USB cable beneath it, wish I had never bothered
to update it now. Any help would be appreciated. rgWhen I restart my iPad the connect to iTunes comes up and stays on until it shuts down again, I have read a report from Apple support suggesting I reinstall iTunes so I might try that again and also your suggestion which i shall also try, but thanks again - rg1547
-
When Safari opens all of my favourites come up as open tabs. I have tried changing settings and deleting and reopening! I removed all favourites but still all open up at start? I have set a homepage and that doesn't come up upon starting safari either?
There are several options in your prefs. See these in order
EDIT: CellarDwellr just gave you a possible answer -
the screen for my ipod touch went all white and I already tried to restarted but still doesnt work. What can i do?
Let the battery drain dead, recharge it and test. If it still does not work, restore.
Troubleshooting 101
Some topics covered
-Basic troubleshooting steps
-Hard reset instructions
-Manual restore instructions
-Hardware troubleshooting
-Preventive Maintenance
-Anti-theft & recovery tips
-Battery-saving tips
-Repair options
-Contacting Apple
17" 2.2GHz i7 Quad-Core MacBook Pro 8G RAM 750G HD + OCZ Vertex 3 SSD Boot HD
Got problems with your Apple iDevice-like iPhone, iPad or iPod touch? Try Troubleshooting 101
In Memory of Steve Jobs -
No sound through external speakers but fine through headphones! Button on left is not on mute and checked all settings and all fine! Tried all solutions here but no luck! Sound gone before I updated the software??
You may have debris in your headphone jack blocking the sensor. Try blowing hard on the jack, and inserting/removing your headphones quickly multiple times to clear it.
-
my ipad2 is unable to find wireless network(s). while at home I am able to connect my MacBook and iPhone to network but am unable to connect iPad. I have restarted the device multiple times and even reset the network and all settings but still no luck
Look at iOS Troubleshooting Wi-Fi networks and connections http://support.apple.com/kb/TS1398
iPad: Issues connecting to Wi-Fi networks http://support.apple.com/kb/ts3304
iOS: Recommended settings for Wi-Fi routers and access points http://support.apple.com/kb/HT4199
Additional things to try.
Try this first. Turn Off your iPad. Then turn Off (disconnect power cord) the wireless router & then back On. Now boot your iPad. Hopefully it will see the WiFi.
Go to Settings>Wi-Fi and turn Off. Then while at Settings>Wi-Fi, turn back On and chose a Network.
Change the channel on your wireless router. Instructions at http://macintoshhowto.com/advanced/how-to-get-a-good-range-on-your-wireless-netw ork.html
Another thing to try - Go into your router security settings and change from WEP to WPA with AES.
How to Quickly Fix iPad 3 Wi-Fi Reception Problems
http://osxdaily.com/2012/03/21/fix-new-ipad-3-wi-fi-reception-problems/
If none of the above suggestions work, look at this link.
iPad Wi-Fi Problems: Comprehensive List of Fixes
http://appletoolbox.com/2010/04/ipad-wi-fi-problems-comprehensive-list-of-fixes/
Fix iPad Wifi Connection and Signal Issues http://www.youtube.com/watch?v=uwWtIG5jUxE
~~~~~~~~~~~~~~~
If any of the above solutions work, please post back what solved your problem. It will help others with the same problem.
Cheers, Tom -
Had to buy a new PC as the hard disk of the old one broke and lost all purchases, but still have them on the iPhone. How can I sync them back to the new PC in iTunes without losing them?
You should be able to:
Backup the device to the new installation
Transfer your purchases into a newly authorized library
Recover any other media using third party tools as suggested in this post from forum regular Zevoneer
Restore the device from the backup
This process should switch the association of the device to the new library, preserving the data and settings in your apps.
May also be prudent to attempt a backup to iCloud directly from the device before you start... Settings > iCloud > Storage & Backup > iCloud Backup > On. It won't save any media but it would preserve the general account settings and documents in case anything goes wrong while you are trying to extract your other data.
When you get it all fixed, make a backup!
tt2 -
I have just come back from morocco where my phone worked ok using the morroco network, but since returning to the uk I can't get it to pick up a signal from the 'Three' network, have tried resetting etc but still wont work, any suggestions
banannaphone,
Welcome to Apple Discussions.
Quit Safari, find the com.apple.Safari.plist file in your Macintosh HD/Users/yourusername/Library/Preferences Folder, drag it to the Desktop, log out/in or restart and let us know what happens.
;~) -
i drained my ipad's battery and trying to charge it. but it won't turn on. i tried it overnight but still the ipad is dead. can somebody help me?
Try this - Reset the iPad by holding down on the Sleep and Home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider - let go of the buttons. (This is equivalent to rebooting your computer.) No data/files will be erased.
Frozen or unresponsive iPad
Resolve these most common issues:
• Display remains black or blank
• Touch screen not responding
• Application unexpectedly closes or freezes
http://www.apple.com/support/ipad/assistant/ipad/
iPad Frozen, not responding, how to fix
http://appletoolbox.com/2012/07/ipad-frozen-not-responding-how-to-fix/
iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
Black or Blank Screen on iPad or iPhone
http://appletoolbox.com/2012/10/black-or-blank-screen-on-ipad-or-iphone/
What to Do When Your iPad Won't Turn On
http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
Home button not working or unresponsive, fix
http://appletoolbox.com/2013/04/home-button-not-working-or-unresponsive-fix/
Fixing an iPad Home Button
http://tinyurl.com/om6rd6u
iPad: Basic troubleshooting
http://support.apple.com/kb/TS3274
Cheers, Tom -
i tried all that but when i connect my iphone to my itunes there is no restore button. why is this happening?
Slightly important info to include.
Once the iPhone is in Recovery Mode, it must be restored with iTunes.
You are unable to select Restore? -
I am trying to make a signature in MS Word (2007) which includes a jpg image, but when I save it as a HTML file and attach it the text appers OK but the image doesn't. I have tried various formats but still no luck. Can anyone help? edit
C'mon! Anyone???? I'm desperate!
Maybe you are looking for
-
Pass a Value to Variable from the unix environment in ODI (ELT)
Hi i am very new to ODI environment. i want know how to pass a value to variables in oracle data integrator from unix environment. Example: Variable name : Sales for variable name sales i want to pass the value from unix environment. Regards, Raj Edi
-
Do I have to pay for "free" wifi in Starbucks, etc?
I just got an iPod touch yesterday. I mainly plan to use it as a PDA device, but since it has wifi capabilities I wouldn't mind being able to check the internet or my Gmail messages now and then. At home I have an iMac desktop and hence don't have wi
-
My ipod touch is neither switching on nor its charging
hi i'm not able to switch on my ipod touch
-
How to encrypt the document number in URL
Hi All, I am working on a project where I need to send a URL to the user in his email, the URL contains the document number in it. when the user clicks on that URL a webdynpro application will open with data prepopulated based on the document number,
-
Hi, Customer on 11510.2 does not have WIP, MRP and APS. Requirement: Sales Order for an assembly needs to be entered. Customer wants to procure each component of the assembly. The components are received in a warehouse and then issued to another vend