TS1559 I did everything and still have the greyed button, sometimes i turn the phone off for more than 30 minutes and then the wifi works i always haver wifi address, help!!
My phone has the wifi greyed out, and no wifi. It has wifi address, whne i turn it off for some 30 minutes, it came back up with wifi but it dont last too long, somebody help!
if it's still greyed out after fully restoring it, the device needs hardware repair.
Similar Messages
-
It's so annoying!! I have created a new Apple ID but after I click verify it just goes back to the previous page!!! It''s really frustrating I have tried for more than 4H, and the problem is not about the apple ID. I can download apps with the apple ID, which means IMessage is the problem! I restarted my iPad, I logged in and out of the apple ID in the store, AND YET IT STILL WON'T WORK, PLEASE HELP!
Hi Vmanfromusa!
It sounds like you are having an issue with activating your iMessage app on your iPad. An article outlining some troubleshooting steps for this issue can be found here:
iOS: Troubleshooting FaceTime and iMessage activation
http://support.apple.com/kb/ts4268
Thanks for using the Apple Support Communities. Have a good one!
-Braden -
My iPhone was stolen a few days ago. It appears to be offline on the Find My iPhone app. If the person who has it turns it on only for a brief moment and then turns it off immediately, will the location still be found? Once it returns to being offline will the location still be sent to me? And also, how can I retrieve my pictures from my iCloud?
Anything is possible.
-
My wifi button is frezon and I tried turning my phone off for a period of time and reset my phone but the button is still frezon it want slide over to turn on my wifi. Is there any other way to fix without going to apple to get it fixed?
Hey Posada143, You can still try the rice thing, but do not expect much, as roaminggnome has stated. The rice only works if you do it ASAP and leave the iPod off-- do not attempt use, turn on or charge until it is completely dried out. This is probably academic at this point but remember this for the next time: The drying can take 10 days. You put the uncooked rice and iPod in a sealed bag, change the rice every couple of days. This creates a low humidity environment and draws the moisture out of the iPod, but it takes time. Turn your iPod on to earlier, and you run the risk of shorting out, damaging the components inside. Even if done correctly it can spotty. If you do get the iPod to work (and this may require Resetting, Restoring or attempting to place it in DFU recover mode) the first thing you do is make backups, because you never know how long it will continue to work. As for your pictures, if you can't get your iPod to work, you can try data retrieval companies, however; there is no guaranty it will work and it tends to be very expensive. In the future get in the habit of as making backups, because you just don't know. And invest in and use a water tight case. Hope this helps, Good luck. Cheers.
-
My iPhone 5s won't turn on. Its battery was drained for more than a month. I tried charging it for more than an hour then pressed reset but it still won't turn on. What could be the problem?, My iPhone 5s won't turn on. Its battery was drained for more than a month. I tried charging it for more than an hour then pressed reset but it still won't turn on. What could be the problem?
You said "reset," so Meg assumed that's what you did. But "reset" is not a button; to reset the phone you must hold the HOME and SLEEP buttons at the same time until an Apple logo appears. You may have to hold for up to 30 seconds, and if the battery was completely drained, you will have to restore iOS using iTunes on your computer.
-
I have purchased two audiobooks from iTunes. They play perfectly for about 13 minutes and then abruptly stop. I have purchased other audiobooks and have not had a problem. Please, any ideas on why this is happening and what can I do to fix it. Thanks!
As long as you use your computer like King Penguin stated for Report a Problem, you should be fine. If you can't get to your computer, are not using your computer, or your computer is not longer in the mix since you have been using your iPad, email iTunes support about the problem.
http://www.apple.com/emea/support/itunes/contact.html -
My phone turned its self off for about 10 minutes, when it came back on it went from 84% to 18%. When I put in on the charger it shows the plug symbol as if its fully charged but the phone stays at 18%. Over time the battery dropped, but it went from 18, to 9, 3, then 1, and every time I put it on the charger it doesn't actually charge. Now my phone is off and it will not turn on.
I'd suggest taking it to apple. Warranty or no warranty.
-
As we know, in planning form, we can add supporting details to one cell for the level 0 members intersections.
But can we do that as below:
add supporting details for more than one cells at the same time?
I tried to do that in workspace and smartview, neither is working.(my workspace version 11.1.2.2.300.20)
I wonder if i am not with the right version, because i don't know how to get the below.
Can any one explain?
Thank you.Hi,
I have tried in Smartview for a simple form where my period dimension was in columns and accounts in rows.
You need to select multiple period and select supporting details, it will show those selected period for which you can add the supporting details.
You can add these details and then submit the data in the form.
Regards,
Sourabh -
Every time my lg g pad 8.3 lte tablet is turned off it reverts the saving email attachment back to internal storage. Every time I turn on, I change it back to save to SD card. It stays that way until it is turned off for more than a minute. If I do a restart, it holds the setting, but loses it when it is shut down for any period of time. Does anyone else have this issue? The setting holds for photos taken with camera storing to SD card. Only the email attachment setting does not hold.
I believe that system has a hall sensor on it to detect when the lid is closed so it can put the system to sleep and/or disable the monitor so it can be used with an external monitor only. If the sensor is marginal or has a bad cable, it may intermittently cut the monitor on and off, and may likewise put the system to sleep. One way to check would be to plug in an external monitor and if the laptop's screen cuts off or doesn't show up, start using the trackpad and press on a non-typing key like the shift key. If the external display suddenly pops and becomes active while the laptop display remains black, it's probably a problem with the sensor or the cable/connection. You might be able to fool the sensor into kicking on and off by moving a magnet over it. It's located on the left had side of the base with the unit opened up, and right over the audio output plug.
I know of some people that put a small magnet right over the hall sensor's location so the laptop display turns off and they use the system with an external monitor, keyboard, and mouse. If fooling with magnets, make sure they're small and don't get them close to the hard drive because a strong magnet can wipe them out.
I don't know if this will help you much, but it might. -
When I restart my Mac, the grey screen appears like usual. But it takes more than 40 minutes (or more) for it to load to finish restarting the Mac. What should I do to fix it?!
Disconnect all devices from your computer if you have not already done so. Restart again. If the problem has been resolved, you had a peripheral conflict. You will then have to reconnect the devices one at time, restart, to locate the culprit.
Login Items is another culprit. Check your login items.
System Preferences>Accounts>Login Items
Delete/disable all you do not need or want. -
I put my sim in someone's phone earlier for about 3 minutes, and now they are receiving my iMessages and can't remive my number from their settings, pls help
They need to turn off iMessage, power the phone off/on, then activate iMessage again with their SIM.
-
my 3rd generation ipad even though my battery is at 100 % the screen goes black after sitting for more than 15 mins. The only way to get it to come is by resetting the ipad. Is there a fix for this. It all started after the last two updates.
Try a Reset...
Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears. Release the Buttons.
If no joy... Try a Restore...
1: Connect the device to your computer and open iTunes.
2: If the device appears in iTunes, select and click Restore on the Summary pane.
3: If the device doesn't appear in iTunes, try using the steps in this article to force the device into recovery mode.
From Here
Unresponsive iPad
http://support.apple.com/kb/TS3281 -
I have a nokia c6-00 that has adobe flash installed. for more than three months can not I watch videos on it. how to solve this situation? best regards
hey! Will someone answer please?? Does anyone hear me?? I'm really getting frustrated! And why isn't firmware 40.0.021 not available for update on phone? I don't have net connection on my pc, and cyber cafes won't let me install ovi suite there!
-
I have an iPhone 4S with sprint. I had to replace my phone after the new update killed my wifi button and wouldn't let me turn my phone off. Since I've had my new phone, I haven't been getting 3G. I have tried resetting my networks, Turing airplane mode off/on and restarting my phone. Nothing seems to work. Any info on what I should do next would be great.
If you have set this phone up, then there would not necessarily be a solution here until you have been verify with the provider that everything is provisioned correctly on their end. Since the 3G comes from your cellular provider, if the settings are correct on the phone, then you should work with the carrier next.
-
please the screen of my iphone 4s has been off for 14hours though the phone is on and calls come through. And i'm not able to answer these calls cos the screen is not responding. please what can i do to get my display back.Thanks
try a hard reset
hold down the home button and the power button at the same time until u see an apple.
if u never see the apple even after holding those buttons down for a while u will need to restore the iphone's software using itunes on a computer.
Maybe you are looking for
-
hi i have stored proc like this ALTER PROCEDURE [dbo].[p_member] @MemberID INT = NULL, @ID INT = NULL, @Type varchar(20) = NULL AS IF NOT EXISTS (SELECT Memberid FROM Member mcd JOIN Pro p WITH(NOLOCK) on mcd.ProgramID = p.ProgramID W
-
Mountain Lion - cannot copy and paste in finder
Hey, I've only just noticed this today and I've done a search but can't find anything so far to help me. I upgraded from lion to mountain lion the day after it was released, not fresh install, upgrade. Basically... I cannot copy files using eith
-
Can I hook my i- Mac core 2 duo monitor to a PC netbook, so the Mac becomes the monitor?
Is it possible to hook my i- Mac core 2 duo monitor to a PC netbook, so the Mac becomes the monitor and the PC the computer?
-
Help me with creating a Livello1.m document
I wish to create a Livello1.m document for a iphone/ipad app? THANK YOU IN ADVANCE, cheers
-
Hi All I have a MacBook and below are the symptoms of its malfunctioning : On startup its gives chime sound with bad resolution of apple logo and load bar goes up to approx. 25% and white screen comes up. And this been happening for almost 2 weeks n