TS1589 i setup my airport extreme and now i do not have no internet connection

I'm having a difficult time setting up my airport extreme to my iphone 4s. i setup my airport extreme and now i don't have no internet connection. I have a PC not a Mac desktop computer at home. i am confused with the setup.

downlaod the airport utility app on your iphone, it will let you setup your device
then factory reset your extreme
Press and hold the reset button with a pen, pencil, or straightened paperclip until you see the status light (LED) start to flash amber rapidly, which should occur after about five seconds.

Similar Messages

I upgraded to ios7 and now it says I have no internet connection.

I upgraded to ios 7 and it says it was successful. Problem is, anytime I try to connect to an app, check my email, etc., it is saying I have no internet connection. It will connect to wifi, but it still says I have no internet connection. I can't open anything. Can't sign into app store or any other app. Won't work connected to wifi or LTE. Very aggravated right now. Have rebooted phone, reset network settings. Nothing is working. Messages won't connect to iMessage. My phone is basically worthless right now. Anyone else having this problem? How do I fix it? Getting frustrated.

I upgraded my iphone 5 to IOS 7 and it will not recognise my previously OK bt home hub connection. If I go to an allternative, BT WiFI it connects but will not allow me to access anything on the web or any applications needing web access. Any way round this or can I revert back to IOS 6?

I just replaced my airport extreme and now the amber light on my airport express is flashing and so it is not being recognized. I have been on the computer and gone to airport utility and it is simply not showing up at all. What can I do?

I just replaced my airport extreme and now the amber light on my airport express is blinking. When I go to utilities and try to find the airport express it does not show up.
What should I do?

Anytime you change networking hardware it is always a good idea to perform a complete power recycle of that hardware. Check out the following AirPort User Tip for details. Please post back your results.

Recently we changed our Lynksys router to an Airport Extreme and now my MacBook Pro running 10.6.8 will not stream radio through Itunes without constantly rebuffering. Any ideas?

Recently we changed our Lynksys router to an Airport Extreme and now my MacBook Pro running 10.6.8 will not stream radio through Itunes without constantly rebuffering. Any ideas?

Recently we changed our Lynksys router to an Airport Extreme and now my MacBook Pro running 10.6.8 will not stream radio through Itunes without constantly rebuffering. Any ideas?

Downloaded IOS 7 and now I do not have a dictionary in iBook. This is very frustrating. What can be done to fix this issue?

Downloaded IOS 7 and now I do not have a dictionary in iBook. This is very frustrating. What can be done to fix this issue?

I've got to agree with Allan. It sounds like the hard drive is corrupt at least. It's possible it might be physically failing. Without backups, it's possible your data is already gone. You need a professional to help you.
If you do not have an Apple Store near you or simply don't have the time to spare, there are some things you can try, but you must understand that it's possible these things could make the chances of recovering your data worse than they already are. Perform the instructions to follow at your own risk!
First, you can try repairing your hard drive with Disk Utility. If that works, see if you can start up the machine. If you can, the very first thing you need to do is back up any data you don't want to lose. You may still need to take other steps, as your system may be damaged as well, but getting the data is the important part.
If Disk Utility cannot repair the problems, you can try DiskWarrior. It can repair problems that Disk Utility cannot. However, it also increases the risk of destroying your data if it fails. If it works and you can start up the machine, do the same as I advised for following success with Disk Utility.
If repairs (with either) were successful, but the machine still won't start up, you can try reinstalling the system. Hold down command-R at startup and then just install right on top of the existing system. If all goes well, you'll be able to start up afterwards and can get your data backed up. If all goes badly, it'll further decrease the chances of getting your data back.
If neither can repair the damage, you're in bad shape. You will need a professional to help you, unless you are willing to lose all your data.

I was able to print from adobe digital editions up to two days ago and now I do not have the option to print. The "Print" option is greyed out. Please help.

I was able to print from adobe digital editions up to two days ago and now I do not have the option to print. The "Print" option is greyed out. Please help.

Printing Expiry option might be set by the Publisher at server level. Right click on the book and select Item Info to know about the book permission.

I reformatted my computer and now I do not have iphoto, how can I download it again?

I have a partition and my mac side stopped working, I reformatted it and re-downloaded lion the newest operating system although my laptop came with the operating system prior to this and now I do not have iphoto. How can I get it again without paying for it, since the computer originally came with it?

Log into the Mac App Store with an Apple ID used to purchase it or the one you associated with those applications and click on the Purchases tab.
If you originally got it on an iLife DVD or are using the version included with a Mac which originally shipped with 10.6.8 or earlier, you need to reload it from DVD.
(72873)

HT5704 I have an iPad mini, but it will not let me update. It is saying that I do not have an internet connection, but I am connected to the wifi. I have tried on 2 different wifi networks and I do not have internet service-it's wifi only. How do I update

I have an iPad mini, but it will not let me update. It is saying that I do not have an internet connection, but I am connected to the wifi. I have tried on 2 different wifi networks and I do not have internet service-it's wifi only. How do I update?

Please download iTunes from Apple.com and then sync your ipad.After which your ipad will appear on the right hand side upper corner of iTunes.Select your ipad and click check for update,once update has been found click update and follow the steps after that.

When i try to turn on my ipod, it tells me to connect to itunes and restore but a message pops up and says that i dont have an internet connection. the connection is on and it loads at 100mb per second.

when i try to turn on my ipod, it tells me to connect to itunes and restore but a message pops up and says that i dont have an internet connection. the connection is on and it loads at 100mb per second.

Update Server
Try:
- Powering off and then back on your router.
- iTunes for Windows: iTunes cannot contact the iPhone, iPad, or iPod software update server
- Change the DNS to either Google's or Open DNS servers
Public DNS — Google Developers
OpenDNS IP Addresses
- For one user uninstalling/reinstalling iTunes resolved the problem
- Try on another computer/network
- Wait if it is an Apple problem

I hard re-set my airport extreme, and now it won't come back. Keeps flashing amber for ever!!! help

I forgot my network password, so I attempted to hard set my aiport extreme. Now I can not get it to come back to green. Won't stop flashing amber. Have tried to re-set and un-plug several times to see if I can bring it back and no luck. Anybody have any suggesions?

Sometimes you just have to perform the reset multiple times to get it to "stick." If after multple attempts, it still does not reset properly, it may be possible that your AirPort has failed.

Can I use a Airport Express and a Foscam IP camera without a internet connection?

Hi All,
I have a Foscam FI8918W IP camera. I have it working perfectly at home on my local network over wifi with either my Airport Extreme or my Airport Express.
I planned to use this IP cam as a wireless camera for on stage work with bands, monitoring equipment that I can't see during the show utilising the Airport Express, my MBP or iPad.
As I have said, i have everything working very well, until I disconnect the Airport Express from the mains power and remove the CAT5 cable from my modem to the A.E. When I reconnect the power (but not the internet connection), I get error messages from the IP camera software that the Subnet mask settings are incorrect.
I cannot get the camera to work until I reconnect the internet connection. After a few moments, the issue's are resolved and everything starts working again and I can view the camera's video feed from an i.p. address.
Question is: Is there a way to set up the A.E. so that it doesn't require a internet connection?
I will not have internet at a lot of venues and need to get this to work just as a stand alone setup.
Thanks in advance!
mark

I'm not sure I quite understand. Do you wish to use the AEX to provide a wireless connection for a device that has an Ethernet port but no wireless capability of its own? You wish to use it in place of a wireless card that isn't internally installed? If so, the answer is, "Yes." It will work as a wireless access point. But you must have an extant wireless network because the AEX won't have an Internet connection when used in this way.
If you have an existing wireless network with a wireless router connected to your cable/DSL model or your modem is a wireless router as well, then the AEX may connect to it in bridge mode. Note that AEXs don't always play nice with non-Apple routers. Some work; others don't.

I just changed the channel on my Airport Extreme and now can't get the Airport Express to recognize the network. What do?

I changed the channel on Airport Extreme to get away from interference. Now I can't get my airport express to recognize the network. What do I do?

I would suggest that you perform a "hard" reset on the AirPort Express Base Station (AX), and then, using the AirPort Utility, reconfigure it "join" or "extend" the AirPort Extreme as appropriate for your networking requirements.

Moved AirPort Extreme and now it won't connect to the internet

I have moved my base station on previous occassions with no problems--plug and play if you will.
I just moved it to a new location and while the computers in the house recognize the wireless network with no problems, the base station no longer successfully connects to the internet.
I have plugged my MacBook Pro directly to my cable modem and confirmed that the internet still works perfectly well to the house. Plugging that same cable into the base station does not bring the internet up.
I've used the AirPort Utility to act like I'm starting from scratch.
I've chosen Manual configuration and replicated all the data from the MacBook's succesful hookup with no success.
I have manually reset the base station and tried the above again, no success.
Any other ideas? It seems too coincidental to me that there could be an actual hardware issue (everything was perfect right before I moved it (I know, I know--that begs the question, why'd you move it? I should say everything was good, except for one room in the house received a weak signal, so I wanted it to be more centrally located)) that arose just as I moved it. My guess is I just need a little tweak to a setting or something but I can't say I understand what all this DHCP stuff is about.
Thanks for your help!

Most cable modems require that you power them off whenever you switch the Ethernet connection from one device to another. The cable modem will refuse to communicate with the new device if you do not do this.
Did you power off/on the cable modem when you switched the connection from the MacBook Pro to the AirPort Extreme base station (AEBS)?
Some cable modems have a reset switch for this task.
Some cable modems have an internal battery which must be removed to do this reset.
Sometimes the cable modem must be left turned off for several hours or even overnight to reset equipment back at the ISP's office.

How far is the range of the Airport Extreme and how much does it boost your Internet speed?

We have a D-link wireless router, and it's worked fine for us, and covers the area around our house easily, but we have lots of other property too, though. I was wondering, what is the range of the Airport Extreme? Besides that, I've seen some communities that say the Airport Extreme is much faster than other routers, but since we have 1 MB per second Internet speed, would that affect speed much? I also was thinking about getting it because we have a USB printer that we'd like to use with our macs, but it would have to be integrated to our network. Our current router has a USB port on the back, but to connect, you have to use Shareport utility, and even then, you can only connect 1 device at a time. It would be nice to be able to convert the USB signal to a network signal.

Hi - it is impossible to know what you are asking without knowing the model of the Dlink - this chart might help you compare - http://www.smallnetbuilder.com/lanwan/router-charts/view - as far as the printer is concerned, the USB port on the Extreme is designed for printers and hard drives - they are recognized when plugged in and seen on your computer so they can be installed - there is no extra utility involved - if you use a powered USB hub you can connect more than one device at a time - http://www.apple.com/airportextreme/features/printing.html - and I recommend that if you decide to try the Extreme that you know what the return policy is in case it doesn't work out in your situation.

New Airport Extreme in Bridge mode -- some devices have no internet access

I just bought a new Airport Extreme as my old one which was probably 7 years old required restarting every day. My setup is as follows: DSL cable modem to Linksys Router (for a long set of convoluted reasons, I can't remove this layer) and then Airport Extreme. This is how I had it set up with my old one. The only difference is I recently started looking into using "Back to the Mac" on MobileMe and in order for it to work, I set my new Airport Extreme to Bridge mode due to dual NAT. I have an iMac, PC, MBP, MBA, iphone 4, AppleTV and ipad. All was working fine last night when I set it up. 24 hours later, for some odd reasons, I can't have my PC accessing the wireless network at the same time. If I did, it would knock my iMac off the network and says some other device is using the same IP address. For a while, only my iMac (my main computer) can access it and even my iphone can't. At this very moment, my iphone, imac and MBP all have access to the wireless network. My MBA and iPad has no internet connection. I've restarted Airport Extreme, Linksys, and modem more than once... If I switch back to "Use Public IP Address" instead of Bridge mode, everything works except for "Back to the Mac"... Help!

Hey Bob, Thanks...I have already repeated that multiple times yesterday and today but to no avail. I tried to get into the Linksys router control panel but unfortunately we can't remember the username and password (the router is not mine). The make things even more complicated, the router is actually part of the internet package provided by the ISP and they use a PPPoE to log in. Theoretically, we could do a hard reset but the problem is the ISP will not release the PPPoE information unless we sign a long and complicated form saying we want to bypass their Linksys router. We can do that but this process will take days and weeks... Our ISP confirmed that the Linksys router is set to max out at 5 DHCP but we can only connect 3 machines at a time. They are coming out to take a look tomorrow but in the meantime I have reset the Airport Extreme to "Distribute a Public IP Address" mode which will allow access to all computers/devices. What's even more weird is that if I did the Bridge mode, it messes up the Linksys router's own network as well. We can't even just sign into that network... Any ideas why?

TS1589 i setup my airport extreme and now i do not have no internet connection

Similar Messages

Maybe you are looking for