TS1717 whilst downloading the Iphone software..it has come up with a message of itunes has detected an iPhone in recovery mode. You must restore this iphone before it can be used with iTunes..if I do this I will lose everything..what can I do?
i was downloading the latest software upgrade when the message "Itunes has detected an Iphone in recovery mode. You must restore this phone before it can be used with Itunes" came up. My option of I phone recovery mode says that it will restore the Iphone to factory mode losing all information.
is there anything I can do to prevent this?
If the iPhone is in recovery mode, all data is already lost.
Restore it.
Similar Messages
-
ok, so i finally found my ipod. I pick it up and it asks me if i would like to download the latest ios6 software so i did. Then moments later it died, ran out of battery. So i pluged it into my computer via apple usb cord. Then this is what itunes says "iTunes has detected an iPod in recovery mode.You must restore this iPod before it can be used with iTunes". All i want is to get my notes from the utilites section there so important to
If i restore it will my notes still be there, i dont want to restore original settings or something like that .
please help me what do i do?You have to restore the iPod, no ifs, ands, or buts...
After iOS is installed you will be asked if you what to set it up as a new iPod or if you want to restore from a backup.
If you have a good backup you can restore that and you're good to go.
If you don't have a good backup, then you end up with a "clean" iPod.... -
when i pluged my ipod classic 5g to PC then it shows “iTunes has detected an iPod in recovery mode. you must restore this iPod before it can be used with iTunes”?then after restoring the PIOD when IPod restarted then Itunes again detect the same ERROR.
If you are using XP, and you went through the procedure at the bottom of the previously linked document to change the iPod's assigned drive letter, and you also tried putting it into Disk Mode...
If you have not already, try shutting down your computer and disconnecting all USB devices, including hub. Start up with only standard keyboard and mouse connected. Just to be safe, put the iPod into Disk Mode again
http://support.apple.com/kb/HT1363
Run iTunes. Connect iPod to a direct USB port on computer. iTunes may prompt you about "recovery" and ask you to do a Restore. Try to do a Restore again. -
I was updating my Ipads software when it just shut off. I turned on the i pad and it gave me this picture of the wire plugging in to itunes. i plugged it into i tunes and i got this message on itunes saying itunes has detected an ipad in recovery mode. you must restore this i pad before it can be used with i tunes. pleasssse help
iOS Recovery Mode -
iOS: Unable to update or restore
http://support.apple.com/kb/ht1808 -
Ipod nano 2nd generation: I cant restore, says, itunes has detected an ipod in recovery mode, you must restore this ipod before it can be used with itunes
What do you mean you can't restore? It's asking you to restore...
B-rock -
iTunes gives me the message that it has detected an iPod in recovery mode and that I need to restore the factory settings. When I click the "restore" button iTunes downloads the software. This is a 30 minute process. Once the download completes, I get the same message "iTunes detects an iPod in recovery mode....". I'm running Windows Vista and ZoneAlarm security software.
I've tried this restore function multiple times and still get the same results.
I've also tried resetting the iPod by holding the wake/sleep button and the Home button at the same time. The iPod turns on but shows the icons of a usb cable connecting to iTunes.
Any help would be greatly appreciated.This maybe yuor problem:
Restore loop (being prompted to restore again after a restore successfully completes)
Troubleshoot your USB connection. If the issue persists, out-of-date or incorrectly configured third-party security software may be causing this issue. Please follow Troubleshooting security software issues. . -
I have tried to update my Iphone 4S today to IOS 7.0.6 and now my iphone wont connect to itunes as it says that it is detected that it is in recovery mode and needs restoring. How do I restore it? I cannot get my phone on at all?
Click restore in itunes.
-
I'm having the same loop message appear when trying to sync my new Ipod Shuffle "Itunes has detected a device in recovery mode. You must restore this device before it can be used w/ Itunes".
I've restored several times but it keeps looping back to the same message. Turns out this message appeared with my last shuffle and I thought possibly the shuffle battery was depleted and it was time to get a new one.
any suggestions?If you restore from backup.
You should have made sure that everything was on your computer bef ore updating anyway. Did you fail to do that?
All pics taken with iphone should be imported to your computer regularly as you would with any digital camera, most especially before any update/restore/etc. Did you fail to do that? -
I reboot the computer, deleted and restart itunes, change computer, change cable, check ping, check connection. need help
Step by step
6. iTune has detected iPad in recovery mode. You must restore this iPad before it can be used with iTune.
7. iPad Recovery Mode on computer screen
8. Select "Restore iPad"...
9. Select "Restore and Update"
10. Extracting Software.
11. Preparing iPad for restore.
12. Waiting for iPad.
13. Verifying iPad restore...
14.Restoring iPad software.
15. Verifying iPad software.
16. Verifying iPad Restore...
17. Restoring iPad firmware...
18. Your iPad is restored to factory settings; keep iPad connected to computer
19. Activate iPad
20. Enter Apple ID and Password
21. Continue
22. Welcome to Your New iPad -
when I wanted to downloaded the new software the phone went of and in my computer saying iTunes has detected an iPhone in recovery mode. you must restore this iPhone before it can be used with iTunes,
my hone is off pls help i need to make calls as i use my phone for work ,
Many Thanks
kerrySo do what it says and restore the phone. Nothing else you can do.
-
Error message on ipad when we tried to download images to computer. 'Itunes has detected an ipad in recovery mode. You must restore your ipad before it can be used with iTunes. It downloaded some images prior to this message and we selected skip any files with errors.
Ipad now just showing apple image with power cord. Don't want to click restore and lose all data.Once the Device is asking to be Restored with iTunes... it is too late to save anything...
To minimise loss... Connect to iTunes on the computer you Usually Sync with and Restore from the most recent Backup...
http://support.apple.com/kb/HT1414
Restore from Backup
http://support.apple.com/kb/ht1766 -
im trying to restore my iPhone 5 and its gone into recovery mode and won't go out I've gone on to iTunes it says that its in recovery mode and to restore it after about 10 seconds it come up with could not restore unknown error occurred (9) i wonder if you could help
you can't update or restore your iOS device
http://support.apple.com/kb/ht1808
If that does not work, take in for service
Genius reservation http://www.apple.com/retail/geniusbar/ -
Hey, my ipad is disabled and i cant open. i tried connecting it with itunes in recovery mode to restore it but it wont work it doesnt show and options itunes doesnt detect my ipad in recovery mode. what do i do know? please help!!!
If you followed these instructions and you were unable to enter recovery mode, I'm still leaning toward a hardware problem. Also, since you have IOS-7, read this. It might help.
-
i'm 11 and my ipod4 is in recovery mode because It's disabled I went to itunes and it said ipod in recovery mode found you must restore so i clicked ok went to files devices but it wouldn't let me click back up whats going on?
Because you can't backup a device that is in Recovery mode.
You have to restore the iPod and restore from backup if you have a backup
For how to restore:
iTunes: Restoring iOS software
To restore from backup see:
iOS: Back up and restore your iOS device with iCloud or iTunes
If you restore from iCloud backup the apps will be automatically downloaded. If you restore from iTunes backup the apps and music have to be in the iTunes library since synced media like apps and music are not included in the backup of the iOS device that iTunes makes.
You can redownload most iTunes purchases by:
Downloading past purchases from the App Store, iBookstore, and iTunes Store -
I did an update on my ipad and now I have to restore it but it says I will lose everything How can I get my pictures on there before I restore my ipad to factory settings?
They will be gone from the iphone, but you should be syning all contacts to your computer regularly and should be importing all pics to your computer regularly, particularly before any update.
Have you failed to do this? -
When i plug my ipod into my laptop, it comes up as a new ipod. It says it can't sync and wants me to restore it to its original factory settings but I don't want to because I will lose everything.
You have no choice but to restore the iPod. You can restore from backup if y have one.
To restore from backup see:
iOS: How to back up
Maybe you are looking for
-
Printing in adobe acrobat 9 standard
when printing a pdf file from a autocad lt 2011 program using adobe acrobat 9 standard program, viewing the pdf file some of the text is missing (random text missing not always the same) this does not happen all the time. does anyone know why this wo
-
Creative Cloud is just circling in my menu bar (10.9.3)
I am trying to download a trial of photoshop, so this is my first install and it just sits and spins.
-
UE or BADI within MIGO Posting
Hi all. I need to call Z transaction within the posting action of MIGO process. I had tried to use MB_MIGO_BADI and MB_DOCUMENT_BADI but when I tried to write set up a break point it didn't stop there. Does anyone has an idea about a specific user-ex
-
Unable to install OS X after restoring
A Friend of my uncle gave this Mac to me and I restored it, but when trying to install OS X it says item temporarily unavailable, I contacted support, but the page crashed twice, they told me that the Mac may be expecting the original id And I dont k
-
How do i end a sub vi when the close window control is clicked?
Hi, I have a sub vi that sits in a while loop until a 'Done' button is pressed but sometimes the user clicks on the close window control in the top left of the window (MacOS) instead. After this has happened I would like control to return to the call