TS2529 My Iphone stops at 4 minutes during the restore process and doesnt budge
My Iphone stops at 4 minutes during the restore process and doesnt budge and it will do that for several other restore times
Any error codes or messages from iTunes? Details please
Details help us help you
Similar Messages
-
Hello
My iphone 4S switches off after showing horizontal lines on the screen cutting through the apple logo during the restore process and then right after my iTunes shows the error 9 message, this happened 2 days ago when my phone just switched off unexpectedily and has been in this recovery mode since then. i have watched videos on Youtube and i have disabled Firewall before starting the process, i think i have done almost everything. please help anyone what do i do from here?
Just for interest sake i watched this video on youtube where this guy had the same problem but the difference is that he had it on an iPad. he opened the ipad up and did something on the ipad, it took less than a minute then his ipad worked.
I would appreciate it if someone would respond to this as fast as they can i am so stressed.
Regards
LwandoRead here:
http://support.apple.com/kb/ts3694#9
Error 9 is usually a security software issue. -
Probably will never ever think of buying a locked phone from AT&T cause its one of the worst system integrations ever that these companies could think of.
The entire problem started when I put in a request with at&t to unlock my iphone 4s (ios7) which did get approved. I performed the entire instructions they asked me to do, which is to backup and restore. After doing those instructions my iphone gave me an error message below
The SIM card inserted in this iPhone does not appear to be supported.
The SIM card that you currently installed in this iPhone is from a carrier that is not supported under the activation policy that is currently assigned by the activation server. This is not a hardware issue with the iPhone. Please insert another SIM card from a supported carrier or request that this iPhone be unlocked by your carrier. Please contact Apple for more information.
Basically saying that at&t hasn't still unlocked the iphone which a really helpful apple executive was able to confirm. I initiated another unlock process from at&t in order to unlock the iphone, just to be sure that its not something wrong from my end. The nice at&t lady stayed on chat with me to unlock the iphone step my step while I was calling the apple tech too. And the apple tech confirmed again that the iphone is locked to at&t.
Now, just a few minutes ago I tried another restore to see if any progress is being made and to my surprise I got an error message saying
Replacement Needed. This iphone is not able to complete the activation process and needs to be replaced. Please visit your nearest apple store or authorized service center.
I feel like I am just going around these two different "money hogger" companies which set certain rules and regulations to screw a regular phone buyer. I purchased this iphone in USA and trying to unlock in India, is it really this hard to simply unlock a device.
For now I am going to try to call a apple office in india (apprently we don't have very many out here) and see if they can help me. But any other assistance regarding unlocking an iphone 4s would be helpful. I have however, tried checking IMEI.info, called up apple, talked to at&t (which always say go talk to apple) I do have a case number from apple as well in case an apple executive reads this discussion forum (case number: 566383594)
ThanksYou got a confirmation from AT&T that it was authorized. Is this correct? - Yes i did get an email authorization on the 21st.
Then you connected the phone to a computer with the latest version of iTunes installed. You clicked on the phone's name in iTunes, then clicked "Backup Now". - Yes
When that finished you clicked "Restore iPhone" (NOT "Restore Backup") - Yes
Are you with me so far? - Yes.
And @ Varjak is right that after the 3rd restore I get the replacement error.
Plus I have NEVER jailbroken the iPhone. To give you another update, I spoke to a really nice apple tech in India who was atleast able to get me out of the replacement error by doing a recovery mode option. However, the lastest restore still gives me the same error
The SIM card inserted in this iPhone does not appear to be supported.
The SIM card that you currently installed in this iPhone is from a carrier that is not supported under the activation policy that is currently assigned by the activation server. This is not a hardware issue with the iPhone. Please insert another SIM card from a supported carrier or request that this iPhone be unlocked by your carrier. Please contact Apple for more information.
Message was edited by: jabgars -
Error 9 pops up when trying to restore Ipod 5. The problem seems to be that my ipod disconnects during the restore process. My ipod is stuck in restore mode so I can't access its update serever. I have already updated my pc and its security settings. Is there anything else i can try?
Hello AS234,
This error is typically indicative of a conflict with installed security software.
Configure your security software
Check your security software and settings, which can block ports and prevent connection to Apple servers during update and restore.
Common errors: 2, 4, 6, 9, 1000, 1611, 9006, 9807, 9844. Sometimes as a result of this issue, a device might stop responding during the restore process.
Resolve specific iTunes update and restore errors
http://support.apple.com/kb/TS3694
Cheers,
Allen -
I am very frustrated. I decided to cancel the restoring process and I can't still access my music because is loading iTunes Match.... this has been going on now for weeks, where i ahve turned off the data mobile and stick to wifi.... Nothing seems to work. Any help mroe than appreciate it.
Hi
You should ask your relative to physically take the iPhone to the store rather than shipping it because as diesel vdub has said:
"No Apple store will accept an iPhone shipped to them"
All you have to do is safely pack and ship your iPhone from the Philppines to your California-based relative.
HTH?
Tony -
I forgot my iPod passcode. I've done the "back up ipod" and restore.
My computer froze in the last 13 seconds and shut off and turned back on.
I tried redoing the whole process, but it won't let me do it.
The passcode is still there and I don't know what to do.If screen-lock passcode
Place the iOS device in Recovery Mode and then connect to your computer and restore via iTunes. The iPod will be erased.
iOS: Wrong passcode results in red disabled screen
If recovery mode does not work try DFU mode.
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings -
How to restore my phone when it gets stuck during the restoring process?
I have got my Iphone 3gs for just over one year. It was completely fine until yesteray. Out of nowhere it just crashed yesterday and has gone into recovery mode ( kept asking me to plug into Itune) . When I tried to restore it using Itube, it got stuck at the stage where it says 'restoring firmware'. I don't know what else I can do? Please help.
I have got my Iphone 3gs for just over one year. It was completely fine until yesteray. Out of nowhere it just crashed yesterday and has gone into recovery mode ( kept asking me to plug into Itune) . When I tried to restore it using Itube, it got stuck at the stage where it says 'restoring firmware'. I don't know what else I can do? Please help.
-
I am using iMovie and can't seem to complete a render of a completed project through the sharing/media browser. Trying to create a medium size movie that I can then access in iDVD to burn a DVD.
But each time I try, iMovie quits on me about halfway through the rendering process.
I have successfully used media browser to create other movies, but now it doesn't work.
Anybody know of any fixes or troubleshooting?
Thanks.
Stuart Schwartz
[email protected]When trying to troubleshoot my problem I discovered a forum that was saying certain NTFS drives work just fine
Apple support says that an NTFS or exFAT drive cannot be used when connected to the AirPort Extreme.
I suppose it is possible that someone might have been using some type of special software on the drive that might perform a "conversion", but without more details, it is hard to know.
Note: ExFAT and NTFS formats aren't supported.
http://support.apple.com/kb/HT2426 -
My IPad 2 is locked with a passcode when I try to restore the ipad halfway through the restore process it is asking for a passcode I do not know the passcode and the IPad was never synced to a computer. Please help
Instructions can be found here.
http://support.apple.com/kb/ht1212
Make sure that you pay attention to the section at the very of the article that talks about having never synced your iPad with iTunes. You may need have to restore the iPad that way. -
HT1339 During the restoration process, how long does this usually take?
I went to use my iPod this afternoon and had a blank screen.
I initially thought the battery was dead, but after about an hour on charge, I still had no screen.
I connected to my itunes and got the message the my iPod had been corrupted.
I selected the restore to factory settings option.
The inital status bar went quick, but now it doesn't seem like anything is happening.
How long will the restore process usually take?Fix: Press center buttun and menu button at the same time for about 30 seconds, or until the screen displays the apple icon. This would be a "soft reset". I did not have to complete the restore operation.
Before restoring to factory settings, try the soft reset first. -
Facing a problem during the clone process
Dear All,
I'm facing error during the clone process and i couldn't found any useful information in the log, the error message is:
| 2% completed
ERROR while running Merge...
ERROR while running perl e:\oracle\prodappl\ad\11.5.0\bin\adclone.pl java=e:\oracle\prodcomn\util\java\1.4\j2s
dk1.4.2_04 mode=stage stage=e:\oracle\prodcomn\clone component=appltop method=CUSTOM appctx=E:\oracle\prodappl
\admin\PROD_odb.xml merge showProgress ... Please check the log for more details..
The logfile :
RC-50208: Exception in method TimedProcessProcess.run
Raised by oracle.apps.ad.util.TimedProcess$TimedProcessProcess: java.io.IOException: CreateProcess: zip -h error=2
System information: DB 9i (9.2.0)
APPS 11i (11.5.10)
Thanks and Kind regardsWhat is the version of the "zip" you are running?
Please make sure you meet all pre-req. software and version in (Using AutoConfig to Manage System Configurations with Oracle Applications 11i [ID 165195.1]). -
My Iphone 4s just stopped during the latest update and now the screen show the Apple icon and an white bar beneath. I can no longer get anything to work on the phone!! Where to from here??
You can not merge accounts.
Apps are tied to the Apple ID used to download them, you can not transfer them. -
InDesign stops responding during the Packaging process.
Design stops responding during the Packaging process. It says it will only take a few seconds, stalls, and then stops responding. Please help!
This normally means that the phone has been jailbroken and discussion of jailbroken phones is not permitted in these formus as it is a violation of the Terms of Use. You'll have to find a solution using Google, if you can.
Copied from http://support.apple.com/kb/TS3694#error1015 :
Error 1015: This error is typically caused by attempts to downgrade the iPhone, iPad, or iPod touch's software. This can occur when you attempt to restore using an older .ipsw file. Downgrading to a previous version is not supported. To resolve this issue, attempt to restore with the latest iPhone, iPad, or iPod touch software available from Apple. This error can also occur when an unauthorized modification of the iOS has occurred and you are now trying to restore to an authorized, default state. -
I missed some steps during the installation process of iOS7 to my iPhone. How do I fix it?
I have a 16GB, white, not jailbroken 4S. During the instalation process it asks me to connect to wi-fi to set someting about the Find my iPhone, iCloud and iMessage. Unfortunately I don't have wi-fi so I just click the "continue " at the top-right corner. How do I fix it? Please help.
What I did was I accept the terms and condition for the iCloud.
I turned on my iMessage. I still have questions.
First for the iMessage, how will you know if you're using the iMessage?
Will there be deductions to my credit if I'm using iMessage?
And my third question is, I press the "Lost Mode" in Find my iPhone app, ask me a number to where the person who found my iPhone can call me, followed some steps, and after a minute it appeared that my iphone is lost and there's a message like "this iPhone is lost, please call this number". Is it normal?
Sorry for having many questions, I'm still not used to iOS7. Hope you can answer all my questions -
My iPhone 4 has become unresponsive during the latest update I have a progress bar about half way through the update and it hasn't moved for about an hour can anyone help???
Hey Ali.M27,
Thanks for the question. I understand you are experiencing issues with your iPhone during an iOS update. If your issues persist, you may need to restore your device in recovery mode:
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
Thanks,
Matt M.
Maybe you are looking for
-
How can I use all tracks from multi-channel source audio with Multicam clips?
I cannot figure this out. Working in Premiere I'm prepping for a 2 camera show, with typically 4 to 6 track dual-system audio recorded by the sound guy. I can sync, and make multicam clips any number of ways–whether sync by timecode, sync by audio, o
-
Start up disk full, computer won't turn on
I have a 2008 Macbook pro, and earlier today it said "start up disk almost full", and did not want to let me download some pictures to the desktop. Now the computer will not turn on at all! It gets as far as the spinner and the apple logo and then th
-
I've bought one of the Apple USB Superdrives thinking I could use it to load DVD's and save them onto my macbook pro, can anyone confirm if I can or can't do this? If I can how do I do it?
-
How to Assign Event to Auth Group
Hello All, Please suggest is there any way to assign Event to Auth Group. Scenario is:- Add event ZHCM* to its own authorization group.These changes to SM64 are needed in order to assign the transaction (restricted to the custom program o
-
Is it possible to recover a foler that was replaced?
A problem has occurred and I was wondering if anyone might know how to fix it. This is what happened. -A folder with the same name existed on a computer and an external HD. These folders had different contents though (all image files). -The folder fr