TS2634 i am getting no sound from my ipod when plugged into the usb connection on a ford mondeo

hi i have a 2009 mondeo with sat nav my ipod works ok with the line in but when i connect via the usb the system recognises the ipod i get all the features but no sound any ideas?

Does Ford say it will work with the 4G iPod?
Contact them.
Sometimes this works:
- Reset the car system
- Reset the iOS device. Nothing will be lost
Reset iOS device: Hold down the On/Off button and the Home button at the same time for at
least ten seconds, until the Apple logo appears.
- Reset all settings      
Go to Settings > General > Reset and tap Reset All Settings.
All your preferences and settings are reset. Information (such as contacts and calendars) and media (such as songs and videos) aren’t affected.
- Restore from backup. See:                                 
iOS: How to back up           
- Restore to factory settings/new iOS device.
It just may not be compatible.

Similar Messages

  • Can't get any sound from my headpeice when plugged

    Hi there,
    Could someone help me out with this? I am unable to get any sound from my headpeice when I plug it in to listen to music. The sound only comes from the phone's speaker. I have reboot the phone but the problem still persist.
    Thank you

    are you using the N900 headset? or a different one?
    (Check your headset conditon using another phone or something)
    *aslo try this;
    after plugged in, rotate your headphone jack slowly..
    **this could happen coz of a app youve installed. So remove apps like headphone demon and apps newly installed.
    ***i got kinda same prob when i bought ma N900 in 2009. But after PR1.2, its gone..
    So check your firmware version and update it...
    "You may loose faith on us.. But never in your selves! From here, the fight will be your own.."
    _____________[Protect Transformers]_____________

  • My IPHONE will not Sync when plugged into the USB port, although the it makes the sound that it is charging, Itunes does not recognize that it is there, what should I do?

    I have restarted the computer, the IPHONE 4, I have checked for updates, and Have reinstalled Itunes.  The Iphone plugged into the usb makes the noise that its charging but nothing else. It does not sync and ITUNES does not recognize its plugged in.
    Please Assist.

    See also Recover your iTunes library from your iPod or iOS device.
    tt2

  • How do I get iTunes to recognize my iPod while plugged into the TC?

    Ok So I have an Apple Time Capsule which I use as my router and NAS drive. Though I also plug my iPod into the usb port on it. The iPod is recognized on my computer and over the network easily although how can I get iTunes to recognize it and be able to add music and video?

    Double-Dee91 wrote:
    I have an Apple Time Capsule which I use as my router and NAS drive. Though I also plug my iPod into the usb port on it.
    Even though it's physically possible, I doubt an iPod is intended to work that way. Why do you want to do that?
    The iPod is recognized on my computer and over the network easily although how can I get iTunes to recognize it and be able to add music and video?
    What I believe you're seeing is the disk drive function of your iPod, which is different from the music player function. I'd give up trying to play music from your iPod while connected to a Time Capsule.

  • I have a problem with the external sound of my ipod, when I take the headphones the music keeps playing and the ipod recognizes still have a headset connected. how do I get external sound out?

    I have a problem with the external sound of my iPod, when I take the headphones the music keeps playing and the ipod recognizes still have a headset connected. how do I get external sound out?

    - Try insering and removing the headphone plug a dozen times or so.
    - Try cleaning out the headphone jack in the iPod.
    - Resett he iPod. Nothing is lost
    Reset iPod touch: Hold down the On/Off button and the Home button at the same time for at
    least ten seconds, until the Apple logo appears.
    - Restore from backup
    - Restoe to factory defaults/new iPod
    If yu still have the problem that indicates a hardware problem, likely a bad headphone jack. Yu can make an appointment at the Genius Bar of an Apple store to confirm.
    If not underwarranty Apple will only exchange your iPod for a refurbished one for:
    Apple - Support - iPod - Repair pricing
    A third-party place like the following is less expensive. Here is one. Google for more.
    iPhone Repair, Service & Parts: iPod Touch, iPad, MacBook Pro Screens

  • I have a macbook pro4.1 and the sound chip in it failed. My speakers and microphone no longer work. Does anyone know of an external speaker and microphone set that plugs into the USB port so I can continue to use both of these functions?

    I have a macbook pro4.1 and the sound chip in it failed. My speakers and microphone no longer work. Does anyone know of an external speaker and microphone set that plugs into the USB port so I can continue to use both of these functions and not have to pay to have the entire main board replaced. Preferably something under $100.

    I don't think you're likely to find a set of external speakers that come with a microphone and plug directly into a USB port. There are USB audio cards that look like tiny flash drives but have microphone and headphone ports in them, to which you can connect a typical two-plug Windows PC headset with a microphone, or else you can connect external speakers and a stand-alone microphone. Those adapters typically cost under $10. I don't know anything about the quality of sound that can be expected from them.
    I have a Griffin iMic, which is much the same idea but larger, a bit more expensive (retail~$40), and perhaps delivers somewhat better sound quality (I hope so, but I don't know because I've never had occasion to try one of the little ones).
    http://www.google.com/products/catalog?oe=UTF-8&hl=en&client=safari&q=usb+sound+ card&um=1&ie=UTF-8&tbm=shop&cid=9618463009759678039&sa=X&ei=tgQoT5zYOMfZ0QHkiICw Ag&ved=0CHcQ8gIwAQ
    http://compare.ebay.com/like/320779457703?var=lv&ltyp=AllFixedPriceItemTypes&var =sbar

  • My iPad 4 wifi 3G keeps charging slowly takes half a hour to get to 15% when plug into the wall with the plug and the lead what come with the iPad just wondering as I think some thing is wrong with the iPad

    My iPad 4 wifi 3G keeps charging slowly takes half a hour to get to 15% when plug into the wall with the plug and the lead what come with the iPad just wondering as I think some thing is wrong with the iPad

    Using the battery level meter in this manner is comparable to using your car's fuel gauge to calculate miles per gallon. The only thing that matters is the total amount of operating time from full charge to auto-shutdown.
    Use the wall-mount charger that came with the iPad and charge overnight.  Do NOT use an iPod/iPhone charger.  Do NOT use a computer's USB port.  Then, operate it normally until auto shut-down (ignore any low level alerts that may appear).  An irony is that doing that test to determine the total operating time is also the procedure necessary to calibrate the battery level meter.
    I'm not claiming that you do not have a problem.  I am stating, however, that we don't yet know.  If the above test does, in fact, indicate a problem, read this.
    Also, according to Apple:
    Use Your iPad Regularly
    For proper reporting of the battery’s state of charge, be sure to go through at least one charge cycle per month (charging the battery to 100% and then completely running it down).
    Elsewhere, Apple elaborates and explains that two half-discharges (or four quarter-discharges, etc.) equals one full discharge.

  • After ejecting a disk plugged into the USB port using Finder, I am now getting "The disk was not properly ejected" message.  This didn't used to happen.  How can this be corrected?

    After ejecting a disk plugged into the USB port using Finder, I am now getting "The disk was not properly ejected" message.  This didn't used to happen.  How can this be corrected?

    When you right (control) click on the disk and click eject "disk name", do you pull it immeadiatly or wait a few seconds for it to unmount? Try waiting and see if you get the same message. If you do, when the disk is connected go to applications/utilities/disk utility, after opening DU, select the volume in question from the left side bar and try a permissions repair, you may also run verify disk and see if it comes up with any errors (they will be in red)

  • MY iPhone 5C suddenly stopped working. It wont connect to my Mac and repeatedly reboots from the apple Logo when plugged into the wall. Help!

    MY iPhone 5C suddenly stopped working. It wont connect to my Mac and repeatedly reboots from the apple Logo when plugged into the wall.
    There is no water damage or anything. I got that checked at the Apple store. I also have Apple Care + but didnt let them give me a new one yet because I have photos on this that I have no yet backed up that are very important. They are the last photos I have with my grandfather. Can anyone help me. Please!

    If the phone shows the "connect to iTunes" screen, the data on the phone is most likely lost.
    Connecting in recovery mode is your only chance to use the phone again, besides getting it serviced by Apple.
    iOS: Unable to update or restore

  • I have an Retina display MacBook Pro with HMDI out port. I also have an HDMI to Component cable with Audio Plugs. How can I get HDMI out to work with this cable when plugged into the Component and Audio ports on my TV?

    I have an Retina display MacBook Pro with HMDI out port. I also have an HDMI to Component cable with Audio Plugs. How can I get HDMI out to work with this cable when plugged into the MacBook Pro and connected to the TVs Component and Audio in ports.

    Will not work.  To my knowledge, dual converting like that isn't supported.  The Mac must detect the connected video output device and that sort of info cannot be done across an analog component uni-directional connection.

  • I was an apple beta tester for iOS7 and now my iPhone 5 shut down, it's unresponsive it gets recognized by iTunes when plugged into the computer but that's it. Since I was a beta tester is there any way to fix my iPhone??

    I was an apple beta tester for iOS7 and now my iPhone 5 shut down, it's unresponsive it gets recognized by iTunes when plugged into the computer but that's it. Since I was a beta tester is there any way to fix my iPhone??

    Are you still running iOS 7 bet?. If so go to the private developer section for help. We cannot help you here with beta software.

  • Iphone 4 unresponsive and flashes apple logo but itunes wont recognise it . when plugged into the mains it turns onto recovery mode and asks to be plugged into itunes, when i unplug it from the mains it turns straight off again

    please help! my iphone randomly went unresponsive, when plugged into itunes it flashes apple logo and itunes doesnt recognise it and when plugged into the mains its in recovery mode, asks to be connected to itunes, but immediately turns off when unplugged from mains

    You could try to do a hard reset, sometimes resetting the phone helps. Hold down the sleep/wake button on the top and the home button until you see the apple logo, this make take a minute or two but this might help.

  • I have several ipod nanos. i can sync one, but since i connected the ipad 2 I am getting an error on two of them, it says cannot sync, error 13019. the loaded songs show on the computer (on the ipods), but not when the ipod is plugged off the usb

    i have several ipod nanos. i can sync one, but since i connected the ipad 2 I am getting an error on two of them, it says cannot sync, error 13019. the loaded songs show on the computer (on the ipods), but not when the ipod is plugged off the usb. Any answers? please

    You can sync your iPod with multiple computers, but what can be synced is very limited.  See this article for more details.
    http://support.apple.com/kb/ht1202
    B-rock

  • After I purchase a song how do I get it into my ipod - the ipod is plugged into the computer

    after I purchase a song how do I get it into my ipod - the ipod is plugged into the computer

    How did you purchase the song, it iTunes? If so, then sync the music to the iPod. See this support document for help with syncing content. Sync your iPhone, iPad and iPod with iTunes using USB - Apple Support

  • Ipod "Click" sound when plug into the Computer

    Hi All,
    My Ipod harddrive clicked periodically when plugged into the computer which never happen before. I can hear the harddrive spin sound but periodically sound clicked in the harddrive.
    Just wondering if anyone experienced this problem before?
    Any suggestion how to fixed it? Is the warranty cover this kind of problem as well?
    THanks for all reply

    Yeah I think so.. Some of the update fixed some problem but some of them make them worse and i hate when apple didnt give the search function on Ipod with video 1st generation
    Just hope my ipod has no problem regarding this issue.

Maybe you are looking for