TS2972 keep getting an error when i try to use home shared with my apple ty 2nd gen

home sharing error it wont connect

Hello mjlamonea
If the update had an error, then check out the article below to restore your iPhone. It will walk you through putting your iPhone into recovery mode and then using iTunes on your computer to restore it. If you have a back up through iTunes or iCloud, then your can put that back up back on after you have completed the restore.
If you can't update or restore your iOS device
http://support.apple.com/kb/HT1808
Regards,
-Norm G.

Similar Messages

  • Why do I keep getting an error when I try to sync my phone with iTunes?  It says I don't have enough privileges.

    Why do I keep getting an error when I try to sync to iTunes? The error says "you don't have enough privileges?"

    Copy all the content on your iPod back to your PC and into iTunes. Then go ahead and sync the iPod with your new library.
    See this older post from another forum member Zevoneer covering the different methods and software available to assist you with the task of copying content from your iPod back to your PC and into iTunes.
    https://discussions.apple.com/thread/2452022?start=0&tstart=0
    B-rock

  • I keep getting and error when I try to start my iTunes. "Apple Application Support was not found. Apple Application Support is required to run iTunes. Please uninstall iTunes, Then install iTunes again. Error 2(Windows error 2)"....

    I keep getting and error when I try to start my iTunes. "Apple Application Support was not found. Apple Application Support is required to run iTunes. Please uninstall iTunes, Then install iTunes again. Error 2(Windows error 2)".... I have uninstalled and reinstalled several times and the error still occurs!!! This started happening after I installed the 10.3 update

    I took the time to research it and come across a couple of people who experienced the same trouble and so I listed some of there steps(with Credits) and  some people said that they worked.
    Here is the original Link:
    https://discussions.apple.com/thread/2151777?start=0&tstart=0
    OK, this worked for me:( Original Post by r0tt3n4pp13)
    1. Save iTunes install file to your desktop.
    2. Disconnect from internet.
    3. Disable Firewall/Security software.
    4. Run install. Note that it installs Application Support and a bunch of other software this time.
    5. Run iTunes.
    6. Enable Firewall/Security software.
    7. Reconnect to internet.
    8. Download Watchmen Director's Cut post haste.
    OR!
    (Original post by Cr4z33)
    1. Download and install WinRAR.
    2. Right-click the iTunesSetup.exe icon and choose "Open with WinRAR".
    3. Once the EXE is opened in WinRAR, double-click AppleApplicationSupport.msi and when the installer window is open choose "Repair".
    4. Done! You can now run iTunes normally.

  • Error Message:  I keep getting this error when I try to download apps or songs :  MZCommerce.CreditBalance Mismatch.Mobile_message   Can someone tell me how to get rid of this?  It is very aggravating when trying to use the IPAD.

    I keep getting this error when I try to download apps or songs :  MZCommerce.CreditBalance Mismatch.Mobile_message   Can someone tell me how to get rid of this?  It is very aggravating when trying to use the IPAD.

    Try to go to Settings and then Store. Tap to your Apple ID and select View Apple ID. Now choose to check your payment information and when you're done tap Done. I had to rewrite my three digit code of the credit card and now it works.
    Oh, I also activated Genius for Apps but I don't think it makes any difference.

  • HT4946 I am upgrading from iPhone 3 to 5. I have backed up my 3 on iTunes. I keep getting an error when I try to download all info to the 5.   The error says I have disconnect my phone but I haven't. Happened multiple times. Any help would be appreciated.

    I am upgrading from iPhone 3 to 5. I have backed up my 3 on iTunes. I keep getting an error when I try to download all info to the 5.   The error says I have disconnect my phone but I haven't. Happened multiple times. Any help would be appreciated.

    Are you running iTunes 11.0.1 (current version)?  If not, get it at http://www.apple.com/itunes

  • TS4020 I get "server error" when I try to use icloud on my Windows 7 pc

    I get "server error" when I try to use icloud.1 on my Windows 7 pc
    How do I resolve this problem?

    Hi doggywag,
    Yes, you must have an iOS device or a Mac to create an iCloud account.
    Cheers,
    GB

  • I am upgrading from Tiger to Snow Leopard. I keep getting an error when I try to load the Mac Os x update combined. It says that it was corrupted during download. Have try loading from Apple website V10.6.7 upgrade combined but it still won't do it?

    I have an Intel Desktop iMac and I am upgrading from Tiger to Snow Leopard. I keep getting an error when it tries to load the Mac OS X update combined. It says that it was corrupted during download. Have try loading from Apple website  Mac OS X V10.6.7 upgrade combined but it still won't do it? Any other suggestions. The printer is not working either - I am not sure if they are connected. Everything else is fine.

    Please excuse, but I have to ask an obvious question: Did you already update using the Snow Leopard Retail install DVD? (You must do this first; 10.6.7 is just an update if you already have 10.6.) Are you, then, trying to update from whatever version was on the install DVD to 10.6.7?
    Otherwise, I'd keep trying. The 10.6.7 Combo is a huge update.

  • I keeping getting this error when i try to scan HVURLHandlerErrorDomain error 1003.)

    i keep getting this message when i try to scan HVURLHandlerErrorDomain error 1003.)

    Your Profile on these Forums does not list which model and version of iMac you are using, nor the verision of OS X you are using, nor which model of Scanner.  Please tell us.
    Hope this helps

  • WHEN TRYING TO DOWNLOAD THE LATEST VERSION OF ITUNES, I KEEP GETTING AN ERROR WHEN I TRY TO OPEN IT. MSVCR80.dll was not found

    AFTER DOWNLOADING THE LATEST VERSION OF ITUNES, I CAM GETTING AN ERROR WHEN I TRY TO OPEN IT. MSVCR80.DLL WAS NOT FOUND. UNABLE TO LOCATE COMPONENT. BEFORE I REMOVE THIS VERSION AND TRY TO RELOAD AGAIN, JUST WANTED TO BE SURE I WOULDN'T LOSE ALL 200 PURCHASED SONGS ON MY PC.

    Click here and follow the instructions. You may need to completely remove and reinstall iTunes and all related components, or run the process multiple times; this won't normally affect its library, but that should be backed up anyway.
    (99220)

  • What is going on with iCloud?  My photos haven't uploaded to Photostream on my computer and I keep getting an error when I try to log in to my icloud account!

    My photos from my iphone 4s have not uploaded to my photostream folder on my laptop in over 2 weeks.  Also, when I try to log in to my icloud account, I keep getting an error.
    Can anyone explain what is going on and when I can expect my pictures to stream automatically again?

    randers4,
    Thanks for your suggestion.  I started to sign off, but was uncomfortable deleting iCal data from my iMac in case there were old entries not sync'd to iCloud.  So I decided to  only delete Notes data from my iMac. 
    I first checked Notes on different devices and saw that they contained more data than my iMac, so I was pretty certain this is what I had in iCloud (another way would be to log on to icloud.com).  I then unchecked Notes under System Preferences>iCloud, which prompted me to delete Notes from this Mac.  I clicked on Delete from Mac, allowed it to finish, then clicked on the Notes checkbox again, and it sync'd the data from iCloud back to Notes on my iMac.

  • I keep getting an error when I try to install reader

    am geting the following error when I try to install reader
    Error 1310. Error writing to file C:\config.Msi\226f17bb.rbf. Verify that you have access to that Directory.

    This may be helpful:
    http://helpx.adobe.com/creative-suite/kb/error-1310-error-writing-file.html

  • Help?  I keep getting "Unexpected Error" everytime I try to use my new Airport Express to extend my network from my 500GB Time Capsule.

    I am trying to extend my network from my 500GB Time Capsule using the new Airport Express I just bought, but no matter what I try I keep getting "Unexpected Error.  Try again".  The Express is still flashing Amber.  I cannot get it to turn green.  What am I doing wrong here?  Please help me.

    Locate the AirPort Express in the same room as the Time Capsule for the setup.
    Power off and restart the Time Capsule
    Shut down and restart the Mac. Turn on the wireless on the Mac and temporarily disconnect the Ethernet cable from the Mac to the AirPort Express. In other words, you want to set up the AirPort Express using wireless, since that is the way that it will be used.
    Hold in the reset button on the AirPort Express for 9-10 seconds and release. Allow a full minute for the Express to restart.
    Click the AirPort icon at the top of the Mac's screen and wait a few seconds for a listing of New AirPort Base Station to appear. Just below that, click directly on AirPort Express.
    AirPort Setup will open up and take a minute to analyze the network, then announce that the Express will be configured to extend the Time Capsule network.
    Enter a device name that you want to use and click Next
    Wait a minute while AirPort Setup configures everything, and hopefully announces a message of Setup Complete. Click Done.
    Now move the AirPort Express to a location that is about half way between the Time Capsule and the area that needs more wireless coverage. Avoid obstructions in the signal path between the Time Capsule and AirPort Express as much as possible. 
    Walls, ceilings, mirrors, heavy furniture, etc. just kill the wireless signal quality. Keep any cordless phones as far away from either router as possible.
    It would be much better if you could plan to connect the Time Capsule and AirPort Express using an Ethernet cable, as best case.....you will be losing about half of the network speed trying to use wireless to extend.

  • I keep getting an error when I try to open iTunes, can anyone help me pleas

    This is the information I get in the Error window
    Error Signature
    AppName:itunes.exe
    AppVer: 6.0.5.20
    ModName: unknown
    ModVer: 0.0.0.0
    Offset: 10001040
    Reporting details:
    This error includes: information regarding the condition of iTunes when the problem occurred; the operating system version and computer hardware in use; your Digital Product ID, which could be used to identify your license; and the IP address of your computer.

    Offset: 10001040
    an "itunes has encountered a problem ..." message on launch citing that offset is almost invariably caused by a broken QuickTime. (itunes needs a fully functional QT in order to work properly.)
    try to open your QuickTime. does it launch properly? or do you get an error message, or some other peculiar behavior, or find that it isn’t on your PC at all?
    if you get an error message (or peculiar behavior, or find that it’s missing), the first thing we'll try is a careful standalone QT 7.1 reinstall.
    download and save a copy of the QT 7.1 standalone installer to your hard drive. (we'll run the install from there rather than online.) switch off antivirus and antispyware applications prior to the install.
    Quicktime 7.1 Installers … get the one that doesn’t mention itunes 6
    if that install goes through okay, does your itunes launch properly again?
    (if you get an error message on the QT standalone reinstall, let us know what it says. include error message numbers if you're getting any.)

  • I keep getting this error when I try to export as pdf or try to print to pdf. Does anyone know how to fix it?

    %%[ ProductName: Distiller ]%%
    %%[Page: 1]%%
    %%[ Error: typecheck; OffendingCommand: showpage ]%%
    %%[ Flushing: rest of job (to end-of-file) will be ignored ]%%
    %%[ Warning: PostScript error. No PDF file produced. ] %%

    I'm having this issue as well. I have tried directly exporting and packaging the file and keep getting error messages. When I initially open InDesign the document has a distiller message error. I'm not sure what that means but I'm sure it's contributing to the problem. After trying Peter's work around it acted like it was exporting but at the last minute failed to. Other ideas/solutions welcome.
    Thanks-

  • Pocket Tunes and Treo755p - keep getting an error when I try to sync

    I just got a Treo755p and I have been trying to add music.  I have Windows Vista on my notebook and I hot sync with BlueTooth and with the cable.  (I have been using the USB cable when I have been trying to add music.)  I downloaded updated Pocket Tunes - version 4.0.7 Bundle.  I have music on my Windows Media Player - but when I try to sync with the Treo - I keep seeing the list with Error beside every song.  There is no error code.  What am I doing wrong?
    Post relates to: Treo 755p (Sprint)

    I banged my head on the wall with the same problem for two days.  Tried everything mentioned, and this worked, finally.  The problem is that the backup files are not where you think they are.
    You need to delete the MobilSync backup folder.  I have a Mac.  Went to /Library/Application Support/MobileSync/Backup and deleted the Backup folder. 
    Fixed the problem.  Give it a try and good luck!

Maybe you are looking for

  • I can't use ePrint or scan with an HP OfficeJet Pro 8500A printer.

    Ever since we got the Time Capsule, I have not been able to use ePrint or scan a document.  I can print just fine.  I think the problem might be that the Time Capsule is blocking some ports.

  • PostScript Imagemask operator and ID preflight

    It appears that EPS images that use the PostScript "imagemask" operator are causing ID CS4's preflight feature to think they're lo-res.  You need to edit the preflight profile and enable the rule that checks image resolution to reproduce this.  If yo

  • IWeb adds "extra" directory in some file paths

    I'm helping a client create a podcast using iWeb. For the record, I have created several functional podcast sites using WordPress, so I'm not a novice. The podcast page is here: http://hauntingofcambria.com/Podcast/Podcast.html You can see that the p

  • Add update to program

    I have created a small software program that installs on a PC. I am wanting to post updates on a web site for people to download. All of the updates eventually need to be placed in the same folder, where the program is installed. I am just looking fo

  • Mms to servlet general methodology?

    I am working on a project that involves mobile device to servlet communication. It allows doctors to submit voice-recorded requests for medical information. The recorded data is run thru speech recognition and nlp software and used to generate variou