TS3274 my ipad says "no service" but I am connected to my wi-fi network?

my ipad says no service although I am connected to my wi-fi

Cellular model? Is the no service in the upper-right hand corner of the device screen?
-MightEMouse

Similar Messages

  • Why does my status in the upper left say no service but I am connected to my wi-fi

    Why does my status in the upper left say no service but I am connected to my wi-fi

    No service refers to the availability of cellular service. If there was no Wi-Fi signal you would see only a dot instead of the Wi-Fi fan symbol.

  • TS3274 Top left says "no service" but bars show Internet and email works. Why does it say no service as everything appears fine?

    At the top left it says No Servive but the bars indicating service are full. In settings it appears I am connected to the Internet. Email works. Everything seems ok. Why "No Service" in upper left?

    No service refers to no cellular service but you may be connected to a WiFi network.

  • HT4623 i just updated my ipad to ios 8 but i cant connect to wifi network..its says my password is incorrect although i know my password is correct as successfully updated 2 iphones and connected to same wifi network

    i just updated my ipad to ios 8 but i cant connect to wifi network..its says my password is incorrect although i know my password is correct as successfully updated 2 iphones and connected to same wifi network

    I had the same problem. I reset my network settings as iOS 8 on my iPad 3 seemed a bit slow. When I tried to reconnect to the wifi the correct password was not accepted immediately.
    after retrying several times it did manage to join the network. The only observation I had was that I had a weak signal and an iPhone next to me at the time.
    make sure you are close to the wifi signal away from any other wifi devices.

  • IPhone 4S says NO SERVICE but able to make calls

    I've had my iPhone 4S several days. When just looking at the phone it can go from 3 bars service, to no service, then it takes a few minutes to pick signal back up.
    Secondly i've noticed that when im on a call.. obviously i start with signal, but then during the call the phone (top left corner) will say NO SERVICE, but i can still carry on with my call, so i clearly do have signal.
    Anything i can do about this?? Or any ideas??

    Haven't seen that issue yet but you could try doing a hard reset (hold down the power and home button together for 15s)  or resetting network settings (settings > general > reset > reset network settings)
    also does it show you as having good service where your at or have you had issues like this before

  • Ipad says no service

    Recently my Ipad says no service on the top left and doesn't let me download apps or upgrade them. I can connect to Wi-fi and use everything else, except that. What can it be?

    Try contacting your carrier as there may be an issue with your account. Or you can try removing and re inserting your SIM card. If that doesn't work try resetting network settings in settings- general-reset. Last Lu, if all else fails do a back up then restore as new to rule out software.

  • Go and use my phone and in the top left hand corner it says no service. i have tried restoring the pone, resetting the network settings and also a hard reset as well.

    I have an iphone 5s and updated it to the new 7.1 software. A day later I go and use my phone and in the top left hand corner it says no service. i have tried restoring the pone, resetting the network settings and also a hard reset as well. It gains service for a short amount of time but then it loses service. Everyone else on my plan has service and their phones are completely normal but they never did the update... what can i do to fix this problem?

    Backup and restore your software via iTunes. If the problem continues, restore as a NEW device. If this solves it, that means there is some corruption in your backup file, or maybe it's one of your apps causing the trouble. If the problem is still there, you should take it to the Genius Bar at an Apple Store for evaluation.

  • I have a new ipad and everything works but can't connect to the app store. Itunes works and the wifi seems to be working but i get a blank white screen when i open the appstore.Nothing will load unter the features or charts tab. Any Suggestions?

    I have a new ipad and everything works but can't connect to the app store. Itunes works and the wifi seems to be working but i get a blank white screen when i open the appstore. Nothing will load unter the features or charts tab so i cant download any apps. Purchased and updates tab loads fine. Any suggestions?

    You would get better response from the iTunes community forum.
    Have a nice day!

  • TS1398 Can't connect to hotspot with my iPad, picks it up but unable to connect. Any sugestions?

    Can't connect to hotspot with my iPad, picks it up but unable to connect. Any sugestions?

    When Access Connections fails to connect it asks if I want to configure the network and there's a bunch of settings. Connection type: infrastructure or Adhoc, Wireless security type "use static WEP keys", "Use Wi-Fi protected Access - Pre Shared Key (WPA-PSK)" - I choose it and under Properties there's more options. Access point authentication, WPA-PSK or WPA2-PSK; I've tried it both ways. Data encryption: TKIP or AES, I've been using TKIP. Under Pre-Shared Key, there's the only box I see to enter a password, so I enter the password there.
    Chances are pretty good that the problem is the network configuration of your PC and not the AirPort Extreme Base Station (AEBS). What configuration options you choose will depend on how you set up the AEBS's wireless network, but the following can be used as a guideline:
    o Connection Type: Infrastructure
    o Wireless Security Type:
    AirPort Setting = PC Setting
    o WEP = WEP
    o WPA Personal = WPA-PSK w/TKIP
    o WPA2 Personal = WPA-PSK w/AES

  • My ipad say no service in the top left hand corner, how can I get it to change

    I recently bought a new I pad.  I installed it and in the top left hand corner where it should say "ipad" it say "no service" how can I get it changed?

    Try going to settings. Tap Reset, tap reset network connection, wait until the apple goes restart your iPad,. Back to setting tap provider and put in your network password.

  • HT1349 Ipad mini need service but inlegible serial number

    My ipad mini is in need of service but the serial number on the back is damaged with a few scratches I cannot start the ipad to get the serial number in IOS neither, The ipad has already been replaced once so the serial on the box will not match and have never synced it to a pc. will apple still exchange under warranty even though the serial number is inlegible?
    Thanks.

    Take it to an Apple Store.
    Make a Genius Bar Reservation
    http://www.apple.com/retail/geniusbar/
     Cheers, Tom

  • When connected to my Mac my iPad says "not charging", but it does seem to sync.  What am I doing wrong?

    My iPad says "not charging" when connected to my Mac, but it does seemo sync.  What am I missing?

    A lot of computers (especially older ones) generally do not provide enough power to their USB ports to charge the iPad at a sufficient rate - it may still be charging slowly, and should be a bit quicker if the iPad's screen is off (if you leave it for a while and then disconnect it from your computer you may find that it's battery percentage has gone up). The wall charger is usually the most efficient way to charge the iPad.

  • On ipad to hp 6500A printer, message says contacting printer, but does not connect.

    New 6500A prints wirelessly ok from vista laptop and desktop. also prints from ipad printbureau app. but when printing direct from ipad email or pic, I get message that it is "contacting printer", but will not go any further to connect

    I have the HP Envy--but it's at my studio and I'm at home so I'm going off memory here, and my understanding of networking is,shall we say, limited. But, as the HP Envy is an AirPrint printer, you don't need Print and Share or any of the other wireless printing apps (although I have Print and Share).
    I have a WiFi iPad 2. After Setting up the Envy, I just joined a local wireless network using the Envy touchscreen and then joined that same network on my iPad. Then, when I choose Print in, for example, Pages, the Envy appears after the Select Printer option.
    All I can suggest is to make sure the Envy has a connection to the same wireless network as your iPad. (in my case I have to select a local network which does not have Internet access as my Envy isn't registered on the university-wide network.)
    (I did complete the initial setup of the Envy on my laptop (MacBook Pro) (and which requires a USB cable for setup) and that gave me printing and scanning options from my MacBook. I don't see how that would have any bearing on the AirPrint function from the iPad.)
    (I do think that the Envy printer is an amazingly useful little printer, especially with the ability to scan to a flash drive or SD card.)

  • My iPad says no service, and cannot connect to the server,cannot get mail .Sim card is locked and down to one last try.My wireless works for other pads and phones.

    IiPad says no service,and in mail says cannot connect to server.Wi Fi is working fine.

    You may not really be connected to your WiFi network.
    Your router may not have given your iPad a valid IP address. Go to Settings > Wifi > your network name and touch the ">" to the right to see the network details. If the IP address starts with 169 or is blank then your router didn't provide an IP address and you won't be able to access the Internet.
    Sometimes the fix can be as simple as restarting your router (remove power for 30 seconds and restart). Next, reset network settings on your iPad (Settings > General > Reset > Reset network settings) and then attempt to connect. In other cases it might be necessary to update the router's firmware with the latest from the manufacturer's support web pages.

  • TS3274 My ipad has stopped responding but the screen is still on. So i cant turn it off because i cant slide the red slider because of the screen not responding. Anysolution on this problem?

    My ipad has stopped responding but the screen is still on. So i cant turn it off because i cant slide the red slider because of the screen not responding. Anysolution on this problem?

    Try a reset:
    Hold the Sleep and Home button down for about 10 second until you see the Apple logo.

Maybe you are looking for

  • HELP!! I'm not getting the security questions reset e-mail from Apple!! D:

    I got an App Store card with €25 and added it to my Apple ID and it worked but as soon as I wanted to buy something, I had to answer my security questions which I didn't know the answer to so I decided to reset my security questions by sending an ema

  • .mac Gallery says Safari is not compatible

    On my MacBook and MacMini I get the message saying my current browser is not compatible with .mac gallery even though it is working fine on my iMac. I haven't had any problems until yesterday (when I uploaded a new set of pictures). Is this a tempora

  • Space bar not working to move the document

    I am having issues with shift-constrain resizing not working, and option-drag duplication not working, also using the space bar to move the document around the viewport. OSX 10.10, InDesign CC. I reset the preferences, restarted which failed to solve

  • Query for the list of publich holidays from the Project Server 2010 for reporting

    I would like to get the list of public holidays that is configured in the calendar from the reporting database. I am not sure if this information is available in the database. Please can you provide with the sql query . thanks Simi

  • SEM - Balance Scorecard: Run-time Variable for value

    Good day, I need to create a CPM Variable for a value that should be entered by the user at run-time. Could you please inform how this would be done? Regards Grant Carelse