TS3274 my ipad will not turn on  The screen is a lighter shade of blue???? HELP!

my ipad will not come on  Its a lighter shade of blue.  I tried holding down the two buttons and it still doesn't work.  HELP!

Did you hold down on the sleep and home buttons at the same time for at least 10-15 seconds? Sometimes it can take a few attempts to get it to work.
But the blue screen that you are describing doesn't sound good. Were you doing anything out of the ordinary when the screen turned blue like did you bang the iPad or drop it....drop something on it?

Similar Messages

  • Ipad will not turn on the screen is just black, using the hone and power buttom together does not fix it

    my ipad screen is blue, using the home and power buttons together do not fix it.

    If you can't reset it by holding the power and home buttons at the same time until you see the Apple logo, then releasing, connect it to your charger for at least 15 minutes then try resetting it again  If it won't reset make an appointment with the Genius bar at a nearby Apple store to have it looked at.

  • My iMac will not turn on, the screen stays black, makes a whistling sound 3 short, 3 long, 3 short, well maintained while keeping on, what solution do you have?

    My iMac will not turn on, the screen stays black, makes a whistling sound 3 short, 3 long, 3 short, well maintained while keeping on, what solution do you have?

    For some reason its firmware seems to have been corrupted. Read:
    About the Firmware Restoration CD (Intel-based Macs)
    iMac (Mid 2007) and later models: About startup tones

  • My iPod touch will not turn on the screen is black?

    My iPod touch will not turn on the screen is black?

    Try:                                               
    - iOS: Not responding or does not turn on
    - Also try DFU mode after try recovery mode
    How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
    - If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
    - Try another cable       
    - Try on another computer                            
    - If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
      Apple Retail Store - Genius Bar                              

  • My iPhone will not turn on, the screen is completely black. It will vibrate while plugged into a charger, but that is it. I have no idea what to do.

    I have no idea what to do please help me!

    Source: http://support.apple.com/kb/ts2802
    Will not turn on, will not turn on unless connected to power, or unexpected power off
    Verify that the Sleep/Wake button functions. If it does not function, inspect it for signs of damage. If the button is damaged or is not functioning when pressed, seek service.
    Check if a Liquid Contact Indicator (LCI) is activated or there are signs of corrosion. Learn about LCIsand corrosion.
    Connect the iPhone to the iPhone's USB power adapter and let it charge for at least ten minutes.
    After at least 30 minutes, if:
    The home screen appears: The iPhone should be working. Update to the latest version of iOS if necessary. Continue charging it until it is completely charged and you see this battery icon in the upper-right corner of the screen. Then unplug the phone from power. If it immediately turns off, seek service.
    The low-battery image appears, even after the phone has charged for at least 20 minutes: See "iPhone displays the low-battery image and is unresponsive" symptom in this article.
    Something other than the Home screen or Low Battery image appears, continue with this article for further troubleshooting steps.
    If the iPhone did not turn on, reset it while connected to the iPhone USB power adapter.
    If the display turns on, go to step 4.
    If the display remains black, go to next step.
    Connect the iPhone to a computer and open iTunes. If iTunes recognizes the iPhone and indicates that it is in recovery mode, attempt to restore the iPhone. If the iPhone doesn't appear in iTunes or if you have difficulties in restoring the iPhone, see this article for further assistance.
    If restoring the iPhone resolved the issue, go to step 4. If restoring the iPhone did not solve the issue, seek service.
    Locate a Service location: https://locate.apple.com (choose your country in the top right)
    Call Apple for Mail-in Service (if available): http://support.apple.com/kb/he57
    Set up service on your own or check options: https://selfsolve.apple.com
    Questions about service and potential costs: http://www.apple.com/support/service/ (Choose your country after selecting your product)

  • TS3274 My iPad will not turn on or power up even when plugged in

    My iPad was down to 20 percent battery.  I turned it off and plugged it in for the night.  In the morning it will not even power on even plugged in.  Only had it 2 weeks

    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    iPad Frozen? How to Force Quit an App, Reset or Restart Your iPad
    http://ipadacademy.com/2010/11/ipad-frozen-how-to-force-quit-an-app-reset-or-res tart-your-ipad
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • TS3274 My iPad will not turn on

    I was in the middle of updating software on my iPad 2 and I needed to use it before I finished updating and I couldn't get it to quit updating so I turned it off, when I turned back on it showed picture of cord with arrow pointing to ITunes. I am not near a computer with ITunes and I don't know how to get back iPad back on. I've tried re-setting by pressing on/off button along with button at the middle of bottom of screen but no luck.

    You need a computer to restore/recover your iPad.
    YOU ARE IN RECOVERY MODE
    1. Turn off iPad
    2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
    3. Plug USB cable into computer's USB port
    4. Hold Home button down and plug the other end of cable into docking port.
    DO NOT RELEASE BUTTON until you see picture of iTunes and plug
    5. Release Home button.
    ON COMPUTER
    6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
    7. Select "Restore iPad"...
    Note:
    1. Data will be lost if you do not have backup
    2. If you did not do step 4 properly, start all over again.

  • TS3274 My ipad will not turn off/go past the black apple screen

    My ipad was generally being slow and unresponsive so I switched it off, when I tried to turn it back on it came up with the Black screen with the apple and has won't come off that. What do I do?

    Press and hold both the Home and Power buttons until it restarts.

  • My IPad will not turn on, despite charging all night and all day. The Apple pops up then goes away. What is wrong and how can I fix it?

    My IPad will not turn on despite charging all night and all day.  The Apple pops on but then shuts off again.  It does this over and over. How can I fix this and get it up and running again?

    Hey bellabeanbag,
    Thanks for the question. The following resource outlines troubleshooting steps if your iPad is not responding:
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
    If iPad won't turn on, or the display stops responding
    Follow these steps, testing after each:
    1. Turn the iPad off and turn it on again. Press and hold the Sleep/Wake button on top of iPad for a few seconds, until a red slider appears. Then slide the slider. Then press and hold the Sleep/Wake button until the Apple logo appears.
    2. Reset iPad. Press and hold the Sleep/Wake button and the Home button at the same time for at least ten seconds, until the Apple logo appears.
    If iPad still won't respond after you restore it
    Follow these steps, testing after each:
    1. If you receive an alert in iTunes while restoring your iPad, refer to this article for instructions on how to resolve common issues with updating and restoring.
    2. If you cannot restore your iPad in iTunes, or if iTunes does not recognize the device, refer to this article for instructions on restoring using recovery mode.
    Thanks,
    Matt M.

  • My iPad will not turn on. I have tried to reset, with no results. I have also tried to restore from iTunes, but it could not recognize the iPad.

    My third gen iPad will not turn on.
    I tried to reset, and the apple icon appears, but it will not load.
    I attempted to restore it through iTunes, but it could not recognize it.
    Any suggestions would be appreciated. Of course, it is out of warranty.

    What to Do When Your iPad Won't Turn On
    http://ipad.about.com/od/iPad_Troubleshooting/ss/What-To-Do-When-Your-Ipad-Wo-No t-Turn-On.htm
    iOS: Not responding or does not turn on
    http://support.apple.com/kb/TS3281
    iPad: Basic troubleshooting
    http://support.apple.com/kb/TS3274
     Cheers, Tom

  • HT201412 my Ipad will not turn on to charge, the apple symbol appears then it blank out

    Ipad will not turn on to charge

    Try a reset:
    Hold the Sleep and Home button down (approximately 10 seconds) until you see the Apple logo.
    Note: Data will not be affected.

  • My 1st generation iPad will not turn off and I have performed the suggested fix. What's next?

    My iPad will not turn off. I have done the off/sleep key home button procedure.

    Just to be perfectly clear, when you reset the iPad by hod,ing down on the sleep and home buttons at the same time for about 10 seconds until the Apple logo appears on the screen, that is a way of resetting the system and restrating the device. If you want to shut down, you still have to hold down on the power button until the slider appears and then slide to the right to shut the iPad off.
    IS this what you are doing and if so what happens when you try to shut down? Describe what happens in detail.

  • My ipad will not turn on when I plug it up, the screen light will occasionally blink

    my ipad will not turn on when I plug it up, the screen light will occasionally blink, thank you

    First, make sure that it's fully charged.
    Then, try a system reset.  It cures many ills and it's quick, easy and harmless...
    Hold down the on/off switch and the Home button simultaneously until you see the Apple logo.  Ignore the "Slide to power off" text if it appears.  You will not lose any apps, data, music, movies, settings, etc.
    If the Reset doesn't work, try a Restore.  Note that it's nowhere near as quick as a Reset.  It could take well over an hour!  Connect via cable to the computer that you use for sync.  From iTunes, select the iPad/iPod and then select the Summary tab.  Follow directions for Restore and be sure to say "yes" to the backup.  You will be warned that all data (apps, music, movies, etc.) will be erased but, as the Restore finishes, you will be asked if you wish the contents of the backup to be copied to the iPad/iPod.  Again, say "yes."
    At the end of the basic Restore, you will be asked if you wish to sync the iPad/iPod.  As before, say "yes."  Note that that sync selection will disappear and the Restore will end if you do not respond within a reasonable time.  If that happens, only the apps that are part of the IOS will appear on your device.  Corrective action is simple -  choose manual "Sync" from the bottom right of iTunes.
    If you're unable to do the Restore, go into Recovery Mode per the instructions here.

  • My ipad will not turn on and is charged, i have also tried a reset and the screen flashes and then goes black.

    My ipad will not turn on and is charged.  I have also tried to reset my ipad by holding in the off/on button and the home button at the same time , but it did not work.  The screen flickered a couple times and then went black.  Is there anything else I can try?

    Hi,
    Does anything appear on the screen at all, e.g: Apple Logo etc?
    You may also find the information here useful: iOS: Not responding or does not turn on
    Regards,
    Steve

  • Suddenly my ipad will not turn on. I used it earlier today ,shu it off and the tried to us it 4 hours latter and it didn't turn off. I held down the button thinking it was an accidental hard shut off but still no response. Has anyone else had this proble

    my ipad will not turn on after using it earlier today has anyone else had this problem?

    If you have juice left in the battery, Reboot your iPad.  Press and hold BOTH the power and home buttons at the SAME time for at least 10 seconds (hold past the swipe to shut down bar) until the Apple Logo appears, then let go of both buttons and your iPad will restart.  It's safe and you won't lose any data.

Maybe you are looking for

  • NO OUTPUT DEVICE ERROR

    Hi Guys Yesterday i reinstalled os x and my audio was working properly..... But from today morning i got no output device error.....it also doesnot work in headphones.... someone do help...thank u....

  • Converting ASCII as Binary... Transposed?

    Hello friends! I am building a VI to break apart a string of characters and convert each to binary code.   Please see the attached example.   When verifying the input string against the output boolean array, I notice that each 8bit code is transposed

  • Unclickable right-click settings menu - Mac OS X

    Hi all, When using Air 3+, on Mac OS X, the settings menu is unclickable. This happens when you load SWF flash content into <mx:HTML. The example below demonstrates the bug. <?xml version="1.0" encoding="utf-8"?> <s:WindowedApplication xmlns:fx="http

  • Not able to start inetd

    Hello, I have one Sun Fire T2000 server and was working fine for quite some time. After rebooting the server, server stopped accepting the network connection because inted was not starting. Following is the output of svcs. I will appreciate help. Tha

  • SAP Fiori Client on Mobile gives a certificate error

    Hi , When i try to open the SAP Fiori  Client App on my android mobile it gives a Certificate Error as seen in the below screenshot. To use the app I connect to the VPN so that the app is connected to the appopriate server.My android version is 4.2.2