TS3274 Screen image doesn't rotate

Screen image does not rotate with iPad position

Is there a lock symbol at the top of the screen next to the battery indicator ? If so, then depending on what you've got Settings > General > Use Side Switch To set to (rotation lock or mute notifications), then you can lock/unlock the rotation by the switch on the right hand side of the iPad, or via the taskbar : double-click the home button; slide from the left; and it's the icon far left; press home again to exit the taskbar. The function that isn't on the side switch is set via the taskbar instead : http://support.apple.com/kb/HT4085
If there isn't a lock symbol then try a reset : press and hold both the sleep and home buttons for about 10 to 15 seconds (ignore the red slider), after which the Apple logo should appear - you won't lose any content, it's the iPad equivalent of a reboot.

Similar Messages

HT4085 Did all of these options as instructed. Screen still doesn't rotate and remains stuck in portrait view

Did all of these options as instructed. Screen still doesn't rotate and remains stuck in portrait view. Help?

Not sure what you've already tried. Have you locked it using the Side Switch then accidentally changed the side switch to permit Muting/Unmuting?
Settings > General > Use Side Switch to: Lock Rotation (make sure check box is here).
Then try sliding the side switch. Also try turning off the device by holding the power and home buttons, then sliding the red slider to the right (then repower).

Screen images won't rotate when I rotate phone

Screen images won't rotate when I rotate phone

It depends on what image you are referring to. Not everything will rotate on the phone, the home screen being one of them. Check to see if Orientation lock is on, it will display a small lock and circular symbol near the battery icon. It is controlled in Control Center. Swipe upwards from the bottom of the screen and Orientation lock is the icon on the far right side of the top row. Tap to turn on or off, white is on, black is off.

TS3274 my ipad doesn't rotate correctly when I turn it. what do i do?

All of sudden my ipad doesn't rotate when I turn it no matter what buttons i push in settings. Has anyone else had this problem & have an answer?

Try rebooting the iPad and see if that helps.
Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up

TS3274 Screen still won't rotate on iPad

Screen won't rotate. The settings show it is unlocked & it's not set to the mute button.
Tried resetting iPad based on other threads & it still won't rotate. Any ideas? Thank you.

If you do not see the padlock icon in the upper right corner, then the screen isn't locked. If the padlock icon is there, the screen is in fact locked. If you don't see the icon, and you have tried resetting the iPad by holding down on the sleep and home buttons at the same time until the Apple Logo appears on the screen, try resetting all settings.
Settings>General>Reset>Reset all settings. No data will be lost but ALL device settings will have to be entered again and that does take some to time to do that again.

The screen image does not rotate.

I have had my iPad2 since Christmas.
Normal use and the screenimage does not rotate.
thanks
Bill

Check the side switch
http://i1224.photobucket.com/albums/ee374/Diavonex/00bf6eae.jpg
Double-click the Home button, swipe to the right and check if rotation is locked
http://i1224.photobucket.com/albums/ee374/Diavonex/a178551c.jpg

IPad 2nd Gen, new upgrade to IOS 7, screen doesn't rotate

I have a 2nd generation iPad that was upgraded to IOS 7 this week. When the pad is rotated. the screen image doesn't rotate, it becomes updside down.
What am I missing?

Understanding the Side Switch
http://support.apple.com/kb/ht4085

Image doesn't match when previewed or exported

Ok, so I have just recently upgraded to the latest version of FCP studio and have been having the weirdest problem with it.
I'm working on a project with two layers of video (a full-screen image with a small box insert. The insert video plays fine but in five spots (out of an eight-minute-long video) the full screen image doesn't play the clip that's put in there.
I've double clicked the clips to verify that they're correct and they look fine on the preview monitor. I tried going in and finding the original shots and replacing them but they are still showing up as the incorrect shots in the sequence monitor. I tried going in to the render files in the document folder and deleting and re-rendering. The problem still re-occurred. I then took off the insert for those clips, rendered, and they looked fine but then when I exported to Quicktime then the wrong images re-appeared in the exported file.
Does anyone have any ideas of what may be going on here, how to fix it, and/or a good work-around?

I wonder if this has anything to do with the MacBook Pro problems?
http://www.apple.com/support/downloads/macbookprosoftwareupdate11.html
That said, I'm not sure I'd run the 1.1 update if you hadn't run the 1.0, there were so many problems with the 1.0...
Are you using filters, or just resizing the overlaid video track?
Patrick

My iPad has locked so the screen doesn't rotate!? How do I un lock it?

My iPad has locked so the screen doesn't rotate!? How do I un lock it?

when you flipped the switch did the roation icon appear in the middle of the screen for a moment?
one thing you can also try is...
Try doing a hard reboot
1. hold the power and home buttons down
2. you will see the "swipe to turn off" screen come up... KEEP HOLDING THE BUTTONS
3. The screen will go black (turn off)... KEEP HOLDING THE BUTTONS
4. A white Apple logo will appear on the screen, now you can release the buttons. Let the iDevice boot... should only take a couple minutes.

IPhone 4 frozen with screen image of usb connector with arrow to iTunes logo. iTunes doesn't recognize my iPhone message says in recovery mode must restore. Try to restore and get - 1 error. What do I do now??

iPhone 4 frozen with screen image of usb connector with arrow to iTunes logo. iTunes doesn't recognize my iPhone message says in recovery mode must restore. Try to restore and get - 1 error. What do I do now??

Hi there beee19,
You may find the troubleshooting steps in the article below helpful.
Resolve specific iTunes update and restore errors
http://support.apple.com/kb/ts3694
Check USB connections
Related errors: 13, 14, 1600, 1601, 1602, 1603, 1604, 1611, 1643-1650, 2000, 2001, 2002, 2005, 2006, 2009, 4000, 4005, 4013, 4014, 4016, “invalid response,” and being prompted to restore again after a restore completes.
If there’s an issue with the USB port, cable, dock, or hub, or if the device becomes disconnected during restore, try troubleshooting the USB connection, then troubleshooting your security software.
To narrow down the issue, you can also change up your hardware:
Use another USB cable.
Plug your cable into a different USB port on your computer.
Try a different dock connector (or no dock).
Add (or remove) a USB hub between your device and computer.
Connect your computer directly to your Internet source, with no routers, hubs, or switches.
If you checked your connections and are still seeing the error message, check for hardware issues.
-Griff W.

My emal screen doesn't rotate

My email screen doesn't rotate but all other screen do, how do I fix that?

Reboot the iPad by holding down on the sleep and home buttons at the same time for about 10-15 seconds until the Apple Logo appears - ignore the red slider if it appears on the screen - let go of the buttons. Let the iPad start up.

Spectre x360 screen doesn't rotate

Screen doesn't rotate when help in portrait or when put into tablet mode

Hello,
HP Support seems not to car about its custommers, so i found a soltuion by myself,
the real settings of screen rotation are on the control panel, please try to find them there, there a box to check/tick, it says "rotate screen automatically" or something like this, once done, the button on the actions center will be able to click on, if you still didn't find it, let me know so I can give you direct location. i'm not on my spectre now.

Outlook doesn't display print screens images sent in my inbox from other people

Hi,
I am using a MacBook Air. My professional Outlook never displays print screens images sent from time to time by other colleagues (they all use PC's with Windows OS), i instead have a little blue question mark icon.
Do i need to download a specific plugin to display those print screens? Could someone help me out with this please?
Thank you for your assistance.
Youjine

Yes, I have added the Page to the Workset, and also the IView to the Page.
If I set up a temporary workset, And assign the 2 objects to it (the IView and the Page), they appear as links at the top of my Portal. When I click the link assigned to the IView, the Inbox is shown. When I click the link assigned to the Page, it only shows a blank window instead of the Inbox.
Michael.

My screen doesn't rotate .

When I turn my iPhone 5s sideways, the screen/picture whatever does not rotate to landscape - is there a setting to fix that that I'm not seeing?

There is a setting in Control Center -- swipe up with one finger from below the bottom of the screen to open Control Center. The orientation lock control is at the far right of the top row (looks like a lock with a circle around it). If on, that same icon will appear in the menu bar. Note that some screens don't rotate even if not lock. Home screen is one example of a screen that won't rotate.

The screen orientation won't rotate.

Please HELP!
I just got my Iphone 4s last month. It's kind of an hand-me-down and I don't know about it's first owner but yesterday it was still fine but when I got home, the screen orientation won't rotate anymore. If I unlock the "portrait lock on" it just reverts back to its landscape orientation and won't rotate no matter how much I turn my phone. I really don't know what to do :(

Hello there, Halloween.
The following Knowledge Base article offers up some great steps for troubleshooting issues with performance of an iOS device:
iOS: Not responding or does not turn on
http://support.apple.com/kb/ts3281
If a single application is not responding or stops responding when it opens, you can force it to close.
If the device is unresponsive or if certain controls aren't working as expected, restart your device.
If the device remains unresponsive or does not turn on (or power on), reset your device.
If there is no video or if the screen remains black, verify that the device has enough charge to turn on:
If you are using an iPad, ensure that it's connected to the USB Power Adapter supplied with the device.
Let it charge for at least twenty minutes, then see if it starts normally.
If there is no image on the screen, press the Sleep/Wake button to attempt to wake the device.
If the screen displays a red battery icon, continue charging the device until the battery is fully charged. Learn more about charging iPhone and iPod touch, or iPad.
If the above steps do not resolve the issue, or the if the screen remains black or shows a persistent Apple logo, try restoring with iTunes:
Connect the device to your computer and open iTunes.
If the device appears in iTunes, select and click Restore on the Summary pane. Learn more aboutrestoring iOS software.
If the device doesn't appear in iTunes, try to force the device into recovery mode, and then restore it.
If the above steps do not resolve the issue, contact Apple.
Thanks for reaching out to Apple Support Communities.
Cheers,
Pedro

TS3274 Screen image doesn't rotate

Similar Messages

Maybe you are looking for