TS3474 How do I get the radio to work on my iPod nano 6th gen?

I have synched my Nano & have music...I have plugged in the earphones, but nothing happens with the radio. I've read the support article about the FM radio, but I don't have any of the radio controls shown in the article--all I have is the radio icon and the Now Playing icon, and when I tap the Now Playing icon, it shows what music is playing, not radio controls. Help!

As mentioned above, the reason is that the FM radio uses the headphone cable as an aerial, so the phone insists on it being connected. It's the same with other Nokias. Apparently there are complicated technical reasons why the FM radio can't use the same antenna as the phone signal.

Similar Messages

  • HT5470 I can't get the radio to work on my Ipod Nano 7.

    I can't get the radio to work on Ipod nano 7.  When I go to the radio screen the following happens 1) the radio screen appears in the backgound with a small rotating icon at its center for few seconds, 2) the screen go blank and small apple icon appears at the center of the blank screen for few seconds, and 3) the home screen reappears. Any suggestions?

    Thanks for the reply.  It turns out my ipod nano was defective.  For some reason it rebooted every time the radio button was pressed.  I tried a software restore and that failed.  Since the unit was just a few days old I was able to exchange it at the retailer.  The FM radio on the new unit works great.

  • How do you get the radio to work ?? - says no radio signal but headphones are plugged in ??

    How do you get the radio to work?  Is another app or download required?  Its a new Ipod nano - 8G, box doesn't say anything about "generation" ?? Appreciate any help
    cr8tivsolutions

    ok, I see now the plug has to be pushed in really tight until the white is flush with the nano

  • I lost my iTunes library on my pc when the hard drive crashed. None of the data on the drive was recoverable and I did not have a backup. How can I get the music that resides on my ipod nano (4th generation back onto the new hard drive on my pc.

    I lost my iTunes library on my pc when the hard drive crashed. None of the data on the drive was recoverable and I did not have a backup either locally or on the cloud. Much of the music is from old vinyl and podcasts which are no longer available.
    How can I get the music that resides on my ipod nano (4th generation) back onto the new hard drive on my pc.
    I have been reluctant to install iTunes on the new hard drive out of fear that I will lose all the contents on the ipod if I try to synch to the new hard drive.
    Help!

    No backup is a huge mistake.
    You can redownload some itunes purchases in some countries:
    Downloading past purchases from the App Store ... - Apple - Support

  • How do i readjust the right and left speaker in iPod nano 2nd gen.

    How do i readjust the right and left speaker in iPod nano 2nd gen.

    Are you playing a song in iTunes that listed in contents of iPod while it is connected. Try going to your music lib and play a song and disconnect your iPod.
    Also, make sure you are not located in some sub dir that utililizes iTunes.
    You can also hit 'ctrl,alt,delete' to see what applications are running on your PC.

  • How much will apple charge me for fixing a cracked ipod nano 6th gen screen??

    Well I don't have any warranty and i want to get my ipod nano fixed! So how much will apple charge me to fix a cracked ipod nano 6th gen screen????

    They won't actually "fix" the iPod, but instead will replace it with an exact refurbished replica.  See this page for pricing.
    http://www.apple.com/support/ipod/service/prices/
    B-rock

  • TS1591 How do I get Itunes 11.0 to recognize my IPOD Nano 2nd gen

    How do I get Itunes 11.o to recognize my Ipod Nano 2nd gen

    Same question here with iPod nano 1st gen and 3rd gen. They all stopped working with the iTunes 11 upgrade.

  • Hey, the stand-by button on my iPod nano 6th gen has been randomly stuck/pushed into the ipod were it does no longer work. How do i fix it?

    Hey, the stand-by button on my iPod nano 6th generation has been pushed into the iPod, I guess after being pressed a lot, to the point were it doesn't work, what do I do to fix this???

    You'll need to take or send the iPod in for service or repair either via Apple or a third party company that does repair work on iPods.
    B-rock

  • Can i get red clock face firmware on my ipod nano 6th gen silver?

    I have an ipod nano 6th gen firmware 1.2 silver and i would like to know if i can get the red or other colour clock face firmware on my ipod.

    I know that but i mean the colour of the clock face like if you get the red ipod you will get the red clock face on the clock number 7-9. Any chance to get it on my silver ipod.
    Thanks

  • HT1364 how can i download from my itunes list to my ipod nano 6th gen ?

    hi can anyone out there help me i purcheased a song from  itunes  it down loaded to my itunes list on laptop but i cant download that song onto my ipod nano 6th gen even thoe it reconises my ipod as before i use to just plug my ipod into the laptop and select down load and it would atomaticly down load song onto my ipod now it wont do that have anyone got any idea why please ?

    It works the same way it has always worked.
    Connect the device to the computer.
    Select the content desired to sync.
    Sync.
    There is no "download" option when an iDevice is connected as content does not get downloaded to devices.  Content gets downloaded from iTunes to the computer.
    Try using the correct terminology and possibly reading the User's Guide... that may allow you to figure this out on your own or ask an intelligent question to get a resolution.

  • My ipod nano 6th gen keeps stopping in the middle of a song, My ipod nano 6th gen keeps stopping in the middle of a song

    My ipod nano 6th gen keeps stopping in the middle of a song

    Double check to make sure the headphones are plugged ALL the way in meaning the white part of the headphones is flush with the Nano and no silver from the plug can still be seen.
    The new headphone jacks are a bit tigher than previous generations and require a little bit of extra force to get the headphones to fully connect.
    B-rock

  • I can't change the lyrics of songs in my iPod nano 6th gen

    I'm using a 6th generation iPod, and I can't seem to change the lyrics in my iPod.
    When I download my music files from melon.com (a legal korean music download site), it already has the lyrics uploaded in the melon site uploaded onto the music file. However, the lyrics uploaded onto the music file aren't accurate, so I go to 'get info'->'lyrics' and change the lyrics to a more accurate one. Then, I upload that to my iPod, but it doesn't show the change on my iPod. The change is made when I connect it to the computer, but it doesn't show on the iPod. Also, the lyrics has spaces between the lines when I never entered any.
    Can you look into this problem?

    Double check to make sure the headphones are plugged ALL the way in meaning the white part of the headphones is flush with the Nano and no silver from the plug can still be seen.
    The new headphone jacks are a bit tigher than previous generations and require a little bit of extra force to get the headphones to fully connect.
    B-rock

  • How do I get the radio to work on my nokia 6230?

    Anyone got any ideas? Tried various things and just can't get it to work. Pls help!!!!!!!!!!

    As mentioned above, the reason is that the FM radio uses the headphone cable as an aerial, so the phone insists on it being connected. It's the same with other Nokias. Apparently there are complicated technical reasons why the FM radio can't use the same antenna as the phone signal.

  • How can i get the SSO to work successfully?

    How can i get the SSO to work successfully?  I followed the note for configuring infoview with ad sso using kerveros & .net.
    Adding the AD group into the win ad authentication configuration page creates the user group but the members of the group aren't being pulled in when I go to the group and select / query the users tab

    Bart,
    By default the setting for update options on the Windows AD tab of authentication does not actually create the aliases until the user attempts to login the first time. We set it this way to prevent a huge group of alias's being created when the administrator sets up Windows AD and also so that only user aliases for users actually using the system get created.  You can change this behaviour though if you like.  Simply change the radio button option to 'New Aliases will be added and new users will be created' this will create the accounts for you when you hit the update button.  If you have a large group your adding I would wait until and afterhours time when you have less activity as this will impact CMS performance while it creates all the accounts.

  • How do I get the iPad to work again after I have erased data (intentionally) and do not have my base computer to plug into to access itunes?

    How do I get the iPad to work again after I have erased data (intentionally) and do not have my base computer to plug into to access itunes?

    If you have iOS 5 installed on it, you don't need a PC.  simply turn it on and set it up.
    if you don't have iOS 5 then you'll need a computer.

Maybe you are looking for

  • ITunes on 1 Win PC - how many different users/devices can share

    Field techies have iPhones but only 1 WinPC in office with iTunes installed....how many users can create new libraries sharing this installed iTunes v10.x??? - to create new library from what I read - hold down shift key while opening iTunes and crea

  • Errors filling up daily.out file, streaming audio/vid problems, how to fix

    I've been experincing some seemingly random problems with my macbook 1) Hard drive suspiciously full 2) Cursor skipping around the screen when using the track pad, I finally disabled the pad and solely use an external wireless mouse. Occasionally whe

  • Data extraction from R/3 Hierarchies to BW

    Hi Guru's I am not comfortable with uploading of  Hierarchies from r/3 to BW. i always get confused . My reporting Scenario is to show cost center ( Regions ), Cost element group , costelements under it and amount corresponds to it. In R/3 I could se

  • Full screen Wallpapers for E90

    Hi guys, I searched the forums but didn't find any info: Is there a way to make a full screen wallpaper on the E90? I would like to make a wallpaper that covers the entire front screen without leaving the top and bottom area blank. Just like those in

  • 4 Billion Standby time?! What's going on?

    Check this out 4 billion days on standby. I don't know what is going on. I'm having problems with my time. Every now and then my time would be 3 hours ahead. When I took this shot it was 9am. On the photo it says 12pm. After a couple of minutes it co