TS3694 i have i phone 3g ios 4.2.1 so i wana to restore so now it is showing an error 1015 so please resolve my problem
i have i phone 3g ios 4.2.1 so i wana to restore so now it is showing an error 1015 so please resolve my problem
Shiv lal wrote:
i have i phone 3g ios 4.2.1 .. now it is showing an error 1015
Unauthorized modification of iOS > http://support.apple.com/kb/HT3743
ERROR 1015...
This Error Code is indicative of the Device being jailbroken / Hacked...
Sorry... But...
The discussion of Jailbroken Devices is against the Terms of Use of this Forum.
You will need to look elsewhere.
Similar Messages
-
Have updated phone to ios 5 now i cannot connect to safari can anyone help pls
I have updated phone to ios 5 now i cannot connect to safari can anyone help pls
The same thing is happening with my wife's iPhone 4 and we can't figure it out. When placing a call, the screen freezes and she needs to restart the entire phone.
She upgraded to 5.01 this morning over the air while it was plugged in. Immediately afterwards, this problem started happening. We've tried restarting the phone several times and plugged in to iTunes but there's nothing she can do do to fix it.
Any help is greatly appreciated! -
my iphone have problem. i was tried to update latest version to phone that time gets freezing. iphone shows only charge plugging can you resolve my problem?????
Hello rj_23_sv,
I would be be concerned too if I was not able to update my iPhone. If you have not resolved the issue, I recommend following article for an issue like this:
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
As always, it is a good idea to create a backup before hand:
iOS: How to back up and restore your content
http://support.apple.com/kb/HT1766
Thank you for using Apple Support Communities.
Best,
Sheila M. -
I have just updated to IOS 7.04 and my mail, calendar and notes are now blank. How do I get it back?
it sounds like you were using iCloud. Go under Settings > iCloud and make sure the switch for Notes is ON (green side showing). If it's already on, turn it off, wait 30 seconds, then turn it back on. Your notes should sync up.
-
I have been given an Apple 3G which is in jailbreak. After restoring and updating my phone to get rid of jailbreak the iphone will not accept any updates or restoration. Unknown error 1015. Please help! I am new to all this and want to start using the phone legitimately.
I believe from the situation you describe your iPhone 3g has the iPAD baseband 6.15.00 which is interfering with iTunes. Remember Apple does not allow downgrade of software typically. The current 3g firmware 4.2.1 has a baseband 5.15.04 which is lower than, what I believe your baseband is of 6.15.00. So to install the current 3g firmware 4.2.1 would actually be a baseband downgrade, which iTunes will not allow. So to fix your iPhone you will have to search the Web like diesel vdub said. There are no parts to buy and your iPhone will work again I promise.
-
TS3694 i have show the error 1015 while restore the iPhone 3g
i have show the error 1015 while restore the iPhone 3g
The phone was jailbroken. You can't get help here. Discussing jailbroken phones is forbidden by the terms of service.
-
The headphone jack on my macbook air isn't working. I have plugged in two headphones and both won't work although they do work on other devices. Any ideas on how to resolve this problem?
update to latest OSX 10.9.3
reset SMC , you likely put your Air into sleep mode with phones attached.
update the OSX to fix the issue. -
Hi, so I pushed autofill because I thought that it would put music on my phone from a different iTunes library but it didn't work, and now the songs show up grey in my music on my phone and they won't play, but they are still there. What can I do to fix this and get rid of the grey songs?
Go back to iTunes, select the Music tab, uncheck the 'sync music; button, then hit apply.
-
I have ipod touch 4G . While updating O/S it stopped in between and now it only shows crashed apple symbol. It is neither turning off nor able to go to main screen. what I see is only crashed apple symbol. What to do?
Download RecBoot and see if that will kick it into recovery mode, so your computer sees it and you can do a restore.
Basic troubleshooting steps.
17" 2.2GHz i7 Quad-Core MacBook Pro 8G RAM 750G HD + OCZ Vertex 3 SSD Boot HD -
I have recently done the update to my iphone and then tried to backup my iphone to itunes and an error meesage has occured and now my phone isn't responding to anything and is stating that it needs to be restored back to manufacturers settings, Can anyone help?
Hi d_diotte,
Thanks for using Apple Support Communities. If you're unable to update your iPhone and keep seeing the "Connect to iTunes" image, this article has some steps you can try:
iOS: Unable to update or restore
http://support.apple.com/kb/ht1808
Cheers,
- Ari -
My I phone is literally dead. I tried upgarding the software yestreday, it refused saying there was an error, I was given an option to restore it, it has failed. Now there is no old software as well as the new software. Its showing a plug and an Itunes signal on top. Thats all that it has. I will be very grateful to receive any form of help out there.
The iOs 5.1 is a huge file that needs to be dowloaded when updating/restoring, your phone hasnt completed the update so its now in recovery mode. Look on the left of itunes, it should say downloads under the store section with a spinning wheel, click that and youll see the update file with a time remaining, wait for that download to finish then try the restore again and it should work
-
TS3694 i have error when i install restore and update in file unknown occurred error 1015
i have error when i install restore and update in file unknown occurred error 1015
http://http://support.apple.com/kb/TS3694#error1015 this should help you with your problem.
-
I have an update for iOS 6.1, but when I select download and store button there is no response. Theire is enough storage to download it. Please help me I need to download it in order to use OU Everywhere application fro the Open University in order to complete my studies.
Kind regards,
KatiaI checked that before, but tried again as you advised and realised that I needed 3.4 GB, which I have managed to get back and it is now working.
Many thanks,
Suseca -
I have tried to install the latest version of itunes to my PC on Windows Vista & I keep getting - "Runtime Error!" R6034 & itunes will not open.
I have tried re-installing itunes but it is the same.....any advice?Try the following user tip:
Troubleshooting issues with iTunes for Windows updates -
I was working on my project on imovie and when I was trying to share it.. it automatically closes and shows an error... I have tried to do it so many times and it shows the same error again and again.. I dont want to loose the document at all.... I facing too much problem plss help me plss its very urgrnt for me... plss help me :-(
well no reply from the community. sniff- do i stink!? - probably a little bit. If i have lost all that data then I'm gonna really really pong.
Any ways i have purchased a 1tb usb HDD and have managed to duplicate the dmg file onto it. however still unable to mount the **** thing. so now i have ordered disk warrior which will be in my possession tomorrow.
fingers toes eyes crossed.
Maybe you are looking for
-
Opening my appleworks file in word 2007
I have a PC at work and used to have a mac at home (I will be getting a new mac in a few months). I have an appleworks file that I saved a while ago that I am trying to open on Word 2007 at work, but there isn't the converter like word 2003 had. Any
-
When does an object gets refreshed, if its state has changed in the cache?
Do I have to use transactional reads for an object to get the changes done by another web application ? Thanks Wolfgang
-
How to search with regular expression
I make pdx files so that I can search text quickly. But Acrobat doesn't provide a way to search with regular expression. I'm wondering if there is a way that I don't know to search for regular expression in Acrobat Pro 9?
-
Restart java application by itself after a while
Hi, I have a Java application that runs on a Time clock (Hand held device). This app. has to be up and run all the times 24/7. After few days the app goes to hung stage, where we need to restart it manually. Is there a way, I can code within the app.
-
A3 and Panasonic Lumix LX3 - recommended
Hi there, just for those who own a Lumix LX3: I am blown away by the results I get from the RAW-files in Aperture 3. Not only have they finally included RAW support for my little gem, the results easily beat those of Lightroom. Especially noise - whi