TS3694 Ipad locked up when doing iOS upgrade . Screen shows iTunes logo and connector . Any suggestions on how to reboot/ restart
iPad locks up when doing iOS upgrade. Screen shows iTunes icon and connector. System will not power up or restart. Any ideas?
FORCE IPAD INTO RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
Similar Messages
-
I just got my Iphone and all its doing is showing the USB cord Logo and the Ituns logo, I need help ASAP!
http://support.apple.com/kb/HT1808
-
i have plugged the ipad into the laptop, but nothing happens and ipad doesn't response anymore
who knows what to do?You are in Recovery Mode.
Follow step 1 to 5 closely to recover your iPad.
http://support.apple.com/kb/HT1808
Note: You may have to repeat the above a few times -
I disconnected my iPad unconsciously while it was updating ios 7.0.4 and it just stuck on that screen showing apple logo and a loading bar that just won't move on what to do now ????
It's not uncommon for it to not work the first time and sometimes, you have to try it a few times. Turn off your antivirus software and your firewall while you are trying to restore the iPad. Enable them again after you restore.
If that still won't work, post back with detailed information as to what exactly does happen as you go through the process. -
i was upgrading my ipad, for atleast 4 hours.. the screen remains itunes.. and i dont know what to do.. please help me
If you have an iPad 1, the max iOS is 5.1.1. For newer iPads, the current iOS is 6.1. The Settings>General>Software Update only appears if you have iOS 5.0 or higher currently installed.
iOS 4: Updating your device to iOS 5 or Later
http://support.apple.com/kb/HT4972
How to install iOS 6
http://www.macworld.com/article/2010061/hands-on-with-ios-6-installation.html
iOS: How to update your iPhone, iPad, or iPod touch
http://support.apple.com/kb/HT4623
If you are currently running an iOS lower than 5.0, connect the iPad to the computer, open iTunes. Then select the iPad under the Devices heading on the left, click on the Summary tab and then click on Check for Update.
Tip - If connected to your computer, you may need to disable your firewall and anitvirus software temporarily. Then download and install the iOS update. Be sure and backup your iPad before the iOS update. After you update an iPad (except iPad 1) to iOS 6.x, the next update can be installed via wifi (i.e., not connected to your computer).
Cheers, Tom -
I updated the IPAD with the latest update and now when I turned the IPAD on, I get the itunes logo and then nothing else. How can I fix this to let me use my IPAD?
YOU ARE IN RECOVERY MODE
1. Turn off iPad
2. Turn on computer and launch iTunes (make sure you have the latest version of iTune)
3. Plug USB cable into computer's USB port
4. Hold Home button down and plug the other end of cable into docking port.
DO NOT RELEASE BUTTON until you see picture of iTunes and plug
5. Release Home button.
ON COMPUTER
6. iTunes has detected iPad in recovery mode. You must restore this iPad before it can be used with iTunes.
7. Select "Restore iPad"...
Note:
1. Data will be lost if you do not have backup
2. You must follow step 1 to step 4 VERY CLOSELY.
3. Repeat the process if necessary. -
Hi, i received my iPad 2, and i tried to use my iTunes, but when I opened it, it showed itunes U and podcast only..no other data like in pc..just only that 2.What i will do? There is no download tabs or anything at all. Please help!
When you erased the disk did you select Mac OS Extended Journaled as the format option?
-
I recently got an iPad and want to use it in the classroom toad in teaching history and geography, any suggestions on how to get started?
I assume you have a data projector to which you want to connect the iPad. You will need the appropriate lead. Is it written material you wish to display? What programmes is your information on?, eg, PowerPoint, Keynote, Pages, Word PDF's etc. A lot more information is required.
-
I tried to download tI tried to download iOS 7.0.4 and have been stuck on a screen with iTunes logo and up arrow and a picture of charger plug. It has been this way for 2 hours. Help??
doreen329 wrote:
... have been stuck on a screen with iTunes logo and up arrow and a picture of charger plug. .
Your Device is in Recovery Mode and needs to be connected to the Computer you Usually Sync with.
Once the Device is asking to be Restored with iTunes... it is too late to save anything...
See Here > http://support.apple.com/kb/HT1808
You may need to try this More than Once...
Be sure to Follow ALL the Steps..
Once you have Recovered your Device...
Re-Sync your Content or Restore from the most recent Backup...
Restore from Backup > http://support.apple.com/kb/ht1766 -
Ipad shows itunes logo and usb
my apple ipad shows itunes logo and usb.
please help to resolve this issue.
thanks
navinIf this a new iPad? You need to connect your iPad to your computer via iTunes to set it up. Make sure you have the latest version of iTunes on your computer.
-
My iPod touch is off and wont turn on because it has the itunes logo and a usb pointing to it, so when i looked it up online, it says i have to restore it but i don't want to because i don't want to lose all my pictures. What can I do?
Try:
- iOS: Not responding or does not turn on
- Also try DFU mode after try recovery mode
How to put iPod touch / iPhone into DFU mode « Karthik's scribblings
- If not successful and you can't fully turn the iOS device fully off, let the battery fully drain. After charging for an least an hour try the above again.
- Try on another computer
- If still not successful that usually indicates a hardware problem and an appointment at the Genius Bar of an Apple store is in order.
Apple Retail Store - Genius Bar -
The lock button on my iPhone 5 no longer locks my phone, but takes a screenshot. Any suggestions as to why and how to fix it?
Sounds like there's actually an issue with your Home button. Screenshots happen when you press both the Sleep/Wake and Home buttons simultaneously.
-
Ipad only shows itunes logo and usb connecter...
my ipad 2 quit in the middle of an app ( I was watching a tv show) and went to the black screen with the white apple logo. I rebooted it and it will only show the itunes logo in the middle of the black screen with a usb cord below it. I cannot get it to respond to anything, i have connecting it to the pc to itunes and done the update and tried to recover the software but it cannot...
Hey RStarks04,
Sounds like this is the image you're seeing?
If so, you'll want to perform a recovery-mode restore. You can read more about it here:
iOS: Unable to update or restore
http://support.apple.com/kb/HT1808
Best,
Delgadoh -
My Apple TV does not work after trying to install the new software update. The main light keeps blinking rapidly and on the screen it shows the itunes icon and a USB cable. What does that mean?
The Apple TV is in recovery mode. Try to restore the Apple TV. Follow the link for instructions on the restore process.
http://support.apple.com/kb/HT4367 -
my screen went black with the iTunes log and USB stick on after iTunes took a reserve copy.
Hard reset or reboot does not work. What can I do next?Your iPhone is in recovery mode. See this support message about how to continue. http://support.apple.com/kb/HT1808
Maybe you are looking for
-
I purchased and installed Family Tree Maker for Mac from the App Store about 6 months ago. I heard that possibly a new version was coming, though I had not received any update notice. I went to the App Store and it no longer shows the app, either a
-
Multiple Portal Authentication when closing Word document
Hi all, We are on EP6 SP2 Patch4 HF7 and CM HF6. When closing a MS Word document accessed from the KM Repository multiple Portal authentication popups appear. This only happens to Word documents. Other documents like Excel, Powerpoint, pdf etc. cl
-
Latest iTunes Setup Does Not Recognize Outlook 2010
I recently had to put in a new HDD in my Dell Laptop (WinXP Pro) and just finished installing iTunes v10.1.1.4 but in trying to setup a sync with my iPhone 3GS (which has all my music, contacts, calendars etc.), iTunes does not seem to find my new in
-
View Database Tables in Multiple Tabs
How do you configure JDev to allow you to open and view multiple database tables in multiple tabs. Currently if I open 1 table and then open another, it loads them within the same tab.
-
Migrate VS SSDT Reporting Project to SQL Server Report Builder?
In the past, I have developed SSRS reports using Visual Studio (BIDS/SSDT). Unfortunately, a company server migration has made it impossible for me to deploy my reporting projects using that devlopment environment, so it appears I have to resort to R