TS3694 what network settings need to be set to update software?

I am having a horrible trying to connect and updatting my ipad. Please help!!

Hello Carl,
to have romaing working fine you need to be sure of following:
1) RF designed correctly , and enough overlapping is availble between the AP's.
in addition for environment to be free from external noise..
this can be confirmed with spectrum expert site survey
2) what authentication and encryption used ( WEP , or WPA-PSK no need to check this point ->> skip :-) )
if you are using any authentication like 802.1x ->> then enable CCKM on the WLAN to make more seamless roaming.
3) if more than one WLC availble on site , configure mobility group between them,
so if client roam from one AP in WLC 1 to AP on WLC 2 ->> no disocnnection observed....
Kind regards
Talal
===========
please rate answers that you find useful , and mark as answered - when it is :-) - so others can find it easily

Similar Messages

  • Network times out on my Windows 7 Lenovo when trying to load IOS 5 on my iPad 2 what network settings do I need to change?

    When I try to upgrade my iPad 2 to IOS. 5 on my Lenovo PC it says the connection had timed out. I have disconnected the firewall and check the connection through the troubleshooting guide on the PC. Can someone tell me what network settings I need to change to make this work? Also iTunes is also up to date on this PC. If I cannot get this to work is there another way I can do a direct update to my iPad?  Thanks so much

    Try temporarily turning off all your firewall and antivirus software until the download has completed.
    An alternative is to try downloading the update via a browser : https://discussions.apple.com/message/16703914#16703914

  • Can't access itunes store or home sharing on apple tv, apple tv 2 keeps saying that network time needs to be set.

    Cant acess itunes store or home sharing on apple tv 2, keeps telling me that network time needs to be set. When I go to time zone section on apple tv - I chose a city...but still no luck. Apparently, can't do anything without the time being set. How do I set this up?

    Yes, I did (turning off and then on again is a way of life for any windows user!). Actually, through a process of trial and error I have fixed the problem although I'm not very comfortable with the fix. For some reason, the OS X firewall is to blame. By relaxing the firewall settings to their most lenient, the iTunes store is now fully accessible via iTunes, and so is the whole of the apple website. Another added side effect has been that general web browsing is now lightning fast.
    I'm therefore left with the (temporary) conclusion that my iMac's internal firewall is only capable of blocking access to the web resources of the people who created it, and slowing my web browser to a crawl.

  • To update my ipod i have to enter network settings, but i dont know what they are? I dont even know what network settings are! any help or suggestions?

    Im trying to update my old ipod touch. Unortunstely it says I have to enter newtwork settings, however I dont know what my network settings are because I dont really know what network settings even means.

    See:
    iOS: Connecting to the Internet

  • I cannot update my ipad2 to ios5.  Updating through iTunes on pc Windows Vista, Error message reads "cannot connect to iPad Software Update Server.  Tried resetting network settings, still not connecting.  Tried updating iTunes, still not connecting.

    I cannot update my ipad2 to ios5.  Updating through iTunes on pc Windows Vista, Error message reads "cannot connect to iPad Software Update Server.  Tried resetting network settings, still not connecting.  Tried updating iTunes, still not connecting.

    Look at iOS Troubleshooting Wi-Fi networks and connections  http://support.apple.com/kb/TS1398
    Additional things to try.
    Try this first. Turn Off your iPad. Then turn Off (disconnect power cord) the wireless router & then back On. Now boot your iPad. Hopefully it will see the WiFi.
    Change the channel on your wireless router. Instructions at http://macintoshhowto.com/advanced/how-to-get-a-good-range-on-your-wireless-netw ork.html
    How to Quickly Fix iPad 3 Wi-Fi Reception Problems
    http://osxdaily.com/2012/03/21/fix-new-ipad-3-wi-fi-reception-problems/
    If none of the above suggestions work, look at this link.
    iPad Wi-Fi Problems: Comprehensive List of Fixes
    http://appletoolbox.com/2010/04/ipad-wi-fi-problems-comprehensive-list-of-fixes/
     Cheers, Tom

  • HT4623 Hi, I need help on how to update software for my ipad1, can someone help me?

    Hi, I need help on how to update software for my ipad1, can someone help me?

    The iPad 1 can not be upgraded beyond 5.1.1. If you haven't upgraded to iOS 5.1.1, see the info below.
    If your iDevice is using a version of iOS lower than 5, you will need to use iTunes on your syncing computer to perform the upgrade. Use the Apple link below as a guide for the upgrade.
    http://support.apple.com/kb/HT4972
    Also read the instructions from the section entitled "Update your device using iTunes" at the link below.
    http://support.apple.com/kb/HT4623
    Information regarding transferring purchases from your iDevice to iTunes on your syncing computer can be found at the link below.
    http://support.apple.com/kb/ht1848

  • HT4972 What network settings do I need to set in order to update my older IPAD.  I has IOS 4.3.3

    I am trying to update my IPAD from iOS 4.3.3 to 5.  I get an error message that I have to reset my network settings?  Where do I do this and to what settings?

    Settings>General>Reset>Reset Network Settings. All that does is make you start from scratch meaning that you will have to join all of your WiFi  networks again, enter passwords, etc. I'm not sure that I've ever heard of this error but it has been years since I was running iOS 4.3.3.
    Anyway, that is where resetting network settings can be found.

  • What profile option need to be set to deny user from login to diff Machine

    Hello all,
    What profile option do i need to be set to deny user access from login on to different machine. I mean a user that logon to Machine A if he/she tries to logon to machine B. Machine A must be disconnected telling him/her that he/she had already logon to a machine before.

    Please see these threads.
    Is It Possible To Block Multiple oracle application logging??? (11.5.10.2)
    Is It Possible To Block Multiple oracle application logging??? (11.5.10.2)
    restricting session in Oracle application
    restricting session in Oracle application
    Is it possible to limit the user to one session?
    Is it possible to limit the user to one session?
    Thanks,
    Hussein

  • Our apple tv keeps saying network time needs to be set

    We have been trying for an hour to get our apple tv to work. Network is up
    , signal strength is strong bit we keep receiving message "network time needs to be reset". We have used it for over 2 years without fail.

    Welcome to the Apple Community.
    Assuming this is not the first time you have used your Apple TV
    You might try restarting the Apple TV by removing ALL the cables for 30 seconds.
    Also try restarting the router.
    If the problem persists, try a restore, you may want to try the previous procedures several times before doing this.
    If this is a new Apple TV, it may also be that your network router is not allowing access to the timeserver, check that your router allows access over port 123.

  • I would like to update my ipad software but under general settings my ipad does not say update software and I would like to update to a ios 5.0 or higher how do I do this?

    I would like to update the version of my ipad from ios 4.3.3 to a 5.0 or higher, but under my ger
    nerel settings it does not say update software. So I would like to know how else I can do this.

    Hello Babs713,
    Which iPad do you have?
    You have iOS 4.3.3; you need to connect your iOS device into iTunes, and update it in iTunes. To update over-the-air you need at least iOS 5.
    Update your device using iTunes: http://support.apple.com/kb/ht4623
    Cedric

  • HT201210 My iPad "settings, general" does not have an "update software" option. How do I update without that option?

    My IPad "setting, general" does not have an "update software" option. How do I update to the most recent version?

    UPDATING iOS
    Over the air updating of iOS needs iOS 5 or later so unless you have iOS 5 or later you will not see updating in setting
    The following link explains how to update
    This link explains  how to update using itunes
    This explains how to transfer purchases to your computer

  • HT4623 my first gen i pad does not have the software update selection on the general settings screen.  How do I update software.

    My first gen iPad does not offer the software update option on the general settings page.  How do I update without this selection

    That only appears when you have iOS 5+ installed, you will need to do the update via your computer's iTunes.
    Connect the iPad to your computer's iTunes and copy any purchases off the iPad to your computer via File > Transfer Purchases - you may also want to copy photos and any important documents off the iPad as well e.g. via the file sharing section at the bottom of the device's apps tab when connected to iTunes, via wifi, email, dropbox etc - they should be included in the backup, but it's best to have a copy of them outside of the backup just in case. You can then force a backup of the iPad by right-clicking the iPad 'Device' on the left-hand side of iTunes and selecting 'Backup'.
    You can then start the update by selecting the iPad on the left-hand side of iTunes, and on the Summary tab on the right-hand side clicking the Check For Updates button.
    Updating to iOS 5+ : http://support.apple.com/kb/HT4972

  • My ipad2 settings menu does not have an update software listed. I'm trying to update to ios5

    My ipad2 settings page menu does not have an 'update software' on it. How do I update to ios5?

    The update to iOS 5 is a lengthy process.  Your entire device is being backed up, then wiped, then the new OS is installed, then your apps, etc., rebuilt on the device.  If you have a lot apps, etc., on your device it will take a long time to update.

  • TS3694 ?? I have Iphone 3G , when i update software & during iphone restore software 3.1.2. i got error 1602. how i can solve it

    ?? I have Iphone 3G , when i update software & during iphone restore software 3.1.2. i got error 1602. how i can solve it ?

    http://support.apple.com/kb/TS3694#USB

  • What settings need to be set for the fastest roaming on my wlc 4404

    Hi all
    I notice that on my WLC 4404 when walking around with my laptop, I am dropping pings when it roams to another access point, Is there anything on the controller I need to check, and can I optimize these settings for roaming?
    cheers
    carl

    Hello Carl,
    to have romaing working fine you need to be sure of following:
    1) RF designed correctly , and enough overlapping is availble between the AP's.
    in addition for environment to be free from external noise..
    this can be confirmed with spectrum expert site survey
    2) what authentication and encryption used ( WEP , or WPA-PSK no need to check this point ->> skip :-) )
    if you are using any authentication like 802.1x ->> then enable CCKM on the WLAN to make more seamless roaming.
    3) if more than one WLC availble on site , configure mobility group between them,
    so if client roam from one AP in WLC 1 to AP on WLC 2 ->> no disocnnection observed....
    Kind regards
    Talal
    ===========
    please rate answers that you find useful , and mark as answered - when it is :-) - so others can find it easily

Maybe you are looking for

  • Using Flash variable in Javascript problem

    I want Flash to load a rss feed and hand it to Javascript which will do the parsing and rendering. AFAIK Javaswcript can't load external documents and include them into the current html page for some security reasons. So I try this approach. I attach

  • Where are my backed up apps after upgrade?

    I just up graded my I Touch to 4.2 and it said my apps were backed up prior to the upgrade. However, now I cannot find them. When I sync to the store they do not auto load. Any ideas where they are and how I can get my apps back? Many of them were ga

  • Portege M200 Display questions

    Hi. I've just received my new M200 tablet pc, but the display is sluggy compared to my Tecra S1 display. It seems like there is something on top of the whole display which makes the picture sluggy and the colours too. This can be seen especially on w

  • Standby database failover flashback restart as standby gap 1-100

    Hi, I have setup a physical standby database for a 3 node RAC primary database and configured the database to run in MAXIMUM AVAILABILITY mode. Both the primary and standby databases use ASM for managing the IO. I have enabled FLASHBACK ON on both th

  • Date Calculation Query

    [code] SQL> DESC MN_EMP_DEP_DET; Name                            Null?    Type EMPID                                    NUMBER(6) NAME1_EN                                 VARCHAR2(20) NAME2_EN                                 VARCHAR2(20) NAME3_EN