Two topics - One a general question and the other related to Mac OS/X 10.4
I need to update my email address and I can't seem to be able to find a way to do in this forum. Can you help me with that ?
The other issue is that since I got my MacBook Pro I am having problems with my USB Flash Drive. Either I can't read from it or write to and I constantly get the spinning beach ball and I have to shut down and restart my computer. Has anyone come across this.
Please remember you have to respond to [email protected] not the address in my profile because I no longer have it.
Thanks
MacBook Pro Mac OS X (10.4.6) Please respond to [email protected]
Change your email address from this page:
https://myinfo.apple.com
For the flash drive question, it may be best to post a topic here where other MacBook Pro owners will be able to help you:
http://discussions.apple.com/forum.jspa?forumID=1149
Good luck.
Similar Messages
-
I have two iPhones, one is a 4s and the other is a 3g. I have not used my 3g in some time now. I recently restored it but I cannot use it without a sim card, it says i have to "activate it." I cannot place my iPhone 4s sim card in it (too small), and i do not want to get a new contract or sim card for an iPhone that i do not ues very much.
Thanks for your help, but i cannot borrow a noral sim card now, my family has all up graded to iPhone 4s's, i have done this before, but one of my family had the same type of iphone so i could use theirs. Now i am the only one who still holds on to their old phone... I am not sure about buying an adapter...
-
Good Morning,
I have a MacBook Pro 15" and my warranty just ran out! I partitioned my harddrive into two partitions, one with Snow Leopard and the other with microsoft.This morning I turned on my Macbook Pro and it will not boot into Snow Leopard. I shut it off took out the battery, reinstalled the battery. Then I put in the Snow Leopard CD and booted up to disk utility and The Snow Leopard partion would not show up?? I do see the microsoft partion.
I also rebooted holding down the shift key and still no Snow Leopard
Could you please tell me what I can do, what keys do I press on restart any advice to get Snow leopard back.
thank you.Have you restarted holding down the Opt key? That procedure should give you a gray screen with all of the partitions that exist. Then select the SL partition for boot. Also go to System Preferences and Startup Disk, unlock the lock and select the SL partition as the default boot partition, then relock.
-
I have two excel files I cannot open or delete from my desktop. One is titled 6ACAD200 and the other file is titled 8D73A700. How can I get these off of my computer?
From the names I'd guess they are temporary files. If excel is running, quit and try again. If they still won't move or delete reboot. If they still won't move or delete...kill a chicken at midnight under an oak tree?
-
Good Evening, I have just purchased a Macbook Pro, and have downloaded two SD cards of a trip to USA and Canada last September. One via Lightrooom 4 and the other via iPhoto. I tried to import the SD card via iPhoto into Lightroom 4 but could not find it. I tried to find this "folder"? via other means with no success. however when I open iPhoto, there it is, so it must be on the Hard Drive somwhere??? I am new to Apple having decided to jump ship from Windows. Would be grateful for any help.
iPhoto is a - like Lightroom - Photo Manager. It's a database. Like any db to get data out you have to export it.
File -> Export
and in this case set the Kind to Original.
iPhoto is a $15 app, LR is somewhat more expensive. As they both want to manage the photos there's no good usage scenario where you use both. Pick one horse and ride, essentially.
This User Tip
https://discussions.apple.com/docs/DOC-4921
has details of the options in the Export dialogue. -
i have two apple id one for Store purchases and the other for iCloud, and i want to merge them into one, can i transfer all app from one to other ?
It is not possible to merge Apple IDs.
-
Can I sync two computers when one is using lion and the other snow leopard
can I sync two computers when one is using lion and the other snow leopard
will my data be shared well using Mobile Me?
-
I need to deactivate two old computers and reinstall CS3 on two new computers. How can I do this if one is long gone and the other just crashed?
contact adobe support and request an activation count reset, http://helpx.adobe.com/x-productkb/global/service1.html
-
I am trying to connect a second monitor on my system so that I have one to work on and the other that I am projecting. Any ideas on how to do that?
connect, then in SystemPreferences/Displays you can set the two as you want.
-
Hi ,
Please check the output of the commands
[# vmware-config-tools.pl -h
VMware Tools 3.0.2 build-52542 for Linux configurator
..# vmware-checkvm
VMware software version 6 (good)
So which command do beleive ? One says ver 6 and the other says 3.0.2 ?
Thanks,Hi ,
Please check the output of the commands
[# vmware-config-tools.pl -h
VMware Tools 3.0.2 build-52542 for Linux configurator
..# vmware-checkvm
VMware software version 6 (good)
So which command do beleive ? One says ver 6 and the other says 3.0.2 ?
Thanks, -
I have two computers, one runs Windows 8.1, the other runs Windows 7.
I have two computers, one runs Windows 8.1, the other runs Windows 7. Can I put Premier Pro, or any of the suite, on both computers at the same time?
Cloud License allows 2 activations http://www.adobe.com/legal/licenses-terms.html
-Install on a 2nd computer http://forums.adobe.com/thread/1452292?tstart=0
-Windows or Mac does not matter... 2 on the same operating system, or 1 on each -
I have two airport extremes, one acting as a modem and the other operating in bridge mode. The extremes are connected using ethernet, but remain connected even when I disconnect the Cat5a cable (I did this to check that the 100 feet of Cat 5a cable connecting them was working). How do I find out if they are operating wired or wirelessly? I want to know as I assume I will get much better speeds if they are wired.
Hi Bob, many thanks for the prompt response. I think I did what you suggested, but you're the expert so I have sent over a few screenshots. The extreme in question is High Birches Home Office (the rest of the network has been in place and working well for some time). My new home office is going to be in the garden, circa 100 feet from the main house. I have installed armoured Cat5e cable down to the shed that is going to be adjacent to the home office once built and situated the High Birches Home Office Airport Extreme there temporarily. Everything works well, so I was surprised when I unplugged the ethernet, that it still worked. I also tested the ethernet cable by switching off my laptop's wifi and unplugging the cable from the airport extreme and directly into the laptop and that worked ok.
If the screenshots below (I did every Airport utility tab for the High Birches Home Office) don't tell you anything more, then the set-by-step instructions would greatly appreciated so I can ensure I completed the steps correctly.
Many
Thanks, Greg. -
In the applications folder I see two iphoto apps. One labeled iphoto (copy) 376 MB/ version 8.l.2 and the other iphoto (original) 346 MB/ version 8.1.1 . Have no idea what I did. Can I delete one of them?
I have iphoto library manager installed and used it for the first time just recently. I merged my photos into one library.
Any help would be greatly appreciated.
Thank you,
LucyKeep the latest verson. But, as Larry cautioned, open it before deleting the other one to make sure it performs as expected.
OT -
I have google toolbar installed on my Firefox 4, whenever I start firefox two tabs open, one is my homepage gmail and the other is "google toolbar updated".
How can I stop the second tab from opening?See these articles for some suggestions:
* [[Firefox has just updated tab shows each time you start Firefox]]
* [[How to set the home page]] - Firefox supports multiple home pages separated by '|' symbols
* http://kb.mozillazine.org/Preferences_not_saved -
I have 2 gmail boxes on my MacBook Pro. One is mine and shows as Gmail and the other is my husband's which shows as his email. When I send an email, it has my email address in the From line automatically, but when someone replys it comes back to my husband's email box. How wo I fix this?
I have this exact problem. I have 3 email addresses on my mac and I can select one, and the email still be sent through another account and I won't know it until I get a reply for that email in one of the other accounts.
MacBook Pro, Mac OS X 10.9
Maybe you are looking for
-
I plugged my iphone into my computer, clicked "Check for Updates" and it downloaded the software and installed it.. and then while it was "Verifying Software Update" it gets an error saying "The iphone "iPhone" could not be updated. An unknown error
-
Variable Costs using SKF in Indirect Activity Allocation
Hello I am trying to use indirect activity allocations and KSPI to transfer costs from an activity in an indirect cost center to multiple direct cost centers. The Receiver tracing factor is planned SKF (i.e. number of employees). The issue I have is
-
Since we now have the free XE, does that mean the personal edition is going away? Just curious. Thanks, LewisC http://blogs.ittoolbox.com/oracle/guide/
-
Flash Builder 4.7 Windows 64 bits MXML visual editor ?
Hi, I installed Flash Builder 4.7 for windows 64bits, but I can not edit mxml in visual editor, no visual flap. Tanks.
-
Line weight will not reduce below 1pt
I'm creating vector files for a laser cutter, which requires cut lines to be weighted at .001. This normally works fine, but for certain shapes, the weight keeps resetting to 1. This seems to happen at random, whenever I create a shape with a pen of