UC560 Forced Authorization Codes (FAC)

Question

Hi All,
Has anyone gotten FAC to work with the UC560? The box only crashing when the voip is enabled. When i shutdown the voip it makes the calls successfully.
can help is greatly appreciated
here is the configuration
Place the files in flash enter_account.au and enter_pin.au
aaa authentication login default local
aaa authentication login sdm_vpn_xauth_ml_1 local
aaa authentication login h323 local
aaa authorization exec default local
aaa authorization exec h323 local
aaa authorization network sdm_vpn_group_ml_1 local
aaa authorization network h323 local
application
service clid_authen_collect
  param uid-len 3
  param pin-len 6
dial-peer voice 50 voip
service clid_authen_collect
destination-pattern 9[2-8]......
session target ipv4:192.168.20.1
incoming called-number 9[2-8]......
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
dial-peer voice 100 pots
destination-pattern 9[2-8]......
preference 1
port 0/1/0
forward-digits 7

Answer 1

Hello Andrian,
There are a few things I noticed, not sure if they are just left out, or not configured.
Your config does not have any usernames/passwords configured, and the dial-peer is pointing to the CME address.  Here is the info I found, with the steps to configure FAC.
https://supportforums.cisco.com/docs/DOC-9795/
application
service clid_authen_collect
  param uid-len 3
  param pin-len 3
aaa new-model
aaa authentication login h323 local
aaa authorization exec h323 local
aaa authorization network h323 local
username 201 password 123
username 201 autocommand exit
username 202 password 321
username 202 autocommand exit
dial-peer voice 5500 voip
description International Calls
service clid_authen_collect
destination-pattern 9011.T
session target ipv4:10.1.1.1
incoming called-number 9011.T
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
Thank you,
Darren