Unable to extend the standard datasource 2LIS_13_VDKON

Question

Hi
we are unable to extend the standard datasource 2LIS_13_VDKON on the
SAP by the following fields: MCKOMV-KNUMA_BO, MCKOMV-KNUMH and MCKOMV-KNUMV. We allways get the error message "End phase 002 - D0322".
best regard

Answer 1

Hi farchid,
i checked that one, but you can ignore that one.
please check the data source status is green that's it. after including that fields in the data source the status change to red. then go to data source maintenance screenselect the field selection check boxand then save it.
now the status changes to yellow.
now select inactive link against your data source in job control--status will turn as green.
now you can do the set up table fill up for that data source.
before doing the transport please make sure the following conditions. this will be displayed when your enhancing the data source.
Extract structure MC13VD0KON generated successfully, see long text
     Notifications MCEX 027
Diagnosis
     The extract structure was generated successfully.
Procedure
     Now choose the maintenance screen of the DataSource. After that, the
     status display (traffic light) jumps from red to yellow.
     Please make note of the following before you transport the changed
     structure MC13VD0KON into another system:
     o   Run the transport when the target system is not being booked.
         Otherwise you will need to initialize it because documents are lost
         during this time. 
      o   None of the clients in the target system in the V3 update for the
     application 13 should contain data. If you are unsure, start the V3
     update of the application 13 in all clients.
o   If there is still data in the central delta management of the target
     system, it must be retrieved by BW before the transport takes place.
o   If you have already reconstructed within this target system, it may
     be that the data still exists in the reconstruction tables. After
     the transport, you can no longer transfer these entries into BW. You
     must delete the contents of the reconstruction tables of the
     application 13 in the target system and run another reconstruction
     if need be.
o   If there is an update log in the target system, you cannot read the
     log data of the application 13 after the transport has been run. You
     can only read it again once data is booked and the last log entry
     overwritten.
Use the report RMCSBWCC to display a log for the changed extract
structure in the target system, to see if any of the above problems
exist. An additional switch deletes all update logs for the application
of the selected extractor.
Please also note that you must reactivate the transfer structures when
you change the extract structure after replicating a DataSource.
hope this help you
regards
harikrishna N