Unlocking T-code

How to unlock t-code locked in SM01

Hi Rohit,
U can lock and unlock the TCode in same SM01 itself.....
Regards,

Similar Messages

My ipod touch is stolen with code, can he unlock my code? I thought it could only be done if it was plugged in with the last used computer

Someone stole mu ipod touch, but can the thief unlock my code? Some people say it can be done by resetting it on a computer, please answer

hosert,
They can reset it by restoring your device to factory settings via iTunes on his or her computer, but when they do that they erase all YOUR content and settings in the process. Either way, I would change the passwords to the all the accounts you were using or had set up on that iPod.
B-rock

How do I unlock pass code?

How do I unlock pass code on ipod touch 32g?

If you cannot remember the passcode, you will need to Restore your device...
Connect to iTunes on the computer you usually Sync with and Restore...
http://support.apple.com/kb/HT1414
If necessary Place the Device into Recovery mode...
http://support.apple.com/kb/HT1808

Unlock Security Code of the device

I have a problem with a Blackberry Torch.
I use a security code for the device, now i have try 8 times the correct code acces, but the phone don't accept this code.
How can i unlock the phone?
Thx!

If you remember the password write it down, make sure you are putting the characters correctly, at the last instance it will wipe all data from your device. You can wait for some time, do a battery pull and check if it starts from 2/10. Chances are you are making a small mistake. If you have all your data backed up you can proceed till eht security wipe. The device password is not recoverable if forgotten as a security measure.

Unlock pin code for macbook air

i have some problem with my macbook air someone try to type the password wrong for more time and i have message the system is locked enter the pin code to unlocked your Mac
and I’m in Egypt and no apple store here I’m sharm el shiekh , can i send you the serial number to send me the pin code ,

I have now unlocked firmware passcode.
First ever!
I CAN MAKE SOME CASH NOW!!!!

Unlock Pin code

Hi,
Was testing out the find myac and it set the (Enter your system lock PIN code to unlock this Mac) now I can't unlock it. Any one have any ideas how I can unlock it.

Here's my guide: How to: Unlock System Lock PIN Code

To unlock t- code scc5

hello sir
i am using education version demo of sap4.7. i have a problem in t-code scc5 delete client. The scc5 t-code is lock. how can i unlock the t-code scc5 in sm01. plz tell me the procedure.

very helpful link ...
Re: How to lock transaction codes in ABAP report
plus you can unlock with SM01.
Regards,

Retrieve your PUK (Personal Unlock Key) code

Your Personal Unlocking Key (PUK) is an 8-digit code linked to your SIM that can reset your mobile PIN. Without your PUK, you'll be unable to unlock your mobile device.
Find your PUK using one of these three methods:
Method 1
Log in to My Account
Select the relevant account or service from the 'Account number' drop down list
On the Plans & Usage page, select the mobile service to find your PUK
Method 2
Visit telstra.com/pinpuk
Enter your account details including mobile number, first name, surname, and date of birth to find your PUK
Method 3
Log in to the Telstra 24x7 App with your Telstra username and password on another device
For iPhone or iPad, go to Settings and select PUK to find your code
For Android, go to Settings and select PUK from the top right drop down menu to find your code

Re: How can I unlock an iphone?
Bought phone off friend, Telstra told her the iPhone was unlocked, put Vodafone sim in for 10 year old daughters Xmas present, it's still locked to Telstra! Want it to work ASAP and cannot get help

HT1766 how to unlock pass code

forgot my pass code lock code. How do i unlock my iphone 5? Pls help! Thanks!

http://support.apple.com/kb/HT1212

Unlock phone code

hi i am using the blackberry curve 8520 and my ime no. is =354908046944019 and i have been trying to get my phone unlocked through vodafone for months and there are not very helpfull , they keep telling me that they have looked for the code from blackberry and have not got back to my, so i have decided to ask myself for the unlock code, if you can please help that would be great.
thank you

You can try HorizonWirelessOnline.
tanzim
If your query is resolved then please click on “Accept as Solution”
Click on the LIKE on the bottom right if the post deserves credit

Unlock keyboard code for Nokia 6300

I think this is a common topis at this section:
I have set an unlock code for keyboard for Nokia 6300 and I do not know it anymore; now I look at my pretty phone and I cannot use it.
Does anybody know how to unlock the keyboard in these conditions, without the code I have set ?
Solved!
Go to Solution.

As always visit to Nokia Care facility with proof of purchase required as there is no longer an IMEI related algorithm mastercode. More details can be found here: http://conversations.nokia.com/2013/08/12/mobile-mythbusting-all-you-need-to-know-about-your-nokias-...
Happy to have helped forum in a small way with a Support Ratio = 37.0

Phone Unlock/Security Codes

PIN (Personal Identification Number) Code
This is the SIM (Subscriber Identity Module) card PIN code which is only available from your network.
PUK (Personal Unblocking Key) code
If you enter the wrong PIN Code more than 3-5 times you will require the PUK Code to unlock the SIM card. Once again this code is only available from your network.
Security/Lock/Unlock Code
The default unlock for most Nokia phones is 12345 unless you have changed it. Normally this code can only be reset by the Nokia Care Points. You will need to provide proof of purchase. However a few S60 models can be reset to the default code by reformatting the phone.
There have been cases of this code being changed by certain networks. When this is the case, the security code will be on the label on the box, close to the IMEI (International Mobile Equipment Identifier) number. This number will be a 5 digit number but not necessarily marked as a security code.
Some S40 5th edition phones, such as the 6500 Slide or 6301, don't always have a preset lock code. In these cases, you will be prompted to create the code the first time you try to perform an action that needs one (such as clearing logs or restoring factory settings). You can also create the code from the Settings>Security>Access Codes menu.
Restriction Code
This is the code to remove networks restrictions (also known as a SIM lock) and is available from the network. See this post for instructions on how to use this code.
/discussions/board/message?board.id=topfaq&thread.id=55
Message Edited by petrib on 14-Nov-2008 10:48 AM
Message Edited by mccbleue on 04-Dec-2008 09:50 PM

Hi ,
I'm not too sure if they're able to do that. You could try tweeting them, they're @EE on Twitter
Cheers,
Titanium

New iPad asking for passcode but I never set one - how do I unlock a code never set?

Just got my new iPad yesterday, have no kids or anyone else around who would mess with it while I'm in another room - go to wash the dishes, come back and it's asking me for a passcode to unlock. I had it running all last night - turned off, turn on, sync with macbook pro, blah blah blah, everything is great until tonight. What's going on? How do I unlock it?

Is your iPad new in the sense of being brand new or is it the latest generation?
If you do not have very much on it you could connect it to iTunes on your computer (if you use one) and on the screen that pops up starting with the Summary tab click on the Restore button further down. Be sure to set it up as a new device? You will lose any saved data but at least it will unlock your device. Alternatively, you could could do it through Settings on your ipad. Either way, you my have to redownload your purchased apps again.

In my template, the code is grayed out and I am unable to edit it. How do I unlock the code?

I have a website based on a template. (Dreamweaver CS6). Just recently, the "code view" in the template is grayed out, and I am unable to edit it. I can edit the template in design view. I would appreciate suggestions of how the code got grayed out- or locked up. Thanks in advance.

Thanks everybody- I found a thread on a forum which solved my problem. In Dreamweaver: Commands → Clean Up HTML → (make sure non-Dreamweaver Comments" is checked. This clean up made the template then editable.
Thanks everyone.

Hey i have an iphone 4 and i dont know how to unlock the code

fadsfs

locked out Pass Code
Device disabled after entering wrong passcode
http://support.apple.com/kb/ht1212
Understanding PassCode
http://support.apple.com/kb/HT4113

Unlocking T-code

Similar Messages

Maybe you are looking for