Unterminated errors using NI's IVI (AG6000) with Agilent's DSO5054A Oscilloscope

Question

Hi,
I keep getting timeout errors when using the IVI file ag6000 with Agilent's DSO5054A Oscilloscope over GPIB.  Using TestStand, I am able to calibrate the o-scope about 50-60% of the time and read from the o-scope about 2% of the time.  When sending a command using the IVI, the o-scope typically displays "query UNTERMINATED."  Attached is the error TestStand gives when it is not able to talk correctly.  In MAX, I can talk to the o-scope using the GPIB communicator tool 100% of the time.
Is there an updated version of the ag6000 IVI file that works with the DSO5054A that I don't know about?
Thanks.
Attachments:
Common Error.JPG ‏115 KB

Answer 1

I believe I am giving enough time for the commands.  What I meant was that I know the NI GPIB card is good, the cable is good, and the o-scope is good, it is just the o-scope just does not like the signals sent using either the LabVIEW LabWindows/CVI Measurement Studio for Visual Studio IVI or the LabVIEW Plug and Play driver.  The site takes me from the DSO5054A page to a 6000 series driver, although according to the description it should work with the o-scope.
http://sine.ni.com/apps/utf8/niid_web_display.model_page?p_model_id=10028
Using the above IVI/Plug and Play drivers, the DSO5054A reads the correct signal but unterminated, so it doesn't know what to do half the time.  In TestStand, I added in the initiate command and added a wait of 10 seconds, and when it doesn't timeout on the calibrate command it will timeout on the fetch/read command.  In LabVIEW, using the read single waveform.vi the GUI displays the signal from the o-scope about 10% of the time, while the rest of the time it times out with error code -1073807339.