Using 3G car charger

Does anyone know if it is possible to use a basic car charger originally intended for a 3G model on the new iPhone 4? It plugs in properly but I want make sure that it wouldn't damage the new phone.
thanks.

It won't do any harm to try. Some older chargers will work, others won't. With the 3GS Apple dropped support for charging on the firewire pins, which some car chargers use. If its a USB charger it should work.

Similar Messages

  • HT4060 Can I use IPhone car charger to charge my IPad when traveling?

    Can I use a car charger for an IPhone to charge my Ipad when traveling?

    Not effectively
    All iphone charger in car and wall chargers produce 5w
    the iPad requires 10w ,you can get 10w USB plugs to fit the car
    power socket ( cigarette lighter)
    Belkin and Griffin make quality versions of the charger

  • Can I use the car charger for my 3gs on my iphone 4?

    Can I use the car charger for my 3gs that i bough in the att store on my iphone 4?

    With the 3GS Apple dropped support for charging over the firwire pin on the dock connector. Some older chargers will only supply power over the firewire pin, and thus will not work. There are adapters that will fix this, here's one example:
    http://www.griffintechnology.com/products/firewire-to-usb-converter

  • HT1665 can ipad 2 and iphone 4s use same car charger?

    can ipad 2 and iphone 4s use same car charger?

    Perfect! A straight answer, finally. and one that this poor ancient techno challanged human could even understand!!!!!!!  Thank you so very much!

  • Can I use my car charger in England?

    I am going to England and want to use my car charger to charge my iPOD. Will my American charger work in a British car? Thanks!!

    Thanks so much! I could have saved alot of time looking thru this website if I would have just posted the question in the forum first!

  • Keeping zen micro backlight on when using the car charg

    Is there any way to keep the backlight on, when using the car charger. I have my zen micro hooked up the my car stereo. It would be nice to be able to see the screen at night. The lights for the buttons stay lit, but not for the screen.

    RMSkater: There's no "always on" setting. This is for good reason I think as the type of light Creative use will wear out with a few thousand hours of use, which will get eaten up relati'vely quickly if "always on". At least I believe that's what Creative have said in the past.

  • Lost data while using a car charger,

    i had a podcast -personal from a company- and i plugged it into the car charger and i had all sorts of problems with it, i used the original ipod cord with the usb car charger a/c adapter, i lost the data and is there any way of getting it back without going to my pc and putting it back onto it??? email me back the answer @ [email protected]

    *+is there any way of getting it back without going to my pc and putting it back onto it?*+
    No.
    Message was edited by: Jeff Bryan

  • I upgraded to iPhone 4s from 3g, can I use the car charger for the 3g with the 4s?

    I have a new 4s and wish to use my existing car charger with the phone. The cables that came with the 4s look like the cables for the 3g and ipod I have, but appearances can be deceptive. Just wish to know if I have to buy a new charger or will my existing one work?

    It should work just fine.

  • White screen of death after using with car charger

    I plugged my iphone into a brand new belkin car charger and it instantly caused the screen to go white. I unplugged it immediately and then reset it.
    The next day I charged it and it booted up ok, but would not acquire the cell network and then would not respond to touch.
    I then rebooted again and rather than getting pure white screen, I got lines of different colour vertically up and down the screen. Eventually it then created a white screen again. Everytime I reset or touched any button, the same sequence would occur - flicker of coloured lines on the screen and then  fill out to a white screen. Plugging it into a mac made no difference, it was not recognised by the computer.
    It is now completely bricked and does not respond to anything.
    Anyone seen anything similar ?

    Yes!!! After the 1.1.1 update, I had the exact same thing happen with my Belkin Auto Kit. A real bummer, because until I updated, I was happy as a clam listening to music in my car off my iPhone.
    Anyway, I had the same thing happen- white screen with flashing colored lines and then a whole bunch of problems. Eventually, my iPhone became completely unresponsive. An Apple Genius took one look at it and gave me a new phone.

  • Has anyone noticed that when using a car charger it causes FM radio to have bad reception?

    This happens in both vehicles. 

    Ok.  I'll go with that.  Although both chargers were from the Verizon wireless store when I bought the iPhones.  Of course that doesn't mean anything.  Thanks.  I'll look in to getting a better one.

  • IPod mini only works with car charger!

    My iPod mini only works when it is plugged into a car charger. It is 4 months old. It does not work (frozen - no response or display at all) on its own, or plugged into the AC charger, or the USB connection on the computer. I have tried the reset procedure several times and with different power connections with no results. The iPod seems perfectly fine when using a car charger otherwise nothing! Whats going on!!?!?!
    Anyone else with this problem??

    Try to reset it.
    Press and hold the MENU and CENTER buttons - at the same time - until you see the Apple logo. This should take about 6 seconds. Also, you want to do this procedure while your iPod is connected to your computer. Ipods are supposed to work with USB port cable and AC Adapters, not only car chargers.
    If this doesn't work, then try to update it using iPod Updater software. Open iPod Update, plug in your iPod to your computer and wait until the software recognizes it. Once it does, you should be able to click on the "Update" button. If you can't, click "Restore"

  • Car charger doesn't charge phone after 4.3 update

    for months the car charger has charged this phone fine, after upgrading to 4.3 it has stopped.
    Anyone else?

    Some more data points.
    If I restart my phone it will work with the car charger until it reaches full charge. Then it stops working with the car charger until I restart it again. So if I get to 100% using the car charger, use the phone for a while and get down to 90%, I have to restart the phone before it works with either car charger again.
    I have the same problem with the verizon branded car charger I have as well
    All three car chargers work just fine with my wife's intensity 2

  • Car charger is not charging phone

    I have a tour 9630, v4.7.1.65. My network is Cbeyond.
    I cannot get the phone to accept a charge when using a car charger from the 12v accessory outlet in my vehicle (ford explorer). I've tried two chargers, in two separate outlets. The fuses in my vehicle are fine, and the red light on the chargers lights up when plugged in. However, the battery will not charge.
    After fully depleting the battery, I plugged it in again to the car charger. The red light came on for a few seconds and then turned off, and the phone would still not even turn on after being plugged in for 20 minutes.
    Does anyone know what could be the issue?

    The first charger was an original OEM blackberry charger
    Second charger was purchased from buy.com
    I have not tried them in other cars.
    Phone charges fine when using a wall charger or when plugged into the USB port on my PC.
    I'm ruling out fault due to the explorer, because my GPS and Satellite radio work fine when plugged into the accessory outlet. Also for the fact that the on light is illuminated on the car chargers but it doesn't charge. The phone reads it as being plugged into a charger, but it does not actually charge up.

  • GPS runs down battery while plugged into car charger

    Hello,
    I have a Fascinate with the 2.2.1 and the Samsung car charger.  When I run Google Navigation or Bing Map while the phone is plugged into the car charger, the phone battery drains and does not charge until I exit navigation.  If I walk out to the car with a full battery and plug it in, the icon will indicate charging while I am driving to my destination but when I arrive and unplug the phone after about an hour's drive time, the battery immediately shows red and the phone shuts itself off.  The phone will charge normally when plugged into the car charger but only if navigation is turned off.
    I don't know if it does this also with the VZW navigation app, I don't use it.
    There are no other apps running other than the pre-installed bloatware. Wifi and Bluetooth are turned off.
    The phone does this with two different Samsung chargers and also a generic charger.  There is only about 6 months on the battery.  It did the same thing before the last system update (I first thought I had a bad charger, which is how I ended up with two).
    Anyone else?

    Hi Andynator,
    Thank you for your posting, it includes some great information. I can assist you with the issue you are having. I would like to ask if you find that this happens only when running maps and using the car charger? 
    I have checked my references here and I am not showing that this is a known issue with the Fascinate. Since you mentioned that this was occurring before the update and is still occurring after the update, this tells me that the root cause of the issue may be with the device itself. 
    You may very well have already called in, since posting your message. However, if you have not and are still having the issue, please feel free to send me a PM with your contact information, as well as the mobile number. I will be more than happy to contact you personally in order to troubleshoot and address the issue further for you. 
    Thank you again for your posting and have a good day!

  • HELP PLEASE! Car Charge

    Hello,
    Today I wasn't at home and was using my phone until the battery ran out and it switched off automatically. So I waited until I get into the car to charge it with the car charger. The car was in I think the mode where radio and lights working without engine on and I plugged the pin into my phone. I waited until the screen lights up then put it in a corner without paying attention to charge indicator. But after 5minutes after my dad switched on the engine and drove, I checked my phone and noticed no 'charging indicator'. I re-plugged but in vain, the screen remained white with NOKIA on it, so I removed battery and tried charging again but with same result. The phone didn't turn off when pressing the power button. So I removed battery again but now use the power button to try turning it on, there's the vibrate, then the white screen with NOKIA on it even after 5minutes. When the phone was off and put the plug in, there's the white screen with NOKIA and when I remove plug, it takes like 2-3 minutes for phone to turn off, horizontal colored lines appeared while the screen lights were fading away.
    I have been using the car charger before on same day with no defects.
    Is it because of the engine switch-on? What should I do? Was the battery damaged or my phone is doomed? Help please!!!

    When you plug your car charger into the cigarette lighter socket or accessory charger point, the cars ignition key needs to be turned to the accessory position for the charger to work. If you are using a nokia charger it should have a light on the portion that goes into the cars socket, that lights up when it is receiving power from the cars battery. Usually this light will not come on until the ignition key is in the accessory position or the engine running.
    It is not advisable to have the charger in the cars socket and connected to the phone when starting the cars engine. I never insert my charger into the cars socket until I have started the engine. In 99 out of 100 times you can start the engine with the charger connected to the cars socket without causing damage. But there is always that possibility. You always have to allow for the Murphy factor (I presume you understand what I mean by that).

Maybe you are looking for

  • V IMP : Report for Cash Customer Bill wise details

    Hi ABAP Gurus, Any body is having the report on Cash Customer Bill wise Details (with invoice details) ? Input criteria - Company Code, Plant, Cash Customer Name(customer Name given while creating cash customer) & Date Range(Document date). I am usin

  • UDF or Javamapping

    Dear All, My Requirement is that, I am getting an XML file as a input inside a string "value_string"   <?xml version="1.0" encoding="UTF-8" standalone="no" ?> - <Si_out xmlns:ns=http:test//>   <value_string><? xml version="1.0" encoding="UTF-8" ?> -

  • Adobe is slow; what is causing this.

    adobe is slow; what is causing this.

  • Is it possible to install adobe flash player in mini Ipad?

    Is it possible to install adobe flash player in mini Ipad?

  • InfoCube - red light for db statistics

    hi all... maybe someone can help me. in Cube administration at performance i get a red light when checking statistics. i try to calculate them, job finishes without problems, but light is still red. when i check via rsrv db statistics for cube i get