Using a garmin sat nav device, when planning a route on the mac it always defaults to the same far away location as the starting point. How can I change this?

Question

Whenever I start route planning using Garmin Connect, the map opens at the same distant location every time, by default. How can I change this and make it open at my own location?

Answer 1

Hello Cgifford,
Welcome to National Instruments Forums.
To output your signal to the PFI lines,
you can use external connectios between OUT0 and PFI lines. You can also use
the backplane to do so by routing into the same RTSI line.
1)
On the SCOPE and FGEN, the name of the
terminals are actually “PXI Trigger Line x/RTSIx” but on the 6602 you might
need to route the signal using the property:
You can also use the DAQmx route signal which perform the same opperation.
2)
This will depend on the frequency of
your pulse train. If this is lower than about 10 ms, then you can probably
place this on a loop and start and stop the acquisition every time. If the
frequency is higher than this, you will have to use:
-       Scripting on the FGEN side (read more)
-       MultiRecord Fetch (more information in the scope help file
section “Acquisition Functions Reading versus Fetching”).
3)
The short answer is yes. The longer one
might depend on how tight you need the synchronization to be (us, ns, ps). For
very tight synchronization, you should look into here.
Message Edited by Yardov on 06-18-2007 03:14 PM
Gerardo O.
RF Systems Engineering
National Instruments
Attachments:
property.JPG ‏7 KB