Voice Over Sync and iPod Shulle 3GS

Hi,
after upgrade to iTunes 9.1.1 (and also Voice Over "plug-in" for my iPod Shuffle 3GS) each time that I connect my iPod, iTunes start to sync ALL voice over messages for all tracks. I' sure that in previous release there isn't it.
Same problem also in iTunes 9.2
Regards.
Thank you for attention.

Also with last VoiceOver kit 1.4 and iTunes 10.1 there is same problem.
Do you know if it is quite normal with last release?
Regards.

Similar Messages

Audio voice over syncing

Has anyone tried to do audio syncing like voice over an animation with EA CC 2014? Using the timeline I was able to embed a voice over in the browser and seems to work very well. I created a symbol with voice over and have an instance created with createChildSymbol() method from another symbol. At times, however, the audio is delayed and throws off the timing. I'm not sure how to solve this problem. Has anyone notice this?

Found a post that could help
Re: Adobe Edge - How to voice over syncing with time-line animation in adobe edge ?
Thanks,
Preran

HT203175 my device launches into the Voice Over mode and I loose touch control how do I stop or change that from happening?

My I-Touch launches into the Voice Over operation and I lose touch control, how do I get out of this mode and back to normal operation? What is causeing this to happen?

@wetdro
If your device has been jailbroken during the warranty, Apple will not service it.
Maybe you missed that in this article:
Inability to apply future software updates: Some unauthorized modifications have caused damage to iOS that is not repairable. This can result in the hacked iPhone, iPad, or iPod touch becoming permanently inoperable when a future Apple-supplied iOS update is installed.
Apple strongly cautions against installing any software that hacks iOS. It is also important to note that unauthorized modification of iOS is a violation of the iOS end-user software license agreement and because of this, Apple may deny service for an iPhone, iPad, or iPod touch that has installed any unauthorized software.
copied from Unauthorized modification of iOS can cause security vulnerabilities, instability, shortened battery life, and other issu…

I have iOS7 on my iPhone4. I turned on the Voice Over option and now my phone is not working at all. At first it was freezing and not accepting any commands. Now all I have is a blank sceen. I can't get back into it. Any ideas what happened here?

I have iOS7 on my iPhone4. I turned on the Voice Over option and now my phone is not working at all. At first it was freezing and not accepting any commands. Now all I have is a blank sceen. I can't get back into it. Any ideas what happened here?

Hi Jeffny01,
If your iPhone is not responding, you may find the following article helpful:
iOS: Not responding or does not turn on
http://support.apple.com/kb/TS3281
Regards,
- Brenden

PHONE WAS IN VOICE OVER MODE AND I LOCKED IT AND NOW I CANT UNLOCK THE PHONE.

i put PHONE IN VOICE OVER MODE AND I LOCKED IT AND NOW I CANT UNLOCK THE PHONE.

i just tried holding the home button and lock button until the screen went black then turned on again, its now back to normal.

Just had itunes 11.1 installed. Now I cannot sync my iPod Shulle 2G. What do I do?

Just had itunes 11.1 installed. Now I cannot sync my iPod Shulle 2G. What do I do?

It has always been very basic to always maintain a backup copy of your computer for just such an occasion.
Use your backup copy to put everything back.

Iphone stuck in voice over mode and not accepting passcode

help, my iphone is stuck in voice over mode and not accepting pass code.

If you have Siri set to work while the phone is locked, you can activate Siri by pressing and holding the Home button and saying. "Turn off VoiceOver."

HT2305 the voice over on my ipod won't stop

my ipod won't stop doing voice over, it interupts my books i listen to, it skips over (fast forwards) on its own... i have restored the ipod many times. IT WON'T STOP. this is very expensive equipment and i'm very disappointed in the product. any suggestions? when i restore, i DON'T mark it to enable voice over. it still happens, incessantly. anyone have a suggestion?

If you restored to factory settings/new iPod via iTunes (Not via Settings>General>Reset>Erase all Content and Setting) and still have the problem that indicates a hardware problem.
Make an appointment at the Genius Bar of an Apple store..
Apple Retail Store - Genius Bar

Tryed to sync and update Iphone 3GS and it started as New phone HELP!

I tryed to sync and update my Iphone 3GS to my macbook computer. In doing so, I think I pressed start as a new phone and now I dont have a phone please help!

Go to iTunes/Settings/Devices and see if there is still a backup from the time before you synced the phone.
If yes, use it to restore from: Backing Up, updating, and restoring your iPhone and iPod touch software
If you're running TimeMachine as well, restore the iTunes backup folder, located here:
The folder where your backup data are stored varies depending on the computer's operating system. Make sure the backup folder is included in your periodic data-backup routine.
iTunes places the backup files in the following places:
Mac:~/Library/Application Support/MobileSync/Backup/
copied from iTunes: About iOS backups

Inherited Linksys Voice over IP and data installation.

I have just inherited a brand new linksys, voice over ip data installation. It has roughly 25 telephones and the same number of computers with new WMP300N network cards and SPA941 IP telephones. The company remodeled an old construction with 100% masonry wall (brick and/or concrete). The remodeling included the 100% wireless data and telephone installation. Now that the remodeling is finished and work has started, the network saturates as soon as there are a few users. The computers are all using LinkSys WMP300N cards and the telephones are all LinkSys SPA941. They installed approx 15 wifi repeaters for telephones and 10 for datos. They installed two separate but identical AP's, one for Data and the other for Voice but both on a 192.168.1/24 subnet.(Zonet ZSR1124WE) The folks who installed this didn't, for some reason, use LinkSys AP's and repeaters but used Zonet ZSR1124WE for all.
My questions are:
1. Wouldn't using the same subnet be the same and using the same
wire that that would allow voice/telephones to saturate and
slow down the data even though the AP's are separate?
2. Wouldn't channel interference between the aprox 25
repeaters be common?
3. If I were to remove all their equipment (APs and repeaters.)
an install 2 LynkSys AP's in the center of the offices
where there is an open patio with a watt or better amplifier
(not illegal here, not in the U.S.) output and a high gain
antenna on each of the two and using separate networks.
172.16.1/24 for datos and leave 192.168.1/24 for telephones
have a chance at success and if so could you estimate
how much of a change and recommend equipment and/or other
critical or semi-critical points that I have missed?
Thanks,
ed
P.S. I have my doubts that this is even possible but it would be cool, if it only worked

Umm.. you left out quite a bit of information:
How are the wired phones connected to the wireless network?
What channels do the APs use and how are they connected in between each other (and other wired data equipment)?
What kind of network is it? B, G, N?
How many WLAN channels are used? One per AP and all repeaters use the channel of the AP they repeat for?
As far as the subnet goes, the current setup shouldn't be a problem - I figure the problems are more likely to come from the wireless than the wired part of your network. Considering that you're basically halfing the throughput with each repeater (assuming the same channel which is likely since there are only 3 that do not interfere unless you have an A network) - the sheer number of repeaters is most likely to be blamed for the poor performance. Traditional WLAN networks generally use a wired backbone, plus you'd have a single net and use one of the three distinct channels in order to minimize interference.
Increasing the output of the main antenna is also only half of the problem... if you can reach clients that are farther away, those clients will also need the appropriate power output to reach the base again - and those wireless cards are limited in that way.
There are two essential pieces to tracking down a problem with your VoIP equipment:
The configuration of every device involved
SIP protocol traces
And don't forget: there's no such thing as giving too much information when describing a problem.

Why does my iPOd over sync and 'lose' music every time

Every time i plug my Ipod (5th gen 80GB)into my pc to automatically sync.
The ipos 'loses' 1/3 of all the music and continues to sync it all back on again (even though there has been no change in any of the music). this happen every time!!!!! and 3000 odd tunes take a while.
Had 1/4 of the art work display is incorrect.
Is there a way to stop this.

Try here:
Can't connect to the iTunes Store
Go to Settings>General>Time&Date and make sure it is set to automatic
Try change the DNS to Google's 8.8.8.8

I did toggle voice over on my iPod and now it's being really slow and won't let me scroll down

Pleeeease help

I had this too, First put it in a bag of uncooked rice over a day period and shut the thing fully OFF. it might be a coincident that moisture has built up inside with the new setting turned ON. Try it.

My Nano suddenly went into voice over mode and I cannot make it stop.

It started reading menus and options when I turned it on recently; I didn't go near any setup screens. It talks even after I've selected and started to listen to a pod cast. It will start over again in the middle of the pod cast for no apparent reason. I've already tried restoring factor settings.

#1:Open Properties
#2: Click compatibility
#3: Click change settings for all users
#4: Under settings click all of the boxes except the first one.
That's how I got it to work

Ford Sync and Ipod Touch ios 5.0

Everything connection wise is working great on my new Escape! I just have one minor question. What is the best way to go through songs on the Ipod Touch?
I can unplug my Ipod Touch and pick a song or particular artist from there it will go through that cycle, but when that album or song is done I repeat the process. My other method, is I can start all songs and go through as it's alphabatized by song name. Just wondering if there is a simple step I am missing to make this a bit easier. Maybe search go through by Artist?
Note that my car did not come with an owners manual and is on it's way.
Thanks in advance!

now i have reset the device and the time is correct. the problem is to search by the alarm. when i tab on the smooth. but i can´t replay that the time step 10 minutes back.

TS4242 how can I get the activation server to activate my phone?All of this happened because I accidently presed the voice over setting and it changed to that in the phone and my password wasnt working so I had to restore the phone to factory settings and

My iphone will not activate,it keepos sending me a message telling me the servers are down and I tried everything.somebody please help

Either your antivirus/firewall is blocking access to gs.apple.com, your iphone is jailbroken, or your computer was used at some time in the past to hack or jailbreak this or some other iOS device. The first you can fix by disabling your security software. The 2nd you can't do anything about, and the 3rd you fix by editing your hosts file and removing the lines containing gs.apple.com.

Voice Over Sync and iPod Shulle 3GS

Similar Messages

Maybe you are looking for